My 2004 f150 xlt has been extremely shaky after exceeding 60 mph thus was a slight problem that has been getting worst it's shaking so hard I feel like the mirror is gonna fall of. What could this be?
View 4 Replieswhat can i do to make my truck really lout? ive already cut 2 cats out and ran 2.25 strait pipes and its not even that loud would it hurt to cut the other 2 cats out??
View 10 RepliesA week and a half ago I went out to my truck to go somewhere and I got about 2 blocks away and the truck started running really rough and had a big lack of power, so I turned around and scanned it with my code reader and the codes I got were p2271, p2196, p0303, p0012, p2197, and p2272. since then I've changed all the spark plugs, boots, swapped all the coils and injectors from a great running truck, fuel filter, and the bank 1 upstream O2 sensor.
the other thing that came to mind that could of caused the problem is that a few days before the problem started. I jump started a co-workers car and he hooked the cables up backwards on his car. Could this be the cause of the problems I'm having.
The truck is an 05 F150 FX4 5.4 with 180,000 miles on it.
I have a 1999 Chevy Tahoe 4WD 5.7L 2 door. I recently had both my upper and lower ball joints replaced along with an alignment. Recently, I noticed I have an extremely shaky wheel and it feels like the front of the vehicle is just rattling. I never had this problem in the past. It seems to do it going between 30-55 mph. Also, on back country roads where they are bumpy. Never happens on the highway.
View 3 RepliesMy spine was damaged in an IED blast in Iraq a few years ago and my truck is getting harder and harder to drive. It sends every little bump up me. It looks like I have the original shocks on there.
What is recommended for shocks or possibly seat upgrades or any other possible solutions. I love my truck and don't want have to get something else.
The most I haul is my jeep on a trailer and occasionally two jeeps (8000lbs)...
My truck will not go above 30 mph - rpm's will rev high but, speed will not climb. I was able to put the truck in 2nd gear and drive home at @ 40 mph. Truck has 135K miles on it, I'm the original owner. What this might be?
View 14 RepliesI was driving my 94 civic lx yesterday, and noticed that on acceleration the car would die when exceeding 3000 rpm, so I proceeded driving not exceeding those rpms. After a few minutes, that “ceiling” decreased to 2700 rpm, then to 2500 and so on. In the course of 10 minutes the car died and would not start. I checked the spark, and fuel pressure everything seems to be fine. It cannot be the fuse because the car was dying slowly, like something was limiting the rpms.
View 12 RepliesI own a Trailblazer 02' LS and its at 152,000 miles at this point. I am currently debating on whether its a better strategy to fix this current issue (explained further below) or start saving for another vehicle.
The problem I am having is the truck will sound extremely rough at random periods when im off the gas pedal. Sometimes it will try and shut off but comes back to me when jam on the gas pedal. Also sometimes during all of this, The oil pressure gauge will drop to 0 and go back up once I hit the gas pedal.
Random things: AC buttons 1-4 don't work but 5 does sometimes. It also Idles at 500 RPM's instead of 1000 like I've seen on other newer cars.
My buddies truck runs fine, but when he floors it he says it dies out. Like it shuts off. Lets off the throttle n it comes back.
View 3 Replies2004 f150, Column shift Auto...
Today I stopped the truck put it into park and shut it off, everything worked fine, when I went to go start it back up it started but I cant put it out of park, I called FORD and they said put the key into the on position press the break as hard as you can and put it into neutral, we tried that and it didn't work, then they asked if we could move the truck because it could be struck or something still nothing... We tried the little cap and hold it to override the solenoid but it didn't work I dunno if I am doing it wrong so Is there any other things I can try or can you walk me through the override button here's what I did with that.
Opened the cap with a flat head
pushed it in
And started tried to shift
Is that what you do or what do you need to do??
Is there any way I could check the solenoid how do i take apart the column to do that?
I've got a 2005 F-150 (5.4 triton) with about 35k miles that I rarely use in 4x4 mode. The other day, after stopping to fill up with gas, the truck 4x4 Lo light was on after starting it. The dashboard switch was still in 2H mode as I never switched it. I first thought that the dashboard light might be in error, but when I began to pull out of the gas station. the truck was in fact in 4x4 Lo. I had forgotten how to cycle it back to 2H so I slowly drove about 3 miles home at 20 mph.
Once home, I re-read the tranny sync sequence and managed to get back to 4x2. I called the dealer who never heard of a truck getting into that Lo mode w/o activating the switch and suggested that I just monitor it. I read a number of forum threads discussing the IWE and solenoid problems, but all of those threads dealt with issues of not being able to get too 4x4 mode. My biggest concern is that I leave in a month for a 2000 mile trip, towing a cargo trailer and I'd hate to inadvertently switch into 4/4 when traveling 60 mpg on a highway.
