Ford F-150 (2004-2008) :: Slight Shake At Highway Speed About 90 KPH
Aug 14, 2011
So, after putting new tires on my truck about 2 years, I noticed a slight shake when I drove at about 90kph. I let it go for quite some time thinking it was just a balance issue.
Well this weekend I spent 7 hours washing, waxing, and polishing my truck. It was worth. The rims reflect the moonlight now. It's amazing. During this washing, I scrubbed in behind the spokes of the rims. I found a big chunk of mud. Well surprise surprise, my shake at 90kph went away... or so I thought.
I no longer have the shake when driving at 90 or accelerating through 90kph like I used to. Now I have the shake when I let off the gas at 100 and drop to 80kph. It shakes at 95 through 90, and then goes away.
What is causing this? The parking brake is never used, and is showing no signs of engaging while driving. Is this a driveshaft issue?
View 3 Replies
Advertisement
As I'm driving down the highway my steering wheel tends to shake a little bit. My tires are fine but are offly loud . They are balanced and all but just sound loud u can hear them rolling inside the cab sounds maybe like if I had mud tires but I don't they are all terrains. . I was told maybe the bearings but I don't know.
View 1 Replies
.Here is a run down of my truck 05 5.4L Screw has 130K on it. Sometime when going up a slight incline the truck at partial throttle will shake very very little. if I put my foot into it the shake goes away and the truck response just fine. It only does this when going uphill on the freeway and on the streets here in Dallas that have slight inclines.
The truck is not throwing any codes nor does it stall at lights. Starts right up in the morning and runs good. Nothing done to the truck except I have an Edge programmer and Magnaflow exhaust. I have pulled the programmer off and returned the truck to stock and it still does the same thing.
I bought the truck used in 07 had 40K miles on it. I'm thinking spark plugs or maybe a coil is going bad. But this doesn't happen all the time just here and there.
View 7 Replies
I have a 2005 F150 5.4 and I recently got a p0175 code. I've replaced the M.A.F. sensor, fuel injectors, fuel filter, new plugs, coils and checked the vac lines but I'm still getting a p0175 code. Ive reset my P.C.M. and the code stopped for 2 weeks but returned later. The truck runs fine when I erase the code but when it returns it hesitates on take off and has a slight shake like a misfire and it makes a bubbly popping sound from the exhaust. Im at a loss of what to do next! Could this be a code stuck in the P.C.M.? My mechanic thinks it may be the cam phasers!
View 5 Replies
I have just over 11K miles on my 2011 and now notice steering wheel vibration & slight shake at 70 mph. The passenger can also feel it.
View 14 Replies
Trying TSB 05-13-1 on f150 ? Mine is a 2004 xlt 4x4 and it shakes and vib really bad from 55 to 60 mph ,had tires balanced 3 different times brakes replaced and rotors turned ...
View 14 Replies
Today I caught a deal on a 06 F-150 with the 5.4l. I noticed a slight vibration that comes and goes at highway speed (65-75), when I got home I jacked the front end up and checked everything out. The right front CV axle is still engaged with the tire when it is out of 4 wheel drive, I can engage the 4wd and everything locks in and works as it should. My understanding is that the axle should spin free and independent of the wheels when in 2wd? How would I go about troubleshooting this?
View 4 Replies
I have a new to me 2005 F150 SuperCab Lariat 4x4 with 155,000 miles on it. About a week ago I replaced the from passenger hub assembly and half shaft (torn boot). When doing that, I noticed that the IWE actuator was not working right (would not compress evenly). When taking that off, there was a bunch of rust that came out of the vacuum line ports. It started moving freely after cleaning all of that out that I could (I will be replacing it soon). I assembled everything back together and all seemed OK mechanically.
I also scanned the truck and saw the code for a bad IWE solenoid so that is being replaced tonight. I also have not checked the drivers side yet.
So...now that I have done all of that, the truck started occasionally bucking/shuddering when I slow down from highway speed to about 30mph and lightly accelerate again. It does not do it every time though. There is no grinding/whining noises either. Could this be caused by the IWE system somehow? Maybe slowing losing vacuum and having one engage and the other disengaged?
View 13 Replies
I just picked up a Sport. I've noticed 1,2 quick stutter type thing happening intermittently at highway speed going up a hill. Dealer service probably won't be able to have it happen as it only has happened 3 times in my 400 miles.
View 9 Replies
I got off the highway today and was at a very long light, but enough time to feel my car making slight jerking movements and i saw the car raise a little over an inch.
View 8 Replies
Middle of May, I went to Boston. On the way there, I started to notice a slight whirring noise that was only present when I gently feathered the gas to maintain highway speed. If I were to apply any more throttle, the noise would go away, and if I were to pull my foot away and allow engine braking, it would also disappear.
So I did my best to finish the trip to and from Boston adjusting my driving to avoid the noise. Once I came home, I researched and thought the noise might have been my wheel bearings (I had just replaced lower control arms, lower ball joints, inner and outer tie rods prior to leaving for Boston). I also had a shop install my upper strut mount bearings and bushings simultaneously with the wheel bearings.
Since then, the problem still continues. It has grown louder, but still occurs under the same situations. I've focused more on it and here are the conditions under which it occurs:
1. Car must be warmed up. Starting it up cold and allowing SAI to run then driving, car is fine, no sounds. Usually takes 20-25 mins of driving to get it to start making noise.
2. Car still only makes the noise when the gas is being feathered (ie barely pressing it enough to give it any sort of throttle. It does also make the noise between shifts when reengaging the gear and applying gas, as the throttle pedal passes the point of throttle off to throttle on.
