My dual gas tanks quit switching over. I replaced the fuel line selector valve and the selector switch. Now my gas gauge will not work on either tank.
1979 camper special E350 fuel system...
I have a '88 F250 with a couple of dual tank issues, first of all if I'm running on the rear tank the fuel returns in the front tank.... not an isssue if trhe front tank is empty, but if both tanks are full the front tank will overflow. If the front tank is empty I run on the back tank until I'm out of gas and switch to the front and I"ll have about a half a tank in the front tank.
Second issue, running the front tank the fuel gauge stays on full until I have about half a tank, then it works OK. If I'm running the back tank it stays on full, even after the tank runs out of gas??
I've had a fuel leak near the pump of my 79 F150 with a 400 for some time. I didn't know exactly where it was coiming from, but fuel was being sprayed on to the oil filter from something near the pump. I assumed it was the steel line, and that it had rusted through or cracked, and was going to replace it when I had a chance. I was poking around today though, and realized that the fuel was not leaking from the line, but from a hole in the side of the mechanical pump.
For someone who knows what these pumps look like, there is a horizontal cylindrical bump out near the top of the pump, on the side of the pump that is away from the engine. The fuel is spraying in a mist out of one side of that. To me, it always seemed to be a screw channel, but I didn't think the pump was 2 halves put together? Need to know more about my pump, what that bumped out section is, or why/how fuel could be spraying out of it.
I have a 79 ford and a 400 engine that i put a 1411 on and it backfires when you hit the gas it is worse when you drive it then when it is just sitting there.
View 4 RepliesI bought a truck a few months back with a Dual Electronics XDVD710 7" pop out touch screen. The radio work and all the screen pops out but the screen is back with the backlight on and doesn't show a display. If I hold info a text comes up that says brightness and I can adjust it but can't seem to do anything else and I would really like to use it especially since my speakers are way out of tune! I read somewhere that they might be locked out and need a special code but I also lost the remote. So i'm down to either just buying another stereo or if it is locked out just getting the remote to put a code in.
View 2 RepliesI have a '99 E-350 6.8L. Where is the check valve that maintains fuel pressure on the system?
I have been experiencing a starting issue when the engine is hot. Cold starts are usually fine. I've replaced the in-tank fuel pump (pump only, not the assembly) to no avail. I was out of town and didn't have access to a fuel pressure gauge when the problem started so I couldn't say what I had prior to replacing the pump. But now, with a new pump, when I check pressure, I get about 40 psi when I first cycle the key on, but it drops right back to zero as soon as the pump shuts off. If I cycle the key on a few times, sometimes I can get it to hold pressure at about 32 psi, and it starts fine. When I shut if off, it goes back to zero psi, sometimes gradually, like a bleed down, and sometimes immediately.
My conclusion from this was that the check valve was bad. I was told it was part of the in tank fuel pump assembly. Since I didn't replace the entire assembly, this made sense. So I just dropped the tank back down, but I don't see anything as part of the pump assembly that serves as a check valve. There is a rubber nipple on the end of the return line, but I don't see how that can hold any significant pressure.
So, before I go out and spend another couple hundred bucks on the complete fuel pump assembly, which apparently can't be purchased without the actual pump, I thought I'd ask. Where is the check valve that holds the pressure in the fuel system?
BTW, I also have replaced the fuel rail pressure regulator, but it made no difference (I went there first since that was much easier than dropping the fuel tank a second time).
I have a 2012 Toyota Camry LE and I wanted to add a dual exhaust system like the camry se has, where could i find it? or could it fit the 2010-11 Camry dual exhaust system to my camry? and if it does, where could i find that?
View 6 RepliesI've replaced the fuel pump, relay, drive module, and the filter. The fuel pump still refuses to switch on when I go to start the vehicle.
View 9 RepliesI have my aux fuel tank pump hooked to upfitter 3. It has worked perfectly until this week. I started to transfer fuel and the aux fuel gauge and fuel pump both quit. The led on upfitter switch 3 still illuminates, but no fuel pump. I found fuse 9 on passengers kick panel is for upfitter 3. The fuse was good. Is there another fuse somewhere for the circuit I've missed? I can trouble shoot the wiring if necessary, but it's tough to do all behind the left side underbed box and not easy to get to. I've missed something simple before I go further????
View 14 RepliesIs it possible to do so with out engine problems later? I would love to go with duals front to rear 3in pipe and tips. Any do's or dont's?
View 11 RepliesI have a 89 F150 4x4 lariat with the 302 8cyl and dual gas tanks. I was driving to work and the truck died. I have spark and enough juice to turn it over so I must be getting no fuel. When I turn the key to the on position I do not hear the fuel pump whine as it primes, it's dead silent. I'm assuming the fuel pump is dead.
Are there any fuses to check? I did check the switch that goes off when in an impact and it was not tripped off so it's not the problem.
My hayes manual (which i find is wrong ALOT) says that 87-89 f150's have a single fuel pump that is external to the tanks and found along the left frame rail? Can anyone confirm? Someone told me they thought it might have 2 pumps but I switched tanks and the truck still didn't start (or make a fuel pump sound) so unless the planets aligned and BOTH pumps blew simultaneously I would assume there's only 1 pump.
I'm having an issue with my Nav system. I'm not sure if its going out or if it's due to the cold weather but it doesn't immediately come on when I start the car. At some point while I'm driving I'll notice that it's on and working but it seems to also be intermittently switching between the day and night time screen mode. How to check to determine if it needs to be replaced or if there is a fix?
