Ford - F150 :: 1994 - Will Not Gain Speed When Press Accelerator To Go Faster
Sep 10, 2012
Ford F-150, 1994 : intermittent problem. going down highway, foot on the gas. At times, will press accelerator to go faster but nothing happens, like clog somewhere. Sometimes, with foot still on gas, i will hear a popping sound coming from under the truck, (under the engine?, or drivers seat). Usually 4-5 pops, sometimes none. But after each pop, car accelerates slightly, as if it is a slight clearing, until finally, as if some clog was opened up, the car plunges forward, so i then take my foot off the gas. Sounds like either problem with fuel getting to the engine or a problem with the exhaust.
View 4 Replies
Advertisement
I'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
View 3 Replies
I have a 1994 4x2 shortbed standard cab Ranger XLT. It has the 4.0 OHV engine, A4LD Automatic transmission, and 195,000 miles.
Under average driving conditions, it operates fine. It shifts up through the gears much like it always has, although the shifts may not be quite as firm as they used to be.
If I'm at cruising speed and step harder on the accelerator, it downshifts, RPMs increase, and it upshifts rather poorly, & then I feel a thump, (maybe the torque converter locking up when it shouldn't be?), and I'm in the higher gear. This seems to happen when it upshifts from 3rd to 4th gears for sure, maybe from 2nd to 3rd, but I'm not sure. Again, it only seems to happen when I attempt to speed up from cruising speed, not from a stand-still.
The transmission fluid and filter have been changed at regular intervals, and the truck has never been abused. The fluid is red in color, doesn't smell burnt, and the level is correct. I don't want to get rid of this truck if I can avoid it. It has been super-reliable and mostly trouble-free for the 16 years I've owned it.
View 1 Replies
I have a 1994 4x2 shortbed standard cab Ranger XLT. It has the 4.0 OHV engine, A4LD Automatic transmission, and 195,000 miles. Under average driving conditions, it operates fine. It shifts up through the gears much like it always has, although the shifts may not be quite as firm as they used to be.
If I'm at cruising speed and step harder on the accelerator, it downshifts, RPMs increase, and it upshifts rather poorly, & then I feel a thump, (maybe the torque converter locking up when it shouldn't be?), and I'm in the higher gear. This seems to happen when it upshifts from 3rd to 4th gears for sure, maybe from 2nd to 3rd, but I'm not sure.
Again, it only seems to happen when I attempt to speed up from cruising speed, not from a stand-still. The transmission fluid and filter have been changed at regular intervals, and the truck has never been abused. The fluid is red in color, doesn't smell burnt, and the level is correct. I don't want to get rid of this truck if I can avoid it. It has been super-reliable and mostly trouble-free for the 16 years I've owned it. What might be wrong with it?
View 5 Replies
What may have wrong with my trans on my truck... this is what its doing, I am able to put in drive and drive it for so long then its like the truck is in neutral and doesn't gain or maintain speed. but i can turn the truck off and put it in park and restart the truck and it will go again?? that is how i got it home....
the fluid is burnt now but wasn't that bad until the trans started doing this. I have pulled off the pan and inspected the filter and it does have metal debris in it, pulling the valve body off tonight before work (work 3rd shift) to inspect that, i think it has something to do with the solenoids or valve body because it actually moves but then quits until i restart the truck. Also does the transfer case use fluid from the transmission? or are the fluids separated between the 2.
Truck has 4.0L SOHC with a 5R55E in it 4WD...
View 7 Replies
2003 hyundai santa fe 2.4l ... When driving on highway speeds of 65 miles hour, I take foot of the accelerator and I put it back on to gain speed , it starts jerking or bagging. Also in the city when I press accelerator seems to have no power. I have no codes or check engine light on, what could it be?
View 2 Replies
Today my Windstar would not start, it only start if I press on the accelerator if I let go it will die, I'm thinking of gas pump?
View 2 Replies
Car Stats: 2005 Chevy Malibu, Automatic
Just recently while driving my car at a normal speed...(Like 55mph wanted to speed up gradually to 60mph) ..I will push the accelerator and my car wont go any faster. It will act like it is switching to passing gear and then the engine will rev up, the car will lurch forward and then it will finally take off. The RPM's also will increase and then suddenly drop back down to normal.
Also I think this is related to the problem. .... but... when I put the car in the low gear to where I can manually shift it to first second and third. It used to automatically be in the 1st gear... but now it will show up in the third gear and you cannot shift into any other gear.
View 9 Replies
Have a problem with a stutter when I press the accelerator while going up hill. I even had this problem driving on a flat road but that was a 1 time thing and happens every time I go up hill. Had a coil replaced that came off of an '04 because one of mine went bad which caused it to shake whenever I came to a stop. Wondering if the coil has anything to do with it... 2007 5.4L ....
View 1 Replies
When I press slightly on the accelerator just to get the truck moving and than let off the engine stays at the higher RPM typically just over a 1000. This only happens in drive not reverse and everytime I just slightly step on the accelerator. The truck only has 1K miles on it.
