Ford Ranger / B-Series :: 1998 - Rear Main Seal Leak
Jun 6, 2017
I just had trans rebuilt in my 98 4x4 4.0 ranger I thought while they had the trans out go ahead and replace rear seal. Got the truck back leaking bad carried it back they claim to have replaced it twice while they had it and guaranteed it was not leaking they say the leak is from the oil pan so I'm gonna pull the motor this week. Question is: can make an offset rear seal I still believe this is the problem. Which oil pan gasket to use.
View 4 Replies
Advertisement
2004 automatic 88,000 miles 2wd
When I bought the truck it had a very small oil leak that would drip out of the bell housing between the housing and the inspection pan. it would leave a quarter (25cents) sized stain on the ground and would only drip for 10 minutes or so after I shut it off. in 3000 miles it would be down 1/2 quart of oil...
Well 3 weeks ago I stopped and noticed a HUGE stain now. I checked the oil and was 1 quart low. I filled it then I drove 90 miles the final week before parking and was down another 1/2 quart...
I am figuring the rear main seal is gone. I did some research and it seems these are common to go in the 3.0? What seal is the best to get? should I get the seal right from the dealer? or I will run into the same problem and go with a after market? I also learned that the crank shafts can get a groove in them and it's good to put a new "speedy seal" where can I get one of those?
Also for some strange reason I take the tranny out and the rear main is good ( I seriously doubt it) is there anything else that could be leaking that I should check when I have the tranny out? Can I remove the tranny with the factory exhaust still in place? it looks like it can squeeze just by it?
View 7 Replies
I wanted to bring attention to an oil leak I discovered today. It appears to be from the rear main seal. My Passat is a 2015 1.8Tsi with the 09G auto. You can see the leak with the belly pan on. From the front of the car, looking through the vent for the transmission pan look at the lowest point on the bellhousing there is a small machined flat area. Pictured is that area (with the pan off). There is also oil on the back side of the bellhousing on one of the main bolts between the block and trans. The three rear bolts on the pan need to come off to see that one. I would recommend looking at this area on your Passat. Currently my Passat has 3,490 miles on. It's not a terrible leak, but it is worse than what should be present on a modern, new vehicle.
View 16 Replies
If I use ATP AT-205 stop leak to stop a slow leak coming from the rear main seal, will it last a long time? And if it stopped working eventually, would adding more stop the leak again?
Also, I'm going to have the transmission out anyway, so how many hours would it probably take to just replace the seal at that point? And someone told me some seals were two halves that fit together as one, and others are just all one piece. Is that true? It would seem to me that a two piece seal like that would start leaking prematurely.
View 3 Replies
Took the torque converter cover off and this is what I see. Before I took it off the cover looked oily. Prev I replaced the EGR valve and some other sensors and there was oil on top of the engine. Does this look like a rear main seal or oil dripping from the top of the engine?
View 4 Replies
I have a 1996 Toyota Camry it has a small leak-from the "Rear Main Seal" Very expensive to repair. I can't afford that at this time. I put in Valvoline Maxlife for older cars, sealed for couple mnthsnow its leaking again. Its not PCV. Would it damage other car parts? " Blue Devil Rear Main Seal Stop Leak and Conditioner"...
View 6 Replies
My girfriend's 2000 Elantra with 175,000 m leaks oil from it's rear main seal, which was replaced once before. Her mechanic has told her that it's not worth replacing again, because the groove it fits in has widened and can never be sealed completely. Does this make sense?
View 5 Replies
I have a 1996 Toyota Camry it has a small leak-from the "Rear Main Seal" Very expensive to repair $800 I cant afford that at this time. My question is: can this product be tried as as temporary fix or if it works? Would it damage other car parts? " Blue Devil Rear Main Seal Stop Leak and Conditioner.
View 7 Replies
2014 RX 350 - 8700 miles - Rear Main Seal Leak
Very disappointed that my new RX with only 8700 miles and has never even had an oil change now has a rear main seal leak. The dealership says that the gasket was defective and that there is no other visible damage. The dealership has filed a case with Lexus corporate.
Granted that it will soon be fixed at no cost to me, it's still very disappointing that a brand I hold so high for quality has let me down in such a big way.
View 6 Replies
2014 RX 350 - 10,300 miles - Rear Main Seal Leak #2
Brought car into the dealership to repair my rear main for a second time. Looks like every 5,000 miles the leak shows up.
The dealership has repaired the rear main seal a second time, and guess what?
Two days later at the dealership the car started leaking oil again.
So now it's been identified that the entire short block needs to be replaced. Should take another week to repair.
This has been the worst experience I've ever had with a new car. Now I have a relatively new car (10,300 miles) that has had 2 rear main seals repaired, a short block replaced, replaced front parking sensors, and a radio that displays the wrong time when first starting the car.
