Ford F-150 (2004-2008) :: Reverse Slow To Engage - 1 To 2 Seconds Delay
Mar 15, 2011
I have an automatic 2004 f150 fx4 with a 5.4 engine. I just bought the truck and noticed the other day that when I shift into reverse, there is a 1-2 second delay. Sometimes it will shift quicker than other times. Drive seems to be a little more swift I think. Everything seems to run smooth and the shifting is very smoot other than the delay. Is this normal or what could be some of the causes. The previous owner has the ATF changed this pst summer and it looks and smells fine other than maybe having to much fluid.
View 2 Replies
Advertisement
Still having issues with the transmission on my 05 F350. I posted before that it would take a few seconds to go into drive or reverse. The fixes were to change filters and do hot flush. I had the dealer do a hot flush, and then I put about 1000 miles on it. That didn't seem to fix anything, so I went back in and asked for more info. They did not change the filters. I thought they did, but found out they did not after the fact, so I decided to change the filters myself.
The interior filter was easy to change. The fluid was clean, and the magnet had shavings on it but nothing that seemed extraordinary. The exterior filter is impossible to get off. I reviewed posts on here before trying, so first was the impact wrench, then the pipe wrench, then the pipe wrench with a block wedged in to keep the thing from bending, still no luck. The cast nut broke off well before the pipe wrench came out of the drawer. How to get that thing off. I read on here somewhere that no fluid goes through that until 180 degrees, is that correct?
Scanguage says it rarely goes over 160, except for last evening when I was stuck in traffic. It went to 187, with ECT at 208. During this period, traveling under 40 most of the time, the transmission was shifting erratically, to the point I wanted to pull over and allow it to cool down. But traffic broke free, speed went up, and temps went down. Shifting returned to normal, except when trying to engage drive or reverse. The 3-4 second delay persists at any temp, and there doesn't seem to be any slippage. Just delayed and sometimes hard engagements. I'm at a loss for whats wrong.
View 1 Replies
Well it's been an ongoing problem with my 4r100, but last week it all come to a point. Reverse delay is getting to near 10seconds then abruptly engages. My 1-2 shift is so soft I have to look down and see my tach to make sure it shifted up. I now have trans squeal during ever shift including OD. Also have a loud screech that gets louder the faster you go, BUT the old girl is still moving the truck and oddly the fluid isn't burnt looking or smells burnt? That's one has me puzzled...
So Tuesday after work I'm pulling the transmission (in the driveway) and bringing it to the shop Thursday. Getting a billet steel converter, having all the planetary gears upgraded to six and four pinion, one way sprag will now be solid steel instead of the plastic one Ford put there, all the bearings will be upgraded to Torrington, I'll have the 45 roller sprag bearing upgrade as well as the 17 roller for reverse, I'm going with Borg Warner and Kolen steels, new solenoid pack.
I'm having the pump pump machined and sonnex upgrades done to it, spiral snap ring on OD piston, case will be machines not hand resurfaced, reverse gear plastic washers will be removed and the gear is getting machined for a Torrington bearing and steel spacer, clutch drum will be machined for a 360 spiral clip, locking snap ring on the OD piston, center support will have some machine work done to it, and I'm having the forward drum plug removed and the hole will be tapped for a steel plug.
View 14 Replies
1991 4x4 f250 idi w e4od w 3:55 ratio... The truck is slow to engage in reverse, about 5-10 sec. It also has a very hard shift 1-2. All other shift points are good. Drop down is good, and TC lock up happens at all the right points (feels like anyway).
I've had the truck for about 2 years now, replaced several sensors an harnesses and a full fluid change to solve other problems but this still remains.
Sometimes when I start it in the morning if I let it sit and idle for a few min it will engage reverse much quicker AND shifts way smoother and constant. Shifts smoothly thro all gears, holding a constant 1800-2000 rpms with no drop or lug. Or do I need a rebuild?
View 4 Replies
I've got an 04' F150 and the ONLY problem I have with it is a ridiculously sluggish throttle. I bought the Superchips Tuner in hopes of eliminating this, but the delay in the throttle is still there (power is much better however). When I talk delay, I am talking hitting the gas and probably a realistic .5-1 sec delay. It is quite annoying to say the least.
