Suddenly power windows wont work... Hopefully its just a fuse or something, going to grab the book to see where fuse block is and where this fuse would be.... I have rear and drivers window stuck open!
View 14 RepliesI have a f150 2007 crew cab I bought used. None of the windows work all the time and the passenger side rear does not work at all. Is there a common problem with these trucks bad switches or motors or something?
View 3 RepliesOdd thing happened this evening, I took the truck for a short drive, rolled down the drivers power window, and then needed to turn on the map light, but realized it didn't work, same with the radio. The clock on the radio works, and now none of the window switches do anything.. I tested every fuse under the dash, even swapped around all of the relays that have the same part number, to no avail.. Is there something simple I'm missing that is a common problem with these trucks? I'd hate to have to leave my window down for awhile till I figure it out on my own..
View 14 RepliesLast week, my 2005 FX4 Screw died suddenly, and would immediately lose all power to the gauges as soon as the jump leads were disconnected, not to mention the engine would eventually die shortly after that. After a bit of logical thinking, a buddy and I determined that it was likely the alternator, so we pulled it and replaced it. We also had the alternator tested, and it failed every single test, so it was pretty clearly the culprit. The good news is that the truck starts and runs/stays running again. The bad news is that my audio and 4x4 systems are both offline.
As far as audio goes, I'm guessing it's an easy fix because it's probably a fuse somewhere that got toasted. But the 4x4 is a little more of a problem. I tested the vacuum lines by pulling them from the hubs, and neither had any suction. Okay, the solenoid isn't getting power, probably another fried fuse, right? Well, here's where I'm getting confused.
My understanding of this 4wd system is that it works like this: When in 2wd, the solenoid engages the vacuum and pulls the part of the hub that locks in the wheels (not sure what specifically to call it) out, therefore disengaging the front 2 wheels. When 4wd is turned on, the vacuum disengages and that part of the hub pops into place, locking out the front wheels into 4wd.
So, by that rationale, if the 4wd solenoid isn't working due to an electrical issue, then my truck should automatically just be locking itself into 4wd, right? Because without the vacuum to disengage that part of the hub, it should just pop into place and keep the truck locked into 4wd. So if I'm correct in my understanding, then I have another problem because my truck is still operating very much in 2wd.
I did the classic 4wd tests: tight circle to feel the front end gripping/pulling, gun it from a dead stop to see if all 4 tires engaged. But I turned in a much tighter circle than 4wd would ever allow, didn't feel the front end grip/pull at all, and the "peel out" test only showed my 2 rear tires as launching me forward. I also tried shifting into 4-Low, but the truck never shifted into low gear either. -I know that's probably just electrical, but I'm just trying to be thorough in my testing/explanation.
I bought a 2004 Explorer a couple of years ago and at the time some ot the windows only work some of the time. Then the drivers side fron and rear passenger window stopped working. Now all but the front passenger side stopped working. I've changed the master switch and no change. I know that it is probably a broken wire between the drivers side door and cab but can't understand how the front passenger side would still work if that was the case. If it wasn't grounded or if a wire was broken wouldn't all of the windows stop working? Also the rear passenger power door lock has all of a sudden stopped.....
View 14 Repliesconverted my 2008 xl to power locks and windows. locks work great, but can't find reliable power source for windows. tried tying into stereo but blew fuses.
View 5 RepliesWindows won't roll up or down in my 2004 F150 , could this be a fuse and where it's located? I can't seem to find it in my manual.
View 4 Repliesmy 2006 f150 fx4 super crew power windows wont go down on the passenger sides. The driver side works fine. i went the owners manual and changed our the fuse in the fuse box and same thing still. just to make sure, i put the fuse and tried the driver side and it did not go down. what could it be? should i just take to one of the local mechanics and have them look at it?
View 3 RepliesWhat Relay switch controls these.
View 3 Replies2006 XLT F150 Triton 4x4 crew cab. My widows all 4 stopped working I have replace the 30amp breaker in pos#401 and I have replaced. The switch in the drivers door but still nothing.
View 2 RepliesI have an electrical issue on my 2007 F150.
The drivers door electrical switches (windows/locks/mirrors) have all stopped working. The locks on the other doors work but not the windows.
I have replaced all fuses with no luck. I'm thinking it's either a ground wire or the accessory delay relay.
My truck was fine yesterday morning, but when I got in it after work, nothing worked. The power windows, radio, ac, gauges all stopped working. Everything else does - power seat, wipers, turn signals....etc. What is going on?
View 2 Replies2006 F150 5.4 2WD extended cab tow package 24k miles
My power windows have stopped working from all locations. I checked and the fuses are good. I can no longer use the exterior keypad to unlock the truck, yet my remote keyring switch will electronically open both driver and passenger doors. Neither driver's nor passenger's interior door switches work.
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
It's my turn, while out site seeing my back seat power window don't work , the control from drivers seat or from the back seat door control, I popped both covers on the control switch and both are firmly plugged in, I don't have my meter with me to see if power is running back to the switch , this morning I'll try to switch out the two back seat controls to see if I can get at least that window to go down , 04 350 , would there be a fuse for each or is it in the switch in the door that the harness plugs into , that's the only window that won't go down...
View 8 RepliesMy power pedals work on and off again with no warning what so ever. checked the infamous orange wire and splice issue and it is fine and there is no issue with my mirrors or power seat as there is power going to them and they work fine.Could it be the switch and perhaps a poor contact. When you push the switch you can hear a faint sound under the dash like it is trying to work but the pedals do not move.
View 1 RepliesHow to get into that bundle of wires going between the drivers door and body for a 2002 Sport Trac? I have a break in the wire that feeds 12v to the passenger windows. If I push the bundle backward the windows work. The flexible rubber jacket goes into a plastic housing and I'm not sure if I need to pull off the door panel and un-hook or unscrew it. Is there a connector inside that plastic thing?
View 2 RepliesI just bought a 2004 Ford F150 supercrew, and I noticed that the rear passenger power locks don't work.
- I can manually lock and unlock the door. But when I try to use the powerlocks, nothing happens at all.
- I have powerlock controls on both front doors and when I try to lock/unlock all the doors, they all work properly besides that rear passenger door.
- I have checked all fuzes, they are fine.
I realize it could be the actuator? But, I can manually lock/unlock the door with no problem, so could it still be that? How do I troubleshoot to see if it is the actuator or just a wiring problem.
I have all the tools and a meter, just don't know how to troubleshoot the problem! I've done a lot of googling about this and there isn't really anything I've seen on troubleshooting to see if its wiring or actuator.
I just picked up our first Lexus, an 08 RX 350 with 140 km on it and while we love the car, have run into a problem with the power windows and driver's door controls.
None of the power windows in the car work, either from the driver's door or from any other door.
The central locking on the driver's door does not work, but does work from the passenger's door and from the key.
The Memory Seat controls on the driver's door do not work. The controls on the seat itself work fine.
The side mirror controls work fine.
Yes, the battery did get low just before all this happened but we can't do the window reset procedure because none of the other windows work.
I've tested all fuses and they are all fine.
I am suspecting it's some controller or wiring in the door.
All of a sudden, all 3 of my outlets for charging stopped working...can't charge my cell phone!
View 7 RepliesI have a 99.5 Passat...the power windows will only click inside the doors. I checked all the fuses and specifically the ones that say on the fuse card are fuses for the windows? ...its not a fuse...is there a relay for the power windows that I need to replace?
View 1 Replies