Ford - Mountaineer :: 2002 - OD Off Light Flashing?
Sep 12, 2013
The below is for a 175k mile '02 Mercury Mountaineer 4.0L with 5R55W trannie that has previously had somewhat of a whining sound in 2nd gear (I thot it was rear differential). Note: I just changed the fluid & filter myself last week due to its shifting being a little harsh. Then, this past Sunday, the O/D light started flashing after about 5 min of driving (but the CEL is NOT on). It also did so the next two times I drove it after that.
View 12 Replies
Advertisement
I am driving home from a meeting yesterday and I notice that my O/D off light is flashing. I drive home approx. 25 miles and the truck still seems to be running and shifting fine. The only time the tranny seems to have any issues is when I am slowing down. Once the speedo hits 25mph while slowing, the truck shifts kinda hard. Upshifting is still smooth and RPMs are still normal. Where I should go from here?
View 1 Replies
The below is for a 175k mile '02 Mercury Mountaineer 4.0L with 5R55W trannie that has previously had somewhat of a whining sound in 2nd gear (I thot it was rear differential). Note: I just changed the fluid & filter myself last week due to its shifting being a little harsh. Then, this past Sunday, the O/D light started flashing after about 5 min of driving (but the CEL is NOT on). It also did so the next two times I drove it after that.
1. Any cheapest reader available at Adv Auto that can get these, I assume, Ford-specific transmission codes?
2. I tried a co-worker's dated Snap-on MicroSCAN (#EESC307A) that indicated all was good. Its software was dated 2002, if it's capable of getting what I need (for cheap, if an update is possible)?
3. I have an Android tablet and my wife has an iPhone. Any Torque app (or other) used in conjunction with one of those bluetooth OBDII readers, provide me with the fault codes I need?
View 14 Replies
I have a 99 Mountaineer AWD 5.0 (143K) and having some issues with it. O/D light is flashing once in awhile so decided to check the codes.
- P07401 (Torque converter)
- P1728 (Transmission slip)
The truck shift fine and no having really issues when driving even if there is a weird noise around 70mph.
View 3 Replies
I have a 2003 mountaineer v-6 awd drives pretty good but od light is always flashing even if ignition switch is open and truck not started..and check transmission on message display also..the only thing that i feel its really tight on turns as if it wants to lock up but once steering gets straight it runs fine... I know that a regular scanner cant pull codes I got to go to transmission shop but chances are there gonna tell me its trans time....
View 6 Replies
2002 Mountaineer... Driving into work today, my over drive light started to blink very fast. I have not had any trouble with high RPM's or shifting..
We had a very rainy/slushy/snowy drive in and never went faster than 30 miles per hour. Could an ice or snow build up be the culprit? I sure hope so!
View 7 Replies
this morning my 02 decided to turn the ABS light on, and start bouncing the speedometer. plus, the OD light is flashing when stopped with foot on the brakes, but the trans is shifting fine.
nothing changed on the truck except almost 3 inches of rain fell last night.
will AE tell me if the VSS is going bad?
View 6 Replies
with a flashing o/d light.
I have a 02 Ford Explorer Sport Trac. V6 4.0L with a 5R55E transmission. About 210,000 miles.
A few weeks ago after a trip i discovered i had a coolant leak. It took me a couple of days to figure out that it was the lower thermostat housing. Fixed that and I thought my troubles were over. WRONG.
A few days later the O/D light started flashing and I got to enjoy the wonderful "Limp Mode". The problem only showed up when I had to slow down for a stop. As soon as I started to go again and it went to shift into second (or overdrive 1st) the o/d would start flashing and hello "limp mode".
I got on the web and started reading. I ended up replacing the speed sensor (in the rear differential), the crankshaft sensor, and readjusted the bands with no luck. I would have to shut the truck off at every stop sign/red light just to avoid "limp mode".
Last week I went to a friends shop to have them change the oil and we started talking about the problem. I got him to flush the transmission fluid and look at the codes.
He got the following codes: P0731, P0732, P0733, and P0734. Incorrect gear ration 1 - 4. He cleared them and nothing popped back up.
That cleared up most of the problems.
Same scenario as before but only after I reach 40-50 mph. If I'm just in city traffic it doesn't pop up. And if I'm driving around with no stop signs/red lights it won't reappear. But if i get up to 40-50 mph and have to complete stop, as soon as I take off again and it shifts into that second gear (or sometimes 3rd gear) it will go into "limp mode".
