Ford - F150 :: Sometimes Starts Fine Other Times Won't Turn Over
Jun 25, 2015
We have a 1999 f-150 just turned 200,000 miles. Two years ago replaced battery and alternator. Problem now sometimes starts fine, other times nothing. Can't jump it. Took battery out and had it tested and it is fine. Cleaned connectors. May start after thirty minutes, an hour, a day. Then runs fine for a few weeks or months, then problem returns. Have taken to two shops, but mechanics said couldn't find anything wrong bc of course it started fine at their shops! When wont start, Lights are on, but when try to crank, they go out and you hear nothing.
View 3 Replies
Advertisement
Today I acquired a 1982 F150 with a 302 engine, 4 brl. Edelbrock carb. The truck starts and idles just fine, but when I come to a stop, try to give it gas to go it dies. It starts right back up, and I have to rev it high a couple of times then put it in gear and it will finally go. When I got it home I let it idle a few minutes and tried playing with the air and fuel mix but don't know what I'm doing, really. It seems I can hear a hiss, and when I was reaching for the air/fuel screws I got a little shock on the hand from the distributor. We want to use this truck as a farm truck, and plan to get a manual for it, but what might I might check for the cause of it stalling.
View 1 Replies
The car will start up and drive just fine but as soon as you turn it off, it will not turn back on. If you wait three to four hours it will restart with no problem. This repeats its self daily. When you turn the key the dash lights come on but will not crank at all. I am skeptical that it might be the alarm system;however, there is no key fab and no code for the check engine. It has 170K miles. Laughing, my sweet husband dictated this...my first attempt to describe the problem was long and rambling!
View 7 Replies
2003 F150 Super Crew 5.4
When I turn off the ignition, the drivers door lock unlocks or pushes the arm through the door for up to 30-60 seconds over and over again. I would say like 10 times and it is annoying as hell.
Is the only part in the door that controls this the actuator or is there something else that can be doing this?
View 6 Replies
I got a new truck bed and decided it was time to finally fix my rear lights. Both blinkers work but only one brake light. It has really got me stumped. Also the rear running lights don't work and never have. When using a multi meter I get continuity between the running light positive and the common negative but only when the rear light harness is plugged in which means the short is somewhere on the way back or under the dash? Any tips about tracking this stuff down.
View 6 Replies
My fuel gauge indicates empty at all times. The first suggestion I received was to replace the sending unit in the gas tank. I did that but the gauge still indicates empty.
I tried the HEC Dealer test mode and I now know that FUEL reads 255. Which should be an 'open' state. The connector near the fuel tank does appear to be making good contact, so my suspicion is a broken wire somewhere between the rear of the truck and the front.
I tried following the wire on it's way towards the front of the truck, but I quickly loose sight of the wire as more branches enter into the wiring harness. Where does this wire end? Does it terminate in the engine compartment, at the instrument cluster, somewhere else?
I just can't figure out how to narrow down where the break in the wire might be. Or am I chasing down the wrong root cause?
View 1 Replies
My daughter called me and said her "battery light" came on. I didn't even know there were battery lights. The car still starts and runs fine. What could cause the "battery light" to come on?
View 2 Replies
We have a 2003 Ford F250 Super Duty, gas engine. This will start fine, then a day later, it won't. Wait 30 minutes, then it starts.
Starter and battery are fine. It acts like it isn't getting fuel. Fuel pump? Filter? What else might cause this?
View 2 Replies
This is an Auto/4z4/4.6 V-8. It's Skidding or a Clutch is not holding at times when shifting up or down while on Cruise and slight hills.
someone suggested changing oil and filter about two years ago. I did that and it didn't change a thing. $145 that time.
I'd like to know if its the clutch in the torque converter, or the Transmission? If I have to change something out, should I get both?
View 3 Replies
I have a 2001 Honda Odyssey that doesn't start sometimes - mostly when it's really cold but not exclusively. It doesn't seem to matter if the gas tank is full or empty. It turns over fine and will catch and the die multiple times. There is sometimes a large "clunk" while it is turning over and all the lights will go off and then it will start turning over again. It can take a minute to 15 minutes to start when it isn't starting but about half the time, it start right up. This is only in the morning, once it's going for the day, it works. 126,000 miles, timing belt changed a couple of years ago.
View 5 Replies
I Have a 93 bronco with a5.8 the truck will start up and run fine for a while and then the engine gets really ruff starts back firing and shuts off it only starts with starting fluid or after it sits for about 30 mins.
View 7 Replies
I have a 2004 Ford F150 and the battery keeps dying. We do not use the truck a lot and it sometimes sits outside for 2-4 weeks without being used. If it sits that long, it might be completely dead, but starts up easily with a jump and then works fine for a while. The battery is a 650 amp Motocraft w prorated replacement from 37-100 mo. The local Ford dealer has checked it several times in the past 2 yr and said it is fine, and that if the truck sits for a couple of weeks the battery will die. Is that right? I am not a car moron, nor am I an expert, but I am concerned that they are missing a small draw somewhere in the system. Should I be concerned about a draw or is this just something that happens to batteries as they get older?
