Ford F-150 (2009-2014) :: 2010 XLT - Caliper Rubbing Up Against The Rim Of Tire
Apr 3, 2014
I recently replaced my pads and rotors. The driver side was no problem, but on the passenger side, when I was finished, the caliper was rubbing up against the rim of the tire. I took both tires off to compare the differences, I noticed that my passenger side caliper is not going down as deep on the pads as the driver side. The caliper on the passenger side depressed with no problems and had no problems fitting over the pads. Whats really confusing is that all of my bolt holes line up.
View 11 Replies
Advertisement
Just got a 2010 lariat supercrew...I put 1900 miles on it so far. When slowly letting off the accelerator (doing between 20-30 mph and between 1000-1500 rpm) there is a distinct rubbing sound for about 1-2 seconds...it is now sounding more like grinding now...took it to the shop today...(they couldn't duplicate (because service rep documented 60 mph instead of the 20-30 mph...went back at the end of the day to ride with the tech, and i was able to duplicate so now they have something to work with....also the noise happens mostly when the path of travel is either level road or slight to great incline..it has not happened on a down slope....
View 14 Replies
I had a new windshield installed and the first time it rained, my auto unlock,the tire pressure monitor and the auto headlights stopped working. The dealer said that the fuse box got wet. I have since fixed the leak but can't find a fuse or reset any where.
View 3 Replies
I was uber excited to buy my first brand new truck in 09..... Amount numerous issues, defective rear window (fought with ford for 3 years never replaced under warranty), sync issues draining my battery, multiple O2 sensors replaced, multiple lights replaced and a blown drive shaft all under warranty. Now my warranty literally just ended, years not miles, just rolled 36k yesterday, ran out 3 years in November 12, now I'm having break issues.
A few weeks ago while driving, I released the gas and truck seem to slow faster than normal. Seemed kind of unusual but also began to noticed a drag on my mpg, about 2-4 mpg difference, depending on highway or in town. Now 3 weeks later, I feel grinding under breaking. Now it's beginning to make sense. I figure probably a stuck caliper. While driving with head out the window , freezing in IL, by the way, seems to be the drivers front. Checked rotors, outsides only as there are the guards preventing me from checking the back side. No visual or touch grooves ground into the rotors from the pads being worn out. Best bet is its the back side of the caliper that is locked.
Question 1, does this make sense, only one side of the caliper locking up? I had a caliper lock on my old GTP but the whole thing locked up.
Question 2, do I just suck it up and replace the breaks my self, gf's dad is a manager at O'rylies so I can get anything I want at cost, or do I go back to the dealer and bitch about mechanical problems being constant with my new now only weeks out of warranty truck? I read some horror stories about clogged lines and numerous other issues causing calipers to lock. I don't feel like replacing my whole break system, lines, calipers and all just to make sure the problem is fixed. At 3 years this seems ludicrous.
View 4 Replies
I've owned this 2012 Lariat 5.0 for about 6 months (has 49,500 miles on it, approx 6000 are mine).
For awhile, I had kinda thought I sensed a slight vibration/grinding when making right-hand turns. But it seems to be getting more noticeable now. It does not happen with every RH turn, but its not all that rare of an occurrence either. (Does NOT happen with LH turns.)
In addition ............ possibly related, sometimes while breaking, I get a somewhat similar grinding sensation, just before coming to a stop. Again, it does not happen every time.
I tend to think both of these could be a brake issue, but wondered if anything in the driveline could be contributing ? (I should note that I'm in 2-High)
View 12 Replies
I have a 2011 F-150 4x4 5.0 with about 45k miles. When I drive at slow speeds (ex. 5mph) and turn the wheels left or right there is a rubbing/growling sound coming from sounds like the front end. It does it either in forward or reverse. It's not a squeaking, clicking, or metal on metal sound. It does not do it when the wheels are straight. I rolled underneath and couldn't see anything that stuck out right away. What could be causing this?
View 12 Replies
I have noticed recently that I have a "rubbing" noise and vibration coming from the right front wheel on my FX4. It is most noticeable from 5-10 MPH, and more pronounced when turning right. it is not constant. It sounds almost like a brake pad rubbing on a badly warped, wet rotor. It goes away when I apply the brakes. I am thinking bearing or possible CV joint.
The dealer can't get it in until Tuesday, and they say I will have to pay the deductible on the ESP, even if it is related to the steering vibration they could not replicate or fix about a month ago. I am seriously considering going to another dealer for my service. Given, they did absorb the deductible last time, but they didn't fix the problem!
View 14 Replies
Having problem with the lower radiator hose rubbing on the serpentine belt...
View 1 Replies
1999 F350 4x4 dually. Replacing brakes front and back. Rotors, Pads, and hoses. On the left front put rotor back on and torqued down hub nuts on rotor. Then caliper mounting bracket wouldn't fit back between mounting bracket and rotor. Loosened the hub nuts on rotor, and fit mounting bracket in place. Then torqued down the hub nuts again, and rotor rubs on mounting bracket and rotor/hub won't turn.
