2014 crewcab lariat 4x4. Here is the question. This is only when I'm backing
it up and only after putting truck back in drive do I get the steering wheel whine. It sounds as if it is low on fluid. Only last for a seconds or two. Could this be the start of a steering problem or possibly a brake issue? Just throwing this out there.
I'm having some strange action in the turn where sometimes it "sticks" and also I sometimes get a loud whining sound for 10 seconds or so and I believe it's coming from the power steering but I could be wrong.
I know my ecoboost has an electronic power steering system but that's the extent of my knowledge on it. Does it have a pump anywhere in the system that could be making this whining noise?
124,+++ miles, no real issues, runs like a champ.
Have noticed lately 2012 4x4 sc with 42,000 k has a slight vibration I guess you would call it you can feel through your fingers at certain speeds. I looked and felt tires which are at approximately 4,000 k from being new and they are wearing on the inside, going to rotate and have it aligned asap.
View 7 RepliesMy steering wheel coating is wearing off and the under material is wearing out. 2009 ltx f150. How many others have this also?
View 8 RepliesJust bought a spotless, low mileag
View 9 RepliesIs there a way to move the wheel higher than the highest setting? I like to keep the seat at its highest and its difficult getting in and out of the truck.
View 9 RepliesIs the steering wheel on the Ford F150 Platinum leather and wood, or is the top portion of the steering wheel plastic?
View 1 RepliesHaving intermittent clunk felt in the steering wheel? It happens at random and not necessarily over bumps. You don't hear it as much as feel it in the wheel.
View 3 Replies2009 FX4... Every once in a while, I'll feel a vibration in the gas pedal. It happens under acceleration, and typically if I'm pushing down and it has not downshifted yet. Then once it downshifts the vibration is less noticeable.
I have had the mechtronic unit replaced due to harsh shifting and the vibration was there before and after that was replaced. The drive shaft was also replaced due to a click/clinking noise and the vibration was there before and after as well. The harsh shifting and clinking noise was fixed with those repairs, but the vibration is still there. I notice it more when I am towing.
My neighbor has a 2010 or 2011 Screw with only less than 10K miles. He complains that the steering wheel vibrates when he applies the brakes; not all of the time, but most of the time. Could it be pads/rotors? With this mileage, and no stop and go traffic, I cannot believe it would be the pads/rotors.........
View 6 RepliesI have a 2014 FX4 Ecoboost with 2K miles. While driving in a straight line on smooth roadway I feel a slight 'clunk' in the steering wheel. Feels a bit like slack or something. It only happens when the steering wheel is in perfectly neutral position ( straight up) with no turn to either side. Oddly I feel it more when I hold the steering wheel in the lower half as opposed to the upper side. Could it be 4X4 play or splines or loose something in chassis?
View 14 Replies2011 F-150 Classic Sync w/ satellite factory radio. A few hundred miles over warranty the radio controller side of the steering wheel buttons has randomized, where the buttons each do a different function, but none of them turn the volume down. Volume Up changes the source, volume down = up, etc. The cruise control side seems to still work.
I have disconnected the battery cable and also done a software reset on SYNC. Read on on other forums to disconnect the air bag and open the steering wheel to spray electrical cleaner in there, or for other radio problems to pull fuse #2. Is this a ghost in the machine type issue?
Also, I have had the truck in for service one time already for the driver door speaker fading out when turning right at specific volume levels. They put in a new speaker which resolved it until the warranty ran out and now it happens again. Could both of these be indicative of a bad radio, or deeper wiring problems?
My Steering wheel is losing the outer coating. is this been seen before?
View 12 RepliesMy '11 has almost 60,000 miles on it and I've turned the front rotors down once already for a vibration at 42,000 miles. Front pads looked good at that time, but I'm pretty sure the brakes are otherwise all original (2nd owner). Not feeling it in the pedal but starting to get a steering wheel vibration when I touch the brakes above 60mph and I figure they will be getting due sooner than later- though I still have not pulled the rears down to check them.
Whats the consensus on replacement brake parts? Is OEM the way to go? I figure any decent ceramic pad set should be fine but what about rotors, OEM, raybestos, wearever, etc? I know everybody wants USA made but realistically price is a major factor. I can get Raybestos advanced rotors and pro pads shipped from rockauto for slightly more than wearever pads and rotors from advanced- is it worth it? Or are the OEM rotors notably more durable?
Keep in mind this truck sees light to empty loading 99.5% of the time and the stock front rotors needed turned at 42,000 and are starting to show signs again at under 60,000.