My question...is there something that I can do myself to improve the throttle response? I drove an older 150..probably an 02 or 03 and it felt sooooo much more powerful just do to the throttle. I am even willing to ditch the Superchips if the Ford re-tune would do a better job.
View 14 Replies
I have a 2008 F-150. When moving gear selector from park to either reverse or drive, trans has a delay engaging. After engagement, it runs fine, shifts ok, downshifts ok....
View 7 Replies
I have a 1998 Mitsubishi Galant, 4cyl., 165, 000 miles. Without previous symptoms, one day the transmission developed a delay of 5 to 30-seconds before it would engage in reverse. The fluid was clean and I have been using the Mitsubishi brand that they recommend. So I replaced the original transmission with a used one. But the reverse delay continued, even with a different transmission. So I removed the used transmission and rebuilt the original one. The problem STILL remained. Since then, the valve body has been replaced and the speed sensor has been replaced. I cannot figure out why there is a delay when putting it into reverse. I ran out of solutions. I did notice one day that when I first start the car, and the engine is at 1000 RPM's or more, the reverse wouldn't engage. Then, as the RPM's dropped to about 200 RPM's, the reverse would engage. I thought maybe this would be a clue.
View 10 Replies
Ok I am getting a (6R140) transmission behaviour every morning drive or later in the day after the transmission cools down. I am experiencing a 2-3 second delay of engagement when putting truck in Reverse. This happens EVERY time whether transmission is cold or warmed up. I am also having very hard/harsh shift fares going into 3rd gear and 5th gear with the 3rd gear being the worse of the two. Also experiencing these hard/harsh shift when downshifting as well.
I took the truck to my local dealer and I let it sit over night in their lot so they could experience it at its worst after sitting all night. They definitely recognized the issue. But since it wasn't throwing and codes. I find this an unacceptable answer.
I brought to their attention that this issue is well documented online and a lot are having success with performing TSB 11-7-10 (replacing solenoids) They looked it up and said my truck doesn't apply to TSB because of the build date. My window sticker and VIN # implies the truck was built 10-11-2010. Which from my understanding, does fall under the required TSB. None the less, I insisted that I know I'm out of warranty and I will just pay to have this TSB performed. They refused.
What should I do? I know everyday I run my truck with this issue it is decreasing the reliability of this transmission and it will most likely end with a full transmission replacement.
View 5 Replies
06 5.4 screw. This truck sits in the garage all week long as I drive a work van daily. When I take the truck out on the weekends it starts up normally at the house and when I stop someplace for a few minutes it starts right back up but if it sits for an hour or more it will crank over for 10-15 seconds, it does always start back up. It always runs and drives fine, it is all factory as far as the motor, intake, exhaust, tuner etc. What to do with it.
View 12 Replies
Monday I started my truck after leaving it in the garage while on a 8 day vacation. Shifting into reverse led to almost no movement at all. After a few seconds, I shifted back into park and then reverse again and got a solid reverse right away. I may have noticed sluggish shifting into reverse previously, but not this noticeable. What could be the culprit?
2001 Excursion 7.3 4x4 .....
View 14 Replies
I have a 08 6.4l F250SD. At 127k miles, it has been a great truck. All service has been performed by dealer. When I shift from Park into drive there is a 3-5 second delay, and when it drops into drive the truck rocks. Once driving there are no shift issues. Into reverse there are no issues.
View 14 Replies
I've been noticing over the past couple years that sometimes when I accelerate, there's a slight delay between the time I press my foot down on the pedal and when acceleration actually happens. From reading other threads it would seem that the most common fix is to re-flash the ECU. I bought a DiabloSport Predator tuner along with a CAI a while back to improve performance/gas mileage and I was wondering if there's a way I can use the tuner to re-flash.
If not, do most ford repair shops already carry these? I don't want to buy a flash programmer. Also, if the shop does carry this type of an item, what is the average cost to get it re-flashed?
I own an '04 F150 XLT 5.4l.
View 1 Replies
I bought my 2005 f150 three years ago and the auto headlights never worked. I have just turned them on manually. Couple weeks ago they started to delay coming on and now they do not work at all. All other lights work including fog lights.
