"95, 2.3L, automatic. Stalls for a couple of seconds and nearly dies when shifting from drive to neutral or from drive to park. Doesn't do it when cold at high idle or when AC is on. It catches back up and idles fine but nearly dies when coming out of drive. Installed a new idle air control valve but no change.
View 1 RepliesI have a 1997 Dodge Dakota V8 (automatic) with about 140k and live in Vermont. Recently, my truck will konk out while I am sitting at a red light. As I'm sitting there, the RPM's keep going down below 700, until finally stalling out completely. When I shift into Park/Neutral then turn ignition, it will start right back up again. To get around this, I have been shifting into Neutral while I wait at the light, then back into Drive when it turns green. I have recently installed a new battery and exhaust system. I am wondering if this is occurring because of worn plugs, a dirty air filter, cracked vacuum hose, or bad alternator?
View 2 Replies2007 Ranger 4.0l, idles rough at low rpm, in park or drive, with or without the AC on.
View 1 RepliesThe trucks seems to Idle Rough in Park and Drive, Cold or Hot. It mellows out as soon as I give it gas but at stop lights or in park it goes back to a seemingly rough idle.
This is my first Ford Ranger and dont know if its normal. No code or dummy lights.
2007 2WD 4cyl
I am driving a 95 ranger xlt extended cab with a 3.0 two wheel drive with an automatic transmission. the two piece drive shaft with the carrier bearing went bad at the bearing. i separate the u-joint just after the bearing and was going to remove the nut holding the bearing housing together but cannot get the nut off. now i'm also finding out that i need a bearing puller to remove the damaged bearing from the 1st drive shaft.
Its turning into something i may not be able to finish. i saw on line an idea where a guy replaced the 2 piece shaft with a one piece. he states that a 1 piece drive shaft, 1998 or newer would work and no need for this bearing. you have to remove the cross member. it sound easier than what i'm trying to do. i looked at some old posts and galleries but did not see an article. here is a link to his website: How-To: Swapping a 2-Piece Drive Shaft for a 1-Piece in a 1983-1997 Ford Ranger
So here in Wisconsin for the last two weeks we have had nothing but ice. That being said, I have a '96 ranger 3.0L, automatic transmission, 4x4. 4 wheel is inoperable at the moment, that's a different story. Here's my question: with the ice, there has been a lot of tire spinning at high RPM's, the other day, I was again stuck on the ice and rocked back and forth had some pushers, thought we were getting somewhere but I went to shift gears and all of a sudden had nothing. No Reverse, Drive, OD, L, 2. Did I blow my tranny? There was no noise or grinding, but the OD light seems to blink. Is there something I can check or look at?
View 4 RepliesIs it bad shifting from drive to neutral then back to drive going 40mph without pressing on the gas only coasting on a daily bases?
2008 Sonata GLS ... Automatic transmission ...
My 1998 Ford Explorer XLT v6 with about 233,000 miles on it has a bit of a problem. Infrequently, when I shift into reverse from park or neutral the engine dies. It restarts without issue. There are no strange noises or smells when this happens.
The transmission was rebuilt 10,000 miles ago by a reputable mechanic. Almost all of the 230k+ miles are highway miles. Each trip around 40 miles.
I have a '98 F150 4.2l with 230k miles on it. A couple of days ago when starting, I noticed that the engine kept racing instead of idling down like it normally does and the weather here in Arkansas has approached the 80 degree mark. The engine also doesn't idle down when shifting (I have a manual tranny). Where to start? I don't have any codes stored other than two for bank 1 and bank 2 running lean but they popped up many miles ago. I'm thinking either a vacuum leak or throttle control. I checked the operation of the cable and the throttle valve and they appear to be fine. Maybe the idle air control?
View 4 RepliesI've got a 2006 F250 6.0 5R110W 4wd 220,000 miles It started getting a slight delay going into reverse and tow light flashing last week. all else functioning perfect Got a pending code P0700 and P0741 I stopped at NAPA when I was leaving no reverse checked every thing all was normal no leaks and fluid good color drove perfect in drive I got back to the shop [10 miles] put truck in park it was like its still in drive same with neutral, in reverse it wants to creep forward.