I'm having an issue with my 2005 f150 xlt. Its been happening for almost near a month and still cant locate the issue .
It has a vibration at 75km throughout the whole truck. Ive tried multiple things done to it by a mechanic, such as having the tires balanced and the ujoints replaced. The problem still persisted and after attempting to test out to see if press/releasing the parking break (my mechani suggested trying that out), my driveshaft fell off.
Apparently the center bearing snapped and cant simply be replaced on the 05's. So i had to get a new driveshaft installed (used, both the 3 mechanics I've gone to say its in good condition).
Even after replacing the driveshaft the issue persists - however it seems a bit softer than it was (I am guessing the old driveshaft was worn from the vibration causing it to be worse). After that I took it to another shop to see if they could locate the issue. They did a driveline inspection and engine inspection too see if a misfire could be the cause.
Again, nothing was found. The only thing they were able to find was that the issue only happens under load and slightly occurs at 40 and 100km as well (although alot softer then the one at 75) and they say they cant find anything physically and it was a mystery to them.
I was just wondering how do I find out if my FX4 has a locked rear? We bought it used so I have no clue.
View 14 RepliesJust got an 04 f150 STX 4.6L Regular cab.
Drove fine for a few months (she's a little rough, but she does the trick).
The other day, I went out to go to work, truck would start and run, won't come out of park. Both turn signal indicators on the dash are illuminated, turn signals, flashers, radio and Climate controls do not work.
Currently driving with the emergency shifter release pulled out and zip tied open. First thought was interlock switch, but I'm not sure if that would affect everything else.
This happened once before, and I pulled all the taillights and checked all fuses, then it just seemed to work again after flipping the rheostat for the interior/dash lights. didn't work this time around.
Dash is all torn apart - where to start looking?
I have a 2004 150 with 165,000 miles I sometimes pull a 5 by 8 trailer. when pulling trailer in overdrive and excelorating the engone will cough several times. I took it to a mechanic and he told me that there was nothing he could do that I needed a new engine. I can pull trailer out of overdrive with no problem. don't undrstand why I need new engine....
View 3 RepliesI may have to replace the starter on my truck. Have heard it is difficult especially on the top bolt. Any stickys/bulletins on how to do this.
View 1 RepliesTrying 1.5 spacers on an f 150? Im not sure if wider is better.
View 5 RepliesE brakes were sticking so I took off wheels, rotors, calipers, and cleaned the E Brake caliper and lubed it. Started driving and E brakes are still sticking? What gives? Could the cable be hung up? Wonder if I should replace the E brake cables.
View 4 RepliesI was getting a misfire in #4 cyl. Couldn't afford to change all my plugs, so I replaced the one that was missing. Two weeks went by, truck ran fine, then it started missing really hard (same cyl #4). Thought my COP was bad, so replaced that and the boot.
Drove my truck to work last night, seemed to run fine, but this morning, it started to sputter again around 45-55. Plug in my OBD2 and it wasn't throwing any codes, seemed to idle just fine.
When I got home I put it park and revved the engine a little bit. Got it around 2500 rpm and it sounded like I have a air leak in a way. What do at this point. It is a 2007 F150 5.4 triton with 104xxx on it.
My garage measures exactly 235" deep, and I would have to remove some shelving on the back wall to get it. I want a used F150 with an extended cab, and so due to the length restrictions, it needs to have a short bed.
One Used Truck dealer actually measured an F150 he had for sale, and it measured 228", which would have left 7" if I had bought his truck. So part of my question is if all F150's are the same length, do they vary by year, body style, etc..., but my main question is if it's possible to know the overall length of the truck just by having the VIN#.
Weeks ago, I found a particular "VIN Checker" website that gave me the length of one particular F150 based on the VIN#, but I didn't bother to save the VIN Checker website, and despite the fact that I've used several sites to check several trucks, the "overall length" specification has not been listed once, ever since.
So I don't know if there was something special about that particular site, or if the overall length spec is only available (via the VIN#) in certain years, on certain models, or what. So I'm asking.
The main reason is if I'm looking at a truck and I can get the VIN. Note I see other physical dimension specs all the time, width, etc... but length is the one that I DON'T see. I don't know if this is because the VIN checking websites don't have/can't get the information..
I have an 05 150, 5.4l, My truck idles around 600 rpm when warm, I think that may be slightly low. Not sure what to check on.
View 1 Replies