Ford Ranger / B-Series :: 1984 - Stalling When Approaching A Stop Sign Or Light
Jun 12, 2013
It's an oldie, 1984, but so far still kicking. 6 cyl 2.8, carb. I took a little couple hundred mile trip a few weeks ago. Rolled back into town no problems.
A few days later I took a ride and the ranger would stall when approaching a stop sign or light. I would hold the pedal down a little to keep it running but it sounded like it wanted to die if I didn't feather the pedal to rev a bit.
I drove a few days later, as I was going down the neighborhood road(25 mph), it acted like it wanted to just die. I mashed the pedal and it had no effect. It didn't stall and eventually I could rev the engine to continue.
It continues to do the same, then will all of a sudden take off like there was never a problem. If/when it does stall again, it can be hard to start until it does start and off I go again like there was never a problem. Other times, it will idle.
Another note: Sometimes when I go to start the engine it will stutter, intermittently turnover. It has done the same thing while actually driving, kind of a jerking deal.
Fuel filter, fuel pump, electrical? I'm going to first check/replace the fuel filter tomorrow.
View 10 Replies
Advertisement
I have a 1997 Ford Ranger XLT 6 cyl. 4 wheel drive. I got this truck from a friend. Only had it for a month or so has about 185K on it but has been running great.
I did notice a couple times that when I pushed the clutch in approaching a light the truck would jump a bit in RPM to about 2600. but go back down in a second or two.
This started to occur more frequently and now it does it almost all the time....when I push clutch in it revs up to about 2600 RPM.
Now I can have my foot on the brake and let the clutch out to put some strain on the engine and knock the RPM down but its still a bot high in the 1k range. Sometimes it actually goes back to normal...
When I started it this morning it was fine....but after two shifts it started and lasted the 12 miles to work. What could be causing this? It does not seem to go above 3000 RPM when it revs.... Other then that the truck runs great.
View 5 Replies
I own a 2002 Acura TL- car has 100K, i am the original owner- always maintained etc.. I am having problems with the transmission- car was in accident back in 2005, and tranny was replaced..Anyways, when i back car out and then hit it in drive, car goes to neutral. also when i drive, approach stop sign, and then accelerate, car goes to netural- dealer says need new tranny- cost is 2400 plus tax.... so i was thinking of doing that but now they say there is a leak with the oil pump- i said i dont see oil leaking they say its hitting the pan, could go in a month or in a year- cost 1200 to fix.. then he said the brake lines will need to be changed evenually- again 1000 or more.....ball joints- they quoated me 625...
So they say they will give me 500 bucks for a trade in- this car is in really good conditiion except for the supposed problems they found..If they car wouldnt have these problems i would get the tranny fixed- but i dont know what to do- ball joints dont have to be replaced- they hvae a little play.. the oil leak? I mean i have a 2000 accord that the dealer says is leaking- my private mechanic says all accords leak.
View 5 Replies
I have a 2007 automatic jeep compass that is stalling. heres the thing, it only stalls when i am idle at a red light/stop sign. I also noticed it only stalls when its in drive. if i switch the car to neutral while stopped/idle it will not stall. i also notice this happens more frequently in the rain.
View 6 Replies
3 mechanics can't find what is wrong but when I come to a stop sign or light my car stalls, not every time but a lot. Also, seems to happen more in cold or wet weather. So every time I stop and idle I have to quick put it into park.
View 2 Replies
I didn't really know where else to turn (no pun intended) every time I turn my wheel to the right the truck sputters out and dies, i checked the ignition switch, tightened her up and shes still killing the engine when i turn right. All other power remains on stereo, car charger etc. its not so bad on continuous turns i can just pop the clutch but for stopping and turning its a huge issue. Why turning left is fine but right kills the engine..wondering if maybe the prongs on the ignition switch may be bad?
View 7 Replies
I just picked up a 1984 ford ranger long box 2 wheel drive w/ 2.0 l and carburetor for our daughter whom is just 15. it has a whopping 19,000 actual on it! It was my wife's grandma's farm truck - ordered it new from dear born. Any way, fuel gauge is pegged at empty and they had a new float assy put in about 5 years ago, but it is dead now, it doesn't appear that this sender is avail any longer. What part might fit in there and or what do i have to do to maintain the original gauge in the cluster but have a working sender to talk to it? is there another unit that goes in the tank that i can modify the signal out to read right with the built in gauge? There can't be too many different ones out there is there?
View 8 Replies
I've got a '84 ranger that idles super fast for about 30 minutes after a cold start. The truck has been in the family since new and has done it since day one. I am wondering if replacing the electric choke or choke pull down would work. I've got a electric choke replacement but the cover place looks to be attached with rivets not screws. How to remove the choke?
View 3 Replies
I have a 1984 Ford Ranger 4x4 with 2.8L V6, carburetor number E37E-AEA. The accelerator pump diaphragm is perforated.
Small holes are visible when I hold it up to a light. Is this part available anywhere? Is it included in these carb repair kits that I see on a lot of auto parts sites? The sites don't list the contents of their "kits."
View 2 Replies
working on a 84 ranger it did run fine for 3 wks then while driving there was a thump and it stopped and wouldn't start. Now working on it has spark cranks but won't start. while trying to start when I let off the key it tries to catch but only at that time not when the key is turn to start normal. we poured fuel into the carb and it still didn't start. Leaning toward compression maybe?
View 4 Replies
So, a few day i bought an 84 Ranger and even since have not been able to figure out what the hell is wrong with the brakes. I know it's not the brake booster for starters. Because, i went to Auto Zone and picked up a new one and when i took the old one off (before i had put the new one on as well) i tried to see if the brake pedal would now move freely and it won't. It is still very stiff and squeaks when you push it down. i then to get it to return have to pull it up with my foot... What it might be? the WD-40 failed here as well.
View 3 Replies
I just rebuilt the carb on the truck, it has the 2.8L, and when I went go go start it, it cranked for awhile until fuel filled the bowl, then it started and revved up high, I shut it off immediately and it turns out the throttle linkage was binding for some reason, I fixed that but now it wont restart.
I was cranking it for a while and gas started spewing out of the top, so I took the top of the carb off and reset the float height and now it doesn't spew gas.
I pulled the plugs and checked for spark and it's a really bright blue spark. I'm thinking it's just flooded, lots of gas on the plugs? I'm just waiting for it to clear out now and trying to brain storm what could be wrong.
View 14 Replies
Last week I was changing the oil on my wife's 2004 Camry (130 000 kms). I noticed quite a LOT of corrosion around the positive and negative battery terminals.. so I decided to clean them.
I removed the negative without any problems but I could not get the positive off. I decided to use a hammer to move the connector back and forth. I was surprised with how much force I had to use to break the connector free.
Once I replaced the oil I tried to start the car but it would not start. I check the voltage and I was down to 10 volts. Obviously I had damaged the battery in getting the positive terminal off. A quick ride to the auto parts store and I had a new battery.
I installed the battery and took the car out for a spin. The car drives normally but it will NOT idle after it has been warmed up. If I come to a stop sign, the car will idle low and stall.
I have already verified that the battery is at full charge and the battery is being charged when the engine is running. No 'Check Engine' light has come on.
View 14 Replies
I have a 04 lariat f150. Problem is every time I stop at a light or stop sign I hear and feel a bump. Coming from the rear I guess . Had my truck aligned asked the alignment person about the situation he said ford just do that. True or false ...
View 2 Replies
I got my b2500/ranger a couple of months ago and I've had very poor gas mileage. I replaced the air filter, changed the plugs, no luck. The truck has 169,000 miles. I haven't checked my exact gas mileage but from what i am seeing its horrible. I filled it up last night, not completely full but really close the full marker. In the morning i drove to school (7 miles) drove home, so 14 miles. Then i had to go back out by my school to pay back a friend. All in all about 28 miles. This cost me a little more than a quarter of a tank. The 2.5l has a 16 gallon fuel tank, so if my calculations are correct im getting about 8 miles to the gallon. I also took it the consideration that it was a half gallon from full.
And it wasn't just past below a quarter to full it was 3/4 of the way to a quarter from full. I know that i didn't test the mpgs "properly" but i think its close enough to draw a conclusion from. And keep in mind its not a 4.0, its a 2.5! Although i do think the engines size contributes to the mpgs because it takes ALOT to accelerate in this truck. At 2k rpm im barely accelerating from a stop light. And on the highway my engine stays a 2500 rpm doing 60-65. I am really hoping I can fix this because I don't want to drive around in a civic. Plus I need a truck for scrapping which is how I pay for gas as i am 17 and jobs are scarce. Also I know about cleaning the MAF butit has tamper proof torx on it which i do not have the tools to remove. I think it could also be the o2 sensors.
View 14 Replies
I have a 2010 Ford Ranger Sport. RWD with the 4.0L. Currently Sitting at 46,000 Miles.
Where I am located, it is very cold. Downwards of 5 Degrees F. I just started noticing a strange sound in my truck. When accelerating from a stop light I hear a single knock, and to my ear it sound as if it was coming from the rear. First thing I did was check the U-Joint, but there is zero play and it is very tight.
After driving quite a lot and unable to diagnose the problem, I part and got out of my truck, only to hear that same noise when I stepped out of the truck. (I am not fat 195b lol). So I sat back down and I heard it again. Did this a few times and consistently heard it. I got into the bed of my truck and started to jump around and got the same knock.
I shook the exhaust pipe to see if it was making the noise, but it wasn't, which makes sense considering while driving over bumps I could not hear anything. I am totally lost as to what this could be....I want to add that I CANNOT feel any difference driving. Feels great.
My ideas on problems are as follows;
-Spare tire
-bushing
-loose bold
-leaf spring (maybe a hanger)
-The cold creating noise like always.
View 3 Replies
Sometimes the check engine light comes on and truck will not start,the fuel pump runs non-stop.. when check engine light goes off,the fuel pump runs for a few seconds and stops,truck will start.... driving down the road check engine light will come on and truck runs bad....
View 2 Replies
I don't drive (aren't you lucky?) but my wife and I own a '95 Ford Windstar and last summer we had issues with coolant leaking and had to have a few head gaskets replaced. Now, when we're idling at a stop light or sign, the oil light goes on but as soon as we accelerate, it goes off. The manual says the light indicated either low fluids (which isn't the case) or that the pressure within the system is low. The vehicle seems to run fine otherwise but I'm wondering if the oil light gauge has been set too sensitive?
View 7 Replies
It can go for days without stalling. It will rev up at a stop light on its own, so I need to put my foot on the break harder to prevent taking off.
Sometimes while shifting gears, mostly to reverse. Car smells like gas when windows are rolled down.
Other people say there's an air leak by listening, but I can't hear it. I sprayed starter fluid on the hoses to see if the rpms would go up but nothing happened.
View 1 Replies
I first heard this on Car Talk on National Public Radio (sundays at 10, on the west coast). I heard the question but not the answer. Wife favored slow and hubby fast.
View 13 Replies
I have a 2010 F150 5.4 with 43k miles. When approaching traffic lights or making a turn and you are approaching idle speeds the truck will start to stall out then ultimately shut off, causing me to loose all functions. It has cause my wife to almost get into a couple of major crashes. Sometimes when trying to start it back up it acts like it is not getting any gas it just keeps turning over. I took it in and it could not be diagnosed because they could not duplicate the problem. This will happen for a couple of days and then be fine for a month or two then start right back at it.
View 2 Replies
