I just bought an FX4 and pick it up tomorrow. When you are in 2wd does the whole front end spin like the axles? Or does only the wheels spin when you are in 2wd? Reason I am asking it seems like with chevy the whole front end spins in 2wd.
View 8 RepliesWent to change the front brake pads on my 2010 F150 today which has 80,000 miles on it and is 2wd. Prior to taking the wheels off we noticed that it takes both hands grabbing the wheel and a significant amount of umph to get them to spin. As soon as you let go of the wheel it stops moving.
While changing the pads we didn't see anything that seemed misaligned or incorrect. The pistons compressed with ease on both calipers. However we did have to fight to remove the inside pad on both wheels.
After re-install wheels back on, they are still just as hard to try to spin. Is this normal if not what could be the problem and could this be affecting my MPG which i get 18.0....
I have a 2011 Tiguan 125 TSI with 4 motion and recently have been getting quite a bit of front wheel spin especially on right turns. I can hear/feel the front wheel spin and also the TCS light is coming on. When the road is wet, it gets worse. Is this to be expected? The car is 2 years old and has only 24000kms on it so am a little disappointed with this. What may be wrong?
View 20 RepliesI have recently purchased a 2011 F150 Ext cab with 3.5L ecoboost with 69k miles. I have no experience with these engines prior to now. I've always wanted a full size truck and after driving my 98 S10 for 17 years, I decided it was time for a new truck. I hope I made the right choice in going for the 3.5 instead of 5.0.
On to my question. I've noticed that the truck hesitates from a dead stop or anytime the RPM's are under 1k. It feels like its missing or running lean/rich during the spin up of RPM's. When I drive it hard, it does seem to subside for a little, and I've heard people say that they run better when run hard. I can attest to that, but is this hesitation normal for an almost 70k mile engine? I am getting 15ish MPG on almost all city driving since I have bought it, but I do expect that to change (job hunting and current commute is less than 2 miles each way).
The only time I get to open it up is when I go run errands out of the immediate local area or visiting friends and family. On one of those trips, before I noticed the hesitation, I attempted to accelerate from 60 to pass on the expressway and it bucked and resisted like a horse. It finally took off up to 80 and completed that journey with no issue but the check engine light came on for a bit. The check engine light went off when I shut it down and hasn't come back on since.
New ride: 2011 3.5L Ecoboost....
I seem to be having a issue on take off with my new Super Duty, it has the michelin atx2 tires than come on these trucks. On any hill or grade on take off she just spins and traction control flashes on dash, what the heck? Do I need to pull out the 4x4 switch to engage the e-locker so this thing will move? Seems crazy to have to put her into 4wheel when there is only a inch of snow on the ground... My 6.0 did this sort of due to all the torque it had, but that had those crap Contitracs on it till I swapped them for BFG at..
View 14 RepliesI'm an owner of a 2013 DSG Golf R. Today on my way to work, my car did a wheel spin in 1st and 2nd gear. This is the first time it did this and I don't know what caused it. For those who didn't experience launching a DSG Golf R, here is a little insight. The car would usually launch in 2nd gear in a normal driving mild push on the throttle at speeds over 5 mph. From standstill, WOT, or a strong push on the throttle, it will launch in 1st.
I was on my way to work and as usual I turned off traction control. I slowed down for a speed bump and the car was doing around 5 mph in 2nd gear. I Pushed on the throttle and as always the car downshifted to 1st. However this time it didn't hook up as it used to do; instead, I felt the car spinning its tires, upshifted to 2nd at 4000 rpm and kept spinning. I released the throttle and it went back to normal.
I tried multiple pulls from standstill on my way back to work and the car was normal. What could be the cause of this incident? My car has a stage 1 tune..
My 1996 ford f150 4x4.. The problem is with the front drivshaft it does not turn even when the 4x4 is not engaged. The 4x4 works and engages and disengages properly but when it is not in 4wd the front driveshaft does not spin freely..
View 1 RepliesReplaced rear brakes for a 2004 camry. Just decided to change out pads/rotors. Rotors were stuck on, had to use the little bolt holes to thread in bolts and push out the rotor. Time to change pads, pads came off fine but when I put on new pads and tried to put it on the rotor, the gap was too small. Seemed like a stuck caliper. Tried to remove the slide bolts, top slide bolt was fine, bottom slide bolt had a lot of resistance and would not come off the slide. Regreased it, re-assembled it and it had a lot of gap to slide over the rotor.
Reassembled everything, tried to spin the rotor by hand and it was fine. Put on wheel, lugged it down and it wouldn't spin at all. Drove it, seemed fine with no pulling but the one rotor was definitely running hotter (163 vs 113) than the other side after a 5 minute drive.What would cause it to spin freely without the wheel, but not spin when the wheel is lugged down?
I have a 2002 Ford Escape 3.0V6 with high miles. A while back the transmission on this vehicle went out while at work. I got the bright idea that I would tow it home with a dolly until the funds were available to make the repairs. We pushed it up onto the dolly and secured it. I also put it in park. It took me about a 1/4 mile to figure out what was with all the resistance (my first thought was "Dang, that sucker is a lot heavier than i thought"). I pulled over, put it in neutral then proceeded without any more problems. A junkyard tranny was put in it. Rides and drives fine. There is a whining noise that is very distinct and gets worse with increased speeds. It sounds like it is coming from the rear end. No noise while stopped.