View 14 Replies
I have a 2004 F150 4.6L... There is a slight hissing sound under the dash on the drivers side when you lightly press the accelerator and then stops. No matter what speed you are going as soon as you apply the accelerator it hisses then stops. There is also the same hissing , only louder when the engine is cut off. It hisses for about 3 seconds. What could be causing this. It has been idling rough since the hissing started. The check engine light is on and showing P0420 and P0430 codes . The cats were replaced with resonators so I believe that is the reason for the codes.
View 2 Replies
I have a 2012 Camry SE I4. The problem is my car speed odometer is faster than my radar detector speed. I have 2 detectors and they are both not show the same speed compare to the speed odometer. For example, I am going 70mph, the detector reads like 67-68mph. So the speed odometer is off about 2-3mph. I have OEM size on my car. I know the GPS on my detector is more accurate. So my speed odometer has problem?
View 14 Replies
2001 f250 7.3L, 289,000 miles, changed the IPR and ICP, noticed the EBP tube was in two pieces. Would this cause the rough idle and shaking? IT started running rough and would die after a mile or two. Would have to wait 30 minutes before it would start again. That is when a buddy told me to change the IPR and ICP the ICP plug was covered in oil as well as the top of the ICP. So I changed the wiring plug as well. I originally cleaned and changed O-rings on IPR but then it wouldn't start, bought a new IPR and started but runs rough. I just started it with EBP tube removed and sensor unplugged. Idling rough when I press accelerator and RPM go above 2K it levels off pouring black smoke everywhere.
View 3 Replies
I have a 2001 Ford Excursion Limited 7.3l with 199,980 miles on it.
It has a TS-6. My first problem is that when I come to a stop or slow down to a crawl then press the accelerator the engine stalls and dies. I have looked and looked at threads and can not find this example anywhere. There is no pressing the pedal and it remains at idle. It dies, shuts off, quiets. I have thought icp, tps, ivs
Second problem is that a/c is blowing hot. Other than being out of Freon, what could be other things to check. It does sometime go to default, but has done so in awhile. It does not blow cold in rear and hot in front. They both blow hot. I have replaced the pvh sensor.
View 1 Replies
My 2005 Santa fe has a single knock when you press the accelerator, then between 60 and 70mph there is now a shake in the steering wheel. I have been told it is probably the CV joint and just wanted more input.
View 2 Replies
2007 with 85000 miles. This noise appeaser only between 64 to 69 miles/hours, either manually pressing pedal or when crus control is on. A/C on or off. Noise goes away as soon as i let off the gas pedal. the noise is not very load it sounds like, when mechanical fuel pump stars going bad.
View 5 Replies
I have a 2006 Rav4 and every time I drive my car after it's been sitting for a while there is a very loud noise coming from the rear of the car, the noise usually lasts about 10 to 20 seconds and only happens when I press on the accelerator, and is always when I go forward, never in reverse. The noise is usually louder when it is humid or it is raining.
View 1 Replies
Had my .:R for 2 years now and just noticed other day. When you cruise in 2/3/4/5 gears about 3000 RPM and suddenly press accelerator 1/3 down RPM jump UP for a split second on tachometer. They go up by one segment (which is 200RPM) and then drop back down.
Now, DSG should not do that to my understanding as clutch pack is engaged! There should be no slip. Also, it is not a drive train shunt, as I kept the car in very slight acceleration.
View 5 Replies
I'm trying to get my neice car going. .I went to move her car yesterday after a snowstorm and it idled fine but would bog down when I pressed on the accelerator. While it was running I checked to see if the air filter was dirty, it was and as soon as I pulled the snorkel off the car stalled. I put everything back in place and after running for a half hour it seemed fine. She drove to school but before she got there it started to bog down again so she pulled into a Toyota dealer. Later they changed spark plugs, new air filter and cleaned MAF sensor. Worked better until the next day, now it will crank over but will not even make an attempt to start. I tried to clean the sensor with rubbing alcohol but no luck.
View 3 Replies
I purchased a new 2015 Santa Fe Sport 2.4L ... transmission/acceleration issue. It's possible I just haven't had enough time to get use to this car but it seems to hesitate when I press the accelerator. Also, the transmission seems to annoyingly down-shift when I step on the break slightly or with a slight decrease in speed. Overall I love the car but I just wanted to see if this is something I just need to get use to or if I should be concerned?
View 11 Replies
I have a 2010 Hyundai Sonata GLS 2.4L. This problem started several weeks ago. When I turn on the ignition on the car, I hear a squeaking noise coming from the engine initially. Once the engine warms up, the squeaking sound lessen but does not go away. When I shift my automatic transmission to DRIVE, and press the accelerator, I hear squeaking noise coming from the engine again. I stopped my car and opened the hood. I could hear the squeaking noise coming from the front left of my car, if you are facing forward the front of the car. I do not know much about cars but I think it is coming from the fan belt/serpentine belt, or possibly alternator but I am really not sure.
Presently, the sound has gotten worse so I want to fix this as quickly as possible. I am second owner and the mileage on the car is 45,550.
View 2 Replies
