Ford F-150 (2009-2014) :: Transmission Dipstick Tube Leaking
Oct 17, 2014
I was changing my oil the other week and when i went to pull the filter I noticed that my tranny pan was wet around the front side, as well as the flywheel insp. plate, and the tranny dipstick tube. It wasn't even enough to drip on my driveway, but wet none the less. after cleaning it up really well and driving it around for 15 minutes it seemed to be coming from the dipstick tube about halfway between where it seats in the tranny and top end of the dipstick.
Removing the tube was easy, just one 10 mm bolt on the back of the engine. After further insp, there was a small piece of insulation on the tube where it passes between the engine and exhaust manifold. when i removed that insulation i noticed there was rust on both the top and bottom of where the insulation sits. i looked it over really well and didnt' see any cracks or holes. I then pluged one end and blew into the other and didnt' notice a loss of pressure or any hissing noise.
I figured if it wasn't leaking and it was already out i might as well clean off the rust and hit it with some paint. I ran a wire brush over the lowest spot of rust and what do you know, 3 tiny little pin holes. I used some 2 part apoxy from work and some aluminum duct tape to repair the hole temporarily until i got the new part in the mail yesterday. total install took around 10 minutes.
View 11 Replies
Advertisement
I got a 97 F250 4x4 w/ 4.6 lt. motor & auto trans. The engine is leaking oil. It looks to be coming from a set of hoses that are on the adaptor that is between the oil filter & the engine block. Also what are the oil lines called? It is leaking motor oil not transmission oil.
Also just pulled my oil dip stick & the whole thing (dip stick & the tube) came off the truck. Seems the tube has rotted away at the oil pan. Is this also a job I can do?
View 6 Replies
The dipstick tube flange is now leaking ....
View 3 Replies
Have a 2006 F-250 with 5.4 motor pulling a 25 ft house trailer. No issues until the towing began a couple weeks ago. Back pressure is building up in the transmission and it is blowing the dipstick out of the transmission tube and spraying fluid all over the place. Truck has 132k miles on it and last serviced @125k miles. No slippage. Fluid isn't burnt. Separate transmission heat gauge not registering hot and it is working - fuse not blown. The transmission does have an auxillary filter on it which is going to get changed tomorrow to see if that solves the problem. Transmission is Automatic. Not driving in 4th gear because of towing. Any thoughts what might be blocking to cause this pressure buildup?
View 6 Replies
I have the 4r75e transmission. Last week I was driving for about 20-30 mins when my transmission fluid started to boiled and came out the dipstick tube. I let it cool off then took my time and drove it home. I know my transmission is not shot because I am getting full power on the transmission. After I got home I checked the fluid level and it's good, then I disconnect the transmission fluid lines on the transmission to see if I am having flow, but no luck...
I took my air hose and blew the lines out and they were clear. I also blew into the transmission thru the ports where the lines were connected. I started the truck up and the fluid came out with full force about 1-2qarts came out before I shut the truck off. I was all excited and I connected all the lines And started the truck to go for a test drive but my gut told me to disconnect the line to see if I am still having a flow and as suspected no flow...
I took off the lines that connected to the transmission and still no flow. I blew the air into the transmission again and started the truck up and bam I have flow again for about 20 seconds... I shut the truck off and I decided to connected the lines back to the transmission and I disconnected the lines about 12" away from the transmission to put a clear hose that connected both lines to make a loop.
Started the truck and there was no flow, I disconnected the 5/8 nut on the transmission and blew the air into the transmission. Started the truck and only got a few dribbles. I check the fluid level and it's still good. I am stuck and don't know what to do... What part of the transmission send the hot fluid out to the cool. The valve body? The main pump? The solenoid???
View 6 Replies
I'm trying to remove the throttle body on my 2002 Echo. However, the transmission dipstick tube is in the way of one of the throttle body bolts. How can I remove the transmission dipstick tube so that I can remove the throttle body?
View 1 Replies
I have 2007 sport trac 4.0 liter V6. I have noticed for the past week or so that I have antifreeze leaking from the bottom of the radiator and I had to add some coolant to it the other day(1/2 gallon). I know it is the radiator leaking and not the overflow so I am going to go head and order me a radiator and change it. I have read that some of the replacement radiators was not lasting but about a year before they leaked.From what I have read on the internet a lot of ford owners is having this same problem with the radiator leaking at around 60,000 miles. Also there is no transmission dip stick to check the fluid, will I lose enough fluid that it hurt the transmission. I have just had the 60,000 mile transmission service done.
View 9 Replies
So my wife nailed a small spike buck and he when up under the truck. On his way back, his antlers hit the intercooler. One side tube was collapsed and the other collapsed but tore open. Has to repair one the tubes and, if so, with what. I was thinking I could pull the dent out with a pick and then put some sort of epoxy over it.
View 14 Replies
I've done 3 oil changes since picking up my 2012 Lariat 5.0 a little over a year ago. And I've always questioned the accuracy of the oil dipstick - seemed to always read 'low'.
