Ford F-150 (2009-2014) :: 2010 XLT - Blower Control - When In Floor Air Keep Going To Windshield
Feb 25, 2011
In the last few weeks I have noticed that when I have the control set to floor only (manual system, not dual) I still have more air going to windshield than the floor. I can switch to Windshield/Floor, Center Vent and all seems ok. Just when in floor only it seems to keep going to Windshield. Asked the service rep at last oil change and he said it's normal for some air to always go to the windshield/defrost. I'm going back to dealer and check a new F150 XLT to verify I have a problem.
View 1 Replies
Advertisement
So I have a 2012 xlt 5.0l single cab. Standard heat/ac with the non-navigation sync system. The blower and heat dosent work. The radio doesn't work on fm or Bluetooth. For the most part the screek doesn't say anything but if I hit the power button on the stereo the time pops up for a second. The key fob also doesn't work. When I click on the font the center console will light up but nothing will happen. The key doesn't work in the door but I'm not sure if it ever did. Intermittently it all comes back on and works just fine but cuts out again. A few times hitting the dash has made it all come back on. When it all isn't working and I press the eject button on the stereo the deck tries to spit something out and it says eject on the screen so I know the screen and the cd part of the stereo are getting power all the time. The Bluetooth doesn't work and the USB port doesn't work or charge my phone. The lights on the center console are all working but it doesn't dim when I dim the dash. I am baffled on what it could be and the harness is impossible to follow.
View 2 Replies
My blower fan will not run on setting 1. on 2 3 and 4 it will work but not on the lowest setting. I replaced the relay and it still doesn't work. I have a 2010 f150 with the 2v 4.6 .....
View 6 Replies
The windshield wipers on my 2010 F-150 do not wipe a clear path. I have tried several different brands of blades without any good results. It is like the blades have to have more tension against the glass. Is there a way to increase this tension?
View 14 Replies
For some reason, when I go up/down driveways, pull into parking lots with sloped curbs, etc, my traction control will engage and there is a grinding noise in the back on the back brakes. I don't know if this is normal or not. I had all the brakes replaced recently but that didn't stop the issue, so I don't know if this is just normal or what. Is this normal and if not, what it might be?
View 3 Replies
Started up today and no response from the A/C fan on any speed- dual climate control. Checked all fuses good. Electronic control panel shows normal with all the fan speeds, but no blower motor action.
Is it the motor or a resistor/controller? Thought with a bad resistor you would get the fan on at least in one speed.
View 14 Replies
Started up today and no response from the A/C fan on any speed- dual climate control. Checked all fuses good. Electronic control panel shows normal with all the fan speeds, but no blower motor action. Is it the motor or a resistor/controller? Thought with a bad resistor you would get the fan on at least in one speed.
View 4 Replies
I have had noise problem under dash or wherever it may be. I am not sure where the exact location because I can't pinpoint it out. I hear the noise whenever I turn on A/C or blower for windshield. Basically, anything which is related to air will make noise. It's like water striping noise. Something like cold water drops on hot metal. You can hear the noise at night clearly but during the day, it is hard to hear but still is hearable. Besides that, the car is quite. The Hyundai service has changed my blower but the noise is still there. The service man said it was hard for them to know what caused the noise but they had no clue right now.
View 8 Replies
My blower on my 2010 Lariat truck isn't working and I can't seem to figure the issue. No heat or AC. It seems that some air is coming through, and the fan indicator shows it on high, but nothing.
View 8 Replies
My fan is NOISY!!! Its noisy in AC mode, defrost mode, heat mode, vent mode.... It really sounds like a leaf got sucked in. I don't wanna mess with the dealer since I don't think its a warranty thing. So, is it as simple as dropping the glove box and three screws for the blower as I have read?
2012 Eco.....
View 6 Replies
Have a 2009 platinum, 5.4, supercrew with dualzone heating and air. The blower motor resistor block is overheating and melting the connector block. fooled with it way too much, and then put a new resistor and pigtail in it. The new resistor would kick out in about 30 seconds, so used the old resistor on the new pigtail, got hot, melted the new pigtail. What is causing the resistor block to get so hot, and what do I do about it?
