Ford Ranger / B-Series :: 1997 - Blinkers Are On And Light Up But Does Not Blink
Mar 9, 2015
1997 Ford Ranger Manual. The blinkers are on and light up they'd just don't blink . Don't know what to do all fuses seem to check out.
View 2 Replies
Mar 9, 2015
Advertisement
Ford Ranger / B-Series :: Blinkers Would Only Flash Once
Ok first I am not super-mechanically inclined but i'm pretty smart and a fast learner, lol. That said I have a 1999 Ford Ranger and two nights ago first one blinker stopped working and then an hour later the other one stopped. What I mean by "stopped" is they weren't turning on at all.
Ok so, the flasher lights are all working when turned on. I went to the auto parts store and they said I needed a new flasher. I bought it but they weren't sure which one to replace. Well there were only 3 that size in the box under the hood so I used the process of illumination. Except the new one didn't exactly fit the first one so i tried the two others. Well when I think I had it in the right one.
The Blinkers would only flash once and then that was it. The guy at the store said the flasher may be faulty but he did not have another one so he gave me my money back. I noticed on the way home that the blinkers would still flash once even with the old flasher in place. The 4 way flashers still work normally so all bulbs are working.
Passat (B5) :: Blinkers Blink Once Or Twice Then Stop
They blink once or twice then stop. What needs to be done and is it a job a backyard mechanic can easily handle?
View 10 RepliesFord Ranger / B-Series :: 1997 - ABS Light On Steady And Never Goes Away
1997 ford ranger 2.3l ...
I have my ABS light on steady and never goes away. This all happened when I had a friend work on my truck. Long story short, it seemed like lost the RABS diode under the hood and replaced it with a 'hacked' 7.5amp fuse. I saw this and was very disappointed.
So I first changed the speed sensor and nothing. I did the RABS code test and received 12.
My questions is whether or not that hacked fuse is causing all of this, and if it can cause long-term damage to the electrical system. I don't mind non-abs at all, but more on the long-term affects.
Ford Ranger / B-Series :: 1997 V6 - Battery Light Came On
I have a 97 Ranger with 4.0 V6 with about 120,000 miles. The battery light came on today so I took it to Advance Auto to check the battery and Alternator. They said both were good. I checked the fuses and relays and nothing was blown or out of place. Could it be a bad ground?
View 8 RepliesPontiac :: 1966 - Lights Malfunction / Blinkers Don't Blink
the blinkers keep working and not working now they aren't of course.. but the left one only worked then something happened and the left only stayed on (not blinking) when the head lights were on. then it switched now they don't turn on at all. the fuses are good the relay is good all the wires are good I got new bulbs in as well and pointers. it's a Pontiac starchief 1966 and the flasher is good
View 1 RepliesFord Ranger / B-Series :: 1997 - Instrument Panel Light Bulb Replacement
I just finished replacing the instrument panel light bulbs on my 1997 Ranger XL, 2.3L, 2WD pickup. I wanted to share how I did this. First of all, if you never have done this before, go slow and take your time removing the dash panels as they are plastic molding and break easily. Allow yourself about an hour to complete the task. You will need smaller sized hand sockets to remove the screws. The very first thing you should do is remove the negative battery cable from the battery. This way you will not risk shorting out anything electrical as well as possibly triggering the airbag in the steering wheel column.
The key piece in starting the process is to remove the radio first and then central console panel that houses the radio. It pops out very easily by gently prying it out in the four corners. Once you get that piece out remove the screws the support the lower knee panel. In order to get that piece off you will have to remove the two screws the hold the hood release lever in place. Get under the dashboard and look up as you lay looking upward near the brake pedal. Pull the hood release lever and you will see the two gold screws. Remove them. This will free up the panel on the under side. The top side of the panel will pop out if you pry it gently on the top two corners.