View 5 Replies
I replaced my wheel bearings and wheels roughly 6 months ago, right after I noticed my wheels gittered when turning at low speeds. I assumed this was a power steering issue or the new tires. I have now learned from this forum that it is most likely stuck in 4x4 HIGH but has no indications on the dash. Just yesterday though the actual 4x4 High light started flashing in different variations. I get 6 flashes one time, then 8 flashes 2 minutes later on the dash and so on back and forth. When I stop I can put the truck in 4x4 high and the light stays on, same with 4x4 low. Then when I go back to 4x4 auto they go off but I still feel gittering while turning at low speeds. What would cause this? I see a lot of people replacing the Xfer case control module but no one seems to have the same problem.
2002 4.0L XLT 135k
View 3 Replies
My 2002 mustang with 97k miles just had what has been described to me as a severely overheated transmission. The O/D OFF light was flashing and I noticed some faint smoke and a terrible odor from the burning transmission fluid. I was told by a nearby transmission specialist that it would cost $2500 to rebuild the transmission and put in an external cooling device (which he said was necessary).
View 8 Replies
Car wont start and antitheft light flashes 3 minutes later light goes off car starts.
View 1 Replies
My 2002 Ford Airbag light is flashing 46. I believe this is the Drivers side crash senor. I am repairing the left front fender and left front wheel suspension. I have replaced the two air bags and airbag control module. Where is the left front crash sensor?
View 13 Replies
I have a 02 explorer XLT with the 4.6L and the oil pressure gauge has never worked (the three years I have owned it) I did an oil change yestarday and replaced the sending unit thinking that was the problem but the gauge is still not working. What other problem it may have? 4x4 light flashing (instrument panel looks like a xmas tree)...
View 10 Replies
I have a '02 F350 just over 114k miles, tow light is flashing and just had P1876 code come up. 4h and 4l engage and disengage with out a problem. Code reads 2wd solenoid circuit failure. Where is this solenoid is located?
View 1 Replies
I thought my tranny shift points had gone a little nutty. This afternoon, it suddenly seemed as if it were starting off in 2nd gear...then the OD light started flashing. Now, when you put it in 1st gear manually, or reverse, it's like it's in park. Can't push the truck or anything...put it in drive or 2nd, and it starts off slowly. Once it picks up speed, all seems well. Definitely not starting off in 1st or going into reverse at all. Have y'all seen this problem before?
View 9 Replies
Wife's truck- 2002 v8 limited explorer with 116k... Yesterday she calls and says the od light is flashing and the message center says check transmission. She drove it home then when I got home the light was off and all seemed ok. I am taking it to have the codes read and hoping that my mechanics scanner picks up a code.
View 2 Replies
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 Replies
The brake lights on my '02 F150 have started flashing spontaneously ie - with no one in truck. This lasts for a few minutes, then stops, but can start again a few minutes later. The fear of course is that someday lights could come on and stay on, resulting in dead battery.
I do have a trailer brake controller that has been on truck ten years. Read something on internet that brake pedal switch might be going bad (??). Any one else observed this strange behavior?
View 3 Replies
How the seatback comes off of the 3rd row seat on an '02? There is a spring or something protruding from the seatback on the right side towards the bottom. I'm afraid it's going to stretch or poke a hole in the leather. I think if I can get the back cover thing off I can reach up under and fix it. I don't know if it's a spring our of place or what.
View 2 Replies
2002 Mercury Mountaineer 4.6L . Ok, 140,000 miles and Engine is seized. Got truck for cheap. So, my problem is this: most salvage yards say that the ONLY engine that will fit into my truck is from an 2002 explorer 4.6L or a 2002 Mercury Mountaineer 4.6L.
Others say the mustang engine or F150 will fit. Can I have other options for a engine swap?
View 1 Replies
My wife's 02 mountaineer AWD 4.0 v6 non-flex fuel has app. 152k on it. And it's really in decent shape. But over the last month a vibration at all speeds over 5mph has started to develop. It doesn't change with cornering it's constant until you stop. I suspect a passenger side wheel bearing. But when you lift that tire off the ground it has no play in it. But when you lift the entire rear end and spin the tires there's a distinct rumble you can hear. BTW this is a non-LSD from what I gather. Wheels spin in opposite directions when lift up.
Looking at the half shafts there's some ability to twist them. I haven't tried to see if there's any play in them, ie in and out movement. I am considering replacing both wheel bearings and half shafts. My wife likes the car and it's been fairly low maintenance. I've been looking for any info online about replacing the half shafts and haven't found much. I have seen some comments that they rarely go out. How can I determine if it is the half shaft? Is there a retainer clip or special tool needed to pull them from the pumpkin? Or do they slide off? Is there any seals that should be replaced while I am digging into this project?
View 14 Replies
