I'm a converted Chevy man and I don't think my 2011 F150 FX4 is cold enough. I am getting 46 degrees at highway speeds and outside vtemp is 77. My Chevy always get 38-40 in the same situations. What is eveybody getting? Is this normal?
View 10 RepliesI have a 2012 Crew cab Silverado 5.3 V8 with the towing package. When I pull my travel trailer (approx. 5000 lbs), the water temp stays 1/2 guage and the tranny temp is 170-190, however, on steep hills the water temp guage goes 2/3 to 3/4 guage for a short time and the tranny temp reaches 200-210 degrees. Is the elevated water and tranny temps okay or should I try to reduce them back to the normal range. What is the max temp I should keep the tranny at?
View 9 RepliesPerhaps it's always been this way but my trucks A/C fan speed seems to only blow air out on speeds 3 & 4 is this normal? I have a 2011 XLT, 5L but should be the same system no matter what motor.
View 9 RepliesTemp control is stuck, but when it reaches over 55 degrees or so, it goes back to normal. Have a very slight clicking sound/feel when it is normal. Toyota wants 10 hours labor up front.
View 1 RepliesI have this info on my new F150 with the Eco. 80 deg. day pulling my dual axle 5000 lb boat 70 MPH. Temp was 199. Is this about right.
View 9 RepliesHaving issue with the outside temperature display being way off. It doesn't do it all the time, but does seem to happen if I've been plowing or something. I think I've had it happen in the summertime also, but can't remember the circumstances. Basically it must be happening because I'm not moving much air. Where the sensor is located, and could there be something that may be blocking the air flow? I know this is a piddlely little problem, but if it's easily remedied, I'd would really like an accurate reading.
View 14 RepliesJust noticed today that my trans temp always starts out from cold even after having driven it and it takes a little while to rise up to the temp I checked the other trans gauge same thing do I have a problem or does it really cool down that fast the truck sat for maybe 10 minutes.....
View 5 RepliesI have absolutely loved my 2011 F-150 8 cyl since I bought it in 2013. I'm just now having my first issue...
For the past two weeks or so, I've had an issue with intermittently hard starting. It cranks like normal but doesn't turn over instantly. The longest its gone before starting has been about six seconds. Although originally happening only 10% of the time, its happening about 40% of the time over the past couple days. I had my mechanic take a look and the battery and starter all checked out fine.
Biggest problem was that it never did it for them making it hard for them to trouble-shoot. Thus far its always started, just takes an indescript amount of time in which to do it. The time of day doesn't seem to matter although afternoons in which I'm heading to lunch after being in the office for 3-4 hours seems the most common time.
I've had this 2012 for several months now but have never really romped on the throttle until yesterday's road trip (not a lead foot driver).
I was driving on the highway at about 55 when I needed to pass so I floored the throttle and - the truck bucked like a wild horse and the power dropped to a low acceleration. Once I backed off the throttle to about half-way the engine took off like "normal".
These symptoms were repeatable throughout my entire 500 mile trip. Is this a known issue with the EB?
2010 F150, 165,XXX miles. On a bridge, at highway speed, the transmission locked up and locked the rear wheels. Everyone is OK, but scared the daylights out of my employee and a customer. Bad situation.
After putting it in park, and restarting, it seemed OK. We towed it to the dealership who replaced what I believe was a control chip on the transmission. Dealer said it is a known problem, and they aren't sure if the new controller would fix it?? They would not guarantee if the new controller would prevent the issue (per Ford).
I run a fleet with 7 F150's in it, and this employee is concerned about driving it. I have 3 2010's in the fleet. I am trying to figure out if this is limited to 2010, an incompetent dealer, or?
Lifting 09-13 F-150 with the two piece drive shaft. I am getting a lot of vibrations at highway speeds(55mph or higher). I have a Pro Comp 6 inch lift that was installed while I was stationed in Alaska. I have the drive shaft spacer that goes on the drive shaft at the pinion. I also have a carrier bearing drop kit from BDS that I am currently experimenting with (trying to find the sweet spot). I am at a loss though because my truck is no longer fun to drive. I drive an hour to work one way and it blows that my truck feels as though it will rattle apart. I have tried doing all the research that I can find about this issue.
View 14 RepliesAbout 3 months ago, I bought a 2012 F-150 XLT 5.0 4x4. I bought it from a private party, a.k.a. without a warranty. It's a Ford, right? What could possibly go wrong??
Shortly after I bought it, I started noticing that it was knocking and tapping when it got up to operating temperature. Also, the idle isn't very smooth.
I have read through several threads here regarding Coyote engines with similar symptoms, and I have come to the realization that my wallet may be about to go on a diet.
Here is a video I made today, moving my phone to various places in the engine compartment, behind the drivers front wheel, and under the truck.
2012 Ford F-150 5.0 Coyote Noises 80k Miles - YouTube....
I realize that it could run a long time like this, but I sometimes take long trips and I really don't want to end up with engine trouble in the middle of nowhere.
