Ford F-150 (2004-2008) :: Tranny Slipping When Pulled Away Up The Hill
Jun 2, 2011
Let me first say that my knowledge about vehicles is nearly non existent. Yesterday I was stopped at a light on a hill. When I pulled away up the hill it felt like the tranny was slipping real bad. I coasted into a gas station and stopped. I gave it the once over look around to see if I could see anything unusual. All looked ok, so I wondered if maybe it wasn't all the way into gear or something.
I limped it home only 2 miles and it was seemingly normal although I was real gentle and it was all flat or downhill. Later that night I drove it around the block and it was shuddering and banging and seemed to be slipping again. My question is doesn't the transmission usually go over time, or does it fail suddenly like this. Could it be something else? And lastly what does a rebuild cost. Truck is 06 FX4 54000 miles 3.73 gears. Edge Evolution on level 2.
I tow a Trailer a few times a year 7000 lbs fully loaded, if I do need a new tranny should I replace to a different gear.
View 5 Replies
Advertisement
I have a older minimax with the latest updates and have noticed that under full acceleration the tranny seems to rev up faster than the truck is accelerating. This occurs i think in 3rd gear like accelerating onto a on ramp etc. Kinda like its slipping if you know what I mean. I'm running the mild tunes in tow mode. Everything else seems ok.
View 7 Replies
I came across this site that seems to implicate very common issues with failures in gen 2 : Transmission Slipping ! | Hybrid Cars
With people experiencing lack of power and "slipping" sensation or tranny going from drive to neutral.
I thought there were common issues with gen 1 motors burning up inside transaxle, but I thought gen 2 was much improved with only rare failures. Yes, I did read both sticky threads giving very detailed accounts how to replace them.
View 13 Replies
What happened is I went to get in the truck I opened the door and the gauges and blower motor came on by itself like the ignition is in the on position. I put the key in the ignition and the truck didn't do anything. No crank or anything and I did notice the anti theft light blinking really fast. I unplugged the battery and plugged it back up then the truck started but I went to shut it off and pulled the key out the ignition and truck stayed running. But also the blower in the truck and the gauges are still staying on. People keep saying it's my key but why would the stuff cut on by itself inside the truck when I just opened the door?
View 9 Replies
When I went to pull my key out of the ignition yesterday the key got a bit stuck and when I jiggled it a little to pull it out the chrome bezel that locks the tumbler in fell out. Now the tumbler is out as well and I cant figure out how to get the tumbler in and lock the bezel in place.
I see a pin on the bottom of the ignition cylinder that I should be able to push in and pull the cylinder out but I cant seem to push the pin in at all.
View 3 Replies
I have an 05 F-150 Lariat 5.4 and it has been going haywire today. While driving if I hit a hard bump the power will cut off (radio, a/c) and even sometimes the truck. Check engine light came on and I pulled codes P2160 & P0506. Also, when it completely cuts off and I start it back up it says "engine in failsafe mode".
View 1 Replies
I have a 2006 F150 4x4, tow package 5.4, edge tuner, magnanflow muffler.
Towing a 21ft fifth-wheel, trailer weighs 4000 lbs, my trans temp will get up around 250 when pulling a large hill.
What is hot for a transmission?
View 13 Replies
2006 fx4 f150 5.4 flex 52,000 miles ... Just got home from a 800 mile round trip vacation, seems I've developed a miss or a tranny problem. The truck runs/idles fine, shifts fine, everything is as normal. Except maybe 12 times while under a load, like climbing a hill, the truck would "bump" that's the only way I can describe it. I only noticed it in Drive/Overdrive. I hoped I had water in the gas so I added gas treatment at 2 fill ups, still seems to do it occasionally. Where to start? I'm going to get a fuel filter today, the one that's on it only has about 12k on it....
View 13 Replies
My 2004 started shuddering at 45mph or while going up a 4-6 degree hill. It was well past the suggested 100,000 mile spark plug change. I thought about changing the plugs myself until I heard that they could possibly break and would be difficult to remove. I took the truck to a shop and had the plugs changed.
