Ford F-150 (2004-2008) :: Truck Shuddered / Lost Speed And Incredibly Sluggish Trying To Get Uphill
Nov 28, 2012
My truck decided to have some issues last weekend coming home from a friends house. After being on the road for about an hour the truck shuddered, lost speed and was incredibly sluggish trying to get up the hill. It flashed the CEL and then went out. I was doing about 75 with the cruise on.
After slowing down to about 60 it stopped the shuddering and resumed operations as normal. Until about 20 minutes later when it repeated the above.
The next day I grabbed my reader and found the P0302 and P0306 codes. I cleared the codes and took it for a "test" drive up and down the mountain to see if it would trip the codes again. It didn't flip the codes. I thought I might have been dealing with a "one off" issue and left it alone for a few days.
Two days ago the CEL light came on and stayed on this time. Sure enough P0306. Cylinder 2 did not throw a code this time. After doing some research on here I ordered two new COPs and bought a mechanics stethoscope and some new spark plugs just in case.
The stethoscope confirms that cylinder 6 is having some issues. The COPs came in today so I'll take it apart tomorrow and see what I see. I'll be looking at both the COPs and the plugs to see what may be causing the problem. The "nice" thing about this is that at least it's one of the easier COPs to get to.
Should be a nice day for working on the truck.
View 7 Replies
Advertisement
I have a 2008 XL 4.2 auto trans with 60,000 miles on it. We purchased a new travel trailer with a total weight just under 5000 lbs that we pulled for about 2000 miles this summer. On the last trip we noticed the truck was missing pretty bad going up hills or under load. After we got home I started to notice the miss at times even not towing. Did a tune up with Motocraft plus and wires and seems to still have a miss at an idle and very low RPM. What would be best to check next?? Would Coil be logical?
View 10 Replies
My 2003 6.0 truck lost most of its power. It has the SCT programmer. It used to run great it would roll coal really well then it slowly started to run worse. Now it runs really sluggish especially when its cold. IT takes forever to warm up. On the freeway when ur going a constant speed it bucks and jerks a lot. It won't roll coal anymore and just runs like crap. A mechanic said I had 3 bad injectors. But I don't believe it.
View 2 Replies
I just recently bought a 337 edition gti and I absolutely love it. But the guy I bought it from says that it was chipped but he doesn't know what brand tune it is. But the problem, like the title suggests, is that in first gear the car pulls incredibly hard but as soon as I shift into second I lose all my momentum and it just feels sluggish.everyone that I've seen on these threads have said that I should be getting the most power I'm second and third gear. Is this tune just not a good one? Could there be something more?
View 7 Replies
2008 F150 5.4L .. The truck lost all power the other day driving and barely made it to work. On the ride home it was still running horribly, like it just fell on its face. the check engine light came on. Went to autozone and put HEAT in the gas tank cuz the night before it was at quarter tank and temp went from warm to freezing(thought maybe condensation in tank).. Truck ran a lot better( not perfect). Drove around that day and it was fine. Pulled down the driveway and CE light shut off. Ran the code anyways and it was P0012..
Talked to a few mechanics and they said try replacing the Camshaft position sensors..did so and it ran worse. the truck hardly would idle or rev and shook violently..i shut it down right away. Then it threw 9 codes..Cam shaft position- over retarded timing bank 1(P0012), misfire cyl2, misfire cyl3, misfire cyl 4, random misfire, cam sensor bank 1, three of them were repeated codes..
I replaced the sensors back to stock and cleared the codes. the truck is running like it was in the beginning of the problem..No vilant shaking but falling right on its face at idle and any rpm..not drivable. Would rather do the work myself. very capable except for replacing camshaft phasers which i have heard could be the issue..Could it by the VCT seliniod, EGR valve, plugs, wires...Did just change the oil a week ago and cleaned and reoiled air filter.
View 11 Replies
While driving up hill at 60mph the truck lost power. Rpm jumped up as to change gears as it hit 55mph. Still losing power until it shut off. I tried to restart and just got a click from the solenoid. No engine codes whatsoever. Battery had 12.1 volts but when turning the key to start in getting 8 volts. Had it towed home. Today I swapped batteries with my other truck and same click noise from solenoid. All lights, radio, ect still work. Where should I start? Alternator, fuses...?? 2008 f250 5.4 ...
