Ford Ranger / B-Series :: 1995 - Fuel Line Leak / Strong Gas Odor
Feb 20, 2013
I let my sister borrow my 1995 4 banger Ford Ranger for about a week. To make a long story short, when I drove it home I could smell a really strong gas odor so I pulled into a gas station and noticed gas pouring out of from what looked like the fuel filter area right under the driver's side.
Anyway, it took another 5 gallons to get home and I later crawled under and took a look. It looks like someone grabbed the fuel line and tried to unsuccessfully pull it out of the fuel filter by hand. I could literally see the imprint of the person's hand where they grabbed the line. They had pulled the line so hard that it crimped and split which is why gas was leaking like a water hose.
I picked up a Ranger specific Dorman fuel-line repair kit from Advance and had my brother install it for me as I'm no mechanic. It was fine for a few days and then I started to smell gas again so I crawled under and took a look. There's just barely a small leak coming from the connector barb/union on the kit. Anyway, I didn't know what else to do so I dropped the Ranger off at a local shop this evening. With that said, this is fixable, right?
View 2 Replies
Advertisement
I got a 1990 ford ranger 4.0l and is been leaking fuel from where the regulator conects to the fuel line the regulator is new. I cant find a new fuel line.
View 4 Replies
I have a 1990 Ranger with a 4.0L that I just changer the intake gasket on. I broke the fuel line at the Fuel Pressure Regulator. Cant seem to find one anywhere. It is a nylon inside/rubber outside with a cloth mesh and quick connect fitting line. Where to get one? Can I hose clamp it the FPR by cutting off the connector that broke?
View 1 Replies
I think I've tracked my power steering leak to some type of sensor on the pressure line, close to where it connects to the steering box:
I assume this is a pressure sensor? I got no CEL or anything like that when the fluid had leaked down to the level that the pump started whining pretty badly though. As far as I can tell by looking at pictures, the parts store replacement pressure lines do not have this sensor, or any provision to connect a sensor to it: Advance Auto Parts: Power Steering Pressure Hose by Powercraft - Part 71878
I may just put a replacement line on there and leave the sensor plug hanging and see what happens...
View 11 Replies
I have a 93 Ranger xlt and after checking wheel cylinders and calipers first I have found a leak that is coming from the brake line or maybe the RABS module. The leak is up along the inside of the frame and I can't get in there because of the gas tank. Has to change line or RABS in that area and am I correct in thinking the gas tank has to come out to do anything in there.
Also, in the manual it says to plug the line as soon as you remove it(at wheel cylinders etc) so the fluid does not leak out of the RABS because it can't be bled without an expensive piece of equipment. I am pretty sure it probably emptied due to the leak location.
View 3 Replies
Car: 02 Passat GLX V6 4motion
Mileage: 99k
Just recently bought this car (3 months ago) and I have had lots of issue with it already. I topped off the tank that same week and it started to leak gas right under the gas tank (driver side in front of the rear wheel).
No engine light came on. It leaked for couple of days for about an hour after I park the car then it would stop until I drive again. It did that for couple of days until the gas level went down to 2/3 then it stopped. Since then I stopped topping it off and it hasn't leaked.
However I always smell gas even when its not leaking. When I go around the car the odor comes from right in front of the rear wheel (driver side).
Prior History: This car was rear ended before and fixed up by the prior owner. The seller told me that he had recently replaced the fuel pressure regulator that week.
I took it to the mechanic and had them do a smoke test. They couldn't pin point the leak so they recommended replacing the entire fuel tank for $1800. I walked away and thought I would just keep the fuel level low and keep driving. However the gas smell really bothers me because the car is parked in the garage and the gas odor builds up to unbearable condition.
What could cause this issue? Does this has anything to do with fuel pressure regulator that was replaced? Anything to do with fuel pump because of the rear end accident or loose seal in that area? Do you think it is necessary to replace the whole tank for this?
