Ford - Mountaineer :: 2006 - ABS And Now All Wheel Drive Light Lit Up On Dash?
Oct 7, 2012
My wife drives a 06 Mountaineer last spring a left front brake caliper piston seized up and there was damage to the rotor I replaced both rotors and that left front caliper then I changed out the rear pads as well . Then ever so often before that the ABS light on the dash would pop on hit reset it wold go off now it just stays on.
Then a few weeks ago she said the little yellow lines that indicate you are in all wheel drive started to flicker on .. Have not a clue as to why that is on now . But I would told most code readers would not read these sort of problems that I needed to get it to a dealer..
View 1 Replies
Advertisement
2002 Mountaineer... Driving into work today, my over drive light started to blink very fast. I have not had any trouble with high RPM's or shifting..
We had a very rainy/slushy/snowy drive in and never went faster than 30 miles per hour. Could an ice or snow build up be the culprit? I sure hope so!
View 7 Replies
looking to replace the front wheel bearings on my 06 Mountaineer. Detroit Axle? I found them on both ebay and amazon and prices almost seem too good to be true (under $100, 12 month warranty).
View 6 Replies
Having problem on my wife's 06 Mountaineer, 4.0. Couple months back the loose gas cap light came on out of the blue. I bought a stant gas cap and cleared the code, no problems. Well about 2-3 weeks ago it threw code 0450.
One of the things I saw it could be was the fuel cap. So I ordered a new Motorcraft fuel cap this time and cleared the code. Ran it about a week and the light came back on. No change is performance, mileage, and no fuel smell. So, I don't know what the problem is.
OBD II Code P0450 : It says that a common misdiagnosis is the fuel cap. Says that it is most likely a defective sensor or something. Need to change the fuel tank pressure sensor?
View 2 Replies
I have a 2001 f250 7.3 powerstroke it is an automatic. It has the switch on the dash to engage the 4 wheel drive. When I turn the switch nothing happens.. no lights come on or anything. it has warren locking hubs. What my problem is???
View 2 Replies
I have a 2006 F150 4x4 5.4L 43000mi. My four wheel drive is not working. I have the dash mounted switch to switch it into 4x4 Hi 4x4 Low. When I put the switch into 4x4 Hi nothing happens. 4x4 does not engage, and the 4x4 Hi light on the dash does not illuminate. I get the same symptom when the switch is placed into 4x4 Low. I have checked all of the 4x4 fuses and they are ok. I checked all of the vacuum lines to the hubs and they appear to be intact. What I should check next? What would cause this?
View 14 Replies
Easy to follow instructions on how to replace the burnt out dash lights on my 1998 mountaineer? I almost bought a new mountaineer; however, I decided to keep this one. It's been very good to me and it's paid off.
View 2 Replies
My 2010 Premier Mountaineer apparently has pressure sensors, because i am getting a warning on the dash. They were down about 4 lbs all the way around, so I topped em off. But, the warning still comes back.
View 9 Replies
I bought a 2000 Excursion XLT, 4x4 with the 7.3 Powerstroke Diesel back in the fall. Here in Indiana the winter is getting bad, not exactly the best time to find out your 4x4 doesn't work! My 4x4 light comes on, but I can tell I'm not in four wheel drive. I've read that on the diesels that the fix could be a simple vacuum line.
View 14 Replies
Do a 2004 Saturn view front wheel drive transmission will fit in place of an all wheel drive...
View 1 Replies
I have a 2006 F250 Super Duty w/ turbo Diesel. Took to dealership for "hopping" feeling when turning sharp. Was told that 4 wheel drive solenoid was bad. Where this solenoid is located? I know I can fix but want to know where it is located.
View 6 Replies
My selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 Replies
Over the past month or so my wife and i have noticed a slight vibration or? I don't really know how to best describe it other than a feeling. The truck has developed this feeling thru the steering wheel and pedals. The best way i can describe it is like a bearing going bad?
It is full time awd and I am assuming it is an awd issue. The truck has about 60,000 miles on it. It can be felt at all speeds. I rotated the tires with no change. My next step would be to go thru the front end, ball joints, tie rod ends, etc. But I really don't think the issue is in the steering. the truck drives straight and no steering vibration.
View 3 Replies
This must have been asked before but I couldn't find any thread about it. Have a 2006 F350 that makes a rattling sound when engaged in front wheel drive. Sounds a bit like a loose ball from a ball bearing (or a small stone) rolling around. What might be causing this?
View 3 Replies
The transmission went out on my 2006 gs300 it is a rear wheel drive car but i am having a hard time finding anything but an awd transmission for that year. Where I can get one? Or I was talking to a mechanic and he was saying the the only difference between the two trannies is a adapter to go from awd to 2 wheel drive cars so I might be able to use an awd trans and pull the adapter of.
View 1 Replies
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 Replies
I have a leak somewhere in my car. There are no spots left from my parking stall, or any visible wet spots under the hood, but my car continuously looses fluid somewhere. It disappears fast enough that in a 10 minute drive it can go from full to the coolant light and alarm going off on the dash.
View 1 Replies
Our 2002 Mountaineer with AWD started to have a clunk noise in the front driver side wheel area. It happens only when you take you foot off the gas between 30 and 65 MPH. If you slowly ease up off the gas no noise you have to totally remove your foot from the gas. It sounds like something needs grease or like a gear is a little loose. I have seen some post about noise but have not found one that happens in this situation.
View 3 Replies
i have a 98 gmc jimmy and the 2 wheel and 4 wheel hi light flicker back and forth. it doesnt do it all the time but is getting more frequent. Is this something to worry about?
View 4 Replies
Horn just stopped working on my 06 mountaineer. 20 amp fuse is good. All other controls on steering wheel work fine (sound system, cruise control, no airbag problem). Also, when I press panic button on remote FOB the exterior lights flash until i press it again but no horn. Any thoughts?
View 5 Replies
I have a 2006 mercury mountaineer awd v8 which up until a few weeks ago would be able to get 22 mpg highway. I have noticed that recently it has been around 17 mpg at the same speed. Could all of this be blamed on winter gas blend, or is there more to my problem?
View 6 Replies
