Ford F-150 (2009-2014) :: 2011 - Brake Pad Wearing At 26000 Miles?
Mar 7, 2013
So last night on my way home I was stopping at a traffic signal and noticed a grinding noise from the drivers side front wheel. Upon further investigation I noticed a lot of brake dust on my wheel. I took it to the dealer thinking the caliper might be seized up. Well they looked at the caliper and said it was OK but the inside pad was worn to the metal. The other pads still looked good but since they have to replace the rotor they might as well replace all of them. The tech told me that being up north where they use salt corrodes the pads and doesnt allow them to move freely. He also asked me if I drive a lot of highway miles and I said yes, 30 miles a day. I guess from what he said is that the less they get used the more they will corrode up. So premature brake pad wear could be worse.
View 6 Replies
Advertisement
So for some time now my truck(2011) has a problem when I floor it while entering the freeway or even down the road..
If im cruising around 30 or 40 and floor it, it down shifts and takes off nice.. but when it goes to change gears, it chokes, not sure how else to explain it, but once past that gear, the following shift fine if im still on the gas..
Normal driving shifts ok, and if im going say 50 or higher and do the same thing, it shifts fine.. so its only when going slower and I floor it..
It has 69,000+ miles on it
View 13 Replies
I traded in my 2011 Lariat last month because I had quite a bit of problems with it in the short time I had it. I also didn't care as much for the bells and whistles as I thought I would when I bought it.
I got such a good deal on a new 2011 Lariat Super Crew, that I traded. Shortly after getting the new truck, I had to take it to the dealer for two dents that I found the first time I washed it. I didn't see them when I took delivery because it was dark. I had not seen the truck before that because they got it from another dealer to get the color I wanted. I also had problems with the radio buttons on my steering wheel and the sirius button on the dash not working at times, damaged trim around the left side of the windshield, a discoloration the size of a nickel on the console that I noticed when taking delivery, and a ticking noise in the engine . After the truck was in the shop for 3 days, I get it back without anything being corrected. Parts had to be ordered for the console and trim piece.
I took the truck back in 10 days ago for the engine noise and for them to repair the dents that were there when I got it, along with more troubleshooting on my intermittent problems with the radio and steering wheel buttons. I get a call late yesterday afternoon with the verdict.....Ford says replace the engine due to something being wrong with the crankshaft.
I have to say, I'm pretty disgusted right now. I'm not so sure that I want this truck anymore because of all the issues I've had in the short time I've owned it. Service department at the dealer has been great, and the dealership has been talking about possibly getting me into a new truck. I'm just not so sure I want to try a a third truck. I've been a Ford man my entire life, but I'm disgusted with them right now. I certainly don't want a Chevy or a Dodge, so I don't know what I'm going to do at this point.
View 14 Replies
Just bought a spotless, low mileag
View 9 Replies
I have a 2010 fx 4 cew cab that has a 2" lift on it. I am new to the truck scene, but my wife has always wanted a big truck. I have pro comp tires that are 35 X 12.50X20 LT. They are the Pro Comp Xtreme A/T. The truck is driven evry once in a while and it is never off road. The issue I am having is that the tire wear is really bad and uneven in the front. It has been aligned 3 times in one year and the balance has been checked. I had the lift kit done at the dealership and they are saying this is normal and that the wear is due to not rotating the tires every 3000 miles. If the truck was driven every day I would understand but it only has 10,000 miles on it. Is this normal? The wear looks like a shock could be bad but they have already replaced the shocks about 3 moths after i purchased the truck.
View 14 Replies
Wanting to put the raptor 3rd brake light on my 2011 limited not sure what has to be done or if they make a harness to allow it to work. What did it take to do it ??? I just like the running light it has kinda cool....
View 8 Replies
I'm looking to buy an ISF and now I'm reading about the 2IS chassis suffering from front inner tire wear with many attributing it to the soft LCA bushing (see FIG fix) and the factory alignment. Most of the reports seem to be focused on the 2008-2010 ISFs and I see little about 2011+ owners reporting this issue. It's my understanding that the 2011+ front springs are slightly taller/higher and a different rate. Did this possibility (inadvertently) correct the front inner tire wear issue?
I had a 2003 G35 and front inner tire wear plagued that car too and it was annoying and no real fix available. It had the same exact suspension setup on ALL components. We didn't smoke through the inner rubber tread, but rather it feathered like and if you didn't stay on top of it, your G/Z would sound and feel like a dump truck after about 10-15K miles because of the feathering.
I'm looking at 2012-2014 ISFs and I would check and correct the alignment if necessary. I know FIG makes a replacement bushing, but it's urethane and after about 20 years of modding cars, I've learned that urethane is best left to race cars. After about 5K miles, urethane needs regreasing and almost always leads to squeaking/clunking as the urethane loosens up after a year or two.
View 14 Replies
I have a 2010 f150 supercrew 4x4 with 8.8 3:55 nls rear differential. my driver side tire has a wobble to it it is wearing the inside of the tire. i have replaced the driver axle shaft with new ford oem shaft put in new axle bearings and seals on both sides and have replaced the spyder gears and i still have the wobble I don't know what is going on. the wobble is more pronounced when the tire and rim are bolted to the shaft only without the drum and caliper attached. with caliper and rotor attached i still have the wobble just not as bad however the tire wobbles going down the road more noticeable between 20-45 mph.
