I am changing the front and rear axle fluids on my '10 f150.The rear was no problem,the front is my issue.I took all the bolts off and loosened the cover to drain the fluid but it is a tight space and cannot take it off completely to clean it up and put on the gasket sealer.
View 2 Replies2010 F150 XLT FX4 5.4L Crew Cab Medium box, nice blue truck, lacking on chrome though.
My friend has a clunk/lag on take off from a dead stop only. Drives fine down the road, but when taking off from a complete stop, you step on the gas, and nothing happens for a second, feels like it lags, then clunks, gives a jerk, and takes off.
From talking to other newer Ford owners, seems like a common problem.
Changing the front diff fluid on truck. I was looking at mine today and it looks like the top bolts will be difficult to reach.
I also tried to suck the fluid out of the fill hole but couldn't really fit a tube into the differential.
I have a 2009 f150 platinum and have been told both sides of the story now... that the front differential is sealed and need not be changed, and also that it is unsealed and can be changed. While asking this question I might as well lump in the rear differential as well. Are they both sealed or unsealed and need to be changed???
View 3 RepliesHad the diff checked today.fluid was grey in color,looked like it might have a little water in it. 2010 limited slip. wasn't over full. 10000 miles.
View 12 RepliesI bought a used 2010 f-150. the passenger air bag cover has a small rip in it. I want to replace it & it looks like a separate part on the parts blow up. i do all my own work & was wondering if i can replace it without screwing with the air bag.
View 1 RepliesI just acquired a 2007 Ford explorer. I'm in the process of changing all the fluids and am wondering if there is room to pull the front differential cover off to clean the gunk out of the bottom of the front differential. It looks tight and I'm wondering if the differential or the steering rack and pinion need to be removed to remove the cover or if there is just enough room?
View 1 RepliesAs I was laying under my truck today I noticed a drip under the front differential, it looks like the cover is leaking by the factory RTV gasket. This is the 00' F150. How hard is it to remove these things? It looks like the front cover mount makes it difficult....
View 3 RepliesI recently installed front and rear Mag-Hytek diff covers and the front had a small leak. I thought I had gouged the housing during removal of the factory cover, so I set aside time to remove the Mag-Hytek and repair the housing. I just removed the new cover and upon inspection, there is no gouge. There is a slight scratch, but not in the area of the leak.
Upon further inspection it appears as though the o-ring wasn't properly sealing. There is a slight rust coloring where the o-ring was seated against the housing, running from where the left lower spring shackle touches the diff housing, to the bottom of the housing. The rest of the o-ring route looks clear (no rusty coloring where the o-ring was seated).
Is it possible that the spring shackle is too close to the diff, causing the new cover to not be able to seal properly? (The truck had a lift on it when I bought it. When I installed the Bilsteins, I noted that the old shocks were installed very "amateurish", so I suppose it's possible the springs were as well.)
Been suffering some take off shudder as well as the 55mph shudder and finally took the truck into the dealer who informed me it is throwing a couple of misfire codes (no CEL). Quoted for spark plugs. Looking around the boards, seems a lot of people are seeing premature wear on the ecoboost plugs and have had success regapping or replacing. Any words from 5.0L owners? What are the odds they just need regapped? I'll probably just replace them anyway, but its a good discussion. Also are they are simple to replace as it looks- just pop the coil packs off and they are there in the valve covers?
View 14 RepliesI have a 2009 f 150 two wheel drive and after reading and doing a little research I found my problem. Slip yoke same as alot of guys here,come to a stop clunk,take off clunk. My question is my warranty ran out,I had a 30,000 or three year and now I have 31,000 plus it's like the truck new when the warranty ran out. There is a TSB on it,10-22-6 NOV 10 Drivetrain - Driveshaft Slip/Bump On Accel. Or Braking... Will they do any thing for me,and how much would it cost me to have the work done at a shop.
