Did I get bent over? had a banging noise coming from the rear and took it to my regular shop, they told me the leaf spring shackle and hanger brackets were almost rusted thru and one more pothole and I'd be all over the road, so they ground out the rivets and replaced said brackets. I don't have the equipment to do that kind of work but I still feel it was a little high.
View 1 RepliesA few weeks back just after buying a new front hub assembly (so I know I have Live Axle 4x4 and 4WABS), a dude on an excavator pulled out in front of me on a blind curve on an interstate exit ramp. Almost got him, then almost got got by the car behind. The hard stop caused a rear line to blow.
When I got home, fluid was still coming out when I pushed the pedal, so the first thing I did was top off the reservoir. I was surprised it was not empty.
I finally got lines that would fit, and replaced both sides. Fast forward a few weeks and I had time to bleed the system. I hooked my vacuum pump to the right-rear wheel cylinder port, opened it and began to pump. Pump, pump, pump, and still no fluid. Tried a few times. Left the pump on, opened the port, (charged the battery), started the truck and pumped the pedal - no fluid. Also, the fluid level did not change in the master.
Master cylinder bleed? Do I need to have the ABS motor bled?
My Ranger has 296,000 miles on it. Most everything has been replaced except the u-joints. It's a 2wd 2.5L with an automatic. The motor was replaced at 228,000 with a used motor with 52,000 miles. The transmission has about 60,000 miles on it. All the bearings in the rear end were replaced about 20,000 miles ago. It has the most annoying whistling noise coming from the rear only sometimes. I don't know if it's the brakes being misadjusted or a bearing with a burr in it. It happens at random times but it's such a high pitched whistling you know everyone on the road can hear it too. There is also a driveline vibration, very minor though when over 60. However, I've had the drums checked and even had the wheels balanced many times. My friend said the ujoint grease could be dried up, but the whistling noise only happens at random, the virbation is anytime you're at highway speeds. It's not a violent vibration just enough to tell that it's not a brand new truck anymore. What it could be?
View 2 RepliesMy 1998 Explorer is making a terrible banging noise when driving. It appears to come from the rear. It only occurs when i step on the gas, gives a bang and the car shudders lightly. The bang can be gone for 10 - 30 seconds, and all of a sudden appear again. If I step hard on the gas, it will make a bang! bang! bang! noise.. If let my foot off the gas, it rolls quitely without any noise.
I have greased the slip yoke, inspected the U-joints, checked the rear calipers, opened the rear axle/differential plate - no metal parts or excessive wear were observed.. The transmission runs smoothly, there are no other noises apart from the bang. It is as if someone is hitting the car with a hammer from underneath...
I have a 06 touareg v8 air sus, loaded. Today was the first time towing my bass boat with this truck, and on the way to the lake, I keep hearing a weird noise, sound coming from the rear of the vehicle, something like a rubbing banging type noise. At first I thought maybe the factory hitch wasn't bolted on very well, but this is not the case(as I could tell not much to see under there) I tried jumping on the trailer to emulate the sound but this didn't work. Its not the trailer brake, which is a self actuating system, that checked out ok.
View 3 RepliesI have a 2000 ford ranger xlt the rear frame section is bad the section is factory rivited on just behind the cab will any other model ranger frame fit my truck if I remove the rivits and bolt the section back together.
View 2 RepliesI drive a 1992 325is,(auto) with 150K... a few weeks ago only when racing or hard acceleration there was banging or clunking, coming from under the E-brake area, almost sounded and felt like the back tires hopping up and down as if i where chirping gears in a riced honda. The tranny IS NOT slipping or banging etc.
Now over time it has progressively gotten worse, it started doing it when rpms jump, now i cant even accelerate, I have to feather the gas OH SO lightly or else, it clangs and bangs almost sounding like the drivetrain is slapping against the chassis. i have to accelerate extremely slowly, and lightly or else it clanks and bangs, it takes me 5 mins to get to 40mph. Can it be the guibo? or mount that keeps the drivashaft in place?
I have a 1998 ranger 2.5L engine. I took it to a Ford garage and they told me I have a rod knock..........I took it also to a good mechanic and he said the sound is coming from the lifters.
There is 172000 miles on motor and the noise started at 131000, and is getting worse. Should I drive it till it blows, or is there a way to tell what the problem is?
When I make a left turn I have a horrible grinding noise. Only when I turn left and at any speed.
View 2 RepliesMy daughter's boyfriend just bought a 2000 ranger with a 2.5. We just put a flexplate in it and it wouldn't start. Just turned over. Listened for the fuel pump and no noise. After a few minutes, it worked. He drove it home last night and said that it didn't want to work first try but worked with the second try. He drove it to church, 40 miles, and it sit for around two hours and wouldn't start, no matter how many tries.
We tried changing the relays around with no luck. We went and eat lunch and back to the truck with a rubber hammer. Then it starts on the second try without using the hammer. We got under it and cleaned the connections up and put some bulb grease on them. I couldn't get the one apart right on top of the pump itself, I was afraid of breaking it. It's been doing fine since we left the church before we cleaned the connections.
