Ford F-150 (2004-2008) :: Tranny Clunk While Going In / Out Of Overdrive
Jun 23, 2011
Well this weekend I'm doing quite a bit of work to the truck. My tires and exhaust got delivered last night, now I'm just waiting on the leveling kit. Here's my issue:
For a little while now (5k-ish miles) going in and out of overdrive the tranny makes a clunk noise during the shift. Time to change the tranny fluid and filter? I am making a trip up north on Sunday and don't want to have the tranny the bed on the way.
On saturday I am doing the leveling kit (2"), brakes, exhaust (MBRP), and new tires (325/60r20 Terra Grapplers). Should I go ahead and do the tranny fluid and filter while I'm at it, or just wait till I get back. I am figuring on about 2k miles throughout the trip.
View 2 Replies
Advertisement
I have had my 2007 GX for 5 months now. I have discovered the "clunk" issue and had the dealership replace the driveshaft. I want to start a new thread because I have a different clunk. The new driveshaft has fixed my clunk issue at a stop but I have one more. While driving in the city or leaving the highway on the exit ramp (transmission is in overdrive) and I press the accelerator I get a clunk.
This only happens when the transmission is shifting out of overdrive. I can repeat this clunk while driving around 30-40 mph. I will coast a bit then accelerate enough that it wants to shift out of overdrive and then "clunk". It sounds loud but not much of a jerk. I have 85K on it and did not perform any fluid changes in the drive train yet. Transmission is sealed so not sure if it is worth changing or just leave it and drive nice so it don't clunk.
View 3 Replies
I have an 05 f150 5.4 and when it shifts into overdrive the whole truck starts jerking, if I turn overdrive off it shifts and runs smooth through all other gears. When it does start jerking if i give it gas and speed up it stops and runs smooth?
View 9 Replies
I have an 04 f-150 supercrew 4x4 lariat with 103k miles that has a pretty bad vibration between 45-50 after it switches into overdrive, when you turn overdrive off the problem goes away. I've taken it to the dealer and they put shutter guard in it an said to let it work through for a couple hundred miles. It still hasn't gotten any better, what it is?
View 3 Replies
I just got back my Accent from the detail shop. Now, the OD/off light is on, the button won`t change it, and I am screaming down the highway with NO overdrive! Armor All in the switch? What the.....!!!!
View 10 Replies
I have a 2004 Fx4 that I took on a cross country trip this past weekend. Everything was running fine until I stopped for the night and got a hotel. Woke up the next morning and the "O/D Off" light was illuminated on the dash and the overdrive toggle button (on mine, on the center console next to the console mounted shifter) doesn't work to turn overdrive back on. When I got on the highway it wouldn't upshift into overdrive.
Hopefully this is just the switch assembly (?) so I won't have to do any major tranny work . . . However, I found it weird that if the switch failed it didn't fail in overdrive since I was running in overdrive the day before.
Also, any link to a good thread about removing the trim on the center console in those trucks to get to the switch assembly? I assume that's a pretty easy job but I've never dug into the console before.
View 5 Replies
My 2005 4.2 L transmission slips in overdrive but I turn off overdrive and it stops slipping instantly. What could be the reason for this does this require an entire trans rebuild or is it an easy fix.
View 1 Replies
I have lost drive and overdrive. I have first and second and when I let off the gas pedal everything seems normal. When I am in drive with overdrive switched off and keep a steady speed it doesn't shift into drive. When I let off the gas in drive the tach goes to 1k and its like I'm in neutral. If I switch OD on it's like neutral and the engine revs. I have pulled the pan and valve body and do not see any metal.
OD snap ring is intact. Fluid looks good with no burnt smell...I'm thinking shifting solenoids but have not tested them yet. There is no grinding noise at all and no slipping in first and second gears. It threw cam sensors codes and I replaced both but I think that was from the neutral condition and test drove before dropping the pans and still no shifting to drive or OD. No transmission codes...
View 7 Replies
I have a 2006 F150 5.4L 3V with 105,000 miles on it. Recently, it has developed a misfire that is progressively getting worse. It happens when the truck is in overdrive, with engine RPM between about 1200 to 1800. Cruising at this RPM the truck runs great. If I increase the throttle, I develop a pronounced misfire. Once the truck down shifts out of OD and engine RPM exceeds 2000 RPM the misfire goes away. I have never had the CEL light come on during any of these events. The truck has the original plugs in it AFIK. I have not changed them.
View 6 Replies
Some what sounds to be metal-on-metal squealing seems to be getting worse. It's coming from the tranny only when it's not torque-converter locked and varies with tranny speed, not necessarily rpms.
Slippage? Signs of some serious problems?
Truck has 90K on it. I don't tow. I changed the tranny fluid about 60K ago. I just checked the fluid on the dipstick tonight and it's still light pink and clear, but I have not dropped the pan to see what's inside yet. No codes and the truck drives perfectly well otherwise.
