Ford F-150 (2009-2014) :: Sharp Snap / Crack Or Bong Sound From Front Suspension
Sep 10, 2015
On my 2012 F150 Supercrew 4x4, when I'm entering parking lots, or other places where I'm turning and going over bumps at the same time, the front suspension make a fairly loud sound. It seems to be much worse when turning left, and the sound comes from the Passenger front side, I think.
The sound is a fairly sharp "snap" or "crack" or maybe even a "bong" kind of thing. So all you keyboard mechanics. As a bonus question, once we have guessed what it is, can I fix it myself with hand tools and very little mechanical aptitude?
View 7 Replies
Advertisement
I've got an '12 F-150 with 7k mi. on it. It developed a squeak/creak noise about 1k. mi. ago. It comes from the r. front suspension area and I noticed it one morning leaving from work. It occurs under suspension loading/unloading and it only happens during cold and dry conditions. It won't make the noise when it's wet or damp outside. I've had it at the local dealer 2 times now and they can't seem to locate it. It sounds like rubber on metal or when the 97 & 98's had the dry tie rod ends or ball joints problem. They are reluctant to throw parts at it to try and eliminate it and I agree with them. What were the findings?
View 5 Replies
2003 passat gl; 1.8t w/all new front control arms, replaced to cure suspension noise, now metallic clatter persists, but any (even) light application of brake pedal and noise stops.. it is most apparent over sharp bumps...
View 3 Replies
Since we took ownership of our 2009 v6 there has been a rumble when going over bumps in the road. A certain amount of this I have put down to the big alloys and low profile tyres, but have always suspected that there was something else amiss.
Today I took her into our local Phaeton garage and asked them to investigate. They has hinted at worn drop links. However after checking everything out in the ramp they can find nothing wrong. They even replaced one if the drop links (whatever they are).
So they came up with nothing wrong but could still here the rumble when driving over un-even surfaces. When I change to sport mode I think the rumble gets less, where to look or what could be wrong.
View 3 Replies
09 stx 2wd 4.6L- I have a 2.5'' leveling kit and 33'' bfg a/t tires. The problem is when I make sharp turns, or turn and go over small bumps. Whats happening is something seems to catching or rubbing it kind of jerks towards the opposite of where I am turning and causes the traction control to slow my truck (sucks on tight off-ramps/ u-turns). this happens at pretty much any speed although it gets worse as speed increases. At first I thought it was the steering stoppers but don't have any wear on them, tires do not rub anywhere. My dealer and a local off road shop cant figure it out...
View 9 Replies
Last winter I had a moaning sound in my front end when slowing down to a stop when the temps were around the freezing mark. When it would happen, sometimes i would engage the 4WD and it would go away, and come right back when disengaging the 4WD. I took it to my dealer and Ford's procedure was to re-pack the front wheel bearings. When I got the truck back the weather warmed up and the moaning didn't come back. When this winter started and the cold weather came back, so did the moaning in the front end when slowing to a stop.
I took it back to my dealer again, and this time they checked what I suspected all along, the IWE's for the 4WD (the integrated wheel ends). the seals were cracked, letting moisture and rust formation inside of them. After the IWE replacement, the moaning noise went away. My research has found that this problem goes back to around 2004 on up. If has these symptoms with the 4WD truck in the cold weather, have your mechanic check out the Integrated Wheel Ends. By the way, my oldest son is the Ford tech that performed the repair on my truck, so it was in his best interest that my truck was fixed .
View 1 Replies
2014 FX4 F. Got 6000 miles on the truck, front tires are wearing on the outside edge, and also when turning the wheels to the max in either direction I get a loud creaking sound,??
View 14 Replies
Curious, how does the 4x4 engage in the new F-150's? When I put the truck in 4WD I can here the click sound coming from the front axle, where as it comes from the t-case on my Ranger. Just wondering how it's set-up.
View 5 Replies
So I got this rattling sound like a piece of tin rattling underneath the truck, it is coming from the front of the transmission area. About 6 months ago the same thing was happening so I took the truck in for some other warranty work and had the dealership check out this rattle. When I picked the truck up I asked and they said it was rocks/gravel caught up underneath and they took them out and the rattle was gone. The truck is a 2010 FX4.