View 7 Replies
I'm an experienced home mech, not really worried about doing the job. Just curious if there is any pitfalls I need to know about, or a trick/tip that may make the job easier?
View 8 Replies
I have an '04 Ranger Edge 3.0 with a severe coolant leak. It appears to be coming from the area where the head/water pump housing meet. I have been told I've lost the seal behind the pump on the timing cover. Is there any way to know for sure? Will I be able to tell, once the pump is out that it isn't coming from the head side? Are there any "special" instructions for re-sealing after replacing pump?
View 6 Replies
I bought a '98. At the front passenger side of the engine, the injector rail is leaking fuel (a fair stream of it). I have done some googling, and browsing around the forums, and can't find much in the way of specific info on where to start with this.
Whatever the device at the front of the rail - Without digging too far, it seems that the leak is coming just below it.
Questions:
Am I obliged to change injectors with the rail?
What is involved with changing the rail? Removing upper intake only? At all?
What is the box shaped device at the front of the rail, passenger side? Test port? Pressure Regulator? Both?
I won't have a chance to work on this again until next weekend, but thought I'd try to do some homework beforehand.
View 10 Replies
We have a 97 f150 4x4, I have pulled the transmission for repair. The rear main seal is not leaking however I have always replaced them when I pulled a tranny. This is a 5.4l and after removing the flywheel I noticed there is another cover around the crankshaft held on by 8mm bolts around the side and 2 oil pan bolts on the bottom. Does this cover come off to fully access the seal? Is there a gasket available for this cover or is silicone the standard?
View 1 Replies
I have a 98 Ranger 3.0 with a standard transmission. The truck has 240,500 miles so far. It runs just as good as the day I got it 11 years ago, doesn't use any oil and still gets 23 MPG. Last fall, it developed what sounds like an exhaust leak under the hood. It seems to be coming from the area of the EGR valve. The trouble is that I can't feel it or smell it. I have carefully felt the entire length of the tube running from the EGR to the exhaust manifold and cannot feel any leaks. There is no soot or any other evidence of an exhaust leak.
The noise isn't there for the first minute or so that the truck is running. I would think that if I had a cracked manifold or some other such leak, it would be worse when the engine is cold but this is not the case for me. It is most noticeable when pulling a hill as slow speeds in a higher gear. I have checked for codes (no CEL) and there are none. When I first heard it I figured that I would wait until it gets a little worse and I would be able to find it. Its been been over 8 months now it has remained the same.
View 1 Replies
My ranger decided to start leaking fuel somewhere probably a few weeks ago. I can smell it whenever I start the motor, and sometimes while driving with the windows down. Last night, I finally looked into the problem. I took the intake air hose off. The hose, air filter, and whole intake smells like gas. I'm thinking that shouldn't be the case on a fuel injected engine. After seeing some people talk about the Fuel Pressure Regulator go bad, I pulled the vacuum line off of it, and it has a very strong gas smell. I don't see any gas coming out of it, though, even with the motor running. Everything I read says if the regulator is bad, then gas should come out of the vacuum line. Is there another check I can do on it to confirm this is the problem? Is there somewhere else I should be looking? It got two new heads right before this problem started, so its quite possible I knocked something putting it back together.
View 6 Replies
2011 F-350 CC, 45k miles... Found out yesterday mine is leaking. Way to early for these issues to pop up.
View 1 Replies
I am tearing down my junkyard engine to prep it to put into my truck and I came across this on the rear main seal... is this a wear ring?
It kinda looks like a oil slinger. My new seal is on the way so I have nothing to compare it to.
I don't want to be yanking on it if it's supposed to stay.
View 6 Replies
My daughter has a 2000 intrepid with i believe a 2.7 engine. the rear main seal is leaking.
View 1 Replies
I haven't had time to take my truck to the dealer to actually be checked yet but it appears I might have a rear main seal going out from what I can see. I pressure washed the whole underside of my truck the other day and there is fresh oil where the engine connects to the transmission.
My truck is a 2011 with a 2013 engine in it. The truck has 103,900 miles on it. The engine has almost 60,000 miles on it. I have the extended warranty on it which is good. All this truck has to do is last 2 more lousy months and I'll replace it.
2011 Ford F-450 6.7L Diesel 12' Flatbed
View 5 Replies
Changing out the rear main oil seal on my 1999 F250 Super Duty. I have a 7.3L diesel with 6 spd manual trans. with 98K miles. This past week it has developed a very slow engine oil drip where the engine meets the transfer case. Is it necessary to remove the engine or just the transmission? What does a transmission/transfer case combo weigh? What special tools would I need?
View 1 Replies
