Ford F-150 (2004-2008) :: No Power To The Starter Solenoid
Jun 6, 2015
Yesterday after work, i got in my truck and it started right up, no problem. my stereo has been giving me some fits the past few days, looks like everything is on but no sound, and was thinking it might be a fuse so i proceeded to shut off my truck and take a quick look at the fuse box. didn't find anything quickly fuse wise, so i got back in the truck to go home and turned the key and nothing. no whine from the starter, no click click click like a dead battery, but i do here a single click from the relay switch as i left the case off to do a more thorough investigation on the stereo when i got home. anyway.. here is all i have ran through.
1. Made sure the battery is good, even tried jumping it for good measure..took cables off and made sure they had clean connections.
2. Switched out the relay, and fuses related to the starter in fuse box.
3. Put the truck in Neutral, thinking safety switch.. wiggled it around while trying to start it as well
4. Crawled under the truck, took a screw driver and bypassed the switch all together to make sure it wasn't the starter, starter kicked in like it was new, but no truck start. (key was in the on position)
5. Checked the solenoid post with a test light to see if it had power on key turn, nothing.
6. Checked the fuse box and surrounding wires to make sure i didn't bump anything when taking off the cover..
From all of this it sounds like some safety switch that isn't giving power, otherwise i would have thought the truck would have started when i bypassed the switch on the solenoid. Just seems very odd the timing of it and i have not had any previous issues like this.. just out of the blue, literally less than 5 minutes from starting the truck without issue.
View 6 Replies
Advertisement
Well it all started when I was having starter issues my starter died and my solenoid was just clicking and after time there was no power at all to anything in the truck i have replaced the solenoid and starter and check battery and cleaned post and terminals. I am going to replace my negative cable as it was pretty bad but if this still does not work, so what to look for. The truck is an 87 ford ranger 4x4 5 speed with a 2.9....
View 9 Replies
Our 2004 GX has been a great car, but is suddenly doing a number of strange things - like not start. When I say it won't start, I mean you can turn the key, the dash lights up, the steering wheel adjusts, radio goes on, etc, but then NOTHING! No solenoid "click", no starter noise, NOTHING! Does not crank at all. The car just turned 60,000 miles, is in great shape, lives in the garage and has never been in an accident.
After the first couple of times it did this, had the battery replaced, as it was getting close. and then the car started again. Until the next day. No rhyme or reason as to when it would do this. It might start 10 times in a row, then NOT start for a while, then magically fire up instantly, even after several key turns. I wiggled the key, tried a different key, shifted to Neutral, wiggled the shifter to try to rule out security interlock, bad ignition switch and shift interlock. No dice.
Did some more research and thought it might be the starter relay - banged on it and it started, so replaced that part. Didn't solve the problem. It also began to randomly die while idling (in park, or in drive). Sometimes it would re-start, sometimes not. The times it has done this, it typically dies after running or 15-20 minutes, but NOT ALWAYS.... Sometimes it will die once, then be good for the rest of the day. Sometimes it re-starts immediately, after a few minutes, or more recently only after sitting for a few hours.. So basically we can't use the car.
View 14 Replies
So getting the lovely cel and its bank 2 vct solenoid. Oh fum because with bank two I have to move the power steering reservoir. I just got the part in from amazon sadly it doesn't have the torque screw so sending it back so it will be another 2-3 days. My question is is there anything too look for or tricks? I have the 04 5.4 so im hoping it goes like a breeze but nothing.
View 2 Replies
I just replaced my starter solenoid and I'm getting nothing. When 12 volts are applied directly from the battery to the solenoid, the engine wants to turn (granted my batteries are weak) however when I turn the key to start, after waiting for the "wait to start" light to go off and hearing the glow plug click, I turn the key and I get absolutely nothing. No click, nothing. Is there a possibility my ignition is bad?
Would the "wait to start" and glow plug keep working if this were true? Electrical is not exactly my forte'. Before I replaced the solenoid, the bad one had a broken post but the truck would still start most of the time, and when it wouldn't I just connected the two large posts on the solenoid with channel locks or pliers or whatever was handy. I put the new one in exactly the same way the old one came out. I only undid one bolt and set of wires at a time so I wouldn't screw the order up, so I'm at a loss.
View 5 Replies
I have no vacuum coming from the engine to the IWE solenoid. This is making my hubs stay locked all the time. where this line from comes from and how to fix this. Which line is the line from the engine, the one with the T in it or the other one?
5.4L V8 2004 New Style
View 5 Replies
My truck has started fine every time I've turned the key except for last night after work. I got in had all the lights on the dash and dome lights. I turned the key and nothing. Not even a click. Hooked it up to a company truck and it fired right up and ran fine. Drove home shut off and then started it a little later and it started fine. Then this morning it wouldn't start. I hooked up the jump pack and still nothing. I drove my fusion to work and when I got home I went out and it fired right up like nothing happened. Does the work sometimes not work other times sound like the solenoid on the firewall? 2000 4x4 4.6 auto 253k miles
View 4 Replies
My starter solenoid keeps dying. I can't use a retail chain part. They burn up in a day. Always Motorcraft and it only lasts a year or so.
Any way to test this thing to see why it burns out prematurely?
View 9 Replies
I had a bad starter solenoid on the fender in my truck I swapped it out and then my starter went so I swapped it now it is not disengaging the starter If I turn the key to the run position it starts cranking and fires right up before I an let the glow plugs cycle or anything and it won't disengage the starter I turn off the truck and the starter is spinning loud for a couple seconds till it stops no matter if it just start the truck or start it and run it for a couple minutes then shut it off. 99 7.3L ....