View 1 Replies
2015 F-250 4X4 CC gas truck. 6R140 Transmission..
My truck has 6500 miles on it and since day one when I put my shifter in (D) there is a 3-4 sec delay in the transmission to engage every morning when I start out, rest of the time there is no delay even when the truck sits all day at work (about 9 hours). I have read in 2011 (?) that the transmission was loosening it's prime and would cause this problem, so how it's got me thinking.
View 9 Replies
I have had an issue with my GX470 almost since I bought it in 2008. It will sometimes not engage in drive after backing out of a parking space.
It usually happens when it is warm and the car has been driving for awhile then I park for lunch or an errand. I come back start up the car put it into reverse backout of the car space and nothing for a good 5-6 seconds. Seems a lot longer when cars are waiting to take your space and honking.
Anyway I have been reporting it to Lexus at every service and getting a no trouble found. Over time it is occurring more regularly and it even happened at the dealership but of course I was the only one in my car at the time.
View 1 Replies
I have a 2006 F450 6.0 Super Heavy Duty. The Problem that I am having is when I turn the key it wont crank over. In order for it to start I have to hold the key in the crank position (like i am trying to start it) for about 20+ seconds, and then it will start cranking over. After it cranks over it starts just fine no problems. This only occurs when I start the truck up for the first time each day. After the initial start of the day its fine. (FYI I turn the ignition to the on position and just let it set it still takes me turning the key to the crank position and holding it 20+ seconds).
View 5 Replies
2008 5.4L triton. When I'm in the snow or mud and engage the 4 wheel drive I hit the gas and I can hear what I think it is the hub spinning but it will not turn the wheel. Hoping it is not my transfer case...
View 3 Replies
For the past two years I've noticed a decrease in fuel economy and recently noticed that the truck did not "feel" as if it had the same power especially when towing. Checking all the usual suspects with the engine turned up nothing and the transmission wasn't showing any signs of problems other than an occasional delay going into reverse. But it had been doing that for years and so I just ignored it.
Recently the torque converter started acting up and had some other occasional shifting delays and so decided to put the vehicle in the shop. The electronics all checked out and so a HD rebuild kit was ordered. The truck was finished this morning. Just barely pressing the accelerator makes the vehicle instantly start forward with noticeable zip. Plenty of power at all speeds, the engine now feels like new.
I suspect the main culprit was the torque converter. It wasn't enough to notice in excessive rpms nor heat (at least according to the instrument gauge) but the loss is noticeable in hindsight when compared to the repaired system. Over the next few weeks I'll get some mileage numbers and will know for sure whether I've found the sole cause of my power problems but I am sure that I've made a fairly large step in solving them.
View 14 Replies
I have a 2008 RX350 AWD with only 500 miles on it so far and I am starting to get concerned about what seems to be excessive slipping or a delay in response in the trans. Under normal forward driving the trans seems to shift very smooth. The problem occurs under situations where I am coming to a near stop, basically coasting, and then have to accelerate again to continue forward. This could be in a slow moving traffic type situation or when maneuvering through a parking lot. When I try to execute a small increase in speed the engine revs but the trans doesn't respond.
It's as though it's in neutral and unable to decide which gear it should be in. After a 2 to as long as a 5 second delay it finally engages and moves forward. The condition is even worse if I am heading into a slight incline. Once it is engaged everything is fine and the subsequent shifts are very smooth. When starting from a complete stop it works perfectly. I've never had a transmission slip this much in any vehicle. There was one situation where I was almost broadsided because the RX delayed in moving forward.
I realize this is a subjective call but I am trying to determine what level of slipping in the trans is considered normal under the conditions I've described. I have searched and read past threads about issues with the earlier model years but I thought they were resolved by now. I haven't taken the RX in for service yet but I fear I will get the standard - everything is working as designed - answer from my dealership.
View 14 Replies
I have a question, regarding the 5.0 v10. When i accelerate from stop, it has a delay, and a slow start, something like it would start in 2nd gear, but it doesn't (it's in 1st). Is the torque somehow limited whet accelerating from a complete stop? Because while driving, the acceleration is instant, and drives normally.
View 9 Replies
2004 fx4, transfer case engages, but front wheels won't engage. I assume the vacuum solenoid is stuck, any other thoughts?
View 1 Replies