For about 2 days it ran okay, but the shudder returned and we got PO303 (mis-fire cylinder #3), PO316 (mis-fire on start-up), and PO171 (system to lean, bank one) Codes. The shop replaced the fuel injector on cylinder #3 and again the truck ran okay for about 2 days. My son and I cleaned the other three injectors on bank one, cleaned most of the sensors and the MAF.
That work cleared the PO171 Code, but we still had a mis-fire on cylinder #3. We swapped the spark plugs between #1 and #3 and got a mis-fire on cylinder #1. We replaced the plug on cylinder #1 and that cleared the code. The truck is running great.
View 4 Replies
I bought a 2004 F150 XLT 4x4 122,000KM. I used to have a 1995 BMW 318TI but I built a cabin and a truck seems to go with it. I have already done some work like new plugs, oil change, tranny flush, fuel filter change and Air Filter. I noticed about 2 weeks ago going up to the cabin a rattle sound when I was going up a hill. It is coming from the right side (FRONT) and it sounds like its from the wheel. I really does it if I give it some gas and then press a bit more on the peddle and then you here like marbles in a tin can if that makes sense. I just got back from my mechanic and we took it out and it is still doing it so we jacked it up and checked everything. Their are no loose clips and back plates making noise. We did notice that a heat shield near the cat was rubbing and we adjusted it, this did not solve out problem. We were both looking at each other after an hour wondering what the hell this could be. I am going back on Wed and he is going to hook it up with some kind of machine with microphones and a headset to pinpoint the problem. It does not affect the performance of the truck but it is very annoying when I need to give it some gas to pass or go up a big hill.
View 4 Replies
I have a 2004 Ford F150 with 149,000 miles I have recently put 5,000$ In the motor that is a 5.4 V8 before it would shake and make a terrible noise got a brand new engine from Ford put in by a ford mechanic but now my rear end squeaks like crazy and it is all the time more so when going up or down a hill or when it's shifting more or less or going over a ruff surface that's been going on awhile and was told I needed a new rear end by the same ford mechanic and wanted 1,000 to fix it!
But also said the whining noise that is coming from the front was the transmission and that I shouldn't worry about it to drive it till it goes out but it's a terrible whining noise that you only hear it when your in gear not in park or neural the truck sounds good what causes this whining noise?? Not done yet but recently the front driver side around the wheel has also gotten a squeak mostly when in low speeds and turning to the left! What to do? I'm already replacing the motor! Hopefully these are some easy fixes! I've done some research and the whining from the front that I was told to be the transmission doesn't seem to be that I would think more along the lines of pulley or alt!
View 2 Replies
I have a 2012 Ford 4x4 crew cab 150 xlt. 15,000 miles. When pulling my dump trailer I was stopping to turn and the transmission disengaged. Once I turned the corner coasting the transmission kicked back in again. During this happening pushing the gas did nothing but rev up engine. My dealer said if this happened that a warning light would of came on or a wrench would appear on dash but it didn't. He said then it didn't happen. This happened 3 times in 10 miles of driving. I had it in tow mode.
View 4 Replies
Ok I have been trying to find out what is going on with my truck and I cant seem to find anything on here that points to all the symptoms I am having. I have a 05 xlt 4x4 with 5.4. For the last 5 months or so I have been noticing a slip or grinding noise when I go up a hill and it downshifts into I believe 3rd gear. It sounds like going over rumble strips on the road but only lasts a second. It also does it sometimes when I pull out from a stop.Also when I let off gas or brake to a stop it seems to shudder a bit.
Maybe its my imagination since I keep hearing for the grinding sound, I don't know anymore.Its driving me nuts(er). It doesn't do it all the time either.It has only 65,000 miles on it and never towed. I know I am due for a total tranny flush since it never had one. Could this be the whole problem? Iv been reading other stories that sound close to mine but they never mentioned about the noise when pulling out. Could it be the rear end? I am totally lost on this one.Other then that problem it runs great. Shifts nice.
View 3 Replies
Some what sounds to be metal-on-metal squealing seems to be getting worse. It's coming from the tranny only when it's not torque-converter locked and varies with tranny speed, not necessarily rpms.
Slippage? Signs of some serious problems?
Truck has 90K on it. I don't tow. I changed the tranny fluid about 60K ago. I just checked the fluid on the dipstick tonight and it's still light pink and clear, but I have not dropped the pan to see what's inside yet. No codes and the truck drives perfectly well otherwise.
