Ford F-150 (2009-2014) :: 2011 - Remove The Rear Headrest?
Dec 17, 2011
I'm trying to take out the rear headrest on my dad's 2011 F150 crew cab so that i can put my kid's carseat back there. I hit the two release buttons, but the headrest hits the ceiling before the pegs come out of the holes. How are you supposed to remove these things? Does the seat lean forward somehow?
View 10 Replies
Advertisement
How to remove the headrests on the rear seat in the supercab?
View 6 Replies
My daughter's car seat will fit our Prius much better if I can remove the rear side headrest. How do I go about removing it?
View 2 Replies
I have a 2010 4 door GTI. I'd like to install my daughter's front facing Britax child seat either in the rear right or rear central position. However, in either case, I'm finding that most of the rear weight ends up on the headrest and I would like to simply remove the headrest from that seating position.
I read in the user manual that to remove the headrest,I pull it to it's highest position and then push the button on the right side of the plastic entrance of the head rest into the seat, and 'simply' pull the headrest vertical out of the seat.
This is similar to how this was done in other cars I've owned. However it is not working for me with the GTI. Once I pull the headrest to the highest possible position I can get to, I press the button but the headrest simply refuses to come out. I've tried this on the other rear seat and same problem. With the middle rear seat I can't seem to pull the headrest out beyond its lowest position.
View 4 Replies
2011 f150 super cab eco boost rear wiring?
View 1 Replies
Trying to install some nice seat covers in my '11 supercab and can't seem to figure out how to remove the rear seat back. What is the combination?
View 2 Replies
Search did not yield useful information, maybe I used the wrong search terms?
Is there an easy way to remove the headrest mounts, e.g. the parts at the top of the setback into which the headrest bars slide?
Also curious on how to remove the seat latch release knobs on the tops of the rear seats.
Replacing factory leather with a Street Wire leather kit due to a tear.
(Once leather kit is swapped out I will have the torn panel replaced and will offer the factory leather kit for sale.)
View 3 Replies
I am on top of my oil changes, but this is the first time I have seen the center display flash "change oil soon" and stay on until you hit the OK button. I went through the manual and I cannot find where there is a provision to clear the message. The oil was just changed, has maybe 600 miles on it.
2011 F150 EB lariat with 10,000 on it....
View 9 Replies
2010 F-150 with 38 gallon tank. Original thought was great way of having some spare fuel available for use during an emergency. How to easily remove gas from these new vehicles?
View 10 Replies
How do I remove the Air Bag from my 2012 F150. I want to install a Cruise Control Switch.
View 6 Replies
I though I would like the tailgate step and assist handle. They are always in the way and I want to get rid of the handle but keep the step if possible. Can I remove the plastic tailgate cover, pull the hande and re-install a metal tailgate cover.
If not, want to swap a tailgate. Its red, has the back-up camera and, no dealer markings and in excellent condition.
View 11 Replies
I continue to get that message whenever about anything is on the passenger seat. Today there was only a wrapper and an empty cardboard box from an oil filter. Together I doubt they weighed more than a few ounces. I normally just clear the message a few times to get it to go away...but today it triggered a seat belt alarm. Is there a way to change the amount of weight that it takes to trigger this message...or is it due to something else?
View 14 Replies
How to remove the drivers side airbag on a 2010 f-150, a deer jumped out at my truck and set off the airbag which now needs replacing besides the body work
View 3 Replies
I have a 2013 FX4 with the 3.5 twin turbo engine. How to remove the right side valve cover to replace the gasket? I have loosened the perimeter bolts and was able to get it to move slightly but nothing more. I also removed the spark plugs thinking that they might be holding the tubes which are connected to the valve cover by round seals. I have not removed the seals since I was concerned that I might damage them. Do they need to come off? If so how do I do it? It's amazing how complicated this job is! Short of calling the dealer service, I have just about exhausted all my usual tech resources.
View 4 Replies
2012 Sonata gls, 84,000 km. Trunk will not open. I am hoping to gain access by removing rear seat and back rest. I believe then I should be able to pull trunk release.
View 17 Replies
How to remove the LED light from next to rear view camera? I know how to change the left side one but the one with the rear view camera looks hard to replace.
View 4 Replies
I'm trying to take out the rear center headrest and I can't for the life of me work out how. Holding the button on the leg collar down only lets me raise it by about half an inch.
View 10 Replies
My rear seat headrest on one side is always up, and I can hear a motor running in the rear seat back whenever the engine is running. Shut the engine off, and the head rest remains up. I couldn't push it down with any reasonable amount of force. Does it need a complete headrest motor, or can the existing one be repaired?
View 1 Replies
My 2011 3.7 CC seems like it is missing at speed.
If I am around 75 or so in 6th is vibrates, but downshifting to 5th or 4th seem to take it away.
I am going in tomorrow and have the tires rotated and balance, but I think it is somewhere else. It has a little over 42,000 miles
View 13 Replies
2011 Lariat. My key fob is starting to come apart, and dropping it didn't work any.
View 7 Replies
i have a 2011 f150 xlt with the 5.0, my 4x4 does not lock in very well, i practically have to come to a stop and wait for it to engage fully or it starts banging and slipping like its trying to engage and not quite making it. are they still suppose to be on the fly? is there any kind of maintenance that i can do to them to have them work better? are they still locking hubs or did they change something?
View 4 Replies