View 4 RepliesI have a P2440 code from warning light- Secondary AIR System Switching Valve A' Stuck Open. This started to appear when I took it into the dealer for other issue with transfer case whining when in 4x4. Can this code be associated with something the mechanic did , would they remove any sensors or wires, that may not have put back. Not happy. Are these trucks know for this code? Estimate cost?
View 4 RepliesI went to move the 2000 yesterday and it will not start because the gas went bad. It has been sitting about 6 months, since it did not snow this past winter. How do I go about cleaning the fuel system? I was thinking suck the gas tank empty with an electric fuel pump, and blowing out the lines with air. Does this sound right?
View 7 RepliesHow many gallon tanks were installed in the E99s?
View 6 RepliesThis van has had a couple of fuel pumps, no surprise there, and i need to look through my paperwork and find out how many miles the current one has on it, but it has the STRANGEST habit I've ever had on any vehicle. Starts fine, runs fine, no fuel pump noise when van is running, and when you turn it off, the fuel pump creeks on and off for several minutes.
I mean a strange creaking noise almost like a shorted electrical device or a vehicle's brakes when you park it on a hill and the breaks creak as it settles into place. I'm probably doing a lousy job of describing this but i don't know how else to describe it!
ALSO, if you lay under the van and wait til it stops creaking, you can tap the bottom of the tank and it will creak for a few more seconds. You can tap repeatedly and make it creak more. Is it about to explode? Can i trust it on a road trip?
I have a F-250 4WD with 7.5L which has a MC/Holley 4180c sitting on top. It was getting very poor mpg (like 5-6 miles/gal) and then was getting harder and harder to start. This progressed rather quickly to not starting with fuel coming out of the primary vent tube. I suspect it has to do with the primary float stuck open. I was considering rebuilding the carburetor. Is this over reaction prematurely or is there something like float adjustment that may rectify all of the symptoms described. If a rebuild is in order what is the information I would need to ensure getting the correct rebuild kit. Info that I have so far from research is it is Motorcraft ID #E5HE-9510-MC.
View 6 RepliesWhat would make a FI engine act like its flooding out and dying after a short run on the freeway?
Details:
1994 F-350 351W (just overhauled this winter)
has new TPS, ICM(?).
Dual exhaust dumps right before the tires
new filters in tanks, new fuel filter on frame rail
All fuel lines have been opened and blown out from the tank to the engine compartment fitting near firewall.
Fuel pumps hold good pressure when tested.
Symptoms:
smells like its running rich most all the time
after a short hiway run @ 70MPH it will stumble and die when returning to surface streets.
fuel smell near engine sometimes, but no obvious puddles or leaks anywhere.
May be related?:
When on a longer highway run, I can't use the FWD tank for a long period without the engine stumbling and cutting out or popping at times. But I can swap to the rear tank for a bit then run the FWD tank again for a while. driving up hills it seems to be worse, but I'm in the panhandle of TX right now..good grief!
I am having to drive this truck for work long distances. While I dont expect a vast fuel range, it would be nice if I could go a couple hundred miles on 20 gallons of gas....
I just bought another 1991 Ford. This one is a 1/2 ton XLT Lariet with the 302 and for the first time I own a short bed. I also have a 1991 F-250 XLT with a 460 and a 8' bed.
Here is the problem, ( I think) it will not run or at least not for long. The fuel pump, which I am guessing is in the rear tank will not stop running. On the F-250 the pump stops running after a few seconds after I turn on the key.
Where should I start to find out my problem with the fuel system?
I have a 95 F150 4x4 reg cab long box with a 302 V8 and dual tanks... I was driving around yesterday when my truck started to lung and then the motor stalled... when I stopped moving I tried starting the truck and it started with no problem, so as i kept on my way, about 5 minutes later the same thing happened and it stalled again, (I have an automatic by the way). but this time before it stopped moving i pump the gas a few times and it fired back up and then stalled again... i switched from my front take to by back maybe thinking it could me my fuel pump in the tank but it did the same thing again about same time later... Would it be my fuel filter on the frame (like in line fuel filter) or why is it doing that? its EFI by the way.
View 14 RepliesMy vehicle:
1976 F150 2wd Extended cab
390 4bbl
c6 transmission
4BBL Edlebrock Carb
Dual fuel tanks, only rear main tank connected
My problem: For the first year I owned the truck, everything ran fine and it started up really quickly even after it sat for a few days or a few weeks. I have since, for about the last year or so, had to crank it for 30-45 seconds to get it to start. This all started around the time my fuel pump went out. I replaced it with an Airtex fuel pump from Autozone. I also installed a glass in line filter before the carb in front of the distributor.
I noticed that after about 4-6 hours, the fuel had drained out of the filter and that's when I would have to crank it forever to get it going. It also seems like there is no fuel in the carb as it doesn't even try to start when it first gets cranked. I thought this was a bad pump, so I bought a new one last week and tried it again. Sure enough after about 4-6 hours, everything is empty again and it takes forever to start it. So it's not a bad pump, or so I think.
The other day I backed it into my driveway and left it, something I never do. I checked about 4 days later and there was still fuel in the filter. This makes me think that gravity is making it drain back to the tank.
Is there something that would cause this? Also I have found a one way fuel check valve online that is supposed to remedy this type of problem. Do they work for this situation? Or is there something else I should be doing to fix this? It has taken a bit of a toll on my starting system having to crank so long all the time. I have so far had to replace my starter, starter solenoid, and all the battery cables, starter cable, terminals, etc. due to excessive wear.
The valve I found is here : [URL] .....