View 4 Replies
Well this weekend I'm doing quite a bit of work to the truck. My tires and exhaust got delivered last night, now I'm just waiting on the leveling kit. Here's my issue:
For a little while now (5k-ish miles) going in and out of overdrive the tranny makes a clunk noise during the shift. Time to change the tranny fluid and filter? I am making a trip up north on Sunday and don't want to have the tranny the bed on the way.
On saturday I am doing the leveling kit (2"), brakes, exhaust (MBRP), and new tires (325/60r20 Terra Grapplers). Should I go ahead and do the tranny fluid and filter while I'm at it, or just wait till I get back. I am figuring on about 2k miles throughout the trip.
View 2 Replies
1991 Ranger 4.0L A4LD... Its a 4x4. ext cab
What else will bolt up to this 4.0L? Could i put a 4R44E/4R55E tranny? Is there a good stick that bolts up?
View 5 Replies
2000 X V10 4WD... 178K. Truck was not well maintained for most of it's existence. Drained both the TC and Drain pain and replaced the oil filter. Tranny oil looked like crude and a lot of tiny specs of metal - it shimmered in the sun... needless to say - I'm pretty sure it had never been changed.
Now - issues since I've gotten it done... Tranny has been slipping... I figured that I may not have filled it enough and after adding a few quarts, it seems to have stopped. Slipping was initially just when going from a stop.
Now it's having a problem where the engine dies when I shift from one position to another... For instance - from Park to Reverse, the engine RPMs drop as the clutch engages - but they drop from about 900 RPM down to about 500. And 50/50 chance the engine dies. Going from Park to Drive, the same thing but maybe drops to about 700 RPMs. Tried it in 2nd and 1st gear. Has happened in both. I've tried shifting to OD first before going to 2nd to 1st or vice versa and seems to behave better.
Should I flash the ECU and have it relearn the shift points? Did I overfill? Between the TC and Drain Pan - about 16 qts came out. I've been checking the dipstick - no frothing or bubbles. When running and in park - it actually shows low. Seems to drive fine once it's on the road. The engine cutting off when it's put into gear is really unexpected.
View 13 Replies
Took my first camping with 2012 King Ranch F350 and 37 feet Challenger 12k fifth wheel trailer over the weekend.
I noticed there is lot of transmission slips in first gear. Once it enters 2nd gear, no more slips.
My previous Chev 2008 2500HD diesel didn't slip much with same trailer.
Is this normal for this F350? My rear ratio is 3.55. No slips without hauling.
Maybe I need to ask dealer to check 1st gear towing?
View 14 Replies
This is my first experience with auto tranny trouble so I'm a bit out of my depth. It started a few days ago. When you put it in gear and step on the gas, the engine revs, but no forward movement. If you keep giving it gas and rev it up, it will eventually grab and off you go. This happened around town after I took it to work last week when I went out for lunch.
When I drove it home, it slipped in and out several times in town, then by the time I got out of town (maybe 5 minutes driving) it evened out and didn't slip the rest of the way home (a 45 min drive). My assumption is that once it warmed up a bit that stopped the slipping. I checked the transmission fluid when I got back from lunch, and it was a little high. I drove it again today a week later and same thing only I didn't drive it long enough for it to warm up and stop slipping like it did the other day.
Other details: The truck is a 4x4, extended cab, v6 Ford Ranger with about 175k miles on it. I've had it about 1 1/2 years and its performed great up till now.
View 5 Replies
Feels like my transmission is slipping from 40m/hr to 65m/hr. But only when I am at a constant speed and not when i am accelerating. only happens when I am at approximately 1400rpms and while in overdrive. Does not happen in any other gear just overdrive.
View 1 Replies
04 F-150 2WD 5.4L AUTO Extended cab
I had my tranny rebuilt under warranty at about 70K and I'm now at 167K. When it was rebuilt (by Ford) it still had a slip feel when I picked it up. Rode the mechanic around the yard and he felt it. Dead stop and take off while turning. Like from a stop sign. He took it back and found a sensor/module/something that was the culprit. Seems I remember they found it with a computer? Is there a computer/reader that will diagnose a tranny?
View 9 Replies
