Ford F-150 (2009-2014) :: 2013 - Clicking Under Dash - Heater Blend Door Motor?
Oct 2, 2016
I have a 2013 Lariat with 135K miles. Yesterday started a loud and consistent clicking under the center dash. When I turn the heater up to 77 degrees or above it stops. I have dual AC controls and the passenger side will now occasionally blow hot compared to the driver side when I have them on the same temperature.
Based on what I have researched I need to replace my heater blend door. Need to confirm if this sounds correct? Are there different blend doors for driver vs. passenger side repair?
As importantly I am looking for a good set of instructions on how to gain access to the heater blend door motor in order to take care of the replacement myself. My understanding is it is a $40 part buy may be heavy on services due to access. My 2013 is stocked with the sync touch screen / navigation option .....
View 5 Replies
Advertisement
As the title says, my 2013 F-150 XLT lost all heater function and rear window/side mirror defrost function. It all worked fine this morning on the way to work but when I got out I had nothing. Looked at fuses under the hood, nothing is blown. Could it be a relay? The led lights in the buttons on the module still light up and I can hear the vent doors open and close when I change modes.
View 5 Replies
Recently when I adjust the temperature, there is a clicking from under the dash. It sounds like the Blend door is stuck.
View 7 Replies
Was on my way to get an oil change at my buddies shop. Started hearing a clicking sound. My climate controls no longer will respond. the Auto button is lit up but I can't turn the air off. I get hot air from the vents. When the clicking does stop the system goes back to working order. My friend checked it out and says the clicking is from the blend door motor.
View 6 Replies
Time for me to replace the actuator. I just have one. I've watched many videos on it but none say anything about re-calibration before using. A few posts say this is needed. Is it? if so how is it done?
View 6 Replies
Question: blend doors clicking even when the key is removed from the ignition? Mine clicks for quite awhile after I turn off the truck (probably 10 mins or so, I haven't stuck around to see when it finally stops) Asking out of curiosity....and this thread may put some people at rest down the line.
I do love this truck and I don't mind working on it at all. The Blend doors allow me to paint the dash trim with Bright Aluminum Plastidip.
Leaky T coolant connector which I don't mind.....wanted to switch out to a 170 degree thermostat (SSI Tuned and South Texas Heat) and do a coolant flush anyways. Might as well hammer it all out. No biggs.
View 4 Replies
got in the truck tonight and she is blowing nothing but cold out the drivers side but the passenger side works as advertised for temp settings. I have been trying to see if there is a self test mode like the earlier year trucks have to see if there is a code. She is dual zone climate/digital so its an EATC if I am not mistaken. I have tried power cycle, pulled and re-installed climate fuse after inspecting. Tried some of the earlier year self test button combinations to no avail. I did notice if I hit defrost a few times after hitting the power and defrost that the temps would go all 00 but I don't know if that is what I am looking for. I probably know my answer which includes tearing out the dash but how to proceed. Bought her with an aftermarket power train warranty so electronics are off the table for warranty. I know the stealership will charge out the rear to fix it too. All signs so far point to a blend door which is not good at all.
View 14 Replies
What is the difference between :
Part # XF2H-19E616-FA and
Part # YL5Z-19E616-AA?
The middle numbers are the same. And they look the same? the first one is mine. Blend door actuator out of a 2000 ford windstar. Will another part # work? If the connection is the same?
View 6 Replies
My actuator/motor doesn't have the screws that hold it on. It's just clipped down. Can I just pry it up & off with out it breaking the clips that hold it down? It's a 97 Ranger.
View 2 Replies
I noticed today my heater did not kick in when I started my truck and about 10 minutes into my drive I finally began feeling hot air. Soon after the air was no longer blowing hot. What this may be and how to verify the issue? I'm interested in taking care of this myself if it is easy/moderate level of difficulty to isolate issue and fix.