View 9 Replies
I have a 95 Ranger 2.3 with a manual tranny. In the past I have had problems with this truck not starting do to a bad inertia switch and numerous fuel pumps. A couple of weeks ago I pulled the truck off of the driveway into the street and let it set there for a few hours. When I went to put it back on the driveway it would not start. I got it pushed on the side of the garage. I did my normal routine of doing a pressure check. I had no fuel pressure so I assumed that it was the fuel pump (as usual) so I dropped the tank and changed the pump.
I got it back together and it still wouldn't start. I checked the fuel pressure and the manifold still had 0. So I started my diagnostic. I have power from the fuse to the fuel pump relay. I then checked the wiring at the inertia switch and found that there is no voltage with the key on at the supply side of the inertia wiring. I verified continuity between power distribution block and the inertia switch. I put in a new fuel pump relay and it still has no fuel rail pressure and there still is no electric signal at the inertia switch. Where to go from here?
View 6 Replies
My 1995 ford ranger with a 3.0 will not start. It acted like the fuel pump was going out so I replaced it. I also replaced cmp sensor and the camshaft synchronizer due to old cmp sensor broke and messed up the synchronizer. My truck is getting fuel and spark but still will not start. Where do i go next?
View 4 Replies
I have been smelling fuel on and off for the last few weeks. I thought it was the fuel bowl drain valve so I ordered the kit for the whole fuel bowl from diesel o-rings. I did the rebuild this morning and I don't see any visual leaks. Still smell a strong odor of diesel though. The lower engine cradle is all wet and the valley is still a little wet too. Could I still have a leak and if so where to look? Could it be just wet still from draining the fuel bowl and needs time to go away?
View 14 Replies
I remember reading very recently about someone who found a fix to the strong fuel odor on cold starts. I can't seem to find it anywhere. I think it mentioned something about a bad ignition coil or something.
View 4 Replies
I changed the gas cap on my car. This did not change a thing. I took to i believe reliable mechanic (has worked on car several times) and was told it is bad leak from the "sending" (I think) tube. I think it is the plastic? thing that sends fuel to the fuel pump. This is cracked.
View 5 Replies
I was adding some fuel from a can to my Ranger last evening and I noticed gas was dripping on the ground. I traced it to, as best as I can tell, where the inlet pipe meets the tank.
Cannot see up there at all so not sure how it is attached. How I might be able to repair it without dropping the whole tank. Some kind of goop I can reach up there with and lather on to try and curb the leak?
View 7 Replies
1994 reg cab 4.ol 13ok.. my wife just got it, been doing some small things like replaced dome light, replaced cargo/third brake light, truck starts and seems to run ok. but i get a headache in it which i believe is carbon monoxide, has a leak or something? i text previous owner, he said he replaced 02 sensors, but didnt say if they were bosch or a good brand.. also trucks has a oil pressure and coolant temp gauge fitted on by the gear shift as the dash gauges for those functions are out. Does this mean the CTS may not be working and affecting fuel/air I do not know these trucks i only just found out what this strange silver looking thing was it is the IAC, I Believe, then there is this black plastic vacuum type cylinder by the passenger side firewall, what is that? and right against the drivers side fire wall is a small reservoir type thingy, is this something to do with ABS? i do have an ABS light on, was hoping it was the bulb out on the third brake light or something quirky like that no such luck its still on after starting engine. but i am concerned about this running rich/strong smell as we really cant take it far as is it, its dangerous, may have to get a smoke test? Just got the truck, trying to get caught up..
View 8 Replies
I've got a 97 Ranger that popped a brake line. The rigid line burst above the rear axle, in the section that comes from the frame rail to the flexible "down" line.
Trouble is, the rigid line that burst disappears between the frame rail and the fuel tank and then comes out a DIFFERENT SIZE where it goes into the proportioning valve.
Looking for a diagram of that line as it travels forward along the frame rail or know where it changes size?
View 6 Replies
So 85 ranger with 2.3l and A4ld. I can manually shift to get first and 2nd. When i look at the vaccume diagram it shows these 2 blocks on the tranny,one box is connected to the next with a vac line. The other box has 2 lines, one goes to the main vaccume block on the intake and the other T's into a small capped off canister and the egr. I can only find one place for a vac line and its on the pasgr side of the tranny... Where is the block that the egr line connects too located? Its not on the tranny as far as i can tell.
