Ford Fuel System :: 1986 - Losing Power While Going Uphill Only?
Jun 22, 2008
I have a 1986 27ft Class C RV on a E350 chassis, 460 ci with about 140,000 miles on it. I inherited it when my Dad passed. I live in the southwest and I am have trouble with it, it seems to be a fuel supply problem, I think?
It runs fine on level ground, but we tried to go to the white mountains this weekend and could not do it. On an incline the engine would start to starve for power. At times we could only drive at 25 mph! It kind of seemed like it was running out of gas, if I tried to give it more throttle it would just die or fall on its face, if I let off the pedal and gave it gas again, it would run for a bit and then do the same again. We were lucky to get it back home. I replaced the electric fuel pump (on the side of the road) during the trip, but that made no difference.
The engine ran cool the whole time! it has only one 40 gallon tank. I can find any other fuel pump on it. but don't understand all the lines going to and from the gas tank either?
I noticed there are these silver metal tubes that feed off the exhaust manifold up to a cylinder looking thing on both sides of the block. One of the tubes is broken from the ex manifold and the manifold is plugged. Not sure how this got damaged or what this parts function is but was wondering if this could be a problem ..
View 14 Replies
Advertisement
I have a 1986 F150 6 cyl, dual tanks, no AC, manual fuel pump. Just recently, I have been having issues with the tanks. At first it seemed like the back tank was siphoning from the front tank. Now I have fuel coming out of my front tank filler neck. When I open the back tank gas cap, there is enough pressure to spray me with gasoline. I am not familiar with the fuel delivery system of my truck ...
View 2 Replies
What to do next. Engine is running on 4 cylinders, #1, 4, 5, 8. Had a mice nest on top of injector #2. Removed mice nest. The mice had chewed through wire for #2 injector and caused bear lead rubbing on the block. One lead rubbed through. Repaired, splised in a wire. Also changed rotor, rotor cap, all sparkplug leads and plugs.
Troubleshooting.
Compression on all 8 cylinders measured to be above 160 psi.
There is spark to all 8 cylinders, including the other 4 cylinders, 2, 3, 6, 7 that is nor developing power.
Fuel rail pressure is 35 psi on idle and spikes to 43 when reving the engine.
The fuel injector resistance all all measured injectors are the same (about 14.8 Ohm). Measured injector # 1, 2, 5, 6, 7, 8. Injector # 3 and 4 is hidden and require too much disassembly. Visual inspection deems wire for #3 and 4 injector to be ok on top of block.
Electric impulse (tested while engine was running) to injector # 1, 5 and 8 are ok, used test lamp to see that there are electric impulse to the injectors. Injector #2, 6 and 7 does not have any electric impulse. Unable to check electric impulse to # 3 and 4. However cylinder #4 develops power. Used moving the sparkplug wire for cylinder #4 to verify that is is developing power.
What would my next step be? Where should i look next?
1. Where is the control module and is it likely to fire to only 4 cylinders
2. Could it be an wire in the pickup element, under the distributor. All wires seem intact.
View 2 Replies
Looking for the wiring diagrams for 86 ranger fuel system. I replaced the fuel pump relay after testing and finding that it was bad, still not getting fuel. I want to test any fusible links or anything else that could have gone wrong before I throw another part at it.
View 1 Replies
I have an 86 F150 that is idling rough. It used to cut out on me until I replaced the fuel pressure regulator. I have read in other posts that the problem for my rough idle could be leaking injectors. When I replaced the regulator I found a bad injector. My question is that if I check my fuel pressure, with the new regulator, would the only way I would lose pressure be that my injectors are leaking?
View 5 Replies
My engine is running rich, flooding? My truck is a 1986 F-150 302 EFI. The engine idles rough, black smoke and soot comes out the exhaust pipes, and black soot on spark plugs. Symptoms seem to disappear if I throttle the engine and hold it, but as soon as I release the throttle the symptoms reappear and in most case causes the engine to die. These symptoms have just started a week ago. What the problem is.
Fuel injectors are cleaned and rebuilt. New plugs and wires. All new fuel pumps and filters. New air filters. New fuel pressure regulator. New dual function reservoir. New 3-piece timing set. New O2 sensor. New EGR Valve and sensor. New idle air control valve. New distributor, cap, and rotor. New ignition coil. New high volume oil pump. New alternator. New pcv valve. New knock sensor and air charge temp. sensor.