I have checked everywhere i can reach to see if anything is hot... (thoughts were maybe a bearing) nothing found.
Fluid is full in rear end.
I just drove it and figured it would get worse or get better.
Now that winter is almost over I am very confident that the 4x4 is not working. It does not matter if you are in Auto or 4x4 only the front tires spin.
06 f150 4x4 when locked in 4 hi or low front doesn't spin and there is a clanking..... not sure what to check first.... u joints look OK....
View 1 Replies1999 f150 4x4 reg cab V6 standard, 4x4 shifter on the floor, pull it into high light comes on, front diff actuator goes in, put in 1st only back tires spin, put in reverse front and back spin (I was on a patch of icy road) I can hear a slight clicking noise maybe when in forward gear but its very quiet so could be normal? When I am underneath everything seems to be working and engaged.
View 1 RepliesMy Explorer is a 1997 with the control trac 4x4 system. It's only purpose in life at the moment is to plow snow and its been doing that quite well. I typically leave it in 4lo all the time. Every once in a while, I will switch it to the other modes to ensure they are all working.
Today I was plowing and it looks like I'm getting nothing, or next to nothing to the front wheels. There is some shudder if the rear tires begin to spin, but the front never spin, or lock up. I can feel/hear the transfer case shift when I change modes between auto/4hi/4lo as I usually do, but the front wheels just are not doing their job. All three modes are not driving the front wheels.
The transmission was rebuilt a few years ago, and it's shifting fine. I'm suspecting the transfer case. Only my OD light is flashing, but it only does that once in a blue moon. I plugged my code reader in and it could not read those codes. I was able to clear the light though.
Just rebuild my civic 2000 b4ra trans. after I install the trans back and the car does not move under all gears. the manual says the fluid should be 6.2 Qt for overhaul and I added an external filter and an external cooler should take another 1 qt (?). I totally added 6 qt and the fluid level is ok. I put torque converter upside to drain and some fluids come out. but did not count how much.
Another weird thing is that I can not push the car down the drive way with slope with engine off and brake down and neutral gear. I jack up the front and give some gas under D4 and the wheel does not spin.
Noticed that both rear wheel hubs don't spin freely, they rub or grind. 2013 Elantra sedan gets about 10% worse MPG than a 2012 Elantra we traded in for it, two identical cars yet 2012 got much better MPG and now we notice a rubbing noise on the 2013.
2013 Elantra has 19000 miles but has always had reduced MPG, markedly worse than the identical 2012 we traded, but dealer could never find a problem with 2013.
Wonder if this rubbing on the wheel hubs is to blame for the lower MPG? I can't think it works. Not sure if its the emergency brake, the power brakes, the wheel bearing or something else.
Is this rubbing noise normal? Rubbing happens with the hub only or even with the wheel attached to the hub.
I have a 2003 four wheel drive Kia Sorento. When not in four wheel drive it is rear wheel drive. On two occasions while driving on snow packed roads, I have had the rear loose traction and spin out luckily going into a soft snow bank. I have good tires, was driving about 15 miles per hour on a flat straight road and not applying the brakes. I can't figure out what is happening. So I started to put it in four wheel drive whenever there is snow pack on the roads. Typically I thought four wheel drive was only for "tough" conditions, but I haven't had a spin since using four wheel drive.
View 19 RepliesI've been noticing bad gas mileage over the last few months. I changed the spark plus, that didn't work. then I noticed the prob when I was checking my mail one day, on a slight incline and the car didn't roll back. so I took it home and checked each tire to see if it spun freely, and the two front ones do not, the drivers side being the worst. I don't here any noises coming from either tires, and have actually replaced front right wheel bearing last year.
View 21 RepliesMy car is pulling to one right slightly so I did the alignment. But it didnt eliminate the problem. Ｉ jacked up my car and try to rotate the front wheel. I can hear slight noise of the caliper rubbing the disk and the wheel does not spin freely if I stopped rotating it. However, the noise is subtle so I don't know if it is by design or I have a brake drag.
View 7 RepliesOK, so the front end of the car is on jack stands. The rear is planted on the ground. The car is in park.
Yet, I'm able to spin the front wheels with my hand.
Wouldn't putting it in park lock the wheels via the transmission?
The car is a FWD 2007 Corolla....
I have a 2000 Ford F150 lariat with the 5.4 liter engine. At least once or twice a day, its like the starter hits a bad spot and will spin but not engage the flywheel. It has a new starter, battery, and solenoid. What this might be?
View 1 RepliesNo crank with key, can jump and it will crank over, no Radio in RUN position, work fine in ASSy position. Engine will not spin over at all with key. Truck low miles like new, what gives? All fuses good and check a full 12volts on both sides. 2008 - 5.4 ....
View 5 RepliesI'm not trying to sound like some dumb kid here but it really bothers me that my truck can't spin the tires. I don't go around beating on this thing, but when my friend's 95 jeep cherokee with a bone stock I-6 can roast his tires off, its kind of embarrassing that my 570 ft lb diesel cant even get a chirp on wet ground. I do have a limited slip rear axle, but shouldn't I still be able to spin them at least a little?
View 14 Replies