Ford Ranger / B-Series :: 1999 - Squeaking Front Wheel Bearings
Aug 31, 2013
4x4 1999 Ranger ... They are a squeaking and driving me crazy. How hard are they to do, do they need a press or can they be done at home?
View 7 Replies
Aug 31, 2013
Advertisement
Ford Ranger / B-Series :: 1999 - Front End Started Squeaking?
I have a 99 ranger with 170000 miles and the front end recently started squeaking. its coming from the driver side but I can't pinpoint it.
View 5 RepliesFord Ranger / B-Series :: 2002 - Tire Wear And Squeaking Front End
My '02 Ranger has had tire wear for a while now, and its on the inside of both front tires. I was thinking it was either toe or camber, or maybe both. I havent been able to get an alignment recently. If its the camber, should I get the camber kit from Ford?
As for the squeaking, it first happened last summer, and I sprayed WD-40 on the upper control arm bushing and it went away until last week (obvoiusly temporary). Now its back. Also happens while turning the front wheels.
Ford Super Duty (1999-2016) :: Greasing Front Wheel Bearings?
If front wheel bearings can be greased through the abs wire hole on a f250 4X4, will that work on a sealed bearing on a gm product? I have done my f250 but I also have a 2004 suburban.
View 2 RepliesFord Super Duty (1999-2016) :: Vibration In Front End - Wheel Bearings
I have a 2000 F350 4X4 crew cab and have a vibration in the front end. I have done sone investigating and have come to the conclusion that is the front wheel bearings. The dealers says I have to buy the entire hub assemble but I seem to think different. But if I can replace the bearings any special tools that might make it easier ..
View 14 RepliesFord Ranger / B-Series :: 1998 B2500 - Squeaking Front End At Slow Speeds
I have had my 1998 Mazda B2500 truck since 2000 and this problem comes and goes (it's mostly been gone lately). Usually when it is cold outside. At slow speeds it creaks and squeaks - kinda embarrassing - if I am sitting still it squeaks when I turn the steering wheel. Once the speed picks up you can't hear it. I have noticed this in other fords about the same year.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Whine Coming From Front Wheel Bearings?
I have some whine coming from my front wheel bearings so I'm going to replace them both. I'm not sure if this had been done on my truck before, but I'm thinking so since I have Moog greaseable ball joints.
Truck has 250k miles on it. I'm going to check the pads, rotors and slide pins. Anything else that might need work? I'm sure the half shaft could use a once over, but I don't keep my hubs locked so they don't turn much in regular driving.
Ford Super Duty (1999-2016) :: 2012 4x4 - Front Wheel Bearings Replacement
Are just the bearings serviceable/replaceable or is the only option to get entire wheel hub assembly?
View 14 RepliesFord Ranger / B-Series :: Faint Rotating Squeaking Noise Coming From The Front Of Engine
I'm hearing a sort of faint rotating squeaking noise coming from the front of the engine; I can only assume that it's something with the belts. Nothing too pronounce cause I just notice it yesterday, anyway I was hoping I get another take on what this might be before I take it to the mechanic tomorrow.
View 12 RepliesFord Ranger / B-Series :: 1996 - Rear Differential Whine - New Bearings?
i have a 96 ranger 2wd with a 2.3l engine and a 5 spd manual. everything works except the rear diff whines a little under load. putting new bearings in doesn't look to difficult that's what i will plan on doing but first i need to take the cover off and need to know what fluid to put in?
View 9 RepliesFord Ranger / B-Series :: 1991 - Front Hub Comes Off With Wheel?
I recently bought a 91 Ranger 4wd for my son. The guy I bought it from put new manual lock outs on it. every time I take the tire off on either side the hub comes with it! Is there a clip or retainer missing? If so what and where can I get one?
View 4 RepliesFord F-150 (2004-2008) :: Roaring Noise Coming From Right Front While Turning - Front Wheel Bearings?
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 RepliesFord Ranger / B-Series :: 2007 FX4 - Clunking Sound From Front End In 4 Wheel Drive
There is a clunking sound and feel from the front end of my 2007 Ranger FX4 when in 4 wheel drive. This happens sometimes but not always on engaging or disengaging 4 wheel drive, as well as sporadically while driving along. I took it back to Ford on warranty with this problem last year, and after a few attempts I had them admit that something was wrong and they finally diagnosed that it was the front drive shaft that was binding where it leaves the transfer case, this was replaced. I have now put maybe 50km (max) on in 4 wheel drive and the problem is back, I don't think the problem was ever fixed.