Next, you will see a metal panel underneath the knee panel. Remove this metal panel as well. Now you will be able to remove the instrument cluster panel piece. There are some visible screws holding this in place, remove them and gently pry the cluster panel out. Once the cluster panel cover is out you will have to actually remove the gauge cluster itself by removing the the four screw bolts that secure it in place. After the screws are out, gently work it out of the dash slowly as you will need to disconnect three electric plug harnesses in the back.
After it is unplugged and out, on the backside of the instrument cluster you will see some round, black colored thumb screw bulb housings that house the light bulb. Just twist them and turn making sure to go in the right direction. Feel it out for the direction, I cannot remember which way it turns. The bulb housings are labeled "ILL" on the circuit overlay. I recommend you replace all the bulbs as you might not want to have to do this again in the near future. Once all the bulbs are tightly seated and installed just reverse the above process for installation. This is a fairly easy job and like I said it takes about an hour. Make sure you test the lights after finishing.
GTI 337/20th Anniversary :: E-Codes Installed - Blinkers Started To Blink Very Fast?
Just installed e-codes in my car about a week or so ago.. When I did, the blinkers started to blink very fast. All the bulbs work fine and everything, and the hazards blink normally as well. Does this normally happen?
View 7 RepliesFord Ranger / B-Series :: 1997 - Horn Stopped Working - Airbag Light On Dash?
Not sure the problem is related.
The horn no longer works. The air bag light is on, on the dashboard.
I have checked all the fuses and they appear to be good.
How would I diagnose this problem?
Ford F-150 - 1997-2003 :: OD Off Light On The Shift Selector Blink / Service Engine Soon Light Comes On
I have a 1999 F-150 w/ 4.2 V6. and auto trans, truck has 219,000 miles on chassis but only 25,000 on engine and 10,000 on trans. I've been getting obd codes p0705 and p0715. I replaced the position sensor on outside of trans. but I continue to get the codes off and on again. I noticed that the O/D "OFF" light on the shift selector blinks simultaneously when the "service engine soon" light comes on. I've noticed that there is no low gear unless I have it in D from a dead stop, and not even when downshifting manually.
View 1 RepliesFord F-150 - 1997-2003 :: OD Light Will Start To Blink When Trans Gets Hot
I have a 1998 f 150 v8 4.6 ltr xlt. A mechanic told me that if my tranny gets hot the OVERDRIVE LIGHT will start to blink. It sounds strange to me, should I have a guage installed? I will be towing a trailer this summer.
View 8 RepliesFord F-150 - 1997-2003 :: 2001 - Code PO1747 - Engine And Overdrive Light Blink And Acts Like Running Out Of Fuel
2001 F150 5.4 Auto ... Truck was running excellent. Engine light and overdrive light begins to blink and it acts like its running out of fuel or water in gas. Baring made it home. Cleared the code and it comes back. Transmission seems fine.
View 2 RepliesFord Ranger / B-Series :: 1997 - Possible 4.0 To 5.0 Conversion?
I recently purchased a 1997 Ford Ranger with a blown 4.0 with a 5 speed , I have a 5.0 with a Carb and 5 speed out of a 80s mustang . Is it possible to use this in the 97 Ranger , I understand I need a different fuel pump but motor mount wise I was hoping it would fit.
View 2 RepliesFord Ranger / B-Series :: 1997 - Won't Go Into Park?
Went to work one day and went to put my truck in park and it went as far as reverse. It has alot of play in the shifter. I have had a couple of people look at it and said that they would not touch it because of the air bag. I am not afraid to work on it myself if I just knew what to do. I am a single mom and on a budget, I would rather do it myself.
View 6 RepliesFord Ranger / B-Series :: 1997 4X4 SXT - 4 Lo Won't Engage
97 automatic 4x4 SXT 4.0L. 4Hi will engage, but when I shift to neutral, press foot on brake, and shift to 4lo, nothing happens. No light, no sound. Occasionally it will make a sound, and even more rarely will light up, but it does not feel like 4Lo is engaged even when indication says it is. I pulled the shift motor and replaced, as well as verified that the transfer case could be shifted to 4 hi and lo by using an adjustable wrench. I have not put truck on stands yet, but I'm pretty sure 4 hi is truly engaging. I did attempt to engage with shift motor connected electrically but not mechanically, and it shifted. What is keeping 4 Lo from shifting? If it's a vacuum issue, wouldn't 4 hi not shift? I did check the vacuum lines and the vacuum reservoir and they seemed to be okay.
