2010 4x4 F150 Lariat 5.4 L, have been working on throttle response problems off and on for a few months. Initially got p0404 codes, and replaced the accel pedal assembly, now graduated to p2135 code, and stall at idle after a highway trip. Wondering if this may be a issue with aftermarket air filter causing misread errors on sensors. Had it to the dealer, with out any real remedy.
View 2 RepliesI have a 2013 with the 3.7 in it with 24,000 miles on it. I bought the truck used with 8,000 on it was a pre-Owned certified and it already had a k&n air intake which I know it's not needed and I would much rather have the factory intake instead.. 7 months ago I took it to the dealer because I noticed at stop lights it idled rough sometimes almost feeling like it was going to stall out so I took it in and they said that the motor was getting to much air and causing it to run like it was and they said the cooler weather was making it worse and said it should get better when it warms up and they said it wouldn't hurt anything... Well I live in Florida and it's been in the 90s and it still idles like crap you can feel the vibration through the truck...
And it's so aggravating and annoying and I wish I had a stock intake that I could install on the truck to see if it fixes the problem but I don't and I've researched the problem and have seen people with the same issues without the k&n air intake and I've also been told that the stock air intake gives the motor just as much air as the k&n so with that being said did the dealer take the easy way out and blame the intake or should they be responsible for installing the factory intake back on since they made it a certified pre-owned with the k&n on the truck? It's been frustrating because I don't know a whole lot about gas motors.. And I'd like to get the problem fixed while I still have warranty ..
I have a 2011 XLT 5.0 V8 with 133,260 miles. I have extended warranty for the next 12,000 miles...which is great because I drive about 400 miles a month... Anyhow it runs great but for one small issue (hopefully) that has been intermittent.
She likes to idle slightly rough in drive at a stop or very low speed, and in reverse at slow speed. If I don't maintain the RPM it will stall and the low oil pressure light will come on, which I imagine comes on because of the sudden stall.
I first noticed this while backing into my garage in the driveway, It would fluctuate in RPMs and if I didn't maintain the gas it would shut off. I took it to the dealer and all they were able to tell me was the Tranny fluid was low and it would cause it to shut off at incline because a sensor isn't detecting fluid in the tranny. I thought this was weird but being as I have never owned an F150, I didn't know better.
It was fine for a little over a month and it started doing it again at stop lights and backing into my driveway. It has become frequent but there is no issue driving at speed and on the freeway. There is no stuttering or shaking and if it weren't for the fluctuating RPM at a stop and the stalling, it would be hard to tell if there was an issue.
All I can note is that there is a clicking sound under the hood, if I remember correctly the last time this happened I was at a 1/4 tank of fuel like I am now, I also feel like it may be a throttle body issue, or some sort of air sensor, I plan on taking it to the dealer but I figure I would get a more informed answer on the forums.
I also hear this is a common issue with the 5.0s... I purchased the truck in December and since then I have only put 250 miles on it.
I have a 2012 ecoboost, recently I went to the trip gauge mode and the display screen for trip A had a yellow rectangle imposed over the time,mpg ect.and would not function correctly. When I switch to trip B info, all info operated correctly and no yellow rectangle in trip B mode. Trip A mode continues be inoperable and still has the yellow rectangle even after the engine was shut off several times during the day.
View 3 RepliesThrottle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not diagnosing. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. If you find yourself in this situation I show you how to change the throttle body and reset the pcm to learn the new idle trims.
Ford F150 F250 5.4L 3v Electronic Throttle Body Replacement P2135 - YouTube ....
I've read through my manual, but can't find anything on how to actually lock the odometer at zero when I don't need it. Trip A is set to my oil change mileage and I just want Trip B to be off or at zero. 2012 F150 XL SBRC, 5.0 V8 4x4, 3.55 gears....
View 8 RepliesI have a 2012 5.0 with about 1500 miles on it. I have noticed occasionally on start up that it feels like it is trying to stall? I give it a little gas and it goes away.
View 14 RepliesThrottle body failures on the 5.4L 3v are more common than you think, luckily it will pop a code for the throttle body more often than not working with diagnosis. Symptoms include start and dies, no start, a really rough idle, surging idle up and down more so in park, poor brake assist due to rpm fluctuation and wrench light on. How to change the throttle body and reset the pcm to learn the new idle trims. [URL] .....
View 2 RepliesMy 04 F150 has started having a rough idle. While in park the engine will stall out with the A/C off. Also when in drive the truck will idle close to 1000rpm's. I had to the fuel filter cleaned and also the MAF sensor cleaned. Also did a vacuum check on it. Pulled the code and it's throwing a Lean Code. What else should I be looking for?
View 12 RepliesBack in March I started a thread regarding my 04 Santa Fe 3.5 which would not start after a spark plug change.
After a ton of research, & a smoke test on the intake I came to the conclusion that there was an issue with the throttle sensor as I unknowingly opened it when I was removing the intake to get to the last bolts behind the manifold. Shortly after my post, I decided to bite the bullet & buy a junkyard TB out of another Santa Fe 3.5.
After installing the new TB, the car now starts but runs extremely rich. I am now getting the code p2135 for Electronic Throttle Control System Malfunction.
Luckily up until this point I haven't needed the Santa Fe as it is mainly a winter vehicle. However, winter is quickly approaching & I would like to have her running before the snow starts to fly.
I've had this 2012 for several months now but have never really romped on the throttle until yesterday's road trip (not a lead foot driver).
I was driving on the highway at about 55 when I needed to pass so I floored the throttle and - the truck bucked like a wild horse and the power dropped to a low acceleration. Once I backed off the throttle to about half-way the engine took off like "normal".
These symptoms were repeatable throughout my entire 500 mile trip. Is this a known issue with the EB?
