Ford - Ranger :: 1995 - Starter Cranks / Engine Turns Over But Will Not Start
Sep 30, 2014
I have a 1995 Ford Ranger, manual shift. It always starts when cold, but sometimes -- very sporadic -- it will not start after I've gone somewhere. This has happened maybe 8 times over the past 18 months or so. Always, after sitting a while, it starts right up as though nothing happened. Several months ago I left it with a mechanic for an entire week, but he could never get it to act up. Of course.
In browsing through these discussions, I've seen the "starter/clutch interlock switch" mentioned. Here is my question, though. Would the starter still crank if that was the problem? or does that switch stop the starter from engaging?
When mine acts up, the starter cranks, the engine turns over ... it just acts like it's not getting fuel. Is that a starter/clutch interlock switch issue? Or something else?
View 3 Replies
Advertisement
I have a 95 Ford Ranger 2.3L with a five speed. I recently had a starting issue were I parked the truck, went into a store came back out and the truck wouldn't start. Figured it was the solenoid as I couldn't jump across it to get the truck to start. Replaced the solenoid. Still no go. Found a fuse in the starting circuit blown. Replaced the fuse and got it started and drove home. Next morning, I go to leave for work and the truck would not start. Got a ride to work came home and checked it over and found the starter locked up. I replaced the starter. Truck started for a few days and now I am having problems again.
Here is the problem I am having now. Starter is good. Proved that as I can start the truck by jumping across the starter relay. Checked the solenoid with a voltmeter and it is doing what it is supposed to do when the truck starts normal. Here is where I am scratching my head. I can start the truck sometimes and it starts just fine. Next time I try to start it, the fuse will blow.
Replace the fuse and it might work for a couple of starts and then the fuse will blow again. I jumped pass the fuse with a piece of wire for diagnostic purposes. Out of 20 starts, it only started normally 4 or 5 times. I have checked every wire I can see under the dash and have not found any obvious issues. I am at a point where I am so frustrated that I just want to push this 400k mile truck into the back forty and put it out of its misery like a lame horse.
View 9 Replies
The car has 175,000 miles on it and is having issues starting but only sometimes. The starter turns over but the engine doesn't catch. Usually if I open the hood, pretend to know what I'm doing, and wait a bit, it will start within 10 minutes or less (sometimes it takes a few tries.) I hear a click when the starter is going and the engine isn't catching, very much like the click I hear if I'm driving with the AC on and the AC needs to draw power. I've recently had a tune-up including new fuel filter, spark plugs and wires. The mechanic can't figure out what's wrong (doesn't seem to be the battery or the battery terminals). The car even started up FINE at 40 below. I can't really see a pattern to it.
View 3 Replies
In a matter of weeks, my truck destroyed two sets of flywheels and starters. When the ignition key engages, the engine "jumps back?. Apparently, this causes the starter and flywheel teeth to grind. My mechanic cannot determine the cause of the "jump back". He thought that it might be the timing. His examination and testing, however, proved the engine properly timed.
View 6 Replies
I'm a relatively new F150 owner (just got rid of the 98 Ranger I drove since 99), so I thought I'd check in to see if I was overlooking something obvious. A few days ago, after driving to the store with no obvious issues, I went shopping (coincidentally for oil change materials) and when I returned to my truck it would not start.
Here is a bit of info:
Starter cranks over the engine.
Battery is relatively new, and has plenty of power.
I can hear the fuel pump kick on briefly.
Check engine light is on (EGR Valve fault).
Engine started with starter fluid.
Engine ran like normal after starting.
Finally, the vehicle started/ran fine for a few days before the issue occurred again.
Like I said, I'm not too familiar with the vehicle yet, but I'm assuming the issue must be with the fuel delivery system. I plan on replacing the EGR valve, but I am curious whether a faulty EGR valve cause a no start? Also, I'm wondering if it's more likely that the fuel pump is going bad, or something electrical is the problem since I'm under the impression that the engine stops sending fuel to the cylinder if/when the engine doesn't start quickly after turning the key.
View 6 Replies
I just got a 1998 F150 5.4l 4x4 autotragic. Was sold to me as needing trans, wouldn't start. Tossed in a new starter and solenoid, now I can hear the the starter turn crank pulley turns maybe a quarter inch and when I let off the starter it goes back to the same spot.
Fear is motor is locked, but question (i don't know automatics) is there any way that a bad trans could keep a motor from turning over? Truck rolls in neutral or drive, pulled the drain plug no water just oil. Tempted to just buy a running 5.4 with trans but if I can avoid that I'd prefer to.
View 3 Replies
So my sister has a 2000 Ranger 2.5L. I put in a new starter today for her today, and the second I re attach the battery terminal it turns over but wont fire.?
View 4 Replies
My kid is using my 94 Ranger with 215,000 miles. It quit while he was on his way to work. Engine cranks but won't start.
Fuel pressure at rail was 12 psi (Key on eng. off). I replaced fuel pump. Pressure at rail up to 20 psi. Still cranks, no start.
I replaced fuel filter. Pressure at rail up to 30 psi. Still cranks, no start.
Replaced distributor cap/rotor and plugs. I have spark at plugs.
