Ford F-150 (2009-2014) :: Tranny Slipping When Pulling Trailer
Aug 3, 2012
I have a 2012 Ford 4x4 crew cab 150 xlt. 15,000 miles. When pulling my dump trailer I was stopping to turn and the transmission disengaged. Once I turned the corner coasting the transmission kicked back in again. During this happening pushing the gas did nothing but rev up engine. My dealer said if this happened that a warning light would of came on or a wrench would appear on dash but it didn't. He said then it didn't happen. This happened 3 times in 10 miles of driving. I had it in tow mode.
View 4 Replies
Advertisement
My husband and I bought a 09 f-250 with 58000 miles. It used to pull our travel trailer with no power issues. Now the rpms go up & the power goes down. It never gets hot nor any lights come on. It's been in the shop twice. The first time nothing was found. The second time we were told it was dirty fuel filters. The truck only has 70k miles...
View 2 Replies
My father has a 2009 F-150 with almost 25,000 miles. (he leaves it in garage and polishes it weekly) He just purchased a new dual axle trailer with electric brakes and led lights. When we hook up the trailer and press the Brake, turn signal or hazards, we blow a under hood fuse (48 if I remember correctly). When connected to either of his other 2 trailers, everything works and no issues. When I connect my 2014 suburban, the new trailer works perfectly. He does not have a brake controller installed on the F-150 yet. It does have the 7 pin and 4 pin plugs under the bumper.
View 7 Replies
Today while towing a 10ft trailer with a golf cart my truck seemed kind of under powered.It has the 5.0 with 3.73 rear end.When I got to where I was going I looked under my truck and there were spots all over the rear end and axle and frame that looked like oil or transmission fluid. I cannot find any noticeable leaks. The air temp today was 100 and the transmission gauge stayed around 200.
View 4 Replies
I have a 2011 Ford F-150 XLT. I did take the fuses out of the glovebox and installed them. So trailer lights and blinkers work fine. I just purchased a small teardrop tailer. My problem is that the trailer lights are always on when plugged into the truck.They are on even when lights are off and key is out.
I am assuming that the problem is with the wiring of the trailer harness but I wanted to ask here first in case the problem might be with the truck. I have never had a trailer so I am unsure if the 7 prong plug is always hot. Obviously it is on my truck. Is this way it should be?
View 6 Replies
Ok we have a 2012 F-150 and are trying to hook up a 16ft trailer but have no lights. We know the trailer wiring is fine (works on other vehicles) but we have no power at the 4 pin trailer connector. We have checked the fuses and all are fine. Having this problem on a 2012?
View 14 Replies
I just bought an electric tongue jack for my utility trailer. Rather than mount a battery on the trailer, I bought a jack that has a 7 way plug, so you just plug into the truck in order to power up the jack. However! My '13 Platinum F150 appears to have a very smart 7 way plug. If I plug in the trailer, everything works fine on the trailer.
If I unplug the trailer and use my tester to check the power inside the 7 way plug on the truck, there is nothing. So when I plug in the jack, which only has 2 tabs on it's 7 way male - positions 4 and 1 (positive and negative since they are red and black) it does not turn on. I wired direct to my battery from the jack 7 way plug and jack works fine.
So I'm guessing that the 7 way plug is not powered up until it senses a trailer is plugged in somehow? Is there a way to override this? Also the 4 flat on the truck was dead when I put the tester to it as well. Maybe same thing? If not, I'll have to hard wire the jack into the trailer wiring harness as a work around I suppose.
View 14 Replies
I have pulled a pop up with my truck before with no problem. I bought a boat on Friday and pulled it too and from the lake ( 2.5 hours each way). The boat is 21 feet and weighs 3000 pounds empty, no gas. The trailer is a bumper pull. I was pulling no more then 4,000. Under 50 mph everything felt fine. At times when going over 50 the truck was shaking. It would happen and then stop. It does not seem to be coming from the engine.
It would happen up hill and down hill. I was thinking it was just the vibration from the boat, can a load that size make the whole truck shake?? Also the truck made a horrible clunk after backing the boat down the ramp and pulling it back up. It happened when I took the truck out of park into drive. This can be something other then the transmission???
View 12 Replies
My wife backed the truck into a pole and bent the driver's side bumper and one of the ears on the trailer hitch (the part that bolts to the frame). I bought all the parts that need to be replaced (the left bumper end, the hitch itself, and the plastic bumper cover), gut am hesitant to try to change it all myself. How hard is it to change out all these parts? Is there a write-up any where out there for this?
