I have a 2008 F-150. When moving gear selector from park to either reverse or drive, trans has a delay engaging. After engagement, it runs fine, shifts ok, downshifts ok....
View 7 RepliesI have a 2005 Ford F-150 with a 4.6L and auto tranny non 4 wheel drive. I have a hard time moving from park to drive and reverse. Is there a switch that lets you put it in gear once the brake pedal is depressed? Could that have gone bad?
View 5 RepliesI have noticed that I have to hold my gear selector towards park to get the reverse lights to come on. Also some times I have to hold it towards park to get it to start. I changed my tranny in Dec 2009 and occasionally it would do this while starting, just noticed the reverse lights about a week ago. Tried moving the cable where it attaches to the tranny a couple of serrations each direction. No luck. Is there another place I can make an adjustment?
View 14 RepliesI have a 08 6.4l F250SD. At 127k miles, it has been a great truck. All service has been performed by dealer. When I shift from Park into drive there is a 3-5 second delay, and when it drops into drive the truck rocks. Once driving there are no shift issues. Into reverse there are no issues.
View 14 Replies2010 Prius 52K miles... Not engaging in Drive or Reverse, Engine is not starting either. Got Message - Put in park , All the lights are ON , in the Dash .
View 11 RepliesMy selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesOn my 04 150 auto, the clip that holds the shift cable to the trans selector shaft broke, Ford says i need to buy the whole cable and what did you do?
View 2 RepliesI have a 2015 with 10k miles on it and every once and a while, when I come to a complete stop and shift into reverse, I take my foot off of the brake pedal and the car will sit there for up to 5 seconds. Then, it kicks in and starts rolling backwards. This has happened 6 times now. Giving it gas doesn't seem to work along. I took it to the dealer today for it's 10k service, and they cannot find anything wrong with it. There are no codes in the computer, the fluid is where it should be, and they think the Neuspeed Power Module has something to do with it. I told them it happened before I installed that piece. I can assure you I am not racing in reverse.
View 7 RepliesI have an automatic 2004 f150 fx4 with a 5.4 engine. I just bought the truck and noticed the other day that when I shift into reverse, there is a 1-2 second delay. Sometimes it will shift quicker than other times. Drive seems to be a little more swift I think. Everything seems to run smooth and the shifting is very smoot other than the delay. Is this normal or what could be some of the causes. The previous owner has the ATF changed this pst summer and it looks and smells fine other than maybe having to much fluid.
View 2 RepliesI have a 2001 Sport Trac. I was hooking up my boat, and went to put it into "R" and heard something that sounded like plastic break. Then, the gear selector seemed to move freely between all the gears. I know it is a pretty vague question, but what part do I ask for to repair it. Or more importantly, HOW do I repair it?
View 1 RepliesI have read through the folders and many websites on 4x4 problems. My problem has to deal with my four wheel drive not wanting to engage. It has nothing to do with the front end or solenoids. When I put it into 4x4, hi or low it will not send any power to my transfer case motor. It wont even illuminate any lights on the selector switch. I have checked all fuses and replaced any relays that have to do with the 4x4. Where I should go with this?
View 7 RepliesI have a 2005 F-150 with ESOF. When I turn the switch to 4x4 or 4low the lights on the dash will turn on but the front tires will not turn. I checked all the fuses and they were good. I'm not very familiar with this 4x4 system, what the issue is or on how to fix it?
View 3 RepliesI have an Elantra 2012 sedan GL and last year i tried installing HID's. It worked for a whole but then it stopped after. I learned that it wasn't getting enough power so then yesterday I bought a wiring kit to be able to wire my HID to tap to the battery to get more power. Everything was fine till I got to work but when I had to leave work., there was an issue. Whenever i switch the gear from park to drive or reverse or neutral. My car seems to jerk. And when I'm driving and it changes gears, it also jerks. Kind of the same thing how if your driving a manual car and you change gears wrong. This happens when my lights are off. But when i turn them on it then stops. And when i turn it back of it doesn't do it anymore.