View 1 Replies08 Expedition... I drive an automatic and I frequently shift to neutral during down or cruise to a stop light. Does this affect the gear assembly, brakes, etc.
View 13 RepliesRecently I've noticed that every time when shifting from park to drive and occasionally from reverse to drive in my 05 Golf GLS, I would have to remain off the gas for 3-4 seconds otherwise the car would jerk forward. If I press on the gas ever so slightly, the rpm would go up to around 1000 then jerk. Why this is happening?
View 2 RepliesMy 2003 escape stalls from park to reverse and drive,not all the time but when warmed up. IAC motor replaced and still stalls.
View 7 RepliesMy automatic 2007 Nissan Altima has developed an intermittent problem when I go to shift it into park it won't shift down past neutral. I can't physically move the gear shift past neutral and can't take my key out of the car. If I wait awhile or drive off somewhere else it will later allow me to shift normally again and won't happen for awhile. It has happened maybe 8-9 times but I worry it will get worse or break the transmission. I've taken it to a mechanic and they looked at the transmission and didn't see a problem but sense they couldn't recreate the issue they couldn't fix it.
View 1 RepliesIs there a bulb that lights up the shifter position on an auto transmission (floor shifter)? IF so... I have 2 that need it done but I can't find where the bulb is since it doesn't lite up any more.
The vehicles are -
1995 Geo Prizm automatic
1998 Corolla automatic
Both need to have the bulb that lites up the Park, Neutral, Drive positions of an automatic floor shifter center console. Both are similar but I cannot for the life of me find this light bulb to replace it.
My 2011 Hatchback automatic has developed a whine in park, neutral and drive. ATF fluid level ok and changed by dealer every 25,000 miles. Seems to be coming from under the car. Could it be the transmission oil pump? If so, does it mean removing transmission to replace? I don't think it's the fuel pump. 62,000 miles.
View 5 RepliesThis is a 1991 Volvo 240 Automatic Station Wagon. The Check Engine Light has been on for at least 6 months, the timing belt was replaced 3 months ago , the battery is a month old, the oil was just changed, gas tank just filled and the odometer stopped at 259,000 miles before I bought it so it has well over 300,000. Yesterday morning it took a minute to start, which happens on occasion, but backed out and drove about a mile and stalled at a stop light. It finally started, after 6 false starts, and I turned around to go back home. It then stalled again but reversed just fine, so I got it turned around and drove in reverse the rest of the way home. It drove fine after a few hours but did the same thing today.
View 13 RepliesI have an '03 sport trac with 146k miles on it. Truck is in good shape for the most part, it has been very well kept before i got it. In the last few months i have had the flow master exhaust put in and the k&n intake. I had the vacuum leak problem with the hole in the elbow, which was fixed and discovered after replacing the IAC.
I have had a problem with the vehicle almost but not quite stalling when shifting from drive to park. The first thing i did was check for vac leaks, found none. I did not replace the IAC again only because it is only a few months old. I also replaced the MAF, which did not work either, I was still almost stalling going from D to P. The vehicle shut off while in the drive through at McDonald yesterday. It restarted roughly and i managed to get it to a safe spot. I lifted the hood and felt the radiator main hose was solid feeling, so i drove home and replaced the thermostat. In the process i got coolant all over everything.
The problem I am having now is the truck is just cutting off, both at idle and while driving down the road. It starts right back up and away i go. It is random, the truck is running a ok with no signs of any trouble then the next second it shuts off.
I have an automatic '95 Toyota Corolla wagon that over the past year has had intermittent problems dying after turning on the ignition. It happens mostly when starting for the first time in the morning in our carport (which is generally flat) [are there enough red herrings yet?]. However, we can go for weeks without problems. Our battery is relatively new (1yr) and the car starts-- however, sometimes the car dies unless the gas pedal is depressed for long periods of time in neutral or park. If I can pull out of the carport without having the car die, we've never had any problems on the road.
View 7 RepliesI have been driving a 2003 Chevrolet cavalier and the automatic shift is stuck and can only shift to neutral and drive since Thursday morning. It wont go up to reverse and parking and down to the other 3 shifts.
This first happened last April but somehow with the right grip or pressure was able to get back to all the other shifts. Since then it happened 2-3 times as I can remember and now could be getting worse.
I have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 Replies