View 6 Replies
Where is the plug on the transmission to disconnect the TCC solenoid? I am trying to diagnose a lockup issue and need to disable the clutch from engaging for a test run.
View 1 Replies
I am having some weird issues with my 2000 F150. When I turn the key all the dash lights go out and no start. Ran 2 wires from the solenoid to a switch and it will eventually start. The starter will start real slow almost like the battery is almost dead and then speeds up more and more till it eventually starts. After it starts the theft light stays on the whole time. At this point I have no clue what is going on.
View 1 Replies
Recently, with below 0 temperatures. there have been a couple of times where my van has trouble starting. I would turn the key forward and here a loud knock coming from the starter solenoid and nothing else. but after a couple of tries, it will crank and start right up no problem. so i figured maybe it just has to do with cold weather? but today it wouldn't budge at all. I've been doing some research and came across the possibility that my engine has seized.
I realized that after replacing the radiator, i never checked my oil level since my engine was over-heating prior to the fix and when i checked it today i found that it is a quart low. I guess, what my question is what would be the issue? is my engine really seized or is it the starter or solenoid? could it be some other electrical issue? what are the steps i could take in finding the problem?
View 4 Replies
Just got 2005 screw fx4. Seemed to run ok 115000 mi.Had exhaust leak,I put on 3" cat back on. Then I noticed tapping at front of the engine.Turns out tim. chain guides are broken. looks like very common prob after reading many forum/threads. Anyway got timing chain kit, phasers, selinoids. Truck runs and sounds great.But so far had truck back 2weeks stalled 2x at idle.What next??
View 14 Replies
I've traced the problem to the starter/solenoid. Battery is good, all dash light power up, but when turning the key to start nothing happens. There is 12v at the signal wire on the solenoid when the key is turned to start. Hitting the starter with the handle of a hammer will get it to engage.
I believe the problem is the solenoid, although it could be the brushes on the actual motor. I've attached a picture of the starter. It looks like the solenoid is a sealed unit; i.e. I can't replace the contacts like the older generation starters. If in fact you can't take apart the solenoid, advice on replacing the solenoid vs. the entire starter? Car has ~125000 on it.
View 4 Replies
2012 Santa Fe all of a sudden won't engage starter. First thing in morning it usually cranks. But once I turn it off it won't crank again. When I turn the key I have full power so it's not the battery or terminals. There's no cracking or popping sound, just a whine like the starter's not engaging. Never had any problems with this car so far. I'm thinking maybe it's the starter solenoid.
View 5 Replies
turn the key sometimes- nothing. sometimes 5 seconds, the longest was 35 minutes always starts, but you never know when. it's not battery, starter or solenoid. it's an automatic, 90k miles Moving the shifter does nothing.
View 1 Replies
1996 SILVERADO TRUCK. Starter solenoid doesn't engage when temperature is below freezing....
View 11 Replies
A couple of years after buying this I had problems with door locks and power windows. (No locking or unlocking or up/down) after looking this up as recommended I removed and replaced all the relays in the power distribution panel. (No fix) I next removed the battery so I could turn this power distribution panel over, then unplugged all the plugs and reseated them. (Wiring plugs) this got everything working. About 1 year later the same issue, with the same fix. About one more year later I encountered a starting issue... you could hear the solenoid click, but no starter engagement.
I checked the starter and it was good. So on a hunch I flipped the fuse panel over, reseated the wire plugs and it started right up, but it was intermittent for a few weeks. After several unplug and reseat the wires it was good again. Six months later it would spin the starter fine, but wouldn't start up. I first checked for fuel and it was good. Next I checked for spark and there wasn't any. Just a hunch... I went after the power distribution again and ended up taking it completely apart, also computer on the end of it, cleaned up all the connections and it fired right up.
View 2 Replies
I have a 2010 Accent with 106 000 km on it (Canada). A couple months ago (just as warranty expired) the car would not start. Nothing. Engine would not even turn over. Just a click of the starter solenoid. battery had a load test and is fine. Removed negative battery cable and cleaned the cable where it bolts to the body under the battery tray. Battery terminals were both cleaned at the same time.
Things worked fine for a couple weeks and the problem is back but worse. Everything in the car works fine when it won't start. If I continually turn the key to the start position it will eventually start to turn over and start fine. Sometimes it takes 20-30 turns of the key till it turns over and starts. When it does turn over and start, the engine turns over fine at the normal speed. Not slow like a weak battery.
Dealer is useless. Had a coil go a couple months back just before the warranty expired and they told us that the reason the coil went was that the car had been rust proofed by someone other than Hyundai.
View 12 Replies
04 excursion 6.0 auto. New batteries a month ago. New alternator (New Bosch) 6 months ago. Charging system shows 12-13 volts on scan gauge with engine off, 14 with engine running. Drops to 10 or 11 while actually engaging starter.
Every once in a while, often when the engine is hot (in fact I can't ever remember this happening when it's cold) the solenoid clicks like it would when the battery is dead. So far, it does this while it's actually engaging the starter, so I hear the solenoid clicking under the hood while I hear the whir of the starter under the floor board.
Never had this happen before. Not sure what part is trying to tell me it's on its way out? Heat soaked starters are harder to start, or less powerful, or something, right?
View 14 Replies
I may have to replace the starter on my truck. Have heard it is difficult especially on the top bolt. Any stickys/bulletins on how to do this.
View 1 Replies
