Ford F-150 (2004-2008) :: Rear Axle Vent Hose Missing?
Mar 12, 2014
I had a loud whine from the rear axle of my 04 SCREW and had the bearings replaced at the dealership. It has been about a year/12k miles since it was done and I just noticed that the vent hose is missing. I'm not sure if they left it off or if it fell off on its own. Anyway, my question is, do I need to replace the fluid once I put a new hose on? I'm not sure how much if any dirt or water might have gotten in there. Also, where does the hose go up to? I figure it must clip to the frame somewhere.
View 5 Replies
Advertisement
I own a 2004 F-150 FX4 5.7L V8, I notice this morning that I had gear oil coming out of my rear Axle Vent Tube. What would cause this issue? I'm kinda at a loss as to what would cause it.
View 3 Replies
Looking to change out my front differential cover tomorrow, cover is pitted, rusted, corroded, and leaking at the seals. While under there I want to inspect the vent for the axle and differential (and replace if it's clogged - which I believe is leading to the seal leaking). Looking for info about the vent tube location on the front axle? Thought I read somewhere it was on the cover itself, turns out that's a negative.
View 1 Replies
Mine was clogged again, and I check it every month.
View 14 Replies
I recently had my rear axle seals replaced due to leaking. Does the rear diff fluid get replaced on that repair since the rear diff cover comes off? Trying to figure out when my next interval for changing rear diff fluid should be.
View 1 Replies
2000 Explorer: on the drivers side is what looks like a vent hose coming off the axle housing. Is it a vent and why??
View 3 Replies
Well I just noticed the rear axle air vent and it is blocked.. I ordered a new one and will replace it once it arrives.. what can I expect once I replace it?
View 2 Replies
Ok, I have a 98 F150 XLT, standard cab, 8 ft. bed, 2WD with limited slip - if any of that makes a difference.
The rear axle vent tube is literally blowing oil out the top, where it's loosely connected to the bed. It does this every few weeks. I pulled the hose and ran a rifle cleaning rod down it to make sure it wasn't plugged ... it wasn't.
It seems like it's building up pressure somewhere, then blowing all at once, but why?
View 13 Replies
had a leaking rear driveshaft seal at the axle and replaced it and fluid. 75W145 full synthetic as recommended. it was changed at 128000 and I've started to get an axle whine over 25 MPH up to 65-70MPH. quites down around 80 MPH. I just checked it after 2 months (whine just started) with 133000. Any TSB. does this fall under TSB 05-23-3? Noise sounds like I've got really aggressive tires on the truck. Only have Dayton HT all season. Did not add the XL3 additive. Would this work at this juncture.
View 5 Replies
so while replacing the rear brake lines in my 2001 F-250. / 5.4, the flex line that drops from the frame bolts to the axle through the axle breather threaded vent line. The friggin thing crumbled on me and now I can't find a replacement for it. Where I can get it or what it's actual name / part number is so I can call the Ford dealer and hope it's not obsoleted?
View 3 Replies
Some family members borrowed my truck, and when they returned I have a loud whining noise coming from the rear axle, which I have determined is a 9.75 rear. I checked oil level and it was high enough, but has a slight leak from the pinion seal. Everything feels solid but I have nothing to compare it to.
Its on a 2005 Super Cab with the 5.4L 183,000 miles. The front pinion seal was replaced in Feb 2 years ago, by the dealer's mechanic, who may have been a shade tree mechanic.
I am a Youtube Certified Mechanic, as in, I watched about 10 videos of people working on their 9.75 differentials, and realize I don't have all of the tools to do the job, such as a press, or race drivers, or the special gauge.
How many of you have tackled this issue? What did you find? What am I looking at for cost? I am on a very small budget.
View 5 Replies
I'm trying to find to rear axle ratio on my 2001 F-350 dually and the axle code seems to be missing.
View 12 Replies
I decided to install a new Optima yellow top battery because I performed the battery check and found the voltage low and therefore believed my 2008 was still running on the original OEM 12v battery. Much to my surprise I found a non-OEM battery installed and the vent tube elbow missing!
View 10 Replies
Front diff does not leak but seems to get alot of oil coming out vent hose. enough to make a mess and require more top offs.
View 4 Replies
What exactly does the sensor on the rear axle do? 08' f350. I know it's a speed sensor of some sort, but what does it do or control exactly.
View 3 Replies
is there an way to remove the defrost vent covers? i think my license slid down the front of the defrost covers. its probably somewhere down under the dash. I would like to start removing the covers up top before I yank the dash. I am 1400 miles from home so I cant run and get a replacement.
View 6 Replies
Last night we had some serious rain and I went through a pretty deep water puddle at speed. I didn't see it until I was right on top of it. This morning I see a vent line of some sort hanging under the truck. The end is attached to the real axle on the left side and on the other end is a plastic connector. I have searched high and low and can not see where this connects to.
View 6 Replies
My truck is a 2008 F250 6.4 Powerstroke 4x4 King Ranch, CrewCab, Shortbed.
I don't know which rear axle ratio it has - maybe someone can help me. the tires mounted are 275/60R17 and in fifth gear (TC locked) the engine has 2000rpm @ 70mph. I think it is a bit to much so I want to install a kit with and lower ratio. I pull trailers just sometimes and here in germany these only have 3,5tons max weight. So I think I don't need this power at 70mph. 1750rpm would be enough. How do I have to modify the front axle ratio if I get a lower-ratio-rear-axle?
I want to lower the fuel consumption. After some modifications, the truck needs round about 12-13L/100km (18-20mpg) and I think it is possible to lower this as bit.
View 3 Replies
I have a 2006 F-150 5.4L 4x4 Lariat. I was wondering where or how I could find out what gears are in my axles.
View 3 Replies
Tried searching, but I couldn't find any good write-ups on how to replace a front CV axle. The boot on mine is ripped and spraying grease so I figure I should just replace the whole axle while I'm in there. In a previous post, I also found out that replacing the CV axle (joint?) is easier than replacing just the boot.
View 1 Replies
Unable to decode the B6 axle code on my f150,5.4 L,FX4 2005. Clearly located on the drives side door is the label 'axle' directly below that is B6 ! Unable to locate a listing for this code any where?
View 3 Replies