I just changed oil tonight (Motorcraft 5w-20 semi-synthetic), and I measured the oil that I drained out - just about right at 8 qts. I put in 7 qts and 24 oz (about 1.6 - 2 oz over the 7.7 qts that it calls for) and the oil barely reaches the low level on the dipstick.
I guess between what I drained out and my current oil level reading, my dipstick is not accurate.
View 14 Replies
F150 2011 3.5L Ecoboost. Where is the transmission dipstick?
View 14 Replies
I just noticed my 13 FX4 isn't draining water, but I checked inside and the carpets feel dry. Maybe I'm just being paranoid but the wifes Jeep always has a huge puddle under it. I'm sure the drain is somewhere under all that silver sound deadener. Is this common?
View 3 Replies
I've got smoke coming out of my oil dipstick tube. 1996 Mercury Mystique 2.0L automatic, 62000 miles. I noticed a burning oil smell after a short (10 mile) drive, and checked the oil when I got home. A few wisps of smoke smelling of burning oil came out of the dipstick tube when I removed the stick. I was just curious how worried I should be about this.
As far as I can tell, my cooling system works (radiator hoses are warm, good hot air from the vents, thermostat and coolant recently replaced, hoses inspected, no leaks) and I'm not thinking the burnt oil is caused by overheating. There hasn't been any noticeable oil consumption, and I'm pretty diligent about checking the oil on this old car. Oil changes every 3000 miles since I've owned the car; dealer performed scheduled maintenance for the old owners.
Here's my thinking: a worn piston ring allowing oil to be burnt and then sucked back through into the crankcase. When I changed my spark plugs, I did notice an oily residue on one of the plugs (cylinder #1), which also leads me towards a piston ring diagnosis (though I was hoping it was a valve seal causing the oily spark plug, or even a spark plug seal). Do a wet compression test is in order, or should I go ahead and get a leakdown test? I am going to buy a compression tester, but I do not have an air compressor to use with the leakdown tester; I'd have to take it to a shop.
I do need to service the PCV system (and would have done it today, but the parts hadn't arrived at the store) -- would a PCV problem cause the oil to burn, though?
View 12 Replies
Rusted dipstick tube I thought was going to be an easy enough fix. Broke off clean at the block. Tried for hours, easy out, prying, vise grips anything I could think of. Well I tried to pry the side of the tube over to make room for my needle nose vise grips, and boom. Down in the oil pan it goes.
Do you think theres any way possible I can fish it out through the drain plug. I really dont want to pull the darn motor.
View 7 Replies
2014 fx4 6.2. Had a coolant leak. Brought to dealer for warranty work. Found a leak in middle lower tube area. Said they replaced radiator part # BL3Z-8005-D. It sure looks like my old radiator still under the hood complete with squished bugs. Am I missing something?
View 2 Replies
2009 Ford Explorer - 6cyl - 4L - auto trans - 35K miles. I'd like to change the automatic transmission fluid, but as some may already know, there is no dipstick on these vehicles. I have one of those hand pumps which will fit on the quart bottles and I'd be able to pump new fluid in (through where the drain torx bolt is). My question is: How do you know when the fluid level is correct when re-filling and then checking ? Also, I'm assuming that this has to be checked while the vehicle is running and in park ?
View 10 Replies
It's really not relevant what brought up this question but do you think a broken dipstick tube can cause an engine to run lean and why do you answer that way?
View 3 Replies
I have a minor leak at the base of the trans dipstick tube. I assume that the tube is press in ? has an o-ring ? I put some silicone around the area and that worked about a week, the fluid is probably eating through that type sealant. The trans is a 4r70. Seems to me that the actual tube should be ok and having never dealt with replacing one I want a little advice before yanking it out.
View 11 Replies
The dipstick tube on my 5.4 snap and ive ordered a new one. it looks like it may not be to hard to replace.
View 4 Replies
I had a leak at the flange several months ago. I fixed it with the diesel o rings kit. I made a trip from TX to AL with no leaking and drive it daily without leaks. But, 2 weeks ago noticed a small dribble of a leak from the same spot again - not enough to leave a mark on the pavement but any leaking drives me nuts. I applied some RTV. It worked for the 2 weeks.
Today, noticing another dribble of a leak coming through the RTV down the pan. I'm thinking the flange is bent and not keeping that o-ring sealed against the pan. I'm going to try to apply some additional RTV at the leak spot. If this doesn't work? Is that Strictly Diesel adapter really worth that kind of dough? Is pushing the OEM adapter into the pan really acceptable? Any other options?
View 14 Replies
Ford F-150, 1999, 4WD. My dipstick tube has rusted off right at the point where it attaches to the engine block. I purchased a new one but I'm not sure if that's a job I can do on my own. What installing a new tube will entail?
View 5 Replies
I have a 2001 7.3 and have found the engine oil dipstick coming out of the dipstick tube by 6 - 8 inches on three different occasions. Did not think much of it until my other 2000 7.3 did the same thing.
What causes this as afraid it will come all the way out and get into the serpentine belt.
View 6 Replies