View 12 Replies
2008 F150 5.4L. So today I was sitting at a stop light and Idk why but I just sawed the wheel a little left and a little right and my RPMs fell off. My idle is set around 600rpm and when I turned the wheel it started shuddering really hard and RPMS fell down to about 300RPM. Once I give it the gas it goes away completely....I got it back to my house and it has continued to do the same thing. The engine shudders really bad and the only thing that will sraighten it up is the throttle. Power steering fluid is full.
View 4 Replies
What is a "normal" number people see on their load factor? Mine was around 25-30 a few weeks ago but I noticed it is increasing to around 30-40 once I'm in gear, in park it's fine. My acceleration is also getting a bit sluggish too especially going up hills and my throttle isn't responding all the way, my turbo boost is normal though and I don't think there is any VGT stiction. I'm thinking either a fuel filter or a MAF sensor to start with. Fuel filters have been in exactly 10 months. Can a dirty fuel filter, air filter, or MAF sensor affect engine load at idle and how fast it accelerates? I feel like I'm pulling a trailer and with it being more sluggish, my transmission is shifting harder as well.
View 14 Replies
2007 F150 King Ranche 4wd 5.4 192000 miles.
I started noticing a little stutter when trying to hold 45 mph if I hit a mild incline, and also at 70 or so if i hit an incline.
Around the same time, I noticed that acceleration seemed sluggish when getting on the interstate. Gas mileage dropped from 16-17 mpg combined to 12-13 mpg combined.
Historically, since I bought the truck 3 years ago, if I go WOT to get up to highway speed (Not my normal mode of driving, more of a test) I would get a misfire on cylinder 8.
About 2 weeks ago, driving around town, I got a check engine light. The code said it was rich on bank 2. Cleared the code, it has not come back.
Here is what I have done:
Flushed the tranny (Vehicle history shows this has been done consistently since original purchase)
Changed all 8 plugs (none broke!) and all 8 COPs. - Fixed the misfire on cylinder 8.
Still sluggish and still have the stutter at 45 and 70 on an incline. I know it's not a racecar, but 0-60 in 19.6 seconds seems quite unreasonable.
New Fuel Filter
New Air filter
Cleaned MAF sensor
Had the back pressure on exhaust checked. No blockage there.
My torque app tells me the TPS is functioning normally.
No codes are being thrown, no CEL at this time.
What am I missing? I have a reader that will chart up to 8 sensors as I drive.
View 6 Replies
Lately I have been having problems loosing power. Truck wants to miss mostly going up hill and runs sluggish I'll pull off the road and let it idle for a minute and it will run fine. And it is only occasionally some days it don't happen at all and other days it happens quit often. New fuel filter, oil is good, had it on the scanner and isn't throwing any codes. Around 230k miles newer injectors.
View 10 Replies
Friend lost reverse and truck shakes at 35 and above seems like it needs a new transmission. What years are a match for this transmission and any other models trans match?
View 2 Replies
Triton 4.6, new air filter, throttle body cleaned, new fuel filter. Seems sluggish off idle, and when I let off accelerator, rpm's take a few seconds to come down. If the truck is setting still, a quick hit on the throttle takes a second for the engine to build rpm's.
View 10 Replies
I've got an 04' F150 and the ONLY problem I have with it is a ridiculously sluggish throttle. I bought the Superchips Tuner in hopes of eliminating this, but the delay in the throttle is still there (power is much better however). When I talk delay, I am talking hitting the gas and probably a realistic .5-1 sec delay. It is quite annoying to say the least.
My question...is there something that I can do myself to improve the throttle response? I drove an older 150..probably an 02 or 03 and it felt sooooo much more powerful just do to the throttle. I am even willing to ditch the Superchips if the Ford re-tune would do a better job.
View 14 Replies
i own a 2005 f150 supercrew fx4. Today as I was attempting to go out of town I was accelerating up hill and heard a noise, sounded like air coming through a window seal or scratching, which is not the problem. The noise only came on when i increased the acceleration, there is no power loss, the truck still accelerated properly and had good power, just that the noise came on. so i returned home only to hear the problem on flat land also, when pressing the gas to accelerate. The truck seems to idle fine and have no problem with low acceleration.
