Ford Focus 2012 - 25,000 miles
There's a loud grinding noise from the front end of car when I turn the steering wheel... even when the car is off and in park.I can post videos of the noise if needed.
One my F350 with 175,000 miles on it, at low speeds when turning the steering wheel it seems as if it has two places during use that it rubs or has an oblong spot in it. I have 285 tires on it and have for years.
Kind of like if you were turning a shaft in a seal and it rubbed or was rough. It makes a faint, muffled, barely audible grinding noise or feel. I have a lift and level of about 4" and 285s for years. This just started in the last 5 months or so.
I have 2016 camry 4 cyl have roughly 2300 miles and I'm noticing a click click while turning the steering wheel left or right while stationary and vehicle running sounds like it's coming from under the dash.
I've seen there is a tsb for other year camry intermediate shaft issue, my vehicle is lowered on eibach Springs and would hate to take back to dealer and have them blame it on the springs in a vehicle that has only 2,500 miles.
I get a grinding or whirring sound when I turn my steering wheel left or right. I gets worse if press the accelerator pedal. I believe it has something to do with the power steering but I don't know how to troubleshoot the issue....
View 5 Replies'97 Ford Aerostar, 155k miles. Airbag model-
The problem: When I turn the wheel, there is some grabbing and tightness, and a strange grinding noise from the top of the steering column, like, right under the steering wheel. What's more, the wheel will actually pivot up and down on the steering shaft. I have tried pulling on it, and it loosen the grabbing, but it won't pull off in my hands or anything....
I suspect a bearing in the upper steering column has failed or has come loose. I guess I need to pull the bag and look around- Are there any tricks to pulling the airbag?
The problem makes the car unsafe to drive. The quickest way to describe it is a hard pull to the left after a very linear steering feel. My perception is almost as something is holding on and then just fails and lets go and the car quite abruptly shoots left in a very unsafe manner. Here are the things I have done to remedy the situation, I replaced the struts with factory replacements 15,000 miles ago. At the same time i replaced the left and right axles, drove the car with the problem then last weekend, I replaced the upper tie rod arms, and lower tie rod ends, the sway bar bushings, and the control arms on both sides. I literally feel as though it is a darn near new front end.
Just yesterday I had 4 new Goodyear eagle tires and an alignment done and the problem became more pronounced and worst. I really like this car and want it to be a joy to drive as I know from others these little hatchbacks are a real joy on winding mountain roads.
I am hearing a grinding noise when I turn the wheel to the left.. and when I straighten it again the noise goes away.. no noise at all when turning the wheel to the right. what could it be? 2006 Hyundai Santa Fe / 205,000 km's
View 4 RepliesI have a 2012 Ford Focus which infrequently makes an odd grinding, scratching sound by the front LEFT tire/ axle. It only does it when turning to the RIGHT. It usually does it as I'm coming out of the turn, not into the turn; so when the tire is moving back into the straight position. It's just the sound, you can very slightly feel it when it happens but really no stability or other steering issues. What is causing this sound?
View 3 RepliesI've got a 1993 ford aerostar. Today, my steering wheel started shaking/rattling when I turn the steering wheel. Seems to be more obvious when turning right rather than left, and is only obvious at low speeds.
Only thing out of usual was that the front had been on jacks for a few days for an unrelated (starter) repair. What to check or how to isolate? I imagine it has to do with the power steering but not sure what to check.
I have a problem! I have only had my 07 gs awd for less than 2 months. I noticed this morning when I turn my wheel all the way to the left or right it makes a grinding or like metal on metal noise. My brakes were done only a year ago, and this noise only happens when I'm turned all the way to the right or left.
View 11 RepliesI have an 08 F-150 5.4. When sitting still or moving, and turning the steering wheel to the right and only the right past center, there is a popping type noise somewhat like a screw driver down a washboard (for those who'll know what that is). I replaced the ball joints because I saw a slight amount of play, but the noise is still there.
View 12 RepliesI have a 2000 Mitsubishi Eclipse GT V6 FWD. about 138, xxx miles
My left rear tire/wheel has free - play (clicking movement) when grabbed at ONLY the 3 o'clock position and push/pulled back and forth (no free-play at 12-6 direction) in the air.
I had grinding noise from rear left side wheel when turning right couple weeks ago. After replacing wheel hub bearing assembly, the noise is gone. But still remains the movement ONLY at 3 o'clock. I replaced stabilizer bar links in both rear sides. This link doesn't look like the reason of free-play (clicking movement).