View 14 Replies
I have a 1986 Toyota pickup. It's small 2 wheel drive with a stick shift. 6 weeks ago, it started lugging very slightly on hills after I had first started the car (only in the first 5 minutes of driving). Then that stopped, and now it loses power on hills so that I have to keep shifting down and going slower until I'm chugging uphill in 2nd gear at 30 mph. It only happens on long hills with a sustained uphill; smaller ones it keeps speed and power fine.
View 2 Replies
My 1986 Ranger 2.9 starts only when I spray starter fluid into the air intake. It does stay running and it drives fine. The engine will not fire up unless I do this process. I have cleaned out the fuel rail, fuel injectors, purchased new fuel filter, and tested fuel pressure (which is good).
View 9 Replies
The 2002 Nissan Xterra (4WD), automatic transmission, I drive for work is starting to have trouble traveling up hills. Just the other day I was traveling on a freeway up a fairly steep grade for ~6 miles. It wouldn't down shift and the pedal was to the floor while I watched the speed slowly drop. I started noticing earlier this year that it will disengage the cruise control on this same steep grade, though not every time. This used to be my personal vehicle and I have been driving it since 2002, so I know how it drives. A mechanic test drove it today and chalked it up to age (our admin assistant took it to the mechanic, so I didn't get to talk to him). Its got something like 170k miles. That is a lot of miles and it is 10 years old, but I am really wary of any diagnosis based solely on age.
View 8 Replies
I've got a 1994 Mercedes C220 which recently has been losing power going uphill. This is a random occurrence but starting to happen more frequently. When going up a hill the car engine starts to "miss" and the engine sounds like its fluttering. It is definitely losing power.When I get to the top of the hill; if I turn the engine off and restart it all goes back to normal and runs properly.what is it??
View 2 Replies
Accent 2008 (155,000 km) .... Walter pump, all belt, timing belt, pulley where changed @ 120,00Km when i bought the car.
**No code showing in dtc no check engine light**
I've been losing power uphill, RPM at 4,000 and and losing speed. I heard a loud sound coming from the front starting at 2,500 rpm and up (like if the exhaust air is struggling to get out), not sure who to explain that accelerating noise
On Flat surface it's slower accelerating up to 3,000 rpm with that loud sound. It's like the more i pressed on the gas pedal, the less acceleration i get.
**Running idle up to 4,000 rpm in park, no loud noise, engine running normal sound with no lack in acceleration in RPM**
2 weeks before I had 2 ignitions coil going bad at same time, i run it about 2 miles before changing them, and the exhaust/catalytic converter came hot and melted the plastic dust cover under the car near the catalytic converter.. Did I premature burn or plug that catalytic converter?
Would it be catalytic converter? Fuel pump? Fuel Filter..
I thought of buying a catalytic converter cleaner and put in fuel tank and up the intake..
View 21 Replies
2004 f450 with 6.0. Was driving down the road when it started losing power like it was starving for fuel. It carried on for about a mile then died and will not start. No codes at all and we put a new fuel pump on but still wont start. Put a rag with gas in the air box and will run but rough.
View 6 Replies
Stuck 398 miles from home. Car kept losing power, running out of fuel (even though I had a quarter tank). Stopped and filled it, but could only barely get to next exit. Step on gas- no go. Let off gas, car catch back up and run. Wife noticed definite new sound in back. Took her many miles and comments before it finally sunk in and I remembered the same groaning noise from a fuel pump going out on a cabrio. So, fuel pump bad.
Am preparing to go out and jump terminals, as per bentley manual. That should tell if it is transfer pump or fuel pump. My main concern now is are the pumps under the rear seat or in the trunk?
By the way, I made it to a motel (lucky enough one that accepts pets!)
View 7 Replies
I was driving my truck then all sudden truck started losing power then slowly died. I restarted it, it was a lil shacky then died again. Iunscrewed the fuel filter and looked in the housing and there was lil fuel in bowl i turned the key to on position and bowl did not fill with fuel looked as if it were shooting some bubbles up(air) could it be outta of fuel???