I'm a converted Chevy man and I don't think my 2011 F150 FX4 is cold enough. I am getting 46 degrees at highway speeds and outside vtemp is 77. My Chevy always get 38-40 in the same situations. What is eveybody getting? Is this normal?
View 10 Replies2010 F150, 165,XXX miles. On a bridge, at highway speed, the transmission locked up and locked the rear wheels. Everyone is OK, but scared the daylights out of my employee and a customer. Bad situation.
After putting it in park, and restarting, it seemed OK. We towed it to the dealership who replaced what I believe was a control chip on the transmission. Dealer said it is a known problem, and they aren't sure if the new controller would fix it?? They would not guarantee if the new controller would prevent the issue (per Ford).
I run a fleet with 7 F150's in it, and this employee is concerned about driving it. I have 3 2010's in the fleet. I am trying to figure out if this is limited to 2010, an incompetent dealer, or?
Lifting 09-13 F-150 with the two piece drive shaft. I am getting a lot of vibrations at highway speeds(55mph or higher). I have a Pro Comp 6 inch lift that was installed while I was stationed in Alaska. I have the drive shaft spacer that goes on the drive shaft at the pinion. I also have a carrier bearing drop kit from BDS that I am currently experimenting with (trying to find the sweet spot). I am at a loss though because my truck is no longer fun to drive. I drive an hour to work one way and it blows that my truck feels as though it will rattle apart. I have tried doing all the research that I can find about this issue.
View 14 RepliesI have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 RepliesI have a 2014 screw 4x4 v8 that has been in the shop 5 times now for something that the dealership can't duplicate, and that is intermittent enough for me that I can't determine what the conditions need to be in order to duplicate it myself.
My transmission will shift hard under two different situations:
1) when rolling through a stop, or a momentary stop at a stop sign, the transmission holds up between 3 and 1, and when I bring the rpms up, the transmission shifts down into 1, making a hard clunk;
2) at highway speeds, more so when using cruise, if I accelerate and the truck shifts down from 6 to 4, there will be a hard shift as well. In fact, when I'm on a long stretch of flat, open road using cruise at 70-75, I can feel a slight bump through the steering wheel and floorboard, as if the cruise is trying to engage the throttle a bit more, but only for a split second. But that will happen quite a few times within a couple miles until I come up on a grade and the throttle has to engage for a bit longer to keep speed. Sometimes, the hard shift will do occur going to 5 as well, but 90% of the time it will be a 6-4 shift. If the truck decides to shift from 6-3, there's no issue and it shifts and accelerates like it should.
Again, this is so intermittent, but when it happens, it happens several times. I've had the service tech ride in the truck with me, all the while not being able to duplicate the issue. I understand that these are learning transmissions, so the only thing I can think of is when I try to duplicate it by accelerating over and over, that the transmission adjusts the shift pattern or fluid pressure to compensate.
I have a 2010 F150 XLT crew cab, and I'm the second owner. Ever since I have owned the truck, it has had a pretty bad shake/vibration at highway speeds, that gets worse with higher speed. I have checked the alignment multiple times, rotated tires, had them re-balanced, and I still cannot figure out what is causing this. What else should I be checking?
View 14 RepliesThis morning (roughly freezing temperature - nothing out of the ordinary after the brutal winter we just had) got onto the highway to head to work and set the cruise control (as normal) at approx 110km/h (65mph) and after several seconds heard a distinct, quite unpleasant grinding noise. It was loud enough to be heard over the heater and radio. Turned the heater and radio off to listen closer and didn't like the sound of it - sounded like metal on metal.
There was no different feel in the floor, pedals or steering wheel. As soon as I turned cruise control off, the noise disappeared! Turned cruise control back on, and the noise returned approx 5 seconds later. If I continued driving along normally and sustained a certain speed, the noise would appear after 5 seconds again and only go away once I lifted off the gas or coasted down a hill... Very bizarre. Once I got to work and poked my head underneath didn't immediately notice anything out of the ordinary - no funny smells or anything...
Background info: 2011 FX4 ecoboost, crew cab. Stock, no modifications. Approx 134,000km (~80,000 miles)...
I have a 2010 ford f-150. My fuel door swings loose and the cover came off on the highway. Where I can get another one? I need to replace the whole thing.
View 2 RepliesI have a 2012 4x4 EB CC. In 6th gear, on the highway between 1200-1700 RPM's, during a slow acceleration, it feels like it is missing or shuddering. It is most pronounced going up a hill, and/or towing something. As soon as you get above about 1700, it goes away. Rig needs to be fully warmed up (not just the engine, but tranny/drivetrain). Needless to say, this is generally from about 52-65 mph, which is most highway (not freeway) driving I do. At times it's so bad my wife says it's time to get a Chebby.
Had it in about a year ago, couldn't duplicate it. Took it in this last week. Did the TSB on the plugs, and was told that would fix it. It didn't. Took it back in; they couldn't duplicate the issue. Rotated the tires hoping that might do something. Took the head service guy for a ride, and made it happen; it was very obvious then. It seems like the tachometer should bounce or shudder a bit when it's doing it, but nothing. It's going back in on Monday to see what they can do.
The past week I have noticed my battery cooling fan running constantly on all highway trips - 20 mile one-way trips going 65-70MPH.
The performance of the battery doesn't seem be degraded, but it seems like the battery is hopping more between charging cycle or whatever you would call it , where you watch the instantaneous MPG on the highway drop down for 10 seconds to 40-50, then back up to 60-70.
The car is a 2011 Prius III. It did not run like this earlier in the summer in the same weather conditions, I would hear the fan maybe once every few weeks in hot 90 degree weather. Now I hear it constantly. This is my first summer owning the Prius so this may be normal, but I wanted to double check with you all if this is a sign of premature traction battery death or something.