Ford F-150 (2004-2008) :: Misfiring On Cylinder 4 - Changing Spark Plugs
Aug 24, 2017
2004 5.4L ... Codes indicate a firing issue on #4 cylinder, figure it's the coil pack. They bought truck used a few years ago and plugs have not been changed since they have owned it. I was going to change plugs while I was under the hood. While checking threads on this engine I picked up on plugs being a major job unless you know the tricks. So what tricks do y'all have up your sleeve to keep from breaking plugs?
View 14 Replies
Advertisement
2004, 4L, sohc - Is there any issues or problems changing spark plugs?
View 4 Replies
I got the plugs for my '06. I hope to put them in in a day or 2. My question is: is it necessary to disconnect the 12v battery to do this? I've changed plugs in other cars without doing so.
View 6 Replies
Right now I am seeing roughly 41 MPG and that is after changing the spark plugs with brand new NGK Iridium's, Air intake filter and did an oil change since it was due for one. I have driven the car roughly 2,500 miles since all of this stuff was done and it just seemed to continue to drop to the 41 MPG mark.
What I have noticed though is that when the motor turns off it shudders and the when it restarts while the car is in park the car will roll back and forth slightly. I have also noticed that the car seems to struggle to get up to the posted speed while climbing an incline and also while the car idles in park or at a complete stop there seems to be a bit of a miss fire. Could that be caused by a bad coil? Because I have tried everything short of taking it to the dealer which I really do not want to do again and be told there is nothing wrong with it when I know there is.
View 19 Replies
Ok , i have a 2004 Pontiac Grand Prix GT V6 GM 3.8, my car didnt have any misfires until after i changed my Lower Intake Manifold Gaskets. After changing the gaskets and putting everything back together. The car ran fine. The next day i took it an hour and 30 min away, while driving there it started misfiring and shaking,rough idle at an hour into the trip. The check engine light went to blinking. The Next day i drove it all the way back home in the condition. Put code scanner to it, and received P0303 "Cylinder 3 Misfire":
So i automatically assumed it was the coil pack because i just installed new wires and plugs a week before changing Lower Intake manifold Gasket. Bought new coil pack. Still getting rough idle and P0303 code. So i decided to take a look at Cylinder 3 Spark plug and it was dry black, carbon fouled:
So went and bought new spark plug, installed it, started car and still rough idle and misfiring. Took the new spark plug out and it had been FOULED also ( DRY BLACK AGAIN). So i was told to switch a coil pack around. I did it and the started car, took away some of the rough idle, car actually wasn't misfring or shaking, would run smooth for about 5-8 seconds then start misfiring (Didn't that until i switch coil packs around).
Next Decided to pull out the rest of the plugs from the back and all of them were WET with GAS!! and 2 Spark plugs are just dry fouled!! (Cylinder 3, Cylinder 1). If I can figure this out i will fully have my car back to running correctly.
View 12 Replies
Sstripped threads using an impact to remove the plugs?
View 4 Replies
My '07 had the check engine come in the other day, engine misfire. I took it to the dealer hoping it was a coil, due to the 100,000 mi warranty from Ford I was hoping would be covered. Sadly, and of course, all coils tested fine, turns out 2 plugs were bad. They replaced all 8 plugs, plus a plug boot. Not one plug broke (truck had 80k on it) so no extra cost there. So much more, but peace of mind that all the plugs are new one piece plugs is great. He recommended that they should be replaced every 60k to avoid any issues.
View 7 Replies
I am a newbie here, and also a new owner of a 2006 F150 XLT 4X4 with the 5.4 engine. It has 68K miles on it and looks to have been well cared for. I have a couple questions. First the truck is runnig great, no problems. I have read the threads regarding the spark plug issues and was looking for an opinion about changing them. Should I wait until I have problems, or due to the age of the truck, should I go ahead and attempt it soon? Also, I would like to find a used cap for the bed. I have the 6.5 bed, and wondered what range of years would work with my truck.
View 3 Replies
I've recently had a small issue with my truck missing under hard load. If you're going around 40 MPH and push it down like merging it will kick back and forth and sputter and then start hitting fine again after a few seconds and move on. Possibly bad sparkplugs and/or wires?
View 3 Replies
My 2011 f250 has 92k miles, I want to change all 16 spark plugs.
Do the 6.2l plugs have problems breaking like the 3v engines did?
I think I'm going to pull the passenger fender liner to get to the lower plugs in the head.
How does the coil pigtail unclip? I looked at them briefly earlier and it looks like you pull the red tab back, then press down and pull on the pigtail but that did not work and I did not want to break anything.
View 14 Replies
I changed my spark plugs now I got a miss and rough idle .#2 and 6 seem to be the ones that miss the idle don't change when I unplug the coil , I take coil off and put it next to the motor it sparks ! I put everything 3 plugs and got about 200 miles on them and 3 out of 8 had melt downs and left me on the side of the hwy. I got autolights in it now but it got a miss and rough idle ! Did I not do something right ?