View 2 Replies
I have read and re-read the owners manual fuse section. Can't find what fuse I blew. I do not have trailer brake or turn signal on either side. I do have running lights on the trailer. Which fuse or fuses control the brake and turn signal lights on a 2012 F-150 ecoboost. I had them all a month ago, but bought a new trailer and first time I pulled it the lights went out. Figured I blew a fuse, but can't find the one! No power at the receiver.
View 7 Replies
Hooked up to my trailer and I have running lights but no turn signals, brake lights, or trailer brakes. I pulled plugged in my other vehicle to the trailer and everything works fine. My truck is a 2011 with the factory trailer brake control and pigtail connection. It worked fine last year.
I checked the connector with a test light and there is only power to the running lights. I then disconnected the plug at the back of the trailer connector and tested there and got the same results. Are there particular fuses or relays I should look at?
View 4 Replies
2010 F-150 owner. Why my left trailer-stop/turn will not work on any of my trailers. This issues has happen to me in the past due to a wire grounding out in one of my trailers, I have fixed the issue in the past by changing the 20amp trailer/tow fuse, this time the fuse looks fine and I am still not having any luck finding the issue. I have went through my manual to see if it could be a different fuse and they all seem to check out ok, I have also messed around with the relays and they seem to be fine too?
View 2 Replies
F150 2011 3.5L Ecoboost. Where is the transmission dipstick?
View 14 Replies
Just returned from an 8500 mile travel trailer trip with my 2012 F150 with EcoBoost. Couldn't be happier with how the truck performed. Did discover, however, that my 7-pin connector does NOT charge trailer battery while driving. Wasn't a problem this trip, but could be an issue when dry camping (no electrical hookup). Is it a big deal to get my connector to charge trailer battery while driving?
View 14 Replies
On 2010 150 had running lights for approx 1 year on both 4 wire and 7 wire then none. Nothing changed, Checked fuses, all ok. Checked on back side of plug, nothing. Everything else works.
View 14 Replies
Setup my Reese brake controller on my 2011 today. The lights, turnsignals, and brakes work when I push the brake pedal. But when I move the lever on the controller, I get nothing. Also, on the info screen, it still says trailer disconnected. What gives?
View 5 Replies
Noticed today in the snow, I was pulling out of the driveway in 2H and the rear tires broke loose, weird sound coming from the front end like the truck was trying to engage the 4 wheel drive but it wouldn't go in. Traction control? Threw it in 4H and the sound went away????
View 1 Replies
I have a new 2011 F150 4x4 6.2 liter with about 1200 miles, 6R80 6 speed Transmission. I haven't liked the shift quality since buying a little over a month ago. I think the upshift from first to second is kind of rough and it feels like it's slipping a little from second to third gear. I've read a lot of negative posts/reviews on the 6R80 transmission, and some people have said it got better over time, or it got better with more aggressive driving. I do notice it shifts better if I drive it a little harder. The build date according to the sticker is 4/11 and I don't think there are any TSB's for PCM updates for this year/engine/model. I'm wondering if I should bring the truck in now for the dealer to take a look or drive it for awhile longer to see if it gets better?
View 7 Replies
I've got a 12 FX4 SC 6.5' w/Ecoboost. After 1K miles I began to develop a shudder/shake in the tranny-driveshaft passing through 1500 rpm. 4 dealers, 6 overnights and 2 escalations, I finally am told there is a design problem in the pre Jan 12 trucks. Fixed with frame mod to manufacturing process after Jan, but no solution for current owners with the problem. I replaced my 07 FX4 SC with this truck and loved it for the first 1K miles. Now I hate driving it, especially in traffic (lots of cycles through 1500 rpm).
View 5 Replies
2000 7.3 180,000 miles. It sounded like I was in passing gear from the turbo but not as loud or strong. The tach never moved like it would if it was in passing gear. We kicked it in and out of overdrive, pushed the O/D, no change. Then while driving it would just go quite/back to normal. Oh forgot, this was while pulling a cargo trailer with a total weight of about 4,500 lbs...
View 5 Replies
i have a 1997 f150 2wd and it has a 4.6 litre v8, it runs good but it seems to have no power when pulling a trailer anymore, it has 321,465 miles on it, original motor and transmission, it uses about a half a quart of oil every 2500 to 2800 miles between oil changes, the trailer i pull is just a small car trailer i have always pulled it with the truck, what could be causing it to lose power?
View 1 Replies
