Ford - Mountaineer :: 2002 V8 AWD - Clunking Noise In Front Driver Side Wheel Area When Slowing Down
Mar 6, 2012
Our 2002 Mountaineer with AWD started to have a clunk noise in the front driver side wheel area. It happens only when you take you foot off the gas between 30 and 65 MPH. If you slowly ease up off the gas no noise you have to totally remove your foot from the gas. It sounds like something needs grease or like a gear is a little loose. I have seen some post about noise but have not found one that happens in this situation.
View 3 Replies
Advertisement
2002 Mountaineer, suddenly started making a loud clicking noise driver side front. Seldom in reverse. Struts and axle look good, nothing hanging down.
View 3 Replies
My front driver side wheel is making a clunk noise when I hit a bump. I replaced the wheel bearing hub assembly and discovered both axle seals were bad.
View 10 Replies
About 6 weeks ago I noticed a noise coming from the front driver side wheel area. We had just gotten the tire rotated and once at freeway speed it was like a squealing noise, just like when you have worn brakes. Since then the squealing noise is gone and now it's a faint (hard to describe over text) "whomp whomp" noise as if I have off-road tires. I notice it more on freeways I supposed because it's a smoother straighter surface. On a particular right bending street by our house it's louder. What it might be? Car has 36k miles.
View 8 Replies
I have a noise that has developed in the front drivers side(wheel area). When I turn right -- it can only be heard at slow speed, when I start from a stop-- there is a " tapping" type noise that appears to come from the wheel area. Is it possible that I am about to have problems from the CV axle?
View 1 Replies
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
View 7 Replies
Started hearing a squeak from drivers front wheel area when turning right, thought maybe pads might need replacing but they were fine as were the pins. So I checked for play with tire off ground and there was def some play pulling from top to bottom, so that lead me to the front hub, I read some posts about pulling the abs sensor and getting some grease in the the hub bearing so I did that but when I replaced the sensor and spun the hub it was scrubbing on the bearing.?
So I shimmed the sensor with a washer but now the abs light comes on but there doesn't seem to be a squeak when turning right anymore. Any example of doing this and had the sensor scrub? And with the play I would assume I need to plan to replace the hub assembly fairly soon...
2000 X 4x4 V10 with 147k
View 14 Replies
I have a 2001 AWD Mountaineer with 5.0 engine and 183,000 miles. A little over a year ago a harsh clunking noise started coming from the front. It was obvious that it was coming from one of the drive component because the noise and harshness changed with speed. At slow speeds it was clunking with every revolution of the wheels. The intensity seemed to change with the direction of the wheels also. I figured it might be a CV joint and proceeded to check them out. None appeared to be bad, but with the mileage on the car I figured it wouldn't hurt to replace the axle shafts, so I started with the left (driver's) side which is where I felt the noise was coming from. The noise went away and I was happy. To my surprise about 6 months ago the same noise came back. This time I replaced the right side axle shaft. Again the noise went away.
Unfortunately the problem hasn't gone away though. A couple of days or a couple of weeks may pass with no problem, but then suddenly it starts again. I took it to a trusted mechanic when it was making the noise. It was so loud when I pulled into his driveway that he stopped what he was doing to look. But, when he took it for a drive it was as quiet as the day I bought it in 2001. I also talked to the service people at the local Ford dealer and they told me that there was basically nothing they were aware of that could cause this problem, but to bring it in the next time it did it and they would check it out. At this point I almost want something to fall out of it. At least then we'll know where the problem is.
View 6 Replies
MY '07 SuperCab just started making a strange rhythmic sound as I drive. It is coming from the drivers side front wheel area. It is like a short creaking sound. It stays the same if I am turning the tires. Seems to go away if I put the brakes on hard, but I slow down so much I am not sure. Front CV Joint?
View 1 Replies
So the wife's 08 Mountaineer 4.6 likes coolant. None in the crank case. I suspect head gasket, since I can smell it a bit in the exhaust, but I have also noticed steam coming from the drivers side firewall area, but can't see anything. If it is head gaskets, am I pulling the engine? If I have to pull the engine.
View 5 Replies
I've been having this ongoing clunk in the front of my 06 Avalon for about a month now. When I slightly hit the brake i'm getting almost a metal on metal clunk sound from right in front of the drivers side wheel area, or possibly on the other side wheel well area, and not sure if its related but a popping noise when i turn my wheel a certain way it seems.
Replaced:
Both CV axles
Both Rotors
Both transmission mount and engine mount (left and right side)
Dog Bone torque bar on top
Drivers side caliper
Control arms
Struts were replaced 6 months ago, and reused old mounts, so I took it out and replaced the strut mount with the bearing on passenger side only.
Control arms have been replaced 4 or 5 times in 6 months because they keep cracking, they are being installed correctly and still having the issue, they're slightly cracked right now (many tiny little rips in the rubber rear bushing of the front control arms) perhaps this is the problem and they're flexing too far? They're Dorman and ordered off of amazon. I have 2 replacement ones arriving tomorrow and will throw them in.