Chiltons from 1994 doesn't list a rail fuel pressure. I see new fuel pressure regulators are set at 41 psi. I pulled mine and hooked air to it. It (FPR) cracks at 37 psi. I have lots of flow returning to tank, so I assume the fuel system is working correctly. I've never replaced the timing chain/sprockets. Distributor rotor spins during engine cranking. When I rotate the crank pulley to 0 Top Dead Center the rotor is pointing to #1 on the distributor, so I don't think the timing chain has skipped a tooth on the sprocket??????
View 4 Replies
I have a 1995 ranger with a 4.0 it cranks just fine wont fire has alot of fuel spark it will crank and crack then it stop and acts like it is going to fire up and stops cranking... This thing has 253k on it...
View 4 Replies
My 1995 Toyota Camry will not start, the engine turns but does not engage. I have had the fuel pump, fuel filter, and a relay switch replaced. After each repair the car runs for twp weeks and then will not start. I have had it towed and the mechanics start the car with no problem and they are unable to diagnose the problem. In a month and a half, I have had the car towed 3 times.
View 4 Replies
1995 ranger. 132k miles. I have been having an intermittent starting problem. I replaced the battery which was 3+ years old. I thought that cured the issue because the truck started without a problem then, the same problem occurred. I started the truck and drove about 10 miles. Parked it for about 2 hrs. Went out and tries to start it. The engine cranked, but would not start.
Tried a second time and would not start.
I turned on the lights and proved the battery was good.
Tried to start it and it turned over.
I took it to a shop and they could not fine the problem.
I asked if it was a possible problem with the solenoid, alternator,
They said if it was those the engine would not turn and you would just hear a click.
They drove it for a week and it happened to their technician but he said he did not have his equipment to check it.
He got it started after a few tries as I did and got it back to the shop. Ran a scan.
Four codes returned that really did not identify the issue - P0231, P1701, P0340, P1270. They cleared the codes and drove it again. They checked the codes. It showed code P0340. The shop says the code states to replace the cam position sensor and installing an updated DPFE sensor.
I have been driving it for about a week on and the problem has not resurfaced yet. A friend whom I work with does some car maintenance told me it is a dead spot on the starter and to replace it.
View 14 Replies
I changed the starter on my friends sunfire gt the other day because it wasn't working. After replacing the starter the engine turns over but refuses to start. When you turn the key on you can hear the pump buzz like normal, but it just cranks and cranks without even firing.
View 3 Replies
My 2008 F150 5.4l SCrew wouldn't start this evening. The engine turns over and the starter engages, but it won't fire. Oddly enough the starter stays engaged after I take my hand off the ignition! I have to physically turn the key off for it to quit (didn't want to burn out the starter). The culprit may be the wet weather....it's been a lot milder today and we've had some freezing rain that turned to drizzle. My truck has only done this once before (last year I think). I eventually got it to start tho.
View 13 Replies
Went to Advanced Auto to get the battery tested since it takes a few cranks for the engine to start. I thought it was the battery but after testing the battery they think maybe its the starter because the battery and alternator shows that its perfect.
I will also be taking the car to get the timing belt and drive belt replaced and the spark plugs and wires. I just want to know if you all think its the starter or should i check anything else.
View 3 Replies
I also tried jump starting - get same same result. Engine cranks, turns, and then sounds like it is just about to start up normally but it just dies completely. It seems to want to start but just can accelerate the engine high enough to keep it running. Almost like it's flooded on a carb motor.. 2000 V10..
View 7 Replies
I have a 2002 Dakota 5.9l r/t. Always started and ran fine. It sat most of the winter approx 2 months. Now will not start but cranks/turns. Has new battery, newer full tune up and tried starting fluid.
View 2 Replies
I have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 Replies
1995 Pontiac Bonneville cranks but wont start.
I've replaced the crank sensor and also the cam sensor with no luck, the car cranks with no start, when I used starter fluid the car runs, when i stop using fluid it shuts off what could it be.
Only has 38,000 Miles on it.
View 2 Replies
My 2001 Ranger is used for work to move furniture multiple times in a day. 7 weeks ago, I had moved a dryer w/ it, drove across town for a meeting, got back in & it refused to start & run. The same thing happened 3 days ago on a longer, fuller route w/ a trailer attached. Both times, the truck started & drove home ok AFTER sitting off waiting for my emergency ride. While I waited, I looked up the issue in the owners manual which told me to depress the gas pedal 1/3 to 1/2 & then turn the key in ignition. The first attempt did not work, so I repeated the steps, which started the truck & I was able to drive back. Both times, the truck started no problem the next workday. Does this sound like a problem worth fixing (for the age of the truck vs. cost of repair)? It has pull some weight, including on trailer, in between the two occasions.
View 1 Replies
95 850 died on the highway - now it cranks and won't start. I had it towed to a mechanic who later told me he didn't work on Volvos. He did however check for spark - good. Timing belt- good. I replaced fuel pump and relay - no go. One possible hint is the lights on the Sport/Econ switch no longer light up and the first light I saw when it died was the up arrow light on the dash. Last winter I cleaned and regreased the PNP switch. Would that have anything to do with it?.
View 2 Replies
The starter cranks, fired a couple of time but will not start. Mechanic blames the key interlock ... Apparently the key contains a microchip that blocks starting... Does this sound right ?
View 3 Replies