View 11 RepliesI have a 2009 f 150 two wheel drive and after reading and doing a little research I found my problem. Slip yoke same as a lot of guys here, come to a stop clunk, take off clunk. There is a TSB on it 10-22-6 NOV 10 Drivetrain - Driveshaft Slip/Bump On Accel. I am going to pull the rear driveshaft and put in new grease MERCURY MARINE GREASE with TEFLON (2-4-c ) part nbr 92-802863A . How much do I need, will 8 ounces be enough.
View 3 RepliesMy 2012 F150 has developed an odd issue.... It doesn't seem to want to always take off in first gear. I've had it happen several times where the truck would take off in a high gear but yesterday was the worst yet....I was towing my boat and the truck attempted to take off in 5th gear....I threw it in neutral and back in drive and it was fine, what's causing it.
View 7 RepliesI have 163,000 + on my 2009 fx4. Recently I have lost my take off power and passing power. I have the manifold leak but the dealership says that's not the problem. Took it in twice to the dealership and once to an independent and nobody knows what's wrong. No codes are showing. Had a dealership tune-up at about 120,000 miles. Need some starting points cause it's very annoying and unsafe. I tow alot and the "get up and go" is gone.
View 3 RepliesI have a 2012 4x4 f150 163" wheelbase 8' bed that vibrates/shutter when you take off you fell it more when you are on an incline and a WHOLE lot more when you have a load on the truck (trailer/load of fire wood).
View 3 RepliesI've been wondering why my 5.4L sounds so grumpy at take off and then so quiet at speed.
I'm assuming this ain't factory? Looks like a flowmaster but can't find any markings on it.
I want to get dual exhaust (yes I like the look) but can't figure if I want Magnaflow or Flowmaster.
What I'm looking for is performance (is there even such a thing--rhetorical) and pure-wood-developing raw rumbling noise! Not the kind of noise but the kind that if you want to pop the throttle a bit you let the awesome guy next to you know that this truck ain't no slum.
I'm trying to figure out tips and placement-- I'm thinking straight back is the best bet?
Well it's been 300 miles since Ford applied their "special grease" and put on clamps to eliminate the clunk when slowing and the slipping feeling at take off. Now the clunk is back. Every time at 25 it downshifts and clunks, then once again at 10. Drives me nuts. My service advisor wants me to "log" these visits so we can be more aggressive with Ford to get this resolved. I love the truck, but this is annoying driveline slop. Almost like the splines weren't cut right and Ford is using heavy grease to fill the gaps......developing...
View 3 RepliesJust a quick question about the locking differential. I'm just wondering can you activate the locking diff while turning or on the gas pedal? Because today when I was climbing up an icy hill, I thought I'd turn on the locking diff,I was still on the gas when I pulled the switch. For a second I saw a warning on my dashboard, but quickly went away before I had a chance to read it. Just wondering in what conditions you can lock the diff. I also hear that you couldn't activate it while turning at a certain degree?
View 7 RepliesNew issue this week - truck developed a leak from the pinion seal. I'm not sure how much has leaked out, so I would like to top it off before limping to the dealership.
From the manual: "Motorcraft SAE 75W-140 Rear Synthetic Axle Lubricant" There is also a footnote for friction modifier required for a Trans-Loc rear diff. Assuming that footnote refers to an LSD and NOT the E-Locker, should be able to top off with just the fluid, correct?
I am a die hard for Truck fan but am really disappointed with the overall quality of the truck. I bought it new and now with 30k, I've had it in twice to have rotors turned, once for transmission getting stuck in 5th and needed a new molded leadframe assembly, and now the pinion leak. All fixed under warranty, however really unacceptable for a truck with this low of miles and an easy life.
My 2010 f150 stx 4x4 fails to lock in the front hubs...
View 2 Replies2010 F150 XLT ... Front driver side door speaker goes from working fine, to crackling, to cutting out. It`s been doing this since the day I bought it. I've had a local audio company tell me they have seen a few new Ford with that problem.
View 7 Replies