View 3 RepliesFord Ranger / B-Series :: 1997 - CEL With Code P0133?
I have a 1997 Ford Ranger with a 4.0L 2WD. The check engine light just turned on with a code of p0133. I know that this is something with the bank 1 sensor 1. I tried doing some research and I think that it is on the passenger side before the cat converter. Now, I don't know what to do from there. How do I go about fixing this? What part do I need? How do I fix it?
View 1 RepliesFord Ranger / B-Series :: 1997 Won't Shift Out Of Park
I have a '97 Ford Ranger with an automatic transmission that wouldn't shift out of park last night. A friend opened the hood and jiggled the steering column some, and finally it shifted. We checked the transmission fluid and it is full, a dark brown color. What the problem might be?
View 3 RepliesFord Ranger / B-Series :: 1997 4WD - Cylinder Misfires On 4 And 6
Besides being spark plugs and wires and/or a bad coil pack, what other things could make it so i have misfires on cylinders 4 and 6? going to replace the plugs and wires later today when they get to my house but i just want to know what other things i could be so I can evaluate the potential repair cost and should the wires for cylinders 4,5, and 6 be under or over the intake manifold? I bought my truck used and they are currently under the manifold i think it would make more sense to have them over personally.
I have a 1997 Ranger 4WD with the 6 cylinder 4.0L engine. I can't remember the codes that it tripped at the moment but i think one might have been the 304 code not sure though.
I tripped the 300,304, and 306 code but don't know about any others i remembered what codes i tripped the other day when i had it scanned
Ford Ranger / B-Series :: 1997 2WD Went From Fine To No Start
My son's 97 2WD Ranger with 2.3L, 5 speed, no a/c, basic XLT standard cab.
I was using his truck because my 93 Ranger was getting a new starter on it. I drove to work with no problems, then after work, it started just fine and drove a few hundred feet to a stop sign where it promptly died. I was able to start it again with some effort and drove to the next stop sign maybe a quarter mile away. Truck died again, but this time it would not start. Towed it home about seven miles and its in the driveway now. The previous owner had new Motorcraft platinum plugs and wires installed, new fuel filter, fuel injectors cleaned, all about 11,000 miles ago. My son has had it for about 6,000 of those miles.
It felt like it ran out of gas, but the gauge showed about 1/4 tank, and I put about 3 gallons more from a gas can into the tank with no change in being able to start it.
Here's what I've checked so far according to my Haynes manual:
Turned key and listened for fuel pump and it seems to go on just fine.
Checked fuses and they are fine.
Swapped around relays in distribution box with no change
Checked resistance at coil pack and it was about 1.7.
Checked resistance at one injector and it was about 1.7.
Checked inertia switch and it did not need a re-set.
I don't have the ability to check fuel pressure.
Ford Ranger / B-Series :: 1997 XL Won't Run / Starts But Will Not Idle
i have a 97 ranger xl with 2.3. it was recently crashed in the front, air bags deployed. i fixed the bodywork but couldn't get it to run properly. it starts but will not idle. i have replaced the iac , evr , maf. fuel pressure holds 35-40 psi running does not leak down after engine stops
View 9 RepliesFord Ranger / B-Series :: 1997 - Turn Over But Won't Start After Hot Sometimes
I have a 97 ranger with 3.0 it runs great but once you drive it and shut it off and go to restart it it will turn over but not start it used to start once I let pressure off the fuel rail, but now is a little harder to start when it does this but it looks as thou coolant comes out of the reservoir when this happens I think it might be coolant sensor or thermostat problem causing the timing to advance until it cools but then again why was it starting when I released pressure from the fuel rail and also I don't believe my check engine light works...
View 8 Replies