Ford Ranger / B-Series :: 1996 - Clicking Noise Under The Steering Column / Relay Sound
May 29, 2014
Can't seem to figure out what is making this clicking noise. It comes from under the dash, drivers side, under the steering column... Now as for when this happens, anytime! Truck on, idling, driving, truck off, key turned to acc or key to on. Also happens even when key is not in ignition?! What this could be? Brand new battery and connecting rings/wires.
Additional info: 1996, 2.3L about 150k miles on her and she's still going strong
View 2 Replies
Advertisement
Within the last couple of weeks, periodically I see small amount of smoke coming from the steering column, from the hazard switch. It only lasts a couple of seconds. I've owned my 99 Ranger for about 7 years now, and since I got it, the dome light has never worked, even when installing new fuses. I'm suspicious it's the multi-function switch but not sure. What this means. I'm no mechanic, I just read alot, and from what I've read, this seems to be the issue.
View 3 Replies
What a great way to start the day! Nice little message on my MFD when I started the car up this morning. It drove to work just fine (which is right by the VW dealership) - but when I turned it off and started it again, the light was gone... Don't want to take any chances so I'll definitely bring it in. On a side note - I'm now hearing a clicking sound at speeds above 40mph. The noise gets faster as the car speeds up.
View 1 Replies
I have an 08 escape v-6 fwd. i recently started hearing a clicking noise in the steering column. Seems to be getting worse and more noticeable. Front end seems normal. This clicking seems to be coming from right under the steering column cover near the turn signal area.
View 4 Replies
2008 R32 with 17k ... What might be causing this sound which is just a faint clicking clicking sound that happens intermittently when driving.
I have an appointment at VW dealer tomorrow but they do not want to take ownership as I have replaced the head unit and have steering wheel controls for my Alpine IVA 505.
It is not electronic as the controls are solid state and the can bus adapter is behind the head unit. It seems mechanical but what could it be? I definitely notice that at a stop when rocking the brake that create the start of the clicking sound .
View 2 Replies
I have a 1996 Nissan Pickup that has been making a clanking noise (that's progressively gotten worse over time) in the steering column every time I go over a bump in the road. The sound is coming from the area between the steering wheel and the dashboard. It sounds like metal hitting metal. The steering seems to be functioning normally, other than the annoying noise. What's causing this?
View 2 Replies
In the past few weeks I have noticed that as I turn the ignition of my 2007 Honda Accord, I hear a strange electrical arcing/clicking sound coming from the steering column. The car starts normally and the sound goes away once the engine has started. I have taken the car to my mechanic and had the ignition checked out and they could not find anything wrong. How to identify the source of this noise/fault?
View 4 Replies
I'm in the middle of replacing my pump. With the new pump are a plastic washer and a small rubber o-ring but no instruction where they are supposed to go. They didn't know at auto zone and I haven't heard them mentioned on any youtube video. I found a crushed torn up washer similar to the plastic one in my catch pan. Maybe it is supposed to go in around the high pressure hose connection.
View 6 Replies
Noticed a clicking noise coming from the steering column or instrument cluster. This usually occurs when the car is warming up, but I have noticed it other times as well.
View 20 Replies
I have a 2006 RAV4 with a clicking noise in the steering column. The dealership says the intermediate steering shaft, which will cost over $500, but that it can wait - I can drive it safely for awhile. First, what the heck is "awhile"? And is he correct - can it be driven safely? How will I know when it is no longer safe?
View 2 Replies
I just received this ranger and have never heard an engine sound like this before.
[URL]....
View 14 Replies
I brought our 2010 Rx450h to the dealership several months ago due to an occasional clicking noise in the upper steering column, behind the steering wheel area. The repetitive clicking was most noticeable at slower speeds while turning the steering wheel.
The dealership had the car for about 3 days saying it was a loose cable and then told me when I picked up the car, that sound was the way it was supposed to be, part of the electric assist steering. So the clicking noise continued.
Now the steering is getting stiffer. Some days much stiffer. This happens more when turning the wheel slowly.
