Ford F-150 (2009-2014) :: Oil Level Slightly High After Change
Jan 26, 2017
2014 F150 3.5 Ecoboost...
I recently got my oil changed at the dealership and yesterday when I did my periodic oil check, I noticed that the oil level is slightly higher than the "high" mark on the dipstick. Its about 4mm above the high line, maybe 5mm at most. I do not smell gas in the oil, and given that its been about a month since the change, I simply think that slightly too much oil was added.
My question is will a slight overfill like that affect this engine? I'm particularly worried about "frothing" of the oil by the crankshaft. I don't think that oil level is nowhere near to be "pushed" by pistons and affect my seals. Correct me if I'm wrong here. I drive on very flat terrain. So the question to those that have knowledge on how much clearance there is between the crankshaft and oil level in that engine is, do I leave as is or go back to the dealer to adjust. (Reason I ask is because I'm particularly busy with a project at work, and if I don't have to burn time to correct this I would rather not given my busy schedule.)
View 1 Replies
Advertisement
The other day my father and I were driving around town in my pickup, he kept looking in the side view mirror and finally he told me he thought that my bed was not exactly in-line with my cab. When we got to our destination we both got out and looked, and sure enough the bedside protrudes maybe 1/2 a centimeter out on the passenger side where the bed meets with the cab.
This isn't really a great big deal, I mean I've owned this truck for just a hair over two years now and I never noticed, That's how unnoticeable it really is. And do you think this is worth taking it to the dealer for?
I mean, I feel like I'm being a stickler here...It's not noticeable unless you are really looking hard for it as in staring directly down the length or the pickup, and even then the bed looks lined up except for the slight protrusion on the passenger side.
View 14 Replies
Occasionally, under the right conditions, my turbo seems to surge...meaning I can hear, and feel the turbo kick in and out...kinda like it is right on the threshhold of not knowing if it needs to kick in out not. This usually only happens when I'm cruising along and just slightly give it a little more gas. Otherwise it seems fine...plenty of power etc. What could be going on here...just the nature of the beast??
My truck is a 2011 F150 Eco Screw 4by....
View 1 Replies
I have a 2002 Ranger that I adjusted the torsion bar so the front end sits level. My dad has a 2007 F150 XLT that doesnt appear to have a torsion bar. I am looking at trading for a 2010-2012 F150. What year did the F150's stop having torsion bars? Do ALL F150's not have them or does it vary by trim package? If I were to buy a 2010-2012 F150, what would I have to do to make the truck sit level (raise the front end)?
View 8 Replies
I recently bought a 09 F150 Screw short box. I just hooked it up to my camper for the first time and was measuring height on the corners of the truck to check my WD hitch. I noticed that the driver's side was higher than the passenger's side in the back of my truck. I checked again without the camper on some level ground and found the same thing - approximately 1 1/4" difference at the wheel wells and about 3/4" at the frame. I can't believe that this would be normal, so trying to figure out what happened here - maybe it got rear-ended?
View 6 Replies
2012 F-150 ecoboost oil level rising up to 1 qt over full. Took it to the dealer, They are installing a block heater and a new vent line. Cannot see what a block heater is going to do for me in a warm climate. I will let them do there thing and see what happens. 24,000 mils on the truck and warranty runs out in Dec 2015.
View 14 Replies
When I press slightly on the accelerator just to get the truck moving and than let off the engine stays at the higher RPM typically just over a 1000. This only happens in drive not reverse and everytime I just slightly step on the accelerator. The truck only has 1K miles on it.
View 14 Replies
I have a 2011 XLT 5.0 V8 with 133,260 miles. I have extended warranty for the next 12,000 miles...which is great because I drive about 400 miles a month... Anyhow it runs great but for one small issue (hopefully) that has been intermittent.
She likes to idle slightly rough in drive at a stop or very low speed, and in reverse at slow speed. If I don't maintain the RPM it will stall and the low oil pressure light will come on, which I imagine comes on because of the sudden stall.
I first noticed this while backing into my garage in the driveway, It would fluctuate in RPMs and if I didn't maintain the gas it would shut off. I took it to the dealer and all they were able to tell me was the Tranny fluid was low and it would cause it to shut off at incline because a sensor isn't detecting fluid in the tranny. I thought this was weird but being as I have never owned an F150, I didn't know better.
It was fine for a little over a month and it started doing it again at stop lights and backing into my driveway. It has become frequent but there is no issue driving at speed and on the freeway. There is no stuttering or shaking and if it weren't for the fluctuating RPM at a stop and the stalling, it would be hard to tell if there was an issue.