View 7 Replies
2011 FX2, 81,000 miles, with dual control A/C. The blower motor works fine on speeds 1-5. Put it on speed 6 or 7 and the motor trips after about 5 seconds. Turn it back below 6 or 7 and it starts working fine. I have replaced the resistor and the blower with the same results.
I have read through a good deal of the posts and most seem to deal with the resistor and the lower speeds not working. It's like its tripping a breaker or overload.
View 8 Replies
What is the testing procedures for the blower motor controller on my 2009 150 Lariat. In the old days it was called the resistor but now it is computer controlled for the dual climate control. My fan is stuck on high, the fan switch does work(the bars on the display change when I push the fan speed button). The climate control works also, just blasts you with air and the temp is changing a lot due to the fact of the fan on High. I am 99% sure it is the blower motor controller, but I would like to test the controller.
View 14 Replies
I have a 2010 f-150. Started having issues with the blend door actuator located behind the radio so replaced that a couple months ago and fixed issue. Now the a/c will only blow through the defrost and floor vents. I replaced the lower blend door actuator thinking that might be the culprit, but did not fix the problem. What the solution might be.
View 3 Replies
I recently had a leveling kit installed on my 2014 f150 super crew 4wd. When I picked it up, I heard a humming in the front end that ended up being a bad iwe actuator. I took it to the ford dealer and they replaced it. No more humming, but now I have a very annoying vibration in my gas pedal that can also be felt in the floor board and gas pedal. I've had it aligned. I thought it might be my front driveshaft so I put it in neutral while driving and vibration is the same. It gets worse when I get up around 70mph. I also feel small jerks in the gas pedal at these speeds along with the vibration. It vibrates worse under heavy acceleration as well. Cause I can't wait to set my cruise every time I drive it bothers me that much. Only has 10,000 miles on it.
View 3 Replies
Was 7 degrees F out this morning. Went to turn on the defrost and heard this: (may need to turn up audio a bit)
2013 F150 HVAC blower noise in cold temps - YouTube
There was some snow/ice buildup under the "grate" that sits above that I imagine is the air intake for the blower. Hoping that it was just Ice buildup that will thaw out.
I ended up having to turn it on because the condensation on the windshield was becoming a safety issue when I drove into work. Motor made quite a high pitched wine. Better that than slid into a car.
View 1 Replies
I did not want to high jack the threat about the blower motor stuck on high, but on rare occasions my blower will quit all together if it is turned up too quickly. I can still hear the compressor clicking on and off, but no air moving. after waiting a few minutes it will work fine if you adjust the blower control slowly.
My truck is a 2012 lariat supercrew with navi and dual climate controls. oh and i believe i have about 300 miles left on warranty, but it is not doing it on a regular basis, i doubt the local ford dealership will repair it.
View 2 Replies
2009 FX4... Every once in a while, I'll feel a vibration in the gas pedal. It happens under acceleration, and typically if I'm pushing down and it has not downshifted yet. Then once it downshifts the vibration is less noticeable.
I have had the mechtronic unit replaced due to harsh shifting and the vibration was there before and after that was replaced. The drive shaft was also replaced due to a click/clinking noise and the vibration was there before and after as well. The harsh shifting and clinking noise was fixed with those repairs, but the vibration is still there. I notice it more when I am towing.
View 13 Replies
So now that heat of summer is here, I have been running the AC and noticed a problem. The carpet under the floor mat on the passenger side is wet. It is not from the rain but only after I run the AC. There is a good amount of water in the carpet. The condensation also runs out from under the truck like normal. Any fix to keep me from spending money at the dealer? 2011 F150 XLT.
View 10 Replies
I have a sporadic problem with my wipers - most of the time they run correct but sometimes there is an annoying chatter - I have the Bosch replacements and they run well even when dry but every once in a while they start chattering. One time the wiper blade even fell off.....if I go to the dealer, they want to see the problem but if it is sporadic they can do nothing (had a problem with a speaker and it took 3 tries before they heard the defect) - what was the solution?
2012 5.0 Lariat
View 14 Replies
I have noticed on my 2013 F150 Eco that I have seem to always have a oil type smear. on the inside of my windshield. It is very hard to clean. Looks like the ones I would get when I smoked many years ago. My Boss has a 2011 F150 ECO and we have two others in our company. We were talking at work today and it seems all 4 trucks are having this problem.
View 14 Replies