Also, I tested (push or pull) after switching the other side(right) wheel, it still had clicking movement at 3 pm. Therefore, it is not a wheel problem itself, I guess.
And I took off the wheel and fasten the lug nuts onto the rotor itself (so, without wheel in this case), then push/pull the rotor at 3 pm, but this time no movement in any directions. @@;; weird.. ONLY, I can feel the clicking movement at 3pm on the Wheel (or tire) even after rotating wheel, exactly in same spot (3 pm) movement~!!!! What's this case??
All 4 wheels aligned recently after got new tires.
I scrutinized inside wheel while pushing/pulling back and forth. But I cannot figure out which one is problem.
1. Knuckle.
2. Lower control arm ( or Rear rear control arm, not typo) which has a Ball joint and a cam bolt the other side.
3. Rear front control arm
4. trailing arm.
5. stabilizer bar link. (new)
6. Wheel hub bearing assembly (new, double-checked the nuts and torques)
7. Rotor and pads (new, if I push the rotor itself then no wobble or clicking at all directions as desribed above)
Where should I direct my attention and/or what component(s) should I look at given the indications above?
When I pull/push the wheel at 3 o'clock, it feels like wiggling the whole part of lower knuckle where is the connection part between the part of 4 bolt (backside) of hub assembly and lower side of knuckle.
I heard that 12 and 6 is usually an indication of ball joint, and play 9 and 3 is usually in indication of steering components ( tie rods , steering shaft or rack itself ), and all around play is an indication of wheel bearing (usually accompanied with a growling noise ).
When I was reversing back and turning the steering wheel. I heard a metal clunk sound and it had happened twice in the past two days. Today happened after I released the parking brake and set it to reverse. What is the problem? Miles on the car is ~30700 miles.
View 2 RepliesWhile in the locked position, the steering wheel was purposely jerked hard to disable the mechanism on a 1996 Ranger. Now the truck will not steer easily or smoothly and a popping noise is evident when turning. I'm not concerned about having the wheel lock, but would like to be able to return driveability to normal.
The same guy who caused this damage also damaged the ignition. No key is needed to turn the switch now.
I'm lost as to how the steering locking mechanism works and wondering if I need to tear apart the column or if maybe there is a locking pin accessible that needs to be removed to regain driveability.
I just bought a 99 f150. Its in great shape only 65000 on it but there is a hissing swooshing sound when turning the wheel... not really any brake sounds. The truck has been maintained and I dont see any leeks in the ps system hoses. I didn't know anything about the atf fluid in the truck... and I haven't added either ps or atf fluid to it. I'm wondering if that is maybe something the dealer i bought it from did. or maybe one of the shops the previous owner did. Would ps fluid cause these kinds of sounds? Do I need a flush of the system.. How to do that.
View 14 RepliesLately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 RepliesI have a 2011 F250 4x4 with 8000 miles. I put a 3.5" ReadyLift on it at 3500miles and Rancho dual stabilizers at 5000miles. This past week I've started to noticed my truck's steering making slight popping noises when turning the steering wheel. I crawled under the truck today and I can't pin point the orgin of the noise. It seems it is coming from higher up in the steering system possibly. It doesn't seem to be from the wheels or tie rod.
View 14 RepliesI bought an 09 Accent and love the car, good mileage and actually quiet. I have developed a noise when I turn my steering wheel. It is not there when the car is cold, but after a few moments, when I turn a corner, I hear sort of rubber on rubber sound as I turn the steering wheel.
View 2 RepliesWhen turning the steering wheel slowly while from a stop or slow speed there is a grinding sound coming from the front end. It isn't very loud but you can also feel it in the steering wheel.
Is there a common thing/problem with these? I know there isn't a pump. There isn't any kind of a vibration or wobble at highway speed.
When I turn the steering wheel I hear what sounds like a frictional noise...like a rubbing. I have checked the tires and they are ok. I have checked the Power steering fluid and it seems fine but I did add a little. I am going to wait a little time to see if the additional PW fluid works.
2002 V6 GLX Passat Automatic ....
My 2010 Wolfsburg Tig makes rubbing noises when I turn the wheel but not moving. The noise sounds from the wheel shaft. The noise goes away when the car is moving. What's noise? Is it a normal noise for Tig?
View 6 Replies