Ford F-150 (2004-2008) :: Torque Value For The Trans Pan Bolts?
Nov 21, 2011
I am finally getting around to changing the trans fluid on my 05 f150 5.4 4wd xlt auto, what is the torque value for the trans pan bolts.
View 1 Replies
Nov 21, 2011
Advertisement
Ford - Explorer :: 2004 - Torque Value For Water Outlet Bolts?
What is the torque value for the 2 bolts on the upper radiator hose water outlet on an '04 4.6L?
View 1 RepliesFord Ranger / B-Series :: 1999 - Torque Value On Head Bolts
I am missing my manual need to know the torque value on the head bolts 1999 ranger 3.0 flex.....
View 4 RepliesFord Super Duty (1999-2016) :: Torque For Differential Cover Bolts
Torque on the differential cover bolts, 2016 F250?
View 6 RepliesFord 7.3L Power Stroke (1999-2003) :: Injector Installation - Torque Hold Down Bolts
I have been reading here about alternate methods to torquing the hold down bolts for the injectors. This winter I replaced my old stock split shots with new alliant single shots. I installed the injectors into a cold engine and torqued the hold down bolts to 10 ft lbs. I did not ever go back and re-tighten.
Is it suggested to go in and re-tighten the injector hold down bolts to 10 ft-lbs after the engine has been heated up and cooled down? What are some symptoms of a loose injector? I am imagining premature wear on the injector cups, low compression and maybe some mixing of oil into the combustion chamber.
Did just throw the injectors in and go back later to retorque only to find they were all fine or were some loose?
Ford F-150 (2009-2014) :: 2012 - Mounting New Shocks - Torque Specs For Upper And Lower Bolts?
Mounting the shock with the boot up or down? I know it doesn't matter according to Bilstein but one way has to be better than the other.
Second. What are the torque specs for the upper and lower bolts? I know the lower front is around 350lbs but haven't found anything for the rest. found out the rear bolts are torqued to 66lb.
Third. The front shocks didn't come with a boot to protect the shaft. Is one needed when the shock is installed?
Truck is a 2012 F150 FX4.
Ford 7.3L Power Stroke (1999-2003) :: Water Pump Lower Elbow Bolts Torque Specs
I read 18lbs for the water pump but it took a cheater bar (perhaps due to corrosion) to get the water pump lower elbow bolts off.
On reinstallation, what should the lower elbow bolts be torqued to? Checked the sticky (Ziggy's Torque Specs) but didn't see the specs for this item.
Ford 7.3L Power Stroke (1999-2003) :: Injector Hold Down Bolts Not Torque Down To Spec - Hard Starting?
I wanted to know what happens when the injector hold down bolts are not torqued down to spec, what problems would arise and could it be a reason for somewhat hard starting?
View 1 RepliesYaris/Scion & Vitz :: Torque Value For 2009 Oil Pan Bolts?
know the torque value for a 2009 yaris oil pan bolts? In another forum somebody quoted a value of 6.6 foot pounds, that seems too small and the wrong value to me.
View 3 RepliesLexus ES 2007-12 :: Torque Specifications For Brake Caliper Bolts
I haven't had luck trying to find the torque specs for the caliper bolts on my 2010 ES350. What are the correct numbers? a pdf diagram would be very useful.
View 1 RepliesFord F-150 (2004-2008) :: Manifold Exhaust Leak - Rusted Bolts
Truck has 107 thousand miles; had to take it in for an manifold exhaust leak. Mechanic said bolts are so rusted they break.
1) was there ever a ALERT from ford about these bolt's?
2) Thought i read ford had stainless bolts for this problem...
I've had F150's only since the mid 70's and this 04 has cost me more in repairs than ANY previous F150..
Ford F-150 (2004-2008) :: Tie Rod End Torque Specs?
Just doing the bro in law's tie rod ends and we are wondering what torque we should be putting on the castle nuts? They are greasable Moogs...
View 2 RepliesFord F-150 (2004-2008) :: Torque Converter Vibrates Between 40 - 55 MPH
I highjacked another thread yesterday but didn't get many responses so I thought I would start a new one... I've done some searching here but no one had any real answers or had a different reason for the vibration...
We have a stock '05 F150 with 24k mi that is having Vibrations not related to bad tires or a bad trailer. It rattles any cups or change that is in the center console area and the dashboard. It seems to come up through the floor.
Symptoms timeline:
The rear pops when you turn tight in a parking lot. I've been told this is normal because of the ratcheting LSD? Is this true?
The tranny fluid was low and we could not find where it was going. Put several qts in it and finally took it to the dealer where they replaced the bad seal between the transmission and transfer case. So we know they took the driveshaft out and the transfer case. Not sure if they dropped the transmission out.
We have a vibration from about 40mph-55mph under medium-full throttle. A lot worse when towing. Put it in neutral and it goes away. Rev the motor and you don't feel it. Only happens under load. Happens in 3 and 4th gear. Goes away once the torque converter locks up.
Am I going down the right path in saying it's a bad torque converter?
Ford F-150 (2004-2008) :: Front Rotor Replacement - Torque?
2008 F-150 2WD
How tight should the wheel bearing retaining nut (sealed bearing hubs) be torqued when replacing the front rotors?
Is there a spec, or just real good and tight since the bearings are sealed units.....