View 2 Replies
At what point does it go off? Mine went off tonight, after about 15 miles on the road, the ambient temp is 60 degrees cooler than when the tires last got air (it was 40 degrees on the drive home).
None of the tires look low. If it had been on at the start, I could understand due to the cooler air, but it was after a few miles and the tires had warmed up some I am sure. (Two miles later when I stopped at my house, the tires felt warm to the touch, at least, noticeably warmer than ambient air.
View 14 Replies
I recently went up in size on my tires after installing a Leveling kit. Today for the first time since I had to take a long trip and was checking my speed against what the GPS was stating.. there is about a 8mph difference.
So if the truck says 65, the GPS was saying 73/74, and the faster I went the bigger the difference got.. so if the truck said 70, I was going closer to 79/80
I know that there needs to be some adjustments made so it read correctly again, just wondering if there is also some adjustments that can be made to get the RPM's down at cruising speeds also..
In the past when I would do around 70 or 75, the RPM's would be around 1500 to 1700, now im staying steady at 2000.
What am I looking at to get back to somewhat normal again?
View 14 Replies
2014 f150 4wd. Jacked front tires off the ground today, right tire rotated easily by hand, left tire VERY difficult to rotate at all. Removed brake caliper and pads, but still difficult to rotate. Started truck up, right tire seemed even easier to rotate, but no change in left tire...
View 4 Replies
I'm working on a 2007 Camry and I had the wheel bearings pressed in & out at a shop. I put everything back together but the driver side rotor is rubbing against the caliper bracket. And there is no air gap between the rotor and bracket so it can spin freely without rubbing. The passenger side is fine, there is a little air gap so the rotor can move freely without rubbing. I don't understand why the driver side rotor is rubbing against the caliper? I checked everything over, the pads and rotor are the correct ones. I also took the pass side caliper bracket and installed it on the driver side and same thing, the rotor still rubs against the bracket.
View 13 Replies
Been looking at a level for my truck and some new wheels and tires. If I change sizes, can the dealership recalibrate my Speedo and transmission shift points for me?
View 14 Replies
I was wondering what the maximum size tire with no lifts or leveling I could put on my truck would be. I was looking at a pair of Nitto grapler g2's at 295/70r17 with my stock wheels. Would that fit?
View 3 Replies
I own a 2011 lariat with 500 miles. We have had several days of rain and I am getting alot of rust spots on my driveway always below and inside the right front tire. None in the rear or left front. Dealer said not to worry about it after they looke at the area. They said it is the new metal forming surface rust. There is a skid plate which seems to cover wherever the rust is starting. Should I demand that area be undercoated.
View 3 Replies
2014 FX4 F. Got 6000 miles on the truck, front tires are wearing on the outside edge, and also when turning the wheels to the max in either direction I get a loud creaking sound,??
View 14 Replies
I would get "Tire Pressure Sensor Fault" on my display all the time. The problem occurred mostly on long trips, however, it would occur from time to time on shorter trips. I complained to the dealer about this every time I went in for an oil change. They could never find a problem and wanted me to bring it in when the fault was occurring. Of course these thing never happen when you're by a dealer. To my dealers credit they said they would fix the problem out of warranty if we can find it.
Well I found the problem. As strange as it sounds if I use the cigarette lighter with a power USB adapter to charge my phone or iPad I get the fault. If I use the 12V accessory port on the dash no fault.
Last weekend we drove to Nisswa MN & back (about 1,200 miles). To test the theory I only used the 12V accessory port and no fault occurred. Normally the fault would occur w/in 50 miles then just continue on being annoying the whole rest of the trip. I wish I would have found this out 57,000 miles ago. I use the adapter because the USB port on the dash will only charge my iPhone if the phone is off.
View 14 Replies
My car is pulling to one right slightly so I did the alignment. But it didnt eliminate the problem. I jacked up my car and try to rotate the front wheel. I can hear slight noise of the caliper rubbing the disk and the wheel does not spin freely if I stopped rotating it. However, the noise is subtle so I don't know if it is by design or I have a brake drag.
View 7 Replies
I replaced my warped front brake rotors a couple thousand miles ago and all was fine but when I went to swap over to my snow tires, I can see that the outer part of the rotor has been rubbing on the caliper bracket. This is happening on both front rotors. Could my new rotors be too thick or something?
View 4 Replies
I have a 2010 f150 supercrew 4x4 with 8.8 3:55 nls rear differential. my driver side tire has a wobble to it it is wearing the inside of the tire. i have replaced the driver axle shaft with new ford oem shaft put in new axle bearings and seals on both sides and have replaced the spyder gears and i still have the wobble I don't know what is going on. the wobble is more pronounced when the tire and rim are bolted to the shaft only without the drum and caliper attached. with caliper and rotor attached i still have the wobble just not as bad however the tire wobbles going down the road more noticeable between 20-45 mph.
View 13 Replies