View 2 Replies
I found recently that my 04' Prius' engine easily goes higher rev than before (based on engine sound pitch). It happens mainly when cold start, go up hill. After warmed up and on flat road, it goes back to normal. Overall, still in great condition at 211K. MPG stays at 46 on meter when temp is around 45F with 50% highway drive at 100 miles/day. I suspect the serpentine belt slippery or something. What do you think? I think the belt is original. I bought it used at 104K.
View 4 Replies
I just replace the engine in my car and I had new plugs and wires put in as well. Ever since the new engine, the car doesn't go up hills well and it is very sluggish from a stand still position. As long as I am driving on a flat surface I am good once I get up speed. I went to autozone and I got a P0300 code. Is this a bad ignition coil or maybe a clogged catalytic converter?
View 10 Replies
Have a problem with a stutter when I press the accelerator while going up hill. I even had this problem driving on a flat road but that was a 1 time thing and happens every time I go up hill. Had a coil replaced that came off of an '04 because one of mine went bad which caused it to shake whenever I came to a stop. Wondering if the coil has anything to do with it... 2007 5.4L ....
View 1 Replies
2005 Ford F150 lariat 5.4
I had a misfire under a bit of a load (acceleration) and up hills. I changed spark plus with OEM Motor craft ones, truck ran super nice for a couple week.
Had the engine light flash, slow down and the RPM go up a tiny bit then back down and the light goes off
Now I'm back to miss fire different location, and a rough idle. I've swapped coil packs around and the miss fire stayed on cylinder 4.
Spark plug screwed or injector or ?????
View 14 Replies
I have a 2004 F-150 SCrew Lariat 4X4 with 80K miles. Over the past month or so, every once in awhile there would be a loud metallic "clacking" sound (kind of like sticking a peice of aluminum in a bike's spokes) that would start at higher speeds and would turn into a low pitched whirring gear sound as I slowed down and eventually there would be a thud followed by a sensation of running over a small bump and the noise would be gone. Kind of confusing I know, but that is the best way to describe it. My gut feeling is a wheel bearing or transmission problem....
View 9 Replies
2004 F150 FX4 5.4L. I drove from Vancouver to Edmonton and back this week and I started to get some issues. If I'm in overdrive at highway speeds, from about 90km/h to 120km/h give or take, which would be around 1600-2100rpm, and then I try to accelerate, sometimes on flats, rarely on downhills, but always on uphills, the truck will begin to jerk fore and aft. It feels like it's something through the driveline, either the driveshaft or the differential, but I really can't say for certain as I'm stuck in the driver's seat while this is happening.
If the truck downshifts or if I take it out of overdrive, i.e. getting the revs up high, the problem is no more. Other than the issue I'm having, it operates perfectly so this is very odd. I know that overdrive isn't a hill climbing gear, but normally an engine in the wrong gear will simply lug along until it's downshifted. The entire truck jerking shouldn't happen.
On my way to Edmonton, I noticed that this would cause one single, minor jerk. This is my way of describing it, but it was like the driveshaft had spun freely and then promptly re-engaged with the differential gear, causing a clunk. I doubt that's actually what happened, but I'm just trying to explain the sensation. It kind of feels like trailer jerking.
On the way back to Vancouver, it was a lot worse. Like I said, the whole truck would be jerking about once per second but there was one time that I found the sweet spot and it began jerking rapidly, twice per second. I threw it out of overdrive to stop this but the vibration caused the check engine light to flash a few times but it went away and didn't stay on.
What I might be up against? Been doing a little research. Seems as though this is common and it's supposedly the spark plugs, but those only have 50,000km on them.
View 11 Replies
2006 F150 Triton 5.4 Motor... It's been over a months journey with fixing this truck....
How it started: had an oil change, a while back, on long drive after, check engine light started flashing as I accelerated up hill so I pulled over and in a while it was ok, but couldn't get on the gas too much, or it would cause that flashy light thing.
So fast forward to now, after driving it with an intermittent miss for a while, was driving it to work and the miss became a shudder, and she stopped going over 30-40, and runs extremely rough.
Steady but loud idle.
Replaced all plugs with motocraft plugs and new coils all around. No change.
Finally hooked it up to a computer and got random misfires, now it's saying
P0174 bank 2 too lean,
But it's bank ONE that's the only side misfiring.
Here are the freeze frame details:
Frame 1 Mod $00
MIL Status Off
Troub Code P0174
Abslt TPS 24.3%
Eng speed 1665
Baro PRS 71 kpa
Calc Load 100%
[Code].....
View 3 Replies