Ford F-150 (2004-2008) :: Power Lag Especially At High RPM - Loss Of Torque
My 2006 F150 King Ranch 90K 5.4 lags both torque and power in addition to only 11-12 MPG
In the city it does not bother me to much but when on the highway trying its very annoying. I used to have 2005 F-150 before so I know the difference. When I accelerate its ok but lags some serious power especially at high RPM. but without any hesitation. When I try to tow my trailer or go uphill it has no torque. I still haven't tried a dyno reading
Note: The engine runs smooth, no misfires or shows no codes. The only codes I got before was for the evaporation system but disappeared after I replaced the Fuel Pump Driver Module
Now I already replaced the: Spark plugs, mass airflow sensor, cats, air filter, fuel filter + fuel pump driver module, bought another tuner. I even took it to the dealership without any findings
Now I am beginning to think if the engine timing could be slightly wrong. I just can't figure out what it is if it throws no codes and runs perfectly smooth. It's just like it's not getting enough air or fuel but without any hesitation or misfire.
Ford F-150 (2004-2008) :: 2007 - Up / Down Shifts Randomly After New Torque Converter
I bought an 07 F150 5.4 4x4 with 135k on it about 6 months ago. Shortly after buying the truck I began experiencing a shudder when lightly accelerating up a hill. Also when accelerating hard it would misfire. Thinking that it was plugs or COPs I changed the plugs and coils. That fixed the missfire issue but it still shuddered when accelerating up a hill.
I decided to take it back to the used car dealer where I bought it so they could fix it. On the way there the fly wheel broke. The dealer replaced it and thought that it was the cause of the problem but on the way home I still experienced the shudder. I took it back and they "scoped" it and found that the torque converter was bad. They replaced the TC and now there is no more shudder BUT now I have a new problem.
Now if I am driving at highway speed and let off the gas it feels like it immediately down shifts for a few seconds then shifts back up and coasts along until I give it gas again. There is enough resistance that it feels like a jake brake or that the breaks are being applied. Also if driving along at 30 - 40 mph and just holding the gas in the same spot maintaining 30-40 it feels like it down shifts and up shifts over and over until I either give it more gas or let off all together. Also a few times pulling away from a stop I will get a thump.
I have an appointment with a transmission shop in a few days but today on the way home I put it in second gear while going up a hill so it would not shift and it seemed like it was coughing and sputtering. So now I am wondering if that is what is happening and either feeling like or causing the down shift up shift issue.
If it is a missfire issue why would the new torque converter cause this? It has all new motor craft plugs and all new after market coils.
There are no check engine or other warning lights lit on the dash. I have a cheap ODB scanner and it shows two codes. B1676 which apparently is a Battery Pack Voltage Out Of Range or ABS voltage issue. The voltage is showing at 14.2 volts and there is no noticeable battery issues. The second code is a P1000 Drive cycle test not complete. (this code has been showing for some time the 1676 code is new since the torque converter swap)
One side note: after the TC change every time I start the truck the radio/cd changer cycles though all the CDs. like it it is checking for a disk so it clicks and pops around from a moment. The only time I heard this happen before was after having the battery disconnected. The clock is not reset though like I would expect if it was losing all power.
Ford F-150 (2004-2008) :: 2006 5.4L - Oil Drain Plug Torque Spec?
Gonna change my oil in a hour or so and I was wondering what the torque spec is for the oil drain plug.
View 3 RepliesFord F-150 (2004-2008) :: Rear Differential Leak - Torque Rating On Bolt?
I am getting a little frustrated with a leak on my rear differential. The leak is on the front of differential rear-end just behind the four bolts you take off to remove the driveshaft. When you take the driveshaft out, there is a single bolt and the seal behind that is leaking. Here is my dilemma, I called my local ford dealership to find out what the torque rating on that bolt is so when I replace the seal I don't over-tighten. He told me there is no torque rating on it because I have to tighten, measure, tighten, measure the bolt. I was lost, I didn't have a clue what he was talking about.
View 6 RepliesFord F-150 (2004-2008) :: Torque Converter Clutch Solenoid Plug Location
Where is the plug on the transmission to disconnect the TCC solenoid? I am trying to diagnose a lockup issue and need to disable the clutch from engaging for a test run.
View 1 RepliesFord F-150 (2004-2008) :: 2006 V8 - OBD Error P0302 / Low RPM Torque Causes Major Shuddering
2006 F150, 4.6 V8 ... My truck was running fine until one morning I was sitting in the truck giving it my customary 30 second morning warm-up and it starting running very rough and quickly threw Check Engine LED.
I hooked up my laptop and got the following error codes: (To assist with future searches, the error codes are P0302, P0303, and P0353)
It seemed to drive fairly well, but low RPM torque causes major shuddering, so I try to keep the revs up to avoid damaging other components. The first step was to replace the spark plugs. They looked to be original and I'm at 140K on the truck, so it's probably time.
I went with Bosch Platinum as the factory plugs were platinum. When replacing the plugs, I moved the coil pack from cylinder 2 to cylinder 3 to determine if the problem would move. After the plug swap, the engine did run noticeably smoother (so the plugs worked overall), but still had the low rpm shudders and the same error codes (after clearing them).
Unfortunately, the error codes still indicate cylinder 2. I guess a misfire could be related to the fuel injector as well, not firing at the right time or not a complete spray, but what else could cause this?
Ford Aerostar :: 1987 - Draining Trans Fluid From Torque Converter?
How to drain the tranny fluid from the torque converter , I am dropping the pan and installing new filter and fluid, I want to get as much of old fluid out as i can It has a 3.0 engine with overdrive...
View 11 Replies