1988 Ranger, 2.9, 5 speed, 2wd, 7.5, 3.42:1, 190K or 290K on the odo.
I've been hearing this rattling, sometimes kind of a metallic ping, from the rear the last week. I thought it was probably the universal joints, didn't do it often, only under load between 1500-1900RPM roughly in second, third and fourth. I planned on working on it this weekend.
Today it started really making noise, sounds like valves rattling as though the timing was too high but it was coming from the rear end. It was making it all the way through the gears into fifth, even when cruising. Once it cooled down a bit it nearly went away.
I'm going to get started on it as soon as I can, but I can't get it in the shop to pull the differential cover and take a look right now. Dad's shop is full of crap, I live on top of a hill, not many safe places to get one up in the air properly. What is causing that sound?
I'm hearing a sort of faint rotating squeaking noise coming from the front of the engine; I can only assume that it's something with the belts. Nothing too pronounce cause I just notice it yesterday, anyway I was hoping I get another take on what this might be before I take it to the mechanic tomorrow.
View 12 Replies2004 Ranger Edge 2wd 3.0L. When the truck has been sitting for a while and i start moving forward there is a very loud sound of metal on metal. Changed the diff fluid last week, used royal purple 75-140 with the friction additive. No change, tried to take rear wheels off, but the drums are stuck by the pads. I was able to get the drums off only bout an inch.
Recently, I've noticed that on hard acceleration the RPM go up but it seems sluggish on acceleration. There is also a vibration that comes from the rear and goes away when i remove my foot from the accelerator. The squeal happens between 15 and 20 mph, but goes away fairly quickly. The vibration happens around 40 or so. I am thinking rear axle bearings? But i cant get my drums off to replace the bearings.
I have an 04 mountaineer and when i shut it of i get a loud banging noise from it. Its sounds like its coming from the engine compartment. The truck itself runs great and I didn't see any exhaust leaks. It has 70,000 on it.
View 2 RepliesI have a 2000 F250 2wd 6spd with a loud banging noise that has been vexing me for quite sometime now. The bang happens when I go over bumps (even small ones like road reflectors) while driving. I don't think it is suspension related since all the ball joints, front/rear swaybar and endlink bushings have been replaced fairly recently. All the springs and bushings also look okay.
The noise seems to come from the rear, and I notice that if I let off the gas when I go over a bump, it does not make a sound. Conversely, if I am accelerating aggressively and hit a bump, the sound is much louder. Also, if I step on the clutch while keeping my foot steady on the gas, it makes a bang. Jumping up and down in the bed while the truck is parked does not recreate the sound. I have already greased the driveshaft spline joint so I'm thinking the sound might be differential or transmission related. What it could be?
00 F250 338k auto
No error codes or warning lights (Forscan verified)
No smoke out of the exhaust
No oil or coolant leaks
Have banging noise from the motor. When cold truck sounds normal, quiet. When it warms up, the banging becomes audible. You can hear it at idle. You can hear it under acceleration. Frequency increases with RPM
When at speed, and letting off the throttle, noise goes away.....comes back when back on the throttle. Any time during driving when I let off, engine quiets down to normal. To me it sounds like exhaust leak, bur not sure how to check for those?
I have been hearing a rattling or maybe more a banging clanging sound coming from the right rear of my 2007 3 door accent. It almost sounds like something is loose, but I have never identified anything. The tire tools are secure and there are no loose panels either.
It almost sounds like the strut is banging around. My wife did bend the rim on the right rear a couple of years ago. I thought maybe the sway bar was broke, until I realized this car doesn't have one.
Just owned a 2011 hyundai santa fe AWD(48002 miles). At 50,100miles I start hearing this banging noise from the rear (quite loud) when accelerating. Usually occurs after 80km/h. Also occurs at low speed when you let your foot off the accelerator.
View 9 RepliesWent out to run some errands this morning, and was alarmed to hear a loud, tinny-sounding banging noise from the rear of the car. It would occur on every bump. little or big; every time I braked; every time I started up from a stop; after each shift to a higher gear; and every time I turned a corner.
I was getting really concerned, as I had never heard a noise quite like this on any car, ever before. When I got home, I pulled the floor jack out of the garage, then went to the trunk to get my torque wrench with the wheel bolt socket on it.
When I opened the trunk, this is what I saw: ...
About 3 weeks ago my car,a 2007 saturn vue 6cyc., started making banging noises in the glove box when I start the car. The noise last for about 10 seconds and is very loud. The car runs great, no problems.
View 8 RepliesI have a 2003 Camry 4 cyl. around 60,000 miles on odometer and for around 3 months the engine seems to have gotten louder while at idle. At the back of the engine around the plastic intake manifold area the engine is making a light banging / tapping noise. It never made this noise before. The engine idles fine and the drives normally. I always keep an eye on the fluid levels and they are up to par. I'm not sure what is going on and if I should just keep an eye on it. I have provided a link below to a video of the noise. The noise can be heard best starting around 15 seconds into the video and fades away around 26 seconds into the video. [URL] ....
View 1 Replies