View 2 Replies
I have a 04 late model F250. I have done the EGR delete, oil cooler upgrade, and blue spring upgrade. I have a SCT tuner but truck is currently set to stock.
My issue is it starts fine runs good but dies after about 2 minutes. No stutter or stumble. It acts as if some one just turns the key off. I have to let it sit for about 2 minutes and then it will restart. If I try any sooner then it just cranks but will not fire. This started about three weeks ago. At that time I would be driving and it would just die. I could slip into neutral turn key and it would fire right back up and I could continue down the road. As time has gone by the issue has reoccurred more often and now I have to let it sit for about 2 minutes to get it to start again but then as stated only runs for about 2 minutes and then dies again.
I have a scangauge and here are the readings I can get.
FICM main power is 47.5 - 48 volts at all times = good
FICM Logic power is 10.5 - 11.5 volts at all times = ???
IPR is 33% at idle = good Scangauge does not react fast enough to get info at startup.
ICP voltage KOEO 0.25 volts
Start 1.33 volts
Idle 1.11 - 1.13 volts dips briefly to 0.96 volts
ICP pressure Start 900+
Idle 830ish
Sync between CAMshaft and Crankshaft is 1 = good
Have not gotten fitting to do fuel pressure test yet.
View 14 Replies
How often should my A/C clutch be cycling when the compressor is being used. (i.e defrost, mix, a/c and max a/c). My clutch never cycles, it starts spinning when I turn something on and it does not shut off until I shut off the a/c. The truck is a 95 F-150 4.9L 5 speed...
View 14 Replies
2002 Excursion, 7.3L 375,xxx miles ... As the weather is cooling off, my excursion has a starting problem for a few years.
Replaced all the glow plugs last year. We (my brothers and I) thought it was injectors, but in the summer time or if block heater is plugged in, she starts normally and idles smoothly. And no smoke and runs fine once she warms up.
When cold, it acts like 1 or 2 injectors are not firing. Have run all kinds of cleaners through the oil and fuel.....
Don't want to swap injectors just to swap parts. Would like to diagnose problem....
View 14 Replies
I'm having an issue with the truck not staying idle after cold start up. The truck will turn over and start right away (not even 2 second crank) but immediately dies. The throttle will not work at low RPM. When I start the truck, it will instantly rev high, the revs will drop low, it will try to compensate and rev high again, then it will immediately die.
If the RPMs are under under 2.5k, the truck will immediately stall and die. When I attempt to use the throttle under that RPM, it will not work. No matter how much I depress it, the engine will instantly cut and stall out. It will not attempt to deliver fuel. The only way I can get the truck started is if I rev the engine high and hold it. I need to hold the truck at 2.5k+ RPM for atleast 30 seconds. It generally takes me about 5 tries to finally get it running (mainly due to the throttle immediately cutting out and I have to 'catch' and hold it.) After that, there is no sign or issue. The truck will start immediately back up after it's been running for a couple minutes.
CEL: MAP sensor (0069?) -- Sensor is spotless. Harness looks fine. I replaced the injectors, both batteries, and the alternator this summer. It doesn't sound to be any these either as the truck sounds extremely healthy and immediately turns over.
View 8 Replies
2007 5.4 . Starts good , idles all day. As soon as you try to rev it, it stumbles rattles etc. Shut it off, wait a second, restart then Idles fine. I watched live Data and it carries on when the VVT solenoids become active (above 800 rpm).There duty cycle goes to 60-70 percent while revving. I think it Is just one side of the engine. Could be VVT solenoids sticking on? yes ? No?
View 3 Replies
I've got an '05 F-250 starts and dies numerous times, have to rev throttle to keep running then it stays running. I've replaced FICM, PCM, Eng. harness, IPR, CMP, what else is there to do?
View 3 Replies
.I have an 06 Rabbit and the clutch is not engaging. I woke up one morning to go to work and the car starts fine but won't go into gear. If i jam it in it just stalls out. I know the clutch itself is good since it was running perfect but just now wont engage.
View 1 Replies
Starts up fine but the car does not move. Car also has loud whine on cold starts coming out of driver side fender. It will also whine above 2000 rpm even after sitting out in the sun but goes away after driving. The car is at my parent's place and will be able to look at it later today..
View 4 Replies
I have an 04 w12 with 80k miles on it. It will start fine but will not run for more than 10 seconds. As it idles down from startup it settles to about 700 RPM's where it normally does then dies. If u drive it it will start and go into gear fine as u go to pull away it loses all power and dies. I have checked the minor things i know like air filters, oil, tranny juice all appears normal. New batteries less than 3 months ago also.
View 11 Replies