View 10 Replies
I own a 2011 f350 diesel. So 2 weekends ago when it iced over in DFW I ended up doing a bunch of driving in 4wd. I pulled out a couple people, even pull out a semi.
After this the truck went on the fritz and gave me a CEL regarding the tcm losing communication with the rest of the electrical system. The truck was stuck in 6th gear and all things related to the tcm gear indicator didn't work. (remote start, backup camera, traction control, stability control and trans temp gauge). I did have drivability issues with the trans when it would sometimes bang gears when i would get on it suddenly and it could get generally confused at times, so generally I drove it pretty gently. The truck had to be towed to the dealer because after a while it would only get neutral of 1st gear and obviously it shouldnt be driven like that. They replaced the tcm under warranty.
The kicker is that all of that trans bs is now gone, there's no more confusion and gear banging.. drivability improved 10 fold. Obviously they updated the software but i was wondering if that was all that was needed to get this trans in gear? (pun intended) maybe they did something else?
View 5 Replies
cant figur this out have no signal to injectors and no power at fuel pump 88 f150 5-0
View 2 Replies
When our Saturn sl2 1999 goes up hill we lose speed from 60 or so down to about 45 with foot to the floor it doesn't regain speed until the hill flattens out..
View 6 Replies
I have another very odd problem with my 2003 F250 7.3 PS with 206000 miles on it.
I am visiting my parents and every time I go thru this certain area my truck will act up. The first thing that happens is the truck starts losing power and then it starts bucking like water in the fuel or the cam position sensor is giving out.
WHAT I HAVE DONE SO FAR: I have drained the fuel filter assembly ( no water ) and a new cam position sensor has been installed (about 5000 miles ago, I even put old one back it to check it out same results). I have driven the truck all over the place and don't have an issue except in this ONE spot. I am beginning to think there is some kind of high powered RF going on in this area causing my truck to act up. I am thinking of hooking up my autoenginuity scanner up to it and hopefully see something going on.
Is there anything I can do to block this out if it is a RF problem. I think it is effecting my Pcm/ECM for then engine causing the truck to act up.
View 6 Replies
I have a '99 E-350 6.8L. Where is the check valve that maintains fuel pressure on the system?
I have been experiencing a starting issue when the engine is hot. Cold starts are usually fine. I've replaced the in-tank fuel pump (pump only, not the assembly) to no avail. I was out of town and didn't have access to a fuel pressure gauge when the problem started so I couldn't say what I had prior to replacing the pump. But now, with a new pump, when I check pressure, I get about 40 psi when I first cycle the key on, but it drops right back to zero as soon as the pump shuts off. If I cycle the key on a few times, sometimes I can get it to hold pressure at about 32 psi, and it starts fine. When I shut if off, it goes back to zero psi, sometimes gradually, like a bleed down, and sometimes immediately.
My conclusion from this was that the check valve was bad. I was told it was part of the in tank fuel pump assembly. Since I didn't replace the entire assembly, this made sense. So I just dropped the tank back down, but I don't see anything as part of the pump assembly that serves as a check valve. There is a rubber nipple on the end of the return line, but I don't see how that can hold any significant pressure.
So, before I go out and spend another couple hundred bucks on the complete fuel pump assembly, which apparently can't be purchased without the actual pump, I thought I'd ask. Where is the check valve that holds the pressure in the fuel system?
BTW, I also have replaced the fuel rail pressure regulator, but it made no difference (I went there first since that was much easier than dropping the fuel tank a second time).
View 8 Replies
I have a 2005 Volkswagen GTI with 80k miles. Just yesterday I went to school and the car drove fine. But when I came back and tried to start my car, it stalled out after a few seconds. Now I thought this was a bad fuel pump until I checked it and found that the fuel pump wasn't receiving any power. I checked the fuse and it was intact. So then I went to check the relay and found that if I unplug the relay and plug it back in, the fuel pump momentarily receives power for about 2 seconds then nothing. Any clue what the interference could be?
View 1 Replies
I have a 86 ranger 2.9 5 speed. A few days a go I replaced the front fuel filter and all seemed ok. Last night on my way home the truck quit and I had to have it towed home. Now I find both pumps don't seem to be working. What would make me loose both pumps??
View 11 Replies
