Ford Ranger / B-Series :: 2001 - Airbag Code 29
Sep 17, 2005
What airbag code 29 on a 2001 ranger means? I have not seen that number on any code lists. I triple checked the code and it is 29.
View 9 Replies
Sep 17, 2005
Advertisement
Ford Ranger / B-Series :: 1999 - Airbag Light On With Code 32
My son has a 99 Ranger where the airbag light is flashing code 32. I had the same code on my F350 and it was the clock spring. What it could be. It is 99 Ranger with 2.5l, auto trans, 2wd, no CC.
View 2 RepliesFord Ranger / B-Series :: 2002 - Airbag Light Is Flashing Code 46
My 2002 Ford Airbag light is flashing 46. I believe this is the Drivers side crash senor. I am repairing the left front fender and left front wheel suspension. I have replaced the two air bags and airbag control module. Where is the left front crash sensor?
View 13 RepliesFord Ranger / B-Series :: 1998 - Seat Belt Light / Chime Not Working - Airbag Code 27?
I noticed the passenger side on/off switch for the airbag doesn't illuminate anymore on my 98 Ranger. Whether I turn the key on the switch to on or off it doesn't illuminate either way. The airbag light on the dash flashes showing, counting a code 27 and then it stays on. I also noticed the seat belts on symbol doesn't illuminate and in the owner's manual it says it should illuminate and chime. I remember it use to illuminate but I don't remember a chime.
Someone with a 98 that has a seat belt reminder light that illuminates and chimes until you fasten the seat belt? I don't know if that and the airbag code is related. But I want to fix both? I guess the simplest one to tackle first would be the seat belt light/chime. I don't see a fuse for it. I guess I need to know first is it really suppose to chime.
Ford Ranger / B-Series :: 2001 - Airbag Light Stays On And Blower Is Not Working
The air bag light stays on & the blower in not working. I checked the fuses good.
View 2 RepliesFord Ranger / B-Series :: 2001 - Airbag Light Blinks For About 1 Minute Upon Startup And Then Stays On Solid?
I have a 2001 Ranger 4.0L 4x4 with 101,000 miles on it. I went to go get in it the other day and the Air Bag Light came on out of the blue. I've drove it some since and it is still on. The light blinks for about 1 minute upon startup and then stays on solid for the remainder of the trip. What would make this come on so suddenly and is there anything I can do/check?
View 3 RepliesFord Ranger / B-Series :: 1999 - Airbag Light Is On / How To Shut It Off
How can I shut off the air bag light on my 1999 ranger? I was in a minor accident and I had to replace the bumper, the light came on after the accident.
View 14 RepliesFord Ranger / B-Series :: 1996 - Airbag Warning Light On Dash Started Coming On
The warning light on the dash of my '96 ranger 4.0, auto with 233k miles started coming on. The only thing I have done recently was to replace my battery. Just trying to figure it out.
View 7 RepliesFord Ranger / B-Series :: 1997 - Horn Stopped Working - Airbag Light On Dash?
Not sure the problem is related.
The horn no longer works. The air bag light is on, on the dashboard.
I have checked all the fuses and they appear to be good.
How would I diagnose this problem?
Ford Ranger / B-Series :: 2000 - Cruise Control Switch Broken / Airbag Removal
The cruise control switch on my 2000 Ranger just broke. It looks like you have to remove the airbag to access it. How is that accessed? It looks like there are 2 plugs on the back of the wheel that need to be removed.
View 9 RepliesFord Ranger / B-Series :: Airbag Warning Light Blinking / Bad Lamp In Deactivation Switch
I have a 98 Ranger 2wd reg cab 2.3L 5sp. Recently the airbag warning light was blinking 2-7 which indicates bad lamp in passenger airbag deactivation switch. Since the lamp has no numbers or markings on it, and my repair manual has no schematic on that part, where I can find the ma, wattage or ohm rating of the lamp? Or a part number / source for a replacement lamp?
View 13 RepliesFord - Ranger :: 1995 - Airbag Light Flashing / Code 41
The airbag light on my 1995 Ford Ranger is flashing a code 41 (four flashes, pause, then one flash...does this a few times when I start the engine, then goes to a solid light which stays on while I drive.) It has been doing this for several months, and to be perfectly honest, this has not been a concern for me but now that my state inspection is coming up in December, I need to do something about it. Just before I noticed it to begin with, I had a major repair done--the dreaded heater core replacement--which involved removal of the dashboard. I never associated the flashing with that repair and the possibility that the repair shop might have inadvertently neglected to reattach something when reassembling the dashboard and now so much time has passed, that I can't just go back to the repair shop.