View 5 RepliesThe car has about 53k miles. The problem has persisted since probably 20k miles. The whine is only after the trans warms up and is in drive or reverse, not in neutral. Whine is while the car is stationary or moving at low speed. The whine doesn't seem to change due to gear it is in. It does not change frequency with engine RPM. It does seem to diminish the more load the transmission is under.
Whine is probably not an accurate description, it sounds like a noisy pressure relief valve. Had Hyundai service look at it and all they said was all pressures in the transmission are normal. They could not find any cause.
It sounds like a bunch of small ball bearings running in a loop and can hear each one impact. Sharp raspy impact type sound.
You cannot hear it from the interior but it is quite pronounced while in the garage or if you hear the car coming down the driveway.
Parked truck, went to leave and truck starts and runs fine, says brake problem on message, wont let me move gear selector out of park, is there a way to do this manually and get it to neutral so it can be towed??
View 2 RepliesI have a 2004 6.0 with the 5L110 transfer and torqueshift transmission. While test driving after installing everything, I didn't get 7 ft down the road and the tires locked up and she came to a dead stop. Now I only have reverse but I can still feel the tranny engaging into drive but will not move.
View 2 RepliesMy car is having delayed shifting (2.0t Auto) when shifting from Park to Drive. Also, whenever im slowing down to turn right or left, and press the gas, it seems to lurch forwars, as it is still downshifting, which seems to be really delayed. Im hoping its the Valve Body since its covered under extended warranty until October, and want to get this taken care of before I trade this piece of crap in for a Ford or Honda. Its in the shop (won't let VW touch it since the dealer screwed up several times), and was wondering if this sounds like an issue of the Valve Body...
View 11 RepliesThe other day I had a metal pin fall out from under my dash and hit me on the foot (only reason I would have know if fell out till I clean the truck)
Ever since then the gear selector handle for my transmission has become sloppy and when I go to turn off the truck, I have to hold the arm up to turn key off all the way. I have looked to try and find where it goes and cannot find the location. I have also looked at a blown up parts diagram and cannot find it. Where it goes?
2002 F250 SD V10 with auto...
I am trying to solve a mystery on my mom's truck. It's an '06 4.2L F-150 STX with about 133k miles. It had a check engine light on until today- I cleaned the TB and changed air filter yesterday, and both were filthy. Code vanished later on while driving.
I want to check the PCV because the truck idles high and rough in any setting from park to OD, stopped or moving. Worse when stopped though. Entire coil pack has already been changed due to previous misfire problems. This feels similar to a misfire but without the acceleration hesitation. It has also had a recent oil change, and fuel/oil filter change as well.
There is only one hose connecting to the intake on this truck, and it appears to be a vapor line of some sort to the valve cover, but isn't a PCV cause it's just a hollow tube. There is nothing else coming out of the TB at all, except for the throttle control cable. I don't even seen any nipples or connections or holes where a PCV hose or valve should go. I thought it was on the passenger side, under the TB... but there is nothing here at all. I'm stumped.
I am beginning to think the truck just does not have one at all, which I know for a fact is impossible. I have traced every line on this motor from top to bottom, and I do not see it. Should have a heater on it I assume? What else can make the truck so rough? I don't buy it that "it's just that way". That is complete, lazy, BS. I have had/driven many trucks; 4x4s, supercrew, diesels, jeeps, dump trucks... I have NEVER had a truck run as badly and roughly as this one does. Heck, a twin-turbo 700HP diesel doesn't run this roughly.
I have a 2004 Explorer 4.0L with 190,000 miles. My wife was driving it and the vehicle stopped moving. Sounds like the torque converter whining and will not drive in any gear or 4wd.
View 1 RepliesToday I noticed that our 5R110 was delaying slightly when shifting from drive to reverse. It was probably about a 1-2 second delay but it replicated itself twice in a row. There was no delay going from reverse to drive. It is just an engagement delay. We are running a Superchips Heavy Tow tune on the truck, it is a 2006 6.0 Powerstroke.
View 4 Replies