i recently got a 86 f250 351w ho. My problem is when i go from a stop or even slow for a turn then reaccelerate it bogs down and i have to pump the pedal to keep is going. My first thought was the accelerator pump but now I'm thinking power valve? I believe this carb is a Holley 4180?
View 3 RepliesI have a 460 with a holley manual choke 750 single pumper carb on it, when I pull out truck bogs very badly, if I try to punch it will stall unless I let off the throttle.
It seems to run best with choke almost all the way on. What the problem could be?
I'm almost positive its a carburetor problem, just not sure exactly what the problem is, could a blown power valve cause this??
The accelerator pump seems to be working properly ...
I have a 2016 Touareg Lux model with just 600 miles. On multiple occasions, when accelerating out of a slow rolling stop, the car bogs down and almost dies.....until I let off the pedal and gradually ease back on it. I was nearly rear ended recently as a result of the acceleration hesitation. It's almost as if the engine shuts down and is starved of fuel.
View 1 RepliesI just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 RepliesIts an 88 F-250 4x4 with a 302 EFI 5-speed. Fair compression, runs smooth. When I press the gas pedal it takes about 5 seconds for the old girl to return to idle. I know nothing about EFI. My buddy,s out of town with the hand held mechanic. Is there anything I could check till he gets back.
View 6 RepliesI've got a 01 f150 yesterday stopped running (like it ran out of gas). Has half a tank. Fuel pressure at rails good but truck will not turn over. Fuel pump and filter less than year old.
View 1 RepliesIs it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.
2000 f 150 4.2 v6 232,000 miles....
Have a 95 Bronco with 5.8, I turn the key on and fuel pump doesn`t shut off. Changed fuel pressure regulator still no shut off. Changed relays, no luck. Have 38 pounds pressure with key on, but no start. Checked spark just in case, and have fire. Don't know what to try next.
View 10 RepliesI'm working on a 170 6 cylinder 65 mustang. Every time we come to a stop in the car it wants to die. And it usually does. Any thing specific I should start with?
View 2 RepliesTruck is a 74 250 390/auto tran. 2wd. When I am at a stop and then step on the gas (not hard) it will sometimes backfire then die. Then I can start it up and it'll run fine. The only other times it backfires is if I am doing about 40 or higher, take my foot off the gas, and let it coast down to around 33mph or so then step on the gas it'll backfire once and run fine. If I am at a dead stop and punch it it will also do some backfiring, usually killing it.
Other than these times it runs fine. I've adjusted the carb (I know not correctly) and that does work if I set the idle higher. Is it possible my fuel pump is going bad? I was always told a mechanical fuel pump pretty much either works or doesn't. If it is a possible pump problem should I test it or just replace it...
I have a 99 7.3 F250. It dies when I slow down for a turn or for a stop sign. At highway speed, it 'surges' sometimes, and makes he whole truck jump. Also, there is a small leak in the tube connected to the turbo. Has 250k miles ......
View 1 RepliesI have a 2000 Expedition that hesitates and sometimes stalls when taking off from a dead stop. The problem is not consistent and therefore hard to diagnose. I have had it to the dealership and two other mechanics and none of them have been able to fix the problem. So far they have replaced the intake gasket, fuel filter, EGR and PCV valves and have changed the PFE sensor and connecting lines. It seems they are just throwing parts at the problem and haven't a clue what is wrong. There are no error codes in the computer.
So far I have spent around $1,500 on this problem and it is not any better from when I started and it might actually be a little worse. I seem to think the problem is in the fuel system and not electrical because all lights and gauges function normally when the problem happens. I can also sometimes produce the hesitation by shifting the transmission into second gear while going around 50 mph then giving it a good bit of throttle after the engine revs. What could be going on.
So my 1987 Econoline Van was running fine until recently we noticed loss of power going up the slightest of hills and it will only hit 55 max with gas to the floor. Its shooting out black smoke and also dying when we stop. We are getting very poor fuel economy as well.
We got a tuneup, oil change, new air filter, etc. We also had a few electrical issues due to a short we thought we had fixed completely... So I'm wondering if it could be the timing? Cause it'll idle low, then high, then bog down and lose power...