View 13 Replies
My friend was looking at my tires earlier today and noticed that my brake pads were wearing at an angle. He was also shocked to learn that these pads have only 6,000 miles on them. We looked at the old front brake pads my mechanic replaced and they are not showing any wear like the current pads.
Below is the old pad that came off the car after 30,000 miles:
This is the pad my mechanic installed on my car, after only 6,000 miles
He also noticed some odd wear on the rotor - evidenced by the vertical lines across it's radius. He thinks it may be related to the problem with the pad. He also recommended a different mechanic... Is this wear considered normal? We looked online and some people reported similar wear, but nothing we found was as extreme as this.
View 14 Replies
Setup my Reese brake controller on my 2011 today. The lights, turnsignals, and brakes work when I push the brake pedal. But when I move the lever on the controller, I get nothing. Also, on the info screen, it still says trailer disconnected. What gives?
View 5 Replies
I have an 2011 Ecoboost SCAB and the front brake dust is ruining my chrome package wheels. The rears are fine. Ceramic or low dust pads??
View 14 Replies
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
View 4 Replies
Started a while back and comes and goes. Only commonality I have found is the truck needs to be warmed up for it to happen and usually after a few hours of driving. The downshift from 5th or 6th into fourth, at times, produces anywhere from a light to violent clunk, feels like a typical tranny slip. It will do it while in cruise and it will do it if I don't have the cruise on. Can't figure out if it is going to be a tune issue or hardware.
It does it only downshifting into 4th from 5th or 6th, no other downshifting is a problem and usually the 6th to 4th produces the worst results. At highway speeds that is usually a shift from around 2Krpm to just over 3K rpm (6th to 4th) if it is from 5th it is about 2500 to 3K. Start from a stop and go WOT and there are no issues.
Having it in Tow/Haul or not makes no difference as far as I can tell. IT can do it on one hill and the next time be just fine or do it 2-3 hills in a row. After this last trip it will do it at 9K feet or at 60 feet elevation, didn't make a difference there either.
Another issue that may be hurting the computer is the truck originally came with the 235 tires, it now has 285's and the rear is only 3.31. I plan on going with 265's and maybe still a gear change to 3.73's in the future. I usually only notice this on long trips, first was a 1500mile hauling an ATV, second was last week during a 2500 mile empty. Although I have had it do it a few times locally. I figure those bigger tires can't be good especially with that high of a rear for the management system.
View 3 Replies
My 04 6.0 Limited and both front and rear sway bars. The front links keep wearing out after 3-4000 miles. But, I saw someone in here put F350 Sway Bars in their Excursion? REALLY?? Is this right or is this snake oil? Is their another way to fix the front links so they don't wear out so quickly??
View 4 Replies
My original 17" Toyo tires are noticeably wearing out after only 25k miles and it appears to need replacement soon. I can probably drive for another 5 to 8 k miles but the edges may be bald by then. I looked at the Toyo replacement tires and the exact ones are actually quite expensive which means they may be in the performance tire category. For a Prius v (lowercase v for the Prius v wagon), not sure this vehicle warrants this type of tire. I will be looking for a longer lasting tire for replacement and not necessarily performance tires.
View 5 Replies
After I change my oil, I need to reset back to "miles to empty" from "% left on oil" warning. 2009 F150, XLT Supercab. I do not know how to do this.
View 1 Replies
I have the normally aspirated 3.7 V6. The ownersd manual talks about the trucks computer telling you when the oil changes are needed.....But, at 6500 miles, bnothing has come through. I have not changed the oil yet on it. I feel this is a huge sin, but am not sure.....I was raised you changed the oil every 2-3 grand. But the owners manual on this truck says the computer will tell you when to. Should I just go ahead and change it?
View 7 Replies
I wanted to change oil at 1000 miles on my new 2010 FX4. The dealer said that I should wait till 2500 miles or so because it still has the break in oil in it.
Does he know what he is talking about or should I change it? He did say he would change it and take my money if I really wanted to.
Maybe my thinking is still old school about changing the oil right away with a new engine.
View 14 Replies
My budy took his touareg to the dealer today because his front tires are wearing funny (cupping). The dealer said that is normal for the touareg. I am having trouble believing that.
View 8 Replies
My truck just hit 110k on the clock, and i've never had the transmission fluid changed. Is this something that I am past due on changing or early? I don't know when it is supposed to be changed. If so is it something that you can do yourself?
View 14 Replies
Brought my 2011 Limited (6.2 so old school hydraulic power steering) in for its 45K service, and they found a weeping high pressure line. $100 special order part + 3 hours labor. This seems a little soon (to me) for PS components to be failing already, or is this a common repair? They said I could leave it alone for now and monitor it but could lose power steering while driving (safety risk).
Any history of high pressure power steering line leaks at such low mileage/age before? Does 3 hours labor sound about right?
View 5 Replies