124k miles. I have had multiple shops look at it and cant figure it out, they said everything is tight. One shop said it was internal transmission.
View 6 Replies
In the last few months my car has been making this crazy medium-weight rattle sometimes, meaning it doesn't sound like something really light doing it and it doesn't sound like something heavy doing it either. Its "history" went like this:
Noticed this sound that really seemed to be coming from the driver-side front, in the wheel well area, checked it out. Nothing obvious. Had the front of the car on ramps a couple of times, poking, prodding, grabbing/shaking things. All is tight. Then had it on stands; same routine, same results. It got a bit worse over time, though it doesn't ALWAYS do it! Sometimes it's quiet forever (on 90-minute drive last week, nothing). This evening, out for 20 minutes, lotsa racket. So it comes and goes. Nothing under the hood seems amiss, either.
At first it seemed to only be present when moving, like something rubbing or dragging on a tire. Nope. Then it seemed to be related to engine speed, like some under-hood component checking out and starting to fuss. That seems not to be the case anymore, either. Now, I've been able to discern that it's something come loose and VIBRATING (I'm pretty sure -- it just sounds like that), but I don't know what yet. I now hear it at idle, sitting at a light (sometimes) and it's definitely worse on rougher pavement than on smoother pavement.
A while back I realized that it must not be coming from outside and under the car after all, because putting the window/s down results in not being able to hear it at all, rather than being able to hear it better. This is true even at 5 mph, rolling along on a quiet street entirely for diagnostic purposes.
Earlier this evening (during the 20-minute out n' about), I note that it's not coming from the driver side anymore; it's more like the whole front of the car. Really seems to be under the dash. When I first figured out that it's NOT outside/underneath, I took off the panel under that side (three Torx screws) and poked around. Didn't find anything obviously loose, etc. I've ruled out the glovebox, its door, and the center console, by holding on to each while rolling. The sound is not quite in the correct spot to be from any of these, either.
View 5 Replies
After driving our 2013 Passat for 215 miles, we noticed that there was a rattling noise coming from the left front wheel area but only at slow speeds (under 10 mph). The noise disappeared at higher speeds. Today, we took the car to the dealership but they could not find anything wrong.
View 4 Replies
At about 20k on my 07 I started hearing a faint whup whup whup between 35 and 50 mph's on the front driver's side area. At 60+ pretty quiet. It has gotten real loud at the present 30K. I suspected the tirers as I know the Integrities are complete junk but as a test I did a rotation and exact same noise.
I thought thats not good but found it hard to believe something else was bad as I had no vibration and no pull whatsoever in steering. Long story short I bought a new set of tires Kumho KR21's at stock size and oh crap exact same noise.
View 10 Replies
started to get a clunk noise, it would correct itself if i kept driving but now it seems to last longer.
[URL]...
View 3 Replies
I have a 2002 GMC Senoma 4WD. I have recently noticed a roaring noise in the area of the left front wheel, The noise is associated with rotation of the wheel. There is no unusual tire wear or shimmy. I rarely use the 4WD however when I engage the 4LO option the noise gets louder.
View 3 Replies
I have an 02 Avalanche 1500 4wd z71. It has 173000 miles. Noticed a clunking noise under driver side when slowly taking off. If I floor it there is no sound at all. This only happens when vehicle is on 2wd mode. If I put it on auto 4wd there is no more clunking. The noise sound like two pcs of bare metal are hitting each other. What this could be.
View 6 Replies
We have a 1999 Passat GLX 2.8 auto. I recently put on a new inner and outer tie rod as well as a lower forward control arm. The issue that we are experiencing is that when accelerating or braking hard there is a popping/clunking noise coming from the driver front area. When accelerating or braking normally/ smoothly it is fine. But, as I said accelerate or brake hard it will make a single pop or clunk and that is it, just once when braking hard or accelerating quickly.
View 2 Replies
I'm getting some heavy clunking from my passenger side wheel area, when I move the wheel side to side. I am almost positive it is the ball joint.
View 19 Replies
I have 7mm spacers and when I take a hard turn, I get like an almost bouncing, rubbingish, thudding noise and feeling from my driver side wheel/tire area. I have FK coils. Do I need bigger front spacers? I have RC's btw, it gets worse as I go lower, and seems to go away if I really raise it up... how does everyone get away with this?
View 11 Replies
I'm having a hard time diagnosing a creaking noise that is coming from the front driver side area. Since the Camry is pretty quiet, this is the one stand out noise that annoys me while driving. I placed my phone next to the front windshield to get as close as possible to the noise but am having trouble locating the exact spot. Where it's coming from.
The noise tends to appear when outside temperature is spring/summer like. In the winter I really didn't notice it. So that tells me the interior temperature is irrelevant despite warming up the cabin in winter. How this is linked to outside temperature I have no idea.
Ignore the large thump in the middle of the video as that is noise from going over potholes.
[URL] ....
View 6 Replies