I took my truck to the dealer because my steering wheel buttons quit working as far as going forward or back between songs via bluetooth. The tech said the buttons don't work via bluetooth from the factory and I told him he was wrong. They worked in a 2007 Edge, 2008 F150, 2009 Fusion, 2009 F250, and until the day before, my 2012 F150. He said "You must be mistaken". I took it home, pulled Fuse 2 (Sync) waited a couple of minutes (Nice place for the fuse box, Ford) put the fuse back, let Sync load, repaired, etc, and my steering buttons now work again. I only use bluetooth with both my S3 and Note 2, so if your buttons stop working, do you always have to pull the fuse, or is there an easier way to fix this? That's the fix I found.
View 8 RepliesI have 2010 f150 when I turn my steering wheel all the way in one direction and I press the gas from a dead stop like at a stop sign it makes sound like metal rubbing together slit vibration with shaking(like the back wheels having a hard time keeping up) from the back end. i took it to a shop they look at it. They took apart the transfer case and re-lubed what was in side told me it should go away in a couple of days. I live in winter climate when it's below freezing it works no problem without any sounds.
View 1 RepliesI took delivery of a brand new 2014 4X4 Lariat this weekend . While driving home I noticed that the leather on the steering wheel was loose and wrinkled around the lower right spoke of the steering wheel. It looks like the adhesive they use to glue the leather to the wheel was never applied to that portion of the wheel. It's so loose that I can press it with my thumb and double the leather over...
View 13 RepliesI have a 2009 screw with ~60k miles. It is used for DD and tows our small camper or my flat deck w/jeep.
The other day I noticed an issue when turning right. The wheel gets hard to turn and does not want to return to center. There is also a low speed clunk you can feel in the steering wheel/column itself.
The truck is at the dealer now and they said the rack needs to be replaced and there is something in the column they need to replace too. I have the extended warranty, so this is all but covered 100%. I just have a deductible to pay.
I have not hit anything with the truck, so I am not sure what caused these issues.
My 2013 Lariat has just over 7,000 miles on it now. If you brake lightly at 55-60 you get a brake shutter, enough to feel it in the seat but also can see the steering wheel shake too. if you brake a little harder you don't feel the shudder much. is it possible to warp rotors in 7000 miles? 3500 of that 7000 was put on driving to Texas and back.
View 14 Replies5.0L ... I'm having one of those moments, you know after you do a mod to your truck and all of a sudden you notice something about your truck that could have been there all along but now you notice it as something new? Ok earlier in the week I had my exhaust resonator removed and replaced with a straight-pipe by a reputable exhaust shop. IMO the work looks to be pretty good for what it is.
That said I have always been nervous about getting exhaust work on any vehicle because it always seems like tampering with or removing the OEM plumbing for aftermarket or custom work tends to develop a vibration at some point.
So here is what I've noticed over the last couple days, when driving my truck it is extremely smooth, almost like glass. When I come to a complete stop say at a traffic light about 1-2 seconds after making the complete stop I feel this slight harmonic vibration in the steering wheel. For those of you that have an iphone it would be like having your phone bolted to the steering shaft somewhere and it on constant vibration if that makes sense.
Just to prove it only happens when I'm sitting still and idling in (D)rive I sat in my driveway with the truck idling, set the park brake and released the brake pedal holding the truck in place in (D)rive with the parking brake. No vibration, smooth as glass engine idle, as soon as I put my foot back on the brake pedal the vibration comes back. It's as if the extra draw of applying the brakes puts an extra load on some sort of accesory drive or componant under the hood and the result is this harmonic vibration.
Just so everyone knows, the vibration is very noticeable to me because I drive the truck daily, most people wouldn't pick it out if I didn't tell them first. Case in point if my wife drives the truck she can't feel it unless I tell her what to look for. There are going to be some of you that just say my truck doesn't do this and has had a smooth idle for XX,XXX miles I believe you but let me know now that I have explained exactly what to look for. Like I said for all I know it's done this since day one.
I have a feeling that the straight pipe might have been welded in slightly longer than the oem section that was removed thus putting more tention on the exhaust and engine if that makes sense, the end result being a slight vibration?? I know that manufactures put these little rubber bushings along the exhaust system on cars/ truck to absorb harmonic vibrations and for all I know my resonator might have been designed to balance out harmonic vibes in the exhaust system as well as quiet down the exhaust.
I have an issue with my new 2011 F150 FX4 super crew with 5.0. I put a Rough Country level kit on the front struts which raised it 2.5 inches and looks great. The issue is that there is a low speed knock heard on the left side and felt through to the steering wheel. The truck has been aligned to factory specs. all bolts have been tightened, the strut has been taken off to check the top mounting bolts. Nothing appears to loose. Can't find anything. Am I forgetting something. Rough Country said it can't be the kit. It has bee used for sometime with no issues.
View 14 Replies