View 12 Replies
Took my 2010 Corolla in to have it looked at since it has recently developed a clicking/thumping sound when I make a sharp right turn (it's intermittent, but frequent enough to be noticed).
The shop I took it to said the source of the noise was the CV axle, but that after inspection, they didn't see anything really wrong with it, so they recommended simply putting up with the noise to save money, and to keep an eye on it and replace it if/when it actually begins showing signs of significant wear.
View 5 Replies
When maneuvering our LS forward or back, we hear a BONG sound as if you were plucking a violin. The Lexus dealer says it's due to the fact that the accelerator pedal is designed differently from previous versions. Why should we be satisfied with an LS460 that makes constant noises!!!
View 2 Replies
I have a 1996 Saturn SW2. When I turn hard left at a bit of speed (like about 20 mph), the left read end of my car makes a BOING sound... what could be causing this??
View 2 Replies
Almost every morning, when I put my car in reverse and then step on the accelerator, I hear a sharp "clink" sound from the front of the car. After I've backed from the driveway to the street, I put the transmission in drive and step on the accelerator again and often hear the clink again. It doesn't happen EVERY time, but has become very common in the mornings. It only started doing this within the last month or two. I haven't observed any other problems.
The car has about 80k miles on it and has not had any transmission work done.
View 2 Replies
Sometimes when closing either the front driver or passenger door, it seems as though the door is not closing properly and it sounds like the latches are striking metal against metal. The doors always close and the noise does not occur all the time, in fact it occurs on a very seldom basis. The noise is very annoying and definitely does not sound right. I can not repeat the problem at will and I fear the dealer will not be able to locaate, unless it happens just as they close the door. The doors do close tight, but the sound is awful (sharp metal hitting metal sound).
View 2 Replies
My 2003 Jetta GLI was making a terrible grinding/knocking noise when i would turn and occasionally make this "Bong" sound especially when reversing. I took it to my local shop and they say my spring in the front left is "either broken or unattached" and that i need spings/struts. I have like 150k miles on this car so the timing is probably right. So my question is, how much should they charge for this? Also, what should i have them order and install? Im not trying to lower or anything like that, OEM or a slight upgrade is what im looking for....
View 9 Replies
2004 PSD 4x4 72k. I thought I would be proactive so I bought the front ball joints and have plans to install them but recently I starting hearing (and feeling) a clicking sound in the front LEFT when I make sharp turns to the left and hit small bumps now and again. I jacked up the front end and am able to get 1/4" of movement front to back (top to bottom so not steering) in the wheel.
I narrowed it down to the hub. I took it apart and it is most likely a sealed unit so no adjustment is possible....that I can see.I pulled out the locking hub and got as far as I can to know there is not an adjustment. Need to confirm that it indeed is a sealed bearing and if so what are the part number(s) I may need to repair it.
View 14 Replies
What is the tool part number for a good pair of snap ring pliers that are heavy duty enough to remove the snap ring from inside an 05+ 4x4 front hub? I have broken two pairs of regular snap ring pliers attempting to remove it. The snap ring itself is roughly 1/8" thick and copper plated. It really wouldn't be that difficult to remove, but that collar on the spline that it has to pass over is thick too and it is whipping me something serious.
View 5 Replies
I too suffer from the "suspension" noise whenever running over a sharp speed bumper. Today I took some pictures under the bumper, wow, what a mess! I don't think all the solutions people posted on the other post could solve the problem, it's rather a design flaw than an problem. This should be a recall.
View 3 Replies
Took my engine cover off and now trying to snap it back on and I can't seem to find the points where it clicks back into place. The top middle has a latch but my bottom half especially the right side is loose and I can't figure out where the snap into place points are.
View 2 Replies
I broke 2 snap ring plier on this thing, what is the make and model of snap ring pliers used to remove the snap ring off axle in hub ? I have some others but too beefy won't move in there. They need to be long but strong. I've heard Snap On Item: SRPC9000A works but I don't know of any Snap On guys around here and I need to get this thing done.
View 10 Replies
I recently picked up a new 2015 Lexus IS 250, AWD with the F Sports package. I'm about to hit 3K miles on the car, and love it so far - only issue is I noticed recently that the front suspension seems to make a squeak when going over bumps at lower speeds (i.e. a parking lot, etc).
View 1 Replies