All I can note is that there is a clicking sound under the hood, if I remember correctly the last time this happened I was at a 1/4 tank of fuel like I am now, I also feel like it may be a throttle body issue, or some sort of air sensor, I plan on taking it to the dealer but I figure I would get a more informed answer on the forums.
I also hear this is a common issue with the 5.0s... I purchased the truck in December and since then I have only put 250 miles on it.
View 3 Replies
Is there any way to check your level of the power steering fluid on a 2013 xlt 5.0,
View 4 Replies
My wife purchased a new F150 4x4 in late 09. We have driven it about 5000 miles. It is garaged year around. Her brother offered to do the first oil change but can't get the filter off. He has tried every type of wrench and has the metal body of the filter nearly completely torn off up to the rim of the filter near the seat and it still won't screw off. we are thinking that is might have gotten cross threaded at the factory and over tightened.
View 8 Replies
Opinions ranged from using the Ford on board system, which can let you go
10,000 miles, to "Ma pappy done said ya gotta git that ol' all outta thar every 3000 miles." Needless to say, we didn't reach a consensus.
So here's a different question:
3 owners, Art, Bob, and Charlie each believe in 5000 miles between changes.
Art drives 10,000 miles a year and changes it twice a year. No problem. Right?
Bob drives 5000 miles a year and changes it once a year.
Charlie is gone from home most of the time and only drives his vehicle to the airport, then back a couple weeks later. He does this once a month and it's 100 miles each way. Otherwise the vehicle sits.
So he drives 5000 miles in 2 years. Any problems there?
View 14 Replies
When should I get the first oil change in our 2013 F150 5.0? We took a 1,000 mile trip right after getting the truck. It's been two weeks and I have put around 1,600 miles on the truck.
Also, how often is everyone getting regular oil changes with the 5.0?
View 14 Replies
Took my truck in Friday for my first oil change at the dealer and they put Pennzoil in instead of Motorcraft. One would expect Ford would require their products in their sponsored dealerships. i didn't realize until I was home and placed a phone call to the service manager and have not got a return call.
View 14 Replies
OK; I give up. How do I check the trans. fluid level on my 2010 F150 6 spd. auto trans????? I see that there is NOT a dipstick in the engine compartment.
View 14 Replies
I am on top of my oil changes, but this is the first time I have seen the center display flash "change oil soon" and stay on until you hit the OK button. I went through the manual and I cannot find where there is a provision to clear the message. The oil was just changed, has maybe 600 miles on it.
2011 F150 EB lariat with 10,000 on it....
View 9 Replies
I don't have my owners manual handy for my 2010 F-150 and was wondering how to reset the "change oil soon" message that appears everytime I start the truck.
View 7 Replies
I have the normally aspirated 3.7 V6. The ownersd manual talks about the trucks computer telling you when the oil changes are needed.....But, at 6500 miles, bnothing has come through. I have not changed the oil yet on it. I feel this is a huge sin, but am not sure.....I was raised you changed the oil every 2-3 grand. But the owners manual on this truck says the computer will tell you when to. Should I just go ahead and change it?
View 7 Replies
2012 F150 STX 2wd 6spd 100kmi
I just dropped the transmission oil pan and changed the filter. Put a new filter in. 5qt of oil came out, I put 5qt of oil back in. Oil level is right between the A and B hash marks.
I start up the truck and put it in gear and nothing happens. Its like the oil filter dropped and it isnt getting oil. I dont think this is possible because i watched it go in, the oil pan holds it, the seal came out with the old filter and the seal went in with the new one.
Am I missing something here? this oil change went just as well as any other tranny oil change i have done but the thing wont move.
View 12 Replies
I have a 2012 F150 XL. I don't have a message center, just a 2 line LED readout, and there is nothing in the owner's manual about resetting the "oil change required" message.
View 3 Replies
I wanted to change oil at 1000 miles on my new 2010 FX4. The dealer said that I should wait till 2500 miles or so because it still has the break in oil in it.
Does he know what he is talking about or should I change it? He did say he would change it and take my money if I really wanted to.
Maybe my thinking is still old school about changing the oil right away with a new engine.
View 14 Replies
I have a 2013 5.0 and every time I change the oil filter the oil runs out the front and back of the cross member. That welded on oil catch plate doesn't work. The suspension is stock and I'm wondering if I lift the rear of the truck with a floor jack will it get the oil from the filter all run out the front of that catch plate?
View 9 Replies
