Ford Fuel System :: 1995 - Stalls - Now Stop Moving - Fuel Filter?
Apr 20, 2008
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 Replies
Advertisement
2002 E-250 with the 4.6 V-6. Pulled the 30 amp fuse, replaced the fuel filter, replaced the fuse, now the truck wont start. Checked the fuse and the kill switch under the passenger kick cover, all ok. Cranks and cranks but wont fire. No problem prior to changing the filter. Even swithed out the relay with another, no luck.
View 4 Replies
Is it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.
2000 f 150 4.2 v6 232,000 miles....
View 7 Replies
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister, there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one. It's a 2007 Ford 4x4 6.0 diesel.
View 2 Replies
I have a 94 F250 5.8 liter with 96K miles. Can I remove the fuel rail and clean or replace the filter that is placed at the top of the fuel injector?
View 10 Replies
I have a 77 f-250 with a 460 engine and a 4bbl Motorcraft carb and its leaking a substantial amount of fuel out of the newly replaced filter that is attached to the carburetor. The fitting is tight and I even tried buying some small gaskets to seat it, but that didn't work either.
View 1 Replies
I have a 1988 Ford F-250 Lariat, 7.5L 460, four-wheel drive. I have two fuel tanks on it, and I've been having a really annoying, obnoxious problem with it lately. After running it for a while, I noticed that I keep losing fuel pressure, and the truck stalls. When I try to start it, it does nothing but roll over. It just won't start. I've changed the fuel filter, I know both fuel pumps are working (I turn over the key, I can hear front, back, and high pressure pump attached to the left side frame rail kick in.) It's Fuel Injected, not EFI, hence that third pump. The problem happens a lot, and it's random. I could drive for 100 miles, stop to get something to eat, come out, and it won't start.
I thought maybe it was the fuel pressure regulator, but I don't think that's the case because it still runs. I would assume that if the regulator was bad, it wouldn't run at all. I also thought that maybe it was the relay, but according to some mechanics I spoke too, if I can hear the pumps kick in when I turn the key over, then the relay is fine. The only thing I could think of is that it might be the fuel selector switch. Maybe it's going bad, shorting out or something. When I flip the switch though, it switches between fuel tanks, and the gauge reads how much fuel is in it from the sending unit.
There's a schrader-type valve up by the fuel injectors. When I push it in, it barely squirts any fuel out, if at all, so I know the pressure is low. When I push it in on a good day, it sprays out like a water fountain. Just tried starting it again - no good. Pushed on the valve, it spurted out some fuel pretty well, but still won't start. Occasionally tries to, but ultimately won't. I know the spark is good, checked the plugs/distributor cap. Can't get the sucker to start.
View 14 Replies
I just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
View 2 Replies
Ok, I've replaced the fuel filter today and my truck still won't start. Checked fuses, and Fuel relay (19th slot). I've found the red fuel switch and it doesn't depress so I suspect it isn't tripped. I'm out of my league if I have a fuel pump problem.
View 6 Replies
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 Replies
Installing the diesel site fuel filter / water separator system for our 6.7's . And If so how do you like it. and your pro's and con's besides price.
View 4 Replies
95 crown vic, 4.6, auto. press the throttle an theres a hissing sound ,let off throttle sound goes away. Air tube to converter ?
View 1 Replies
I have a '99 E-350 6.8L. Where is the check valve that maintains fuel pressure on the system?
I have been experiencing a starting issue when the engine is hot. Cold starts are usually fine. I've replaced the in-tank fuel pump (pump only, not the assembly) to no avail. I was out of town and didn't have access to a fuel pressure gauge when the problem started so I couldn't say what I had prior to replacing the pump. But now, with a new pump, when I check pressure, I get about 40 psi when I first cycle the key on, but it drops right back to zero as soon as the pump shuts off. If I cycle the key on a few times, sometimes I can get it to hold pressure at about 32 psi, and it starts fine. When I shut if off, it goes back to zero psi, sometimes gradually, like a bleed down, and sometimes immediately.
My conclusion from this was that the check valve was bad. I was told it was part of the in tank fuel pump assembly. Since I didn't replace the entire assembly, this made sense. So I just dropped the tank back down, but I don't see anything as part of the pump assembly that serves as a check valve. There is a rubber nipple on the end of the return line, but I don't see how that can hold any significant pressure.
So, before I go out and spend another couple hundred bucks on the complete fuel pump assembly, which apparently can't be purchased without the actual pump, I thought I'd ask. Where is the check valve that holds the pressure in the fuel system?