View 4 RepliesFord Excursion :: 2001 - Got SRS / Airbag Code?
I have suddenly acquired a new value added feature to my X. An airbag warning light flashing code 18. Through the research I have found it is either a pretensioner issue or a short. Would like to know for sure what it is.
It is a 2001 LTD 5.4L.
Ford Ranger / B-Series :: Code 157 For MAF Sensor
So here is what I got. Code 157 maf sensor below minimum voltage. Here is what the truck does. When the MAF is plugged in and I step on it, the truck surges and when it drops below 1k rpm it dies but I can start it back up. If I hold the throttle at 1k it stays alive. When I drive with the MAF unplugged it runs better no surging but it still dies. Here is what I have done. Reset codes no change, put new MAF in no change. I have traced all 4 MAF wires checked continuity from inside of plug to inside of plug.
All wires checked out good. No cuts breaks or anything. I have checked my battery, starter, and alternator ad all check out fine. I read that someone said if the corresponding transistor in the PCM took a dumb then it would cause not enough voltage to get to the plug because the transistor would dump the voltage from the battery leading to the MAF. I thought about running a direct power source from the battery to the voltage side of the MAF with a switch in the truck to just see if that would solve the issue but I don't know if that is possible or smart.
Ford Ranger / B-Series :: 1997 - CEL With Code P0133?
I have a 1997 Ford Ranger with a 4.0L 2WD. The check engine light just turned on with a code of p0133. I know that this is something with the bank 1 sensor 1. I tried doing some research and I think that it is on the passenger side before the cat converter. Now, I don't know what to do from there. How do I go about fixing this? What part do I need? How do I fix it?
View 1 RepliesFord Ranger / B-Series :: Got Code P0162 - O2 Sensor Or MAP?
Just checked SES code and read P0162 I think. Stated rich fuel mixture bank 1 & bank 2 (3.0) Is this an O2 sensor or MAP issue?
View 8 RepliesFord Ranger / B-Series :: 1995 - CEL Came On - P0340 Code - CPS Bad
I am having an engine issue with my 1995 Ranger with a 2.3L. I have been having a P0340 code that kept appearing after several attempts at resetting the PCM. I gave up and took it to a Ford dealer for diagnostics and they called the CPS bad. They changed it, but the CEL light immediately came on with the code still kept coming up. The service rep. showed me the old sensor, it had a spot on the head of it where it looked like something was rubbing it. I'm assuming it's slightly rubbing on the gear it points to, which is the oil pump gear, correct? The truck runs fine, no performance issues whatsoever. Is it possible my oil pump shaft has developed play in it's shaft, causing this?
View 1 RepliesFord Ranger / B-Series :: Getting Code Pesky P1443 With CEL?
I've been getting this code for a while. Changed the Purge solenoid and valve, replaced the hose from the canister to the two units, didn't change the hose to the intake.
Is there anything else to check? Could it be a bad gas cap? the one on the truck is a replacement.
Ford Ranger / B-Series :: 1994 - How To Check Code For CEL
1994 Ranger xtra cab
4x4
v6 4.0
5-speed
113K miles
Just bought this truck. When I test drove it no "check engine" light came on, but after purchase driving home is came on and then off many times. It only comes on at high rpm/speed. I have my trusty ODBII scanner but realize that this 1994 was pre-ODBII. How can I figure out what the CEL is about?
Ford Escape / Hybrid :: 2001 - Airbag Light C1414 Flash Code 29
I picked up a 2001 Escape 2.0 manual with 160K. She runs great but I realized that the airbag light was burned out so I hooked up my scanner and pulled 2 codes C1414 and B1869. I changed the bulb and cleared the B1869 but the C1414 remains. the airbag light also flashes and gives me a 29 code. I am not finding much on the subject. The airbags appear to be there and it does not appear that it has been wrecked. I am guessing that it is the airbag control module. Where the module is located on this vehicle.
View 7 RepliesFord Ranger / B-Series :: Code P1403 Keeps Coming On After Clear It
My 96 4x2 2.3ltr is throwing this code (P1443). I clear it and it comes back a few cycles later. I will fix it next but won't be able to get to it for a couple weeks. What if any affect does this code have on fuel mileage and or engine performance/power?
View 3 Replies