View 7 Replies
I have with my F150 5.4 liter truck. I had the spark plugs replaced about 1 year ago. since then I have had 2 plugs back out and come loose. I would smell a faint gas smell first that would tell me know that it was happening. the first plug was if memory is correct either number 8 0r 7 on bank 2. this time its number 2 on bank 1.
I hope that my mechanic just did not torque the plugs correctly and all I have to do is tighten them. If that's not it. Could the spark plug holes be stripped and have to be re-threaded? And if so how us that done?
View 7 Replies
I have a 07 with the 5.4 engine and it has started to jerk or miss sometimes when I'm pulling my trailer. I'm thinking about changing the plugs, but the dealership is telling me they will break off in the head.
View 11 Replies
I purchased a 2000 Ford Ranger last year. Within the first two months of ownership, the vehicle was having a cylinder 4 misfire. To fix it, I replaced the fuel filter, plugs, wires and cap - replacing the wires, plugs and cap fixed the issue. The issue went away for four months when cylinder 4 misfired again. I brought it to a repair shop and they again replaced the wires and plugs. The vehicle now has a cylinder 6 misfire.
There has to be something causing these plugs to continually go bad. Rather than just replacing the plugs again, I'd like to attempt to be proactive and fix the root of the issue. I've googled the issue and some of the forums seem to indicate a bad EGR valve.
View 10 Replies
I have a 2008 Touareg 2, V8, 4.2L.
I bought it used (~95k miles) and almost immediately had an issue. #5 is misfiring. Since then, it has been in the shop 10-12 times with no resolution. Here is what I have done so far:
Put in all new plugs/coils sent the ECU to SIA electronics in Chicago for testing - no errors replaced the injector with a new injector on #5swapped #1 for #5 (plugs/coils)checked the harness (dealership said they did this, but not sure if they did or are just tired of me)
Through all this, #5 is still misfiring. The dealership is out of options, suggesting that the ECU is faulty and needs to be replaced ($1600) or they need to swap the #5 injector with #1 to see if that is the issue (~$1000+). Neither of these options sound reasonable because a) the ECU was already tested and b) the injector is brand new, yet the exact problem (#5 misfire) has persisted before and after the injector replacement.
View 3 Replies
I just changed the plugs in my 05 stx 4x4 4.6L. Truck was running fine, never a problem but it has 105k so I figured id change them. #4 was the only one that gave me a little problem (besides being so tight). The coil and spring pulled off the boot, and I had to get a pair of pliers and get the boot off the plug.
I simply slid the spring back through the boot and replaced it once I had changed the plug. Other than that they all came out easily. I replaced with motorcraft plugs, and #5 did have what looked like some oil down on the threads when I pulled it out, but not sure if that's a big deal or not
Any way, I am torn between ordering new boots and changing them out, or just biting the bullet and getting 8 new coils with new boots attached. Truck runs fine, but does the usual buck/jerk under a load in overdrive now (never once did it before)...
View 3 Replies
I have rough idle problem after changing spark plugs, fuel filter and battery. There was no rough idle problem before this work was done. What could be wrong. Once the speed is above 20 mph it seem to run fine but at stops it vibrates and seem like it may stall!
View 6 Replies
My 2010 prius had been giving low mpg since the last three months. It has now 145K miles.when I bought it a year ago, it had 134K on it. I haven't changed the spark plugs, do they have any effect on low mpg? My mpg is about 39 now,but was 42_45 before.
What are the symptoms for the spark plugs to be changed?
View 1 Replies
Had a miss in the #5 cylinder on a 2005 F-150 5.4 Triton. Had it hooked up to see which code was given and the tech said that #5 was the culprit. Taking no chances, I purchased a new plug and coil pack. I installed them and it ran great until I got up to around 70mph and then it started dong the same thing it was doing earlier. I took it back to the place that checked the codes and it came back as the #5 cylinder misfiring again. I am not sure how this is possible after replacing the plug and coil pack. Is there some way that the plug that fires just ahead of #5 is fouled out and causing the #5 cylinder to get too much fuel transferred to that cylinder? Or is there a possible short somewhere causing that cylinder to misfire and ruin the coil pack? I am stumped on this for the moment anyway.
View 8 Replies
2001 LS v8 .... What would cause the car to give off a strong smell after changing the plugs?
View 5 Replies
I got the APR ECU Tune in June along with VW Racing air intake. Car runs great except... the engine is knocking under full load. The guy who did the install heard it right away but I just thought he was trying to up sell me. He suggested new spark plugs.
Well it's two (three?) months later and I've come to accept that I can't drive it in the 91 program anymore (I paid extra for the ability to switch programs - lucky!!). I was switching back and forth between 91 and stock and I can hear the difference.
Are spark plugs the likely fix, and how do I choose the right ones for my Mark VI Golf R? "one step cooler"??
View 12 Replies