View 14 RepliesPrius (2004-09) :: Clucking Noise From Near Front Driver Side Wheel - Replace Wheel Bearings?
My 2005 Prius has 95k miles on it. I've been hearing a cluck-cluck-cluck noise from near the front driver side wheel. I had an independent mechanic test drive it, who said the wheel bearing needs replacement. Should I have it checked out by a Toyota dealer? They're so much more expensive, but are is it worth taking it to them?
View 15 RepliesFord F-150 - 1997-2003 :: Sloppy Front Wheel Bearings
In 30 years of wrenching on cars, I've never encountered this problem. Replaced the pads and left rotor. Rotor is typical Chinese rotor. While there, replaced the wheel bearings. Also knocked out the races (with a brass drift) and replaced the races with the ones that came with the new wheel bearings. The bearings are NAPA bearings. Packed the wheel bearings just like always.
Applied some grease just like always on the spindle. Put it all back together. Tightened the wheel bearing nut while rotating the rotor in the opposite direction. Went to maybe 10 ft lbs. Backed the nut off, set it firm finger tight. Installed the cotter pin. Got a whole bunch of sloppiness in the wheel bearings. I can feel a LOT of it when rotating from the 6 o clock and 12 o clock position. What did I miss? NEVER had this happen before. 2002 f 150 2wd
Ford - Mountaineer :: 2006 - Replacing Front Wheel Bearings?
looking to replace the front wheel bearings on my 06 Mountaineer. Detroit Axle? I found them on both ebay and amazon and prices almost seem too good to be true (under $100, 12 month warranty).
View 6 RepliesAvalon 2005-12 :: Noise Coming From Front Left Tire - Front Wheel Bearings Replacement?
I've been having a lot of noise coming from the front left tire, and I finally had it diagnosed as a bad wheel bearing today.
I noticed that the front wheel bearings are sold individually while the rear wheel bearings are sold as hub assemblies. Is there a certain way that the front wheel bearings have to be removed and pressed on? I'm trying to see if this is a DIY repair.
Ford F-150 (2009-2014) :: 2012 XLT 2WD - Front Wheel Bearings Making Noise
Front wheel bearings making noise. Can I buy replacement bearings/races/seals, or must i buy a whole new hub front assembly?
View 3 RepliesFord Ranger / B-Series :: 1999 - Four Wheel Drive Will Not Engage
I bought a 99 ranger few months ago cant the 4x4 has not worked in the truck for about 4 years. Bought it off my dad. He hasn't figured it out the t case locks in the drive shaft spins but hubs will not lock in. Has new hubs in it and still not working. Trying to get it fixed so I can park the diesel for the winter and run the ranger.
View 3 RepliesSierra :: 1984 K2500 4WD - Front Wheel Bearings Loose
1984 K2500 4WD 8-lug
Front DS wheel hub. The front wheel bearing nuts come loose all the time. I have to check it every weekend, usually starts to get loose after a week and I have to pull apart the hub and re-tighten the nuts. Bearings are all okay, but tires wobble when they get loose...
Reverse order of install: nut -> keyed washer -> nut -> washer -> snap ring -> 4wd auto engaging assembly -> spring seat -> cap seal -> spring -> cap
My understanding is the deepest nut gets adjusted so that the bearing is tight enough that nothing wobbles but not so tight the wheel can't freely spin. Then the keyed spacer goes in and the second nut is tightened down hard to lock the first nut in position.
I've had on-and-off issues with the front DS in general as well. That side the brake caliper always start to suck in air after a few months, on #4 now. Brake system has been replaced with rebuilt MC & calipers, all new lines and warning switch. Also the 4WD doesn't seem to lock in on that hub every time. It will engage, but doesn't hold if it gets too much torque. Then other times it engages and locks and won't have any problems until next time I want to use it. It works about 70% of the time. I've taken it apart and checked everything, no burrs or wear that I've noticed to cause it.
Sonata I45 (YF - 2011+) :: 2013 - Front End Noise Like Bad Wheel Bearings
I just got a new Sonata and I find the car has a noise like bad wheel bearings in front, it sounds like driving on really rough pavement.. I have changed the tires and still get this..
View 1 Replies