Also was thinking maybe bad fuel pressure regulator or fuel pump....but how would I check this? And since we did experience a short, could we have blown a sensor too?
I have a 1994 F150 XLT 5.0 . The problem i am having is when I turn the ignition on I hear the fuel pump come on [both front and rear tanks] and it should stop when the system is pressurized but it does not,and the truck then fails to start. Intermittantly the pump does stop and the truck starts up.
There is fuel at the rail and there is spark,i have changed the filter ,fuel pressure regulater and the pump relay to no avail.
I have a '99 E-350 6.8L. Where is the check valve that maintains fuel pressure on the system?
I have been experiencing a starting issue when the engine is hot. Cold starts are usually fine. I've replaced the in-tank fuel pump (pump only, not the assembly) to no avail. I was out of town and didn't have access to a fuel pressure gauge when the problem started so I couldn't say what I had prior to replacing the pump. But now, with a new pump, when I check pressure, I get about 40 psi when I first cycle the key on, but it drops right back to zero as soon as the pump shuts off. If I cycle the key on a few times, sometimes I can get it to hold pressure at about 32 psi, and it starts fine. When I shut if off, it goes back to zero psi, sometimes gradually, like a bleed down, and sometimes immediately.
My conclusion from this was that the check valve was bad. I was told it was part of the in tank fuel pump assembly. Since I didn't replace the entire assembly, this made sense. So I just dropped the tank back down, but I don't see anything as part of the pump assembly that serves as a check valve. There is a rubber nipple on the end of the return line, but I don't see how that can hold any significant pressure.
So, before I go out and spend another couple hundred bucks on the complete fuel pump assembly, which apparently can't be purchased without the actual pump, I thought I'd ask. Where is the check valve that holds the pressure in the fuel system?
BTW, I also have replaced the fuel rail pressure regulator, but it made no difference (I went there first since that was much easier than dropping the fuel tank a second time).
Started up my truck today, accel pedal didn't want to move, after giving it some more force it eventually became "unstuck". Now, the real issue I'm having is from a dead stop, in 1st gear, as I'm letting out the clutch the truck boggs down as if I'm not trying to accelerate. I'm giving it as much as I normally would as I'm letting out the clutch but the motor will either die or take a couple seconds before it starts to go. Once I'm moving I don't notice any problems clutching through gears. The check engine light IS on now, however I don't have any diagnostic gear or really any tools for that matter. 1998 2.4L 5-speed...
View 2 RepliesI am having problems with my automatic choke. Holley 80457. When I turn on the ignition and depress the accelerator, the choke plate does not close. It is wired and has vacuum.
View 1 RepliesMy wife's car is a 2006 2.0T Passat. It has been very slow to blow cool air on starting. Once you are moving at highway speeds it cools fine, but then blows hot air when you slow or come to a stop.
I have taken the car to a mechanic who purged and refilled the coolant. This did not fix the problem. Upon checking with the mechanic, we noticed that both the primary and aux. cooling fans start and stop at the same time, and only would come on when I would rev the engine up some (around 2000 rpm).
I have talked with this mechanic and one more. Both are certified master mechanics, but neither specializes in VW. They believe it may be the high pressure side switch or the compressor itself.
I have a '99 passat 1.8t Tiptronic. 106,000 miles. Recently I've been getting a bad hesitation when accelerating from a stop. At half throttle the car kinda bogs down and hesitates then as the rpms get higher it seems to clear out and accelerate smoother. At the same time the car doesn't have the same sack it used to. I checked he plugs, found them very fouled. Replaced them and the problem got a little better, but definitely still there. There has to be a reason the plugs fouled. There is no CEL so I don't really know what to check first.
View 2 RepliesI have a new problem that I only discovered a few days ago. As I come to a stop at a traffic light, turning out of somewhere or whatever if I give the car a little more gas than normal not that I punch it or anything from a stop the car bogs down and bangs a little rough like I was rear ended. The car is in drive when it happens. Its just fine any other time. I was told it could be as simple as a bad tps or as bad as a defective torque converter or tranny. Its a 2005 gls hatchback with the 1.8L. also, the engine has been running a little rough recently too if that could have anything to do with it. No warning lights are on either.
View 15 Replies