BTW, I also have replaced the fuel rail pressure regulator, but it made no difference (I went there first since that was much easier than dropping the fuel tank a second time).
View 8 Replies
Changed fuel filters today. Now my water in fuel light is coming on. But the truck is not running any different no sputtering or anything. ????? Could this be human error
View 14 Replies
I have a very slow fuel drip off the housing for the fuel filter on the engine. Can't see where it's coming from. It started sometime after I changed the filter a couple of months ago.
View 5 Replies
My truck starts and runs fine cold. after 10 minutes or so of driving, it starts choking and stalls. If you try to start it, it will not. If you wait about 3 minutes, it is fine, starts , and drives ok, for about 3 minutes. I have replaced, plugs, fuel filter, battery, and a ignition module, as well as cleaned the opening of the throttle body
Ford has ordered a fuel pump, I am thinking it could be the
-Throttle position Sensor?
-MAF sensor?
-fuel pump?
It puts out code p0191 for low fuel pressure. Ford is scheduled to install new pump in am, but I don't want to spend a grand if it is just the TPS or MAf?
View 1 Replies
I had my fuel filters changed at the dealership today on my '15, and then I bought fuel and headed home (70 miles). About half way home I got a "Low Fuel Pressure" message and a little while after that "Reduced Engine Power" along with the check engine light.
I pulled over to see if they did something like leave the drain open, thinking it might be sucking air. Of course it was dark and I could not see anything. However I did hear a buzzing sound and could feel a vibration when I touched the fuel line going into the top of engine filter.
While it is possible I got bad fuel, I suspect they did something wrong installing the filters. Even after cycling the fuel pump multiple times they had a hard time getting it started afterwards; I think they finally disconnected the top fuel line to bleed the air out.
I continued home and made it, but not sure what to do now; its 70 miles back to the dealer.
What is the most likely problem? Improper fuel filter installation or bad fuel?
Should I pull the filters in the morning see if there is something obvious like an out-of-place gasket? If so, top or bottom filter?
Is this a tow truck affair or should I drive 70 miles back to the dealer?
What the heck is the buzzing sound?
View 7 Replies
I have a 92 f150 w 302 . My front tank leaks out of the gas cap and builds up pressure. Even though I have never put fuel in it (owned it 7 mos). I siphon fuel out of it weekly. If I switch from rear to front. The truck stalls out.
View 1 Replies
I'm working on a 170 6 cylinder 65 mustang. Every time we come to a stop in the car it wants to die. And it usually does. Any thing specific I should start with?
View 2 Replies
Today, my 1995 E150 suddenly started acting like it was running out of fuel Lucky for me, this happened close to both a parts store and my usual mechanic's shop. Unluckily for me, it happened on Saturday, and my shop can't get to it until Thursday. So here I am, hoping to do a fix in the meantime.
At first, it seemed that it must have been the fuel pump, because I couldn't hear it come on when I turned on the ignition. Then, a guy who said he was a mechanic told me he could hear the pump cycling, and that my problem was the fuel pressure regulator. So he managed to start the vehicle after a few tries, then it crapped out again. He did this twice. Then he went away.
I called every parts store in town, and none of them had a fuel pressure regulator for my vehicle, and the earliest any of them could get one was Monday. But I knew I was due for a fuel filter, and I'd changed filters on this vehicle before, so I got one of those and put it in. To my delight, the van started right up and idled beautifully. In fact, it ran beautifully for about 15 minutes, until I came to a slight rise, then it crapped out again. It still started up and idled smoothly, and even revved up smoothly, until it reached a high idle speed, at which point it crapped out. I did manage to limp into the parking lot of my shop - which, again, can't get to it until Thursday.
So my question is: does this sound like a fuel pressure regulator to you? If so, is that a job which somebody with a reasonable mechanical aptitude (i.e., at least good enough to change the fuel filter) should be able to feel safe doing? If the answer to those two is "yes" (or even if it's "no")....
View 15 Replies
Truck is a 74 250 390/auto tran. 2wd. When I am at a stop and then step on the gas (not hard) it will sometimes backfire then die. Then I can start it up and it'll run fine. The only other times it backfires is if I am doing about 40 or higher, take my foot off the gas, and let it coast down to around 33mph or so then step on the gas it'll backfire once and run fine. If I am at a dead stop and punch it it will also do some backfiring, usually killing it.
Other than these times it runs fine. I've adjusted the carb (I know not correctly) and that does work if I set the idle higher. Is it possible my fuel pump is going bad? I was always told a mechanical fuel pump pretty much either works or doesn't. If it is a possible pump problem should I test it or just replace it...
View 2 Replies