View 2 Replies
Over the last few days I have read several threads about heaters not working and blend door replacement. My '02 4.6 F-150 has 250k+ miles and I've always done regular maintenance on it. With the cold front moving in I've noticed that the heater is not blowing hot air. I flushed the radiator and flushed the heater core several times to make sure the core was not clogged. I also replaced the upper radiator hose because of the "crunchy" sound when squeezed. I also replaced the thermostat. Still, the heater is not blowing hot. I assume like many others that the blend door needs to be replaced. My question is do I need to replace the door only or the door and the motor (actuator)? I guess I need to test the motor before buying a new one. I saw a video where you remove all the components on the transmission hump and can actually stick you finger in the motor opening to see if the shaft has come apart.
View 8 Replies
My ex-has the electronic temp control. I've noticed there is very little difference from full hot to turned down less than 1/2 way.
(I'll convert to Fahrenheit here) Example - lowest temp setting is 60. If I am on heat, turning it from 60 to 66, gives me almost full hot. A slight difference is felt turning it to 68 and 70, but basically, 70 is full HOT. Continuing to turn it up to 88 makes zero difference.
I figured the blend door actuator might be toast, but it is in fact moving. I pulled the heater core cover off and here is what I noticed.
At 60, the blend door is fully open (correct, pulling cold air from outside) turning it to 66 the blend door almost fully closes. then the last little bit gets closed when going from 66-70. Anything hotter than 70 is of no use because mechanically it IS on full hot at 70. So basically I get full cold, or full hot, nothing in the middle. I pulled blend door actuator out, cleaned all the built-up crud around the shaft, took it apart and cleaned it, (no broken gears) no effect.
View 11 Replies
Having issues with the blend door on the AC system. I will have it on AC or MAX AC. I will have it on the setting to be point out of the dash at me. It occasionally will switch to the defrost windshield setting. I can hear the blend door moving and changing from chest level to the windshield.
View 12 Replies
Have a 13 FX4 CC Eco
Recently the drivers seat would only recline/move front to back tilt on the outer left most side. The seat back appeared to be frozen on the inner/right hand hinge by the center console. It just twists the seat back if I try to recline or move it at all
Is this a warranty thing or is there something simple like a fuse or plug the at could be the culprit?
View 4 Replies
Ok, I know the problem is the blend door, but not which one. I hear a clicking constantly whether the truck is started or not near the center of the passenger side. I can adjust the temp to be 65-70 on the driver side and be fine, but the passenger side is hot. I've looked for TSB's for 2010 and have come up empty. I bought the truck used, and bought an extended warranty, but not sure it will cover this repair.
Is there a TSB for this? If you had this done at the dealer, how much did it cost to repair? Would you attempt the repair yourself? I've taken the dash apart to find the problem, but then determined it might be too involved for me to do and I wasn't comfortable disconnecting the air bags.....
View 1 Replies
I have a SAAB 2000 95, and the heat isn't working. I was told by a local shop that the blend door motor isn't opening to allow the system to switch from air to heat. He said that the heating system was working, but that the hot air can't exit the dash. He said it would have to be repaired at a dealership.
View 3 Replies
Started the other day. Seems like the blend door that channels air to the dash vents is opening and closing as it feels like it. Sometimes open for awhile, sometimes closed. The defrost vents keep blowing cold and normal while doing this.
View 9 Replies
Noticed on my wife's 2013 F150 that when you put the key in the ignition without turning it on that the dash lights will flicker on/off and the easy out power seat will move back and forth if you wiggle the key. My SD did the same thing while under warranty and the dealer replaced the ignition switch. How hard of a repair is this to do? It doesn't do this with the key in the acc or run position.
View 1 Replies
Any issues with a rattle in the door? Sounds like from within?
Are these easy to take apart or would I be better off dropping off at the dealer to fix?
View 14 Replies
sitting at a redlight with radio off, sounds like heater door or something under the dash is moving. Thing is, all the controls for heater and a/c were off.
2009 f250 5.4.
View 9 Replies
The Issue: Dash display reads "Passenger Door Ajar", interior lights stay on, drains battery
Current Fixes I've completed
Sprayed electrical cleaner in all 4 door latch assemblies (didn't work)
Relubricated all 4 door latch assemblies with food grade lithium grease (didn't work)
Replaced passenger door full latch assembly (didn't work)
What is my next step? I have noticed that if I wedge the door lock button on the driver's side door into the lock position, the door ajar message turns off and stays off? I was thinking wiring or relay issues?
View 3 Replies