Considering I don't have a warranty, and assuming the problem is out-of-round cylinders and/or worn valve train parts, what is my best course of action?
Been having an issue lately with the AC system on my 2010 4.6L F150. The AC system is not working properly and is only blowing air the same temp as outside. In other words, if its 60 degrees in the morning the AC will blow cool, but later in the day its blowing warm. Pushes air no problem, but living in Florida, it's mainly warm air. Compressor clutch is kicking on and off fairly rapidly when on max AC setting (5-10 seconds on, then 5-10 seconds off). Hooked up gauge to low pressure side and the readings were 60psi WITH compressor on, then fell to 30psi when the compressor turns off. Where to start? Haven't done too many AC fixes before. Potentially a bad compressor? Overcharged lines?
View 7 RepliesFord Tech. told me today the reason my a/c wouldn't cool is I have a bad evap. temp. sensor and this part was "non-replaceable" the fix is a HVAC Box from ford, (price includes a h/core replacement since dash would already be out) it has 85000 miles 2010 f150 Screw 4x4.is this my only option for repairing my a/c.
View 3 RepliesExperienced noise coming from the temperature control unit? I generally hear it immediately after turning on AC or Heat and then when I adjust the tempature up or down. It only last for a few seconds then goes away. I plan on taking it by the Ford dealership. 2010 F150 Platinum...
View 7 RepliesI have a 2014 screw 4x4 v8 that has been in the shop 5 times now for something that the dealership can't duplicate, and that is intermittent enough for me that I can't determine what the conditions need to be in order to duplicate it myself.
My transmission will shift hard under two different situations:
1) when rolling through a stop, or a momentary stop at a stop sign, the transmission holds up between 3 and 1, and when I bring the rpms up, the transmission shifts down into 1, making a hard clunk;
2) at highway speeds, more so when using cruise, if I accelerate and the truck shifts down from 6 to 4, there will be a hard shift as well. In fact, when I'm on a long stretch of flat, open road using cruise at 70-75, I can feel a slight bump through the steering wheel and floorboard, as if the cruise is trying to engage the throttle a bit more, but only for a split second. But that will happen quite a few times within a couple miles until I come up on a grade and the throttle has to engage for a bit longer to keep speed. Sometimes, the hard shift will do occur going to 5 as well, but 90% of the time it will be a 6-4 shift. If the truck decides to shift from 6-3, there's no issue and it shifts and accelerates like it should.
Again, this is so intermittent, but when it happens, it happens several times. I've had the service tech ride in the truck with me, all the while not being able to duplicate the issue. I understand that these are learning transmissions, so the only thing I can think of is when I try to duplicate it by accelerating over and over, that the transmission adjusts the shift pattern or fluid pressure to compensate.
I have a 2010 F150 XLT crew cab, and I'm the second owner. Ever since I have owned the truck, it has had a pretty bad shake/vibration at highway speeds, that gets worse with higher speed. I have checked the alignment multiple times, rotated tires, had them re-balanced, and I still cannot figure out what is causing this. What else should I be checking?
View 14 RepliesI have a 2004 Grand Prix and it is displaying the symptoms of overheating but the temp gauge is not going above normal operating temp. I replaced the thermostat twice, and after driving for about 10-20 mins coolant comes out of the overflow. I'm at a loss, I'm thinking temp sensor(?) But I don't want to keep throwing unnecessary money into it. The fans work fine, the heater blows as it should.
View 8 RepliesThis morning (roughly freezing temperature - nothing out of the ordinary after the brutal winter we just had) got onto the highway to head to work and set the cruise control (as normal) at approx 110km/h (65mph) and after several seconds heard a distinct, quite unpleasant grinding noise. It was loud enough to be heard over the heater and radio. Turned the heater and radio off to listen closer and didn't like the sound of it - sounded like metal on metal.
There was no different feel in the floor, pedals or steering wheel. As soon as I turned cruise control off, the noise disappeared! Turned cruise control back on, and the noise returned approx 5 seconds later. If I continued driving along normally and sustained a certain speed, the noise would appear after 5 seconds again and only go away once I lifted off the gas or coasted down a hill... Very bizarre. Once I got to work and poked my head underneath didn't immediately notice anything out of the ordinary - no funny smells or anything...
Background info: 2011 FX4 ecoboost, crew cab. Stock, no modifications. Approx 134,000km (~80,000 miles)...
I have a 2010 ford f-150. My fuel door swings loose and the cover came off on the highway. Where I can get another one? I need to replace the whole thing.
View 2 Replies2010 4x4 F150 Lariat 5.4 L, have been working on throttle response problems off and on for a few months. Initially got p0404 codes, and replaced the accel pedal assembly, now graduated to p2135 code, and stall at idle after a highway trip. Wondering if this may be a issue with aftermarket air filter causing misread errors on sensors. Had it to the dealer, with out any real remedy.
View 2 Replies