The Cruise Control on my truck works intermittently. Sometimes it cuts out when I am driving and sometimes it fails to work at all (usually in the morning). Sometimes it will re engage if it cuts out and sometimes it will not re engage for hours.
View 1 RepliesFirst it wouldn't turn on, at times now it at times won't work even though the light is on, on the dash. At other times it works as expected. I dun think it's the 12V battery, because when only the center console is on in diagnostics the battery reads 12.2-12.4 and 14.5 + when the engine is on.
View 13 RepliesI have a 99 Passat 4 cyl turbo and the cruise control seldom works. Sometimes it works, sometimes not, and sometimes it shuts itself off. What could be the problem?
VWFahrer
85 Jetta Diesel
93 Eurovan
99 Passat
I have a 2000 f250 7.3 and the cruise control works when only when the engine is cold. Once the truck warms up, cruise will shut off and not reactivate. I have no lights on on the dash new clutch safety switch a new sensor on the master cylinder horn works and have had a scanner hooked up and compared the electrical values of the buttons pushed to the spec.
View 3 RepliesMy fan control went out yesterday (hot day with no A/C), It comes back on at times, but if it's on three it may only blow like it's on one. What I need to replace??
View 3 RepliesWhere is the cruise control amplifier located on an 85 F-150? The Chilton manual just says "behind the instrument panel". No pic or further description. Just looking up from the bottom of the dash I see a "black box" with 2 wires going into the top of it located just between the steering column and the wiper switch.
Is this it?
I recently changed out the power boost canister for the brakes on a 1990 f-150 2wd. It was successful but now i have no cruise control. I double checked my plugs, all good. I checked my brake lights, all good. brake pedal seems fine and completely raised when not in use. i looked for a fuse and can't find it for that system, seems odd. it's not in fuse jct under dash, can't find a fuse jct under hood, seems odd also. No check engine light has lit.
View 3 RepliesMy trusty 1994 Ford F150 is starting to show her age, I think. I'm noticing a few issues:
1 - most concerning to me is she jerks pretty hard when shifting through the first few gears during relatively warm weather. The cold snap has abated the issue for now. Had the transmission fluid checked - mechanic said it's fine.
2 - This is a fun electrical issue. I'm driving down the highway when suddenly the cruise control shuts off, as does the speedometer and the digital odometer. The Tach still works, as do the rest of the gauges. Maybe 10 - 15 minutes later, they all come back on. It's done this a couple times.
3# - Really annoying but very minor; when I push down on the foot feed, there's a bit of a squeak in the engine. I'm guessing it's a tensioner pulley on the serpentine belt, but why it would only happen when I give it some gas?
I had had intermittent issues with the cruise control not working in my excursion. most of the time it was fine though. after a recent 150 mile trip it stopped working half way through. i didnt worry about it too much..got back into town and checked under the hood. i found brake fluid running down the inner fender well! all over everything under the master cylinder. finally tracked it down to the cruise control switch on the master cylinder leaking. I pulled the plug apart and it was full of brake fluid.
Meanwhile the master cylinder was about half full, so i replaced it with the same switch out of a '96 parts explorer which is the same part luckily. also yes i have had the cruise control recall done. So if you have lost CC and you have a leak replace the switch! seems it can leak..and at a pretty good rate..alittle scary! glad i figured it out before my 800+ mile trip later this week/weekend.
2002 Ford Excursion cruise control inoperable. Problem began when cruise would come on intermittently. I would push the on button then set, at which point the green cruise icon light would either come on and the cruise would set or she would flash and not set. Sometimes holding the switch down worked, other times not. Now no matter what I do the cruise will not engage.
I have had the recall done for the cruise control by the dealership.
I have checked the fuse on the recall module, the 2.5 is in good shape and not blown.
I also found this guide to a self test (copied below). I used the test, turning the key on with the off button depressed yields a green speed icon light. Letting go and pressing on yields a green flash as well. But when I move on to pressing resume I get no lights at all, same if I continue through the other switches, no more lights.
Here is the self test guide -
*cruise control self test
Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo.
Release the OFF switch.
Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL. If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch. NOTE: There will be a slight delay when the last button is pressed and the lamp flashes.
A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective. If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
3 flashes - deactivator switch is open or circuit defective.
4 flashes - vehicle speed signal is out of range or circuit is defective.
Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.
2003 X limited 2wd 6.0L ... My cruise control was working intermittently. Could it be the buttons on the steering wheel itself? there is a cluster that I see. Does it pop off to expose the connectors/switches? Can these go bad? Can I buy new switches for the steering wheel?
View 2 RepliesIn the past month, I had to use my "cruise control" a few times, and I had the bad experience that sometimes it works as it is intended to do, but other times I am unable set it after I turn on the cruise control; thus, it works on and off.
View 14 RepliesWhen I turn my Cruise Control "On" it will light up green on my dashboard, However when I press the "set" button to set the speed nothing happens. It was working fine a few weeks ago. Could it be a fuse? If so what fuse? How I can fix this? 2011 Sonata
View 17 RepliesI am normally on the super duty side but I have a 2002 ranger 3.0 auto EX cab if that matters with this issue. My cruse control will only come on rarely but when i does it works fine. Most of the time when I hit the ON button the indicator only blinks like a "relay" of some sort is not latching up. Don't know if this is an all solid state system or if there are electro mechanical relays involved as well. When it does work and I hit the brakes it will drop out completely rather than just disconnect from the controller and need to hit the ON button again, usually with no results.
View 8 RepliesI'm at my wit's end trying to install cruise control in my 2009 Corolla. I thought it was a relatively easy install, but then after putting the airbag in place, I find that the horn no longer works. I test out the cruise control, and the green "Cruise" lights up on the dashboard..but it doesn't actually work.
View 9 Replies1999 F250.. What would cause my cruise control to work sometimes and not others. it may work today and not tomorrow.
View 2 RepliesHad an intermittent problem with my Cruise Control engaging. The CC light would come on when the CC on/off button was pressed.
When the CC would engage the "set" light would come on and the speed would hold. On occasion the CC would not engage.
I looked are reread the owners manual.....NOTHING! I was double checking to make sure there was nothing different with the hybrid. (I have owned Toyota for a very long time...since 88').
Since the Hybrid is new to me, "shifting" is a little bit different. There is a "B" on the shifter which is mentioned for "downshifting". There is no mention that once you are done with downshifting that you must shift back to "D" for normal operation. The only mention is not to run in "B" for an extended amount of time.
So, when you are in the "B" position, the CC with disengage.
The cruise control on my '05 Avalon Limited was working intermittently for a while. I'd hit the button to turn it on and nothing. Then a few miles down the road, I'd hit it again and it would work just fine. Today I tried to turn it on and nothing. Three different trips today and no luck.
View 1 RepliesMy Prius cruise control will intermittently not activate when I try to turn it on. One day it will turn on and work fine. The next day I can not get it to turn on. I took the panel off of the back side of the lever and the contacts look ok for the on/off button.
View 8 RepliesMy engine and cruise control lights keep flashing....This happens intermittently (been going on like this for several months). I took it to my mechanic and he cleared the computer...was fine for awhile...but happening again. Mechanic said that if it happened again, it might be the catalytic converter. I hope not b/c this is a very expensive part to replace!!! Is my mechanic correct or could it be something else?
View 3 RepliesI just returned from a 4K trip through 7 states and my cruise control will go batty and make you pull over and re-boot the car. Basically I am cruising down the interstate with cruise control on. When I come into a town I will either pull the cruise lever forward or step on the brakes to disengage it.
The traffic comes to a stop or slows to a crawl for a short period of time. Once the traffic starts to move again and we are back to highway speeds I can no longer use the cruise control because it is intermittently flashing on the dash as a malfunction. The only time it doesn't do this is when I am slowing down if I turn the power off to the cruise control system.
I stopped in the middle of my trip at two different dealers and there were no codes stored. One dealer charged me a diagnostic the second didn't after I showed him my receipt from the day prior from the other dealer but then he wanted to sell me a brand NEW MFD.