View 2 Replies
My 96 ranger with a 5 spd manual and two piece drive line has the center carrier bearing going out (squeals,vibrates,etc.) I got the part no. from the dealer but they are obsolete. is there a one piece drive line i could put in and what would that take to do.i remember a thread on it somewhere but cannot find it in the search. i would prefer not to use aftermarket because they only have a one year warranty.
View 10 Replies
I have a problem. I have a nylon return fuel line that is SHOOTING out fuel at the quick connect at the fuel pump. See video: [URL] ....
How do I repair? I think the o-rings in the quick connect went bad. I'm thinking to dip the connector in hot water to soften up the nylon, take the old connector off, and put a new connector on. What size connector I need?
View 1 Replies
I have an Oct 2001 2.7 GLS which apart from the odd ABS Tone Wheel and speed sensor issues has been uber reliable and a real pleasure to own (I've had it from new).
We had a problem about a year ago when the wife didn't get the fuel cut-off when filling up and over filled the car resulting in fuel pouring out of the tank vent and down the fuel tank under the car but after a long drive that cleared up and has not happened again. Interestingly we didn't get any engine CEL's or have any codes turn up at all when checked by my mechanic.
Over the past couple of weeks we have noticed a very strong smell of fuel under the car around the fuel tank. I can't see any indication that there is a fuel leak but have noticed when filling up that the smell is very strong and as the car runs the fuel down the smell reduces to almost nothing.
Today I removed the rear seats and the fuel pump access panels to see if there was any seeping around the pump gaskets but couldn't see anything and the top of the tank around the both pumps was a dry as a bone. Using a torch I did however notice that there was a darkening of the fuel tank surface in the centre which I guess is close to the vent valve, part 311990b:
Or maybe is where the fuel vent pipe runs to?
View 2 Replies
My front driver side brake line broke. It had a typical double flare fitting at the caliper but at the distribution block on the other end it had a flared fitting that would be used on a industrial hydraulic unit. I took it to the NAPA store and they told me to cut the nut off the old line and put it new line and double flare it. I did and it leaks. Do I need a special fitting on the end that goes the distribution block?
View 2 Replies
A few weeks back just after buying a new front hub assembly (so I know I have Live Axle 4x4 and 4WABS), a dude on an excavator pulled out in front of me on a blind curve on an interstate exit ramp. Almost got him, then almost got got by the car behind. The hard stop caused a rear line to blow.
When I got home, fluid was still coming out when I pushed the pedal, so the first thing I did was top off the reservoir. I was surprised it was not empty.
I finally got lines that would fit, and replaced both sides. Fast forward a few weeks and I had time to bleed the system. I hooked my vacuum pump to the right-rear wheel cylinder port, opened it and began to pump. Pump, pump, pump, and still no fluid. Tried a few times. Left the pump on, opened the port, (charged the battery), started the truck and pumped the pedal - no fluid. Also, the fluid level did not change in the master.
Master cylinder bleed? Do I need to have the ABS motor bled?
View 10 Replies
1995 Ford 4.0 ... All the following have been replaced on the truck.
High Pressure Fuel Pump and assembly
Idle Air Control Valve
Spark Plugs
Oxygen sensor (Bank 1 sensor 1 Oxygen)
Fuel Filter
The most recent item that I replaced is:
Coil Pack
Spark Plug Wires
Now, with the Coil Pack replacement, the truck drives good, as long as I do not floor it (After it heats up, about 15 minutes). Basically, if I try to pass someone, the truck acts as if it is chocking out, like it is not getting any fuel.
Before replacing the Coil Pack. It would chock out at any given time, rather just barely pressing the gas peddle, or just sitting idle.
I took it to a friends muffler shop, and he stated that it is not the exhaust that is causing the issue. I am at a loss. Is there anything else that I can check?
The truck seems to drive fine, as long as I do not get down on it, and try to take off fast after it heats up. When it is cold, I can take off like a bat out of hell, and it runs like no-ones business.
View 14 Replies
