Ford F-150 (2004-2008) :: Making Roaring Noise After Playing In Mud?
Apr 9, 2011
The front of my truck is making a roaring noise after playing in the mud while your going down the road is the only time I hear it. It sounds as if I have really aggressive tires on it. I did do my best to clean out from under it... It doesn't seem to feel like its dragging. 4x4 engages fine? I mean it started only after a few days of playing in it, I didn't wash the mud off right away. Should I be concerned? I mean if its just some dirt up against something, then that is no big deal, but my ranger whined when it was low on differential fluid. However its not whining, just roaring.... Should I be concerned? Truck drives fine... no issues there.
View 5 Replies
Advertisement
I got an 08 F150 2wd. I noticed lately a mild roaring noise coming from right front wheel, but it only does it when I'm turning left. There is nothing while driving straight or during right hand turns. Only happens during left hand turning.
View 1 Replies
2010 F150 XLT 4.6V .... Not too long ago my truck started making this whining/roaring noise when I accelerate. It does not matter what speed I am going from the slowest to the fastest it makes this noise but it does not make it when it is idle or at least it is not loud to the point where I can hear it while inside my truck. I am not sure what this can be I am at about 51,000 miles and have no problems other than the noise besides the fact that to me it seems as if it pulls at times when I drive it but others say they don't feel it pull. So I am not sure what is going on and I do not want to take it to any mechanic I'd rather fix it myself and know what is going on with my vehicle?
View 5 Replies
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 Replies
I have a 2002 Honda Accord coupe with 130K miles on it. A few days ago the AC started to make a loud roaring noise when it is turned on full blast. As you turn it down the noise gets quieter and when the fan is on low the roaring noise stops. Other than making this sound it is running fine and there are no other issues/noises coming from the car. What is causing this noise?
View 3 Replies
2004 F150 Super Crew Lariet 4x4 with limited slip. Center console with electonic switch 2wd/4hi/4lo on dash right of steering wheel. My 4 wheel drive does not work.
When the truck is in 2wd I have no issues, no sounds(I've heard anyway) or anything. The only questionable is when turning with wheel at full lock in either direction at low speed, my front wheels grab/lunge. Not sure if that is normal or not on these trucks.
When I put it in 4wd in the snow, it acts as though it wants to engage, but the second any power is applied to the wheels, the back wheels just spin and it makes a higher pitched grinding/chattering noise up front. It will also lightly clunk into 4wd with little power applied to the wheels, but once it has accelerating power applied the front diff "pops" and is clearly no longer engaged.
When in reverse in 4wd, it makes no noise, but still doesn't work.
Yesterday I had it in the shop for an oil change and to rotate my tires. While it was all off the ground I turned the ignition on and put it in 4wd. Both back wheels turned it the same direction(limited slip) as they should, and the front left wheel turned fully engaged with them. The front right wheel did nothing and turned freely on its own(assuming because front it open diff?). One oddity noted, when the back wheel were rotated one full revolution, the front rotated 2 full revolutions(also assuming this is because of the front diff being open and rear being locked?).
When I spun both front wheels by hand regardless of 4wd turned on or not, IIRC, they both made a clicking/ratcheting sound as the spun.
I left it in 4wd when I brought it back down on it's wheels and backed it out of the shop into the unplowed area of snow, I lunged the throttle a touch and the front end dropped as the front wheels gripped and slightly broke loose in the sticky snow. It was fully engaged and working properly for a second. I then put it in drive and tried to move forward, soon as any power was applied it "popped" out of engagement in the from diff and was back to 2wd and light grinding noise.
Another note, our first big snow fall a few days back is when I first had a real issue with the 4wd not working at all. It had snowed pretty well and I didn't feