Ford - Ranger :: 1997 - Heat / Gas Gauge Won't Work - Electrical Malfunction
May 19, 2014
We have a 1997 Ford Ranger, live in Minnesota. The heat doesn't work, the electric windows need to be pushed up the last 4 inches, the radio is stuck on loud, the back window latch is broken off, the dash lights only light up the speedometer to 50 mph, the driver's seat doesn't adjust for reclining, and the gas gauge doesn't work. We tend to drive our cars till they die and have been able to live with the above annoyances. However, in dealing with the lack of a gas gauge the person driving it when the odometer hits 200 miles is suppose to fill it up then reset the odometer. That was me this weekend.
Once the gas nozzle clicked off I gave it one last squirt to top it off and gasoline began flowing out under the car. Not dripping, not trickling, not squirting out back at me. Under the truck. Maybe a pint to quart of gas. After wondering if I was going to blow up that part of the county if I started my truck, I figured God wasn't done with me yet, so I started it and drove until I used up about 3 gallons. My husband thinks it is OK to keep the truck because by overfilling it I triggered a valve that actually supposed to do just what it did….release the extra gas.
View 19 Replies
Advertisement
I own a 1997 ford f150 V6 engine and I have problems with the electrics. I turn the key on and the engine starts up runs great but I then look at the gauges and not one moves at all the. No fuel when i have just filled up,no tep,no oil,no battery all read nil. I went a drive and the speedo reads 0 it does not move but the truck drives great. Could it be a fuse, does a fuse control the gauges, which one it could be. I have lifted the hood and under the hood on the drivers side there is a box with small and larger fuses.There is one that is very small and the colour is white that's blown. Would you no what that fuse is for.
View 1 Replies
Water temperature gauge doesn't work. Assumed the problem was the sensor so bought a new one. Installed it, still nothing registering on the gauge after I know the water is heated up (drove it for 45 minutes, heater blowing hot).
So crossed the ground on the sensor and the gauge shot to the top so gauge is working.
Pulled wiring diagram and that sensor is SUPPOSED to register 79ohms for cold and 8 ohms for hot.. So bought a 10ohm resistor from radio shack and attached the water temp lead to it and the gauge read correctly about 1/8 inch from the H mark on gauge. This confirmed for me that gauge is not at fault.
Next I attached the ohmmeter to the sensor itself, boiled some water, placed the sensor tip into it and it read 86 ohms, in freshly boiled water! So at boiling the sensor isn't anywhere near to tripping the gauge to even start reading cold! So I tested the old sensor that I was replacing and in boiling water it shows 94 ohms?
What am I doing wrong, is there an assumption I am making here in error? I want to conclude the new sensor is bad, but the old sensor reads nearly the same reading under same conditions.So yes maybe they are BOTH bad but that seems to be pushing probability.
If it matters this sensor is the type that is inline from radiator to heater core, not the type that is in the engine block, at some point ford changed their sensor setup but didn't change the schematic drawing. Which doesn't matter the only difference is the one in-line has a ground wire to it rather then grounding off the engine block.
Vehicle is a 97 Ford Ranger with the 2.0 liter engine.
View 4 Replies
I have a 2011 xlt extended cab with a 2.3l 4 cylinder. The truck is great... I put 120,000 miles on it in under a year.
But about a month ago the temperature gauge started malfunctioning. for what ever reason -- the truck is NOT over heating-- the gauge would increase past the "H" and then the temperature light would come on. Because the truck thinks it's overheating -- the engine goes into a "safe mode" and runs with no power. When i shut the motor off and turn it back on temperature gauge resets and the truck will run fine.
Then in another 50 or 100 miles it will do it again. Why is it doing this? I took it to the dealer here in Columbus, Ohio and the mechanic installed a new thermostat and a new "control modulator" (and a part -- not really sure what it is called) anyway, the truck is doing the same thing and the mechanic still does not know
View 3 Replies
I have a 2003 Odyssey EX - everything was working fine up up to last year. When summer was almost at an end, the A/C suddenly failed. I pressed the 'Auto' button, I heard the compressor kick in and felt the slight kick/drop in rpm like normal, but after about 3-5 seconds the compressor disengaged and the engine went back to unhindered idle speed. The A/C console was still set at Auto, so i turned it off then back on, but this time there was no compressor kick in at all. At first I thought a fuse blew, but I checked them and they were all fine. I continued on my way and decided I would just turn on the fan/blower, but it didn't work either. It didn't matter if I set the console for auto or manual, heat or cold, when I turned the fan knob to any speed it would not turn on - with the following exception: If I turned it all the way to max and waited about 10 seconds or more, then it wold blow at full speed. Same would happen if I put it on auto and turned the temperature knob to lowest or highest temperature - after 10 seconds it would turn on the fan at max speed (since I figure consoles are programmed to go to max fan at temperature extremes to get to either one faster...)Also of note: When I turned off the vehicle, and turned it back on at a later time, the compressor again wold kick in for 5 seconds then turn off......and by the way the rear fan control works just fine throughout all this.
Since the summer was over, I didn't need the A/C and figure I would fix before the next summer. Every once in the while I would test again, and a couple of months later the A/C decided to work just fine for a whole day, but then it went back to the odd behavior
So now I'm thinking the environment console is busted and I need to replace it, except other things start to behave erratically:First was the break release for the transmission lever. I wold press down on the break but could not hear the 'click' that releases the transmission lever to shift out of park. That first time I just couldn't get it to work, so I used the emergency release on the top of the steering column, but after that I could simply pump the break or release and pump repeatedly until the click happened, usually took 3 tries. The funny thing is that this becomes consistent for about a week, and then months will pass with no problems shifting out of park, only to happen again for a week...
On some rare occasions, the interior lights don't work they way they are supposed to: They'll stay on when with all doors closed even when set to turn on only with open doors, or won't turn on at all with the same setting even with a door open (rarer still, will turn on with one door, but not another). I can always just set them to remain off all the time...
Same kind of issues with the rear windows and cruise control, most times they'll work fine, others they don't.
The only thing I really need to work in this Texas heat is the A/C, but before I go get an expensive A/C console replacement, or have technicians accumulate hours and hours of diagnosis to figure out the problem, I wanted to know if perhaps these are all related as an electrical issue with a buss-bar or a junction box - or a short from stripped wires in the harness, loose terminals, etc.
View 3 Replies
I am having problems with ALL my driver door electronics, except the fuel door. my passenger side works fine, sunroof works fine. Ive removed the door panel to look for obvious problems, like broken wires.. Fuses are good, looking for a good place to start. Power winder/locks.
Little update, i reset my battery and they worked, waited like twenty minutes, nothing works again.. why would i have to reset the battery every time for the windows to work?
View 1 Replies
I have a 99 Super Cab 4x4, 4.0, XLT. The radio has terrible static and the back lighting of the climate control goes off and comes on at different intervals. Are the two issues related?
View 1 Replies
It seems as though whenever I turn on the AC in the car (and sometimes even if I don't engage the AC) all the windows lock and only I can control them from the driver's control panel...
View 2 Replies
I was noticing this morning, that my left front and right rear windows didn't work. Also each of my two side mirrors would only adjust to the left but not to the right. When I try to do the non-working windows the dome light would dim a little bit when I push the button, but no sound or anything.
This is an intermittent problem. They usually work, but sometimes they don't.
View 3 Replies
I'm having some issues with my 99 ranger. It all started on my way to work one afternoon. Going down the road I started to smell some type of electrical burning smell. I looked at my instrument cluster and seen a trail of smoke come up between the steering wheel and ins cluster from under and gear selector covers. After that the O/D off light started flashing and downshifting hard. My pwr windows and dome light also quit working. Checked fuse #26 and all my fuses before going into work that afternoon, all of them were good and none blown. After shift was over that night going home I needed to use the wipers and they wouldn't work either. Also noticed then that my speedo, odometer and trip odometer not working. I've pulled my dash and steering covers off trying to find or see anything but nothing yet.
View 14 Replies
I just got the F150 ext cab 5.4 auto 235000 miles, and there is no heat and the fan only work on high. I am also changing all the coils plug and injectors. The guy I got the truck from said he never chanted them. I know it is going to be fun , soak the plugs and be careful. Any thing else I should know or do???
View 5 Replies
My oil pressure gauge does not work. I was told that it's most likely the sensor. Where would I find this to change it out?
View 3 Replies
I have a 97' F-150 4.6 L and I've been having some fuel gauge issues.... I filled up my tank up and I drove it 130 miles and it still said full tank... even when I had 1/2 I would start it and every time I started it it would jump up all the way to full and slowly drop down. Then randomly last night it started working... I noticed as I hit rough patches in the road and bumps it would usually fluctuate, but it would also fluctuate up... It read I have 3/4 tank last night and I go to start it today and its back up to full! I don't understand... Wouldn't a bad sending unit just stop all together?
View 1 Replies
I have a 2005 ECHO. Heat does not work. Water pump appears to be fine. The fan works fine. AC works great but I just don't have any heat. When i turn the temperature dial all the way to hot- the fan still blows cold. How I can fix this?
Also, my fuel gauge is not accurate. I will fill the tank and it will still read empty and will slowly go to the right level. Could it be a bad gas cap? Its got 145km.
View 3 Replies
I just bought a 97 f-150 from my dad, there are some electrical issue's but the main one seems to be battery drain.
I have noticed with the truck off key in my pocket, the a/c doors keep trying to move and the a/c head has power to it.
I know the engine has been replaced, with about 20k on it.
The temp gauge pegs w/o getting hot, and it even turned over once while we were getting in the truck. Again key in pocket.
View 1 Replies
97 Explorer XLT ... All lights , radio, etc. work, so not battery. When turning key to start, there is silence. No click, no stutter, nuttin. Starter?? Where should I start?
View 4 Replies
My sons 97 has a lot of electric probs, one of which is the cig lighter quit working recently. I checked the fuses (under hood and on dash), and wiring to both plug-ins.
View 1 Replies
Was driving my truck I have a 97 f150 4x4 4.6L, btw. The heater started blowing cold air and I looked at the temp gauge but it was showing lower than it normally does and then, after a couple of miles or so I looked at the temp gauge again. By this time I was in my driveway. And it was overheating it might have been that way before I looked at the temp gauge again. But any way I opened the hood didn't see any leaks, all my hoses were hot except the top heater hose. Also checked the oil it was full and coolant was too, what this could be? Sounds like a t-stat to me? But could be worse. Also forgot to mention that the oil had no signs of water in there nor the expansion tank cap !
View 3 Replies
There used to be a audible pop in my stereo speaker when my heat would kick on. Now there is not. My heat did this last winter around the same time. I checked Fuses. The blower blows, but it just blows cold air. It could be a thermostat, or a clogged heater core. 1997 Ford Ranger 2.3L ...
View 2 Replies
I have a 97 Ranger, v6 4.0L, 2wd, 5spd. It has been my daily driver since 1999. I was driving to work today and when I pulled into the parking spot, I turned the truck off, and I thought it was odd that the locks didn't pop up when I shut the truck off.
I then realized that I had completely lost all electrical power. Tried to turn the truck on and nothing. No click. No dome light, no horn, no nothing.
My battery reads 12.5 volts and the connections are all clean on the battery. I checked all the fuses and they are all good. What else should I check? This may be the first time this truck has ever stranded me before.
View 6 Replies
I've got a new to me 97 Ranger that the blower has never worked in and I can't get it going. I've checked the fuse. That's good. Tested the relay. That's good. Did an ohm test on the power switch for the blower. It's open in the "OFF" position and closed in the other positions. I've got continuity through the speed selector switch. New resistor and pigtail because the other one was nasty looking. What seems odd to me is that I've only got power to the blower motor relay at one terminal with the switch on (number 30 I believe). In addition, when I test the plug for the motor itself with my test light, one of the wires (org/blk I think) has power only when the switch is off. And I ran power straight to the fan from the battery and it spun right up. What am I missing?
View 8 Replies