3. I'm hearing more noise now during engine braking than I had been previously. Could be related?
View 6 Replies
Ok,I have an 05 f150 4x4 5.4. And I have noticed for a little while now that once in awhile,it seems like the front end,will shake like an up and down shake.Today it was the worse,now it only does it maybe once a week if that but usally its not too bad. Just a little shimmy. But today it really shook.Now when it happened I put on the overdrive,applied the brakes and even put 4x4 on and still did it. Now it does it the worse at very slow speeds even at crawling speed in an alley.I parked it at home and took it out again after 10 minutes and nothing! What could be causing this??
View 14 Replies
I have a 08 F-150 4x4 King ranch with 5.4L Duel fuel motor. Last year we were backing a trailer and the whole truck started shaking. Stopped, but it in forward and no problems, tried backing again and same thing. It did back up but shook worse with more gas.
We took it to a mechanic who said without even looking at it "Sounds like a reverse clutch, common problem" So we had them rebuild the trans, a few months later it did it again once but we were 300 miles from home. Since we could still back we did what we needed to do and drove home with no problems. Dropped it back at the mechanic who said he couldn't find anything and eventually had a yelling fight with my wife. We couldn't get it to happen again either until last week it did it again and she grabbed the camera to record it.
Took the truck back with the video, he had a mechanic look at it and said the transfer case mount bolts were loose, tightened them up which did get rid of a knock that we had since the trans rebuild and said that was the problem, it was binding and causing the shaking. This weekend did the same thing again.
Now the truck is back at the shop and only 100 miles or so left on the warranty (12m/12k). So after that long story my question is if the problem really was/is the reverse clutch or if there is something else wrong that he never fixed and was just intermittent enough that we let him get away with it this long?
View 1 Replies
I have a 2007 F150 with the 5.4 FFV. Early last summer my truck started acting like the harmonic balancer was going bad, when it was hot out my engine would shake at an idle. Then in October it threw a check engine light, wouldn't get over 20 mph and was shaking the entire truck. The codes said my timing was out so I replaced the timing chains, guides and tensioners, which were bad on the passenger side. When I started it back up it ran rough, and the check engine light came back on with a "bank A over-retarded" code.
So I went back in thinking I had put the chain on one tooth off. Got it back together and it ran the same way. After doing some soul searching on this website I determined the VCT Solenoid for the driver's side may be bad, and I went back in a third time and replaced the solenoid. Now it runs worse than it did the first time, it won't even idle and it is nearly impossible to start in the first place... This truck only has 103,000 miles and was running great before this...
View 11 Replies
I have a 2004 fx4 supercrew 4x4 , 170k miles. I bought it a few months ago and installed a 6" rough country lift and 35" tires. I noticed a little shake in the steering wheel but not too bad, just annoying. I just put on a fabtech dual steering stabilizer to remedy the problem and its much worse. What could be at fault that dual stabilizer would make it worse? I hate to just take them off, I would rather find the problem. Oh, the tires are all balanced and I had an alignment done also.
View 14 Replies
Over the past year, I have had an issue with the front end shaking on my F150.
I have a 5 x 10 trailer. Weight capacity is roughly 2200 pounds. I hook up my trailer empty and head down the road. When I hit about 55 mph and above, the front end starts bouncing/shaking/vibrating.
Now I put a load on the trailer. Get going down the road. Hit those same speeds - no shaking/bouncing/vibrating. I have had a mechanic ride with me to check it out. First place to start, he told me, jack it up and see if anything is loose. I have not done that yet.
He has the same opinion as I do. This makes no sense. No load, shakes. Load, no shakes. You would think it would be opposite.
View 4 Replies
On my 2007 f150 5.4 last week i changed out the driveshaft and it smoothed things out. This past weekend I dropped the transfer case oil and refilled it with motorcraft transfer case oil as per ford but now the front end seems to shake more than before. It just seems to come through the steering wheel but the wheel seems tight almost like a death wobble with solid front axles except obviously this truck doesn't have that. There are no leaks and I filled it up to the top fill hole with between 1.5 to 2 liters of oil until it started running out. I should also mention that when i went to check the level it was overfull on the top plug but it was that way for the last 90,000 km or so.
View 3 Replies
I have a 05 f150, on initial startup ALL of my needles shake for about 5 seconds and then return to normal operation. What is wrong.
View 2 Replies
I have an 07 F150 xl 2wd 5speed. It has a vibration/shake at about 30-45 mph no matter if its in gear or neutral, or if its under throttle or not. It also gets a little worse when breaking coming down from about 45-30mph.
I was thinking at first it was the wheels out of balance since it was only at a certain mph range but the braking thing has me thinking rotors. The truck has about 51000 miles on it.
View 4 Replies
I took it to the dealer and they blamed the trailer. I told them that I have pulled two different trailers and it did it with both. Then he said that the trailer was not heavy enough to weigh down the springs. So now I not suppose to tow an empty trailer? Also my father in law has pulled the trailer with his Z71 with no shake and the other belongs to a neighbor with a 98 F150 with no shake. The vibration only starts above 45mph. Any clue as to what could be causing this?
View 14 Replies
Well I believe I finally had the opportunity to experience the wide open injector issue. I was driving to work and all of a sudden at a stop light my truck started shaking bad. It went away but as I took off every so often it would shake. I thought it was a tire or front end component so I pulled over and just got overwhelmed with the smell of gas. I drove 30 miles back home and check engine light blinked the whole way and truck ran . Also wasted at least a 1/4 tank of gas and the a/c wouldn't blow cold air either. Hooked it up to read DTC codes and got P0172, P0300, P0303, P0304, P0316 and P2196.
View 14 Replies