View 4 Replies
I have an 06 Lincoln MK LT with 147K miles. Just recently when it went into overdrive it was like I shifted into neutral. Pushed the overdrive off button and it drove just fine although no 3rd gear (overdrive). what do I need to do here other than paying for new tranny.
View 2 Replies
Lost overdrive. Shifts when o/d disengaged. Dropped pan, valve body and found that the servo retaining ring is still intact but the small clip for the center shafts of the servo was broken. Found it loose on the valve body along with a flat piece of metal shaped like half of a hexagon. 3 sided shape, approximately 1 inch each side. Like one 6 inch piece that's folded together. Don't know where that came from. Afraid to put back together without knowing where that came from. Was founded right next to the broken clip. 2007 f150 4.6 4x2 ....
View 13 Replies
I just bought a 2007 f150 4x4 5.4 triton with 69 thousand miles less than a month ago. Since then the transmission has been rebuild but come to find out a misfire will cause overdrive to act up, and it just recently started misfiring badly. It was throwing a code. 2 coils were replaced and still misfiring. It's not throwing a code anymore. No check engine light flashing or nothing.
View 1 Replies
Let me first say that my knowledge about vehicles is nearly non existent. Yesterday I was stopped at a light on a hill. When I pulled away up the hill it felt like the tranny was slipping real bad. I coasted into a gas station and stopped. I gave it the once over look around to see if I could see anything unusual. All looked ok, so I wondered if maybe it wasn't all the way into gear or something.
I limped it home only 2 miles and it was seemingly normal although I was real gentle and it was all flat or downhill. Later that night I drove it around the block and it was shuddering and banging and seemed to be slipping again. My question is doesn't the transmission usually go over time, or does it fail suddenly like this. Could it be something else? And lastly what does a rebuild cost. Truck is 06 FX4 54000 miles 3.73 gears. Edge Evolution on level 2.
I tow a Trailer a few times a year 7000 lbs fully loaded, if I do need a new tranny should I replace to a different gear.
View 5 Replies
Okay so I have a 2003 Toyota Camry with 358, 000 miles. I replaced the transmission in 2010 with a gently used one that only had 100, 000 in it. Out had been running great until today when it started slipping in and out of overdrive. I had to turn the o/d off just to drive home and not get it over fifty. Now I don't know if I need to change the filter and fluid or just take it to a mechanic. I read on another site not to change the fluid and filter at such high mileage b/c the clutch and guys might rely on the friction of the gunk in the fluid and that new smooth fluid might keep it from running right.
View 4 Replies
My 94 accord lx just received a replacement motor and tranny from jdm auto.its from a 95 odyssey. I had to swap throttle bodies, distributor... from the old one cuz the new one didn't have cruise control components, external coil... Now its seems rather gutless and it wont down shift when in d4 or d3 unless I come to complete stop, but sometimes it stays in 4th which sucks at an intersection! Also the shifter moves freely from first to neutral without pressing the button. and of course check engine light is on constantly. I've played with tranny cables fuses are good, reset ecu, fluid is new... every thing seems fine and the tranny that we took out down shifted fine so I must be missing something simple. timing?
View 3 Replies
I have a 2004 f150 with an edge programmer. My transmission will only stay in 3rd gear, the overdrive light is flashing, and it is giving these dtc's: p0720, P0722, P0731, P0732, P2106.... What is going on?
View 1 Replies
06 with 5.4 and AT. It shudders in overdrive during light to no acceleration. I was told it was the converter. I was also told by a technician in a trans shop that the Trans-X additive for hypoid oil in a posi-trac was ok to use even though the back of the tube says "Not safe for automatic transmissions". Do this is accurate or if the guy was just blowing smoke?
View 5 Replies
04 F-150 2WD 5.4L AUTO Extended cab
I had my tranny rebuilt under warranty at about 70K and I'm now at 167K. When it was rebuilt (by Ford) it still had a slip feel when I picked it up. Rode the mechanic around the yard and he felt it. Dead stop and take off while turning. Like from a stop sign. He took it back and found a sensor/module/something that was the culprit. Seems I remember they found it with a computer? Is there a computer/reader that will diagnose a tranny?
View 9 Replies
I have a F-150 5.4 automattic 07 model and I need to add some tranny oil,I can't see on dipstick or in book what oil I need,(4) (5)??? I still can't see any markings on dipstick, where would I see a 4 or 5 on dipstick??
View 2 Replies
I just bought a 2007 fx 4 with 116000 miles it has the triton 5.4. I know I test drove it good etc well I am out of town with work right now and drive it on a 400 mile trip and noticed that when you are in overdrive and going up a small incline it acts like the truck is locking up, if i get on the gas a lil and make it shift it stops.
The truck shifts smooth and everything on this truck is tight no clunks or nothing. Ihope its not the transmission and sometimes after putting it in park and idling and turnings steering wheel it will start idling really rough . What could this be only does it speeds 50-57 like i said if i make it shift it stops....
View 5 Replies