View 2 Replies
Just received my car back from the service department and noticed a slight clicking sound that isn't too loud, it's mechanical sounding.. Quieter than a ball point pen retracting I'd say. It clicks every quarter of a turn while stopped and low speeds.
View 2 Replies
I ask this because when on the hwy (60-70mph) you can feel some vibration in your hands. I can let the steering wheel go and it won't move a bit but when hands placed on it you can definitely feel the road, including bumps, and regardless of road conditions. Tires where balanced at 7500mi but it still happens. Regardless of temperature or PSI in the tire.
I thought we had electric/electronic steering and no hydraulics? Maybe unrelated but, when turning in my driveway, very slow, I can hear a slight clicking (maybe rubbing) noise coming from the steering wheel column. Everything else has to be silent to be able to hear it.
View 1 Replies
I have been hauling a lot of garbage with my 96 ranger this last week. The differential has been making a little more than usual noise like growling, but it has always been smooth, now all of a sudden it shakes like a tire out of balance up to about 55 then it is like a switch is thrown and everything quiets down and the shaking goes away, until i get around 55. I haven't climbed under the truck yet just checked the tires and grabbed the drive line they are all ok,i don't see any leaks so it is a head scratcher. Hopefully it will be something easy, but it hardly ever is.
View 7 Replies
I have 2003 Toyota corolla. Recently one of the relay from the fuse box under the steering wheel started making clicking noise. I got it fixed from my mechanic by replacing it twice. When my mechanic checked for codes, he found that there was some problem with igniter circuit and car's motor is not able to generate enough power. I have observed that whenever I try turning on the heater, the relay also starts making clicking noise. I got it diagnosed from a professional auto electrician but he was also not able to find the fault and now the check engine is on all the time and flashes some time. I don't know how to fix my car.
View 19 Replies
This is probably a dumb question but what is going on here:
YouTube.....
This is with the AC running. That wheel spin and loud click (it's a lot louder in person) is starting to annoying me. When I am sitting in traffic or at lights and I have the AC running the noise is very noticible in the cab. If the AC is off the idle settles down and the click goes away. So what causes this - AC compressor going out? It needs lube? Freon?
View 3 Replies
i have a 2001 ranger 4x4 the problem is sometimes it will switch into 4 wheel drive and sometimes it wont just hear clicking noise ,i'm preety sure it doenst have a vaccum.
View 14 Replies
Recently noticed when driving, I'll hear and feel a slight clicking noise coming from my steering column. I can be going straight or turning. it is intermittent. I've look underneath and nothing seems obvious. when the truck is in park, I've tried to manhandle the steering wheel, the steering wheel is solid. the truck is a 1998 f150xl v6.
View 1 Replies
I have an 03 ranger and my driver side window will not roll down... My pass side rolls down just fine...when I push the down button all I get is a clicking noise out of what seems to be a little black box underneath the driver side dash and I can actually physically feel the clicking along with hearing it... When I push up on the button I get no noise or anything... this might be the motor...the regulator...or the actual switch?
View 1 Replies
I've been having problems with my column shifter ever since I installed a Pioneer shift cable probably about 3 years now. I was told and also thought that the cable would loosen up after awhile but it never has. I had some put it on and I watched him do it. He seemed to have some trouble because it took him a long time under the dash. It shifts so stiff that over a period of about 2 years it finally broke the end of the shift tube one night. Luckily I was able to fix it the next day by getting a spare without missing any down time. It was still just as stiff with the other shift tube. It finally broke the plastic on my shifter tonight, not necessarily whatever is causing it but because it takes so much effort to shift into Park, Reverse or Drive.
I think the plastic may have cracked over time. Luckily I had another one at home along with another shift tube. I didn't replace the shift tube this time but I did remove the caps and smear some grease on the bushings to see if it would make it turn. I looked further down at the end cap that broke last time and sure enough one of the bolts was backed almost all the way out. I retightened it tonight too. That's what happened when the bottom broke last time. One of those bolts backed out and it cracked the housing. It works now but if you go all the way to 1st to get back to anywhere it really takes a tremendous amount of effort to get it to shift. Something is not right and I cannot pinpoint it. I know they offer brand new shift tubes but I'm not sure if that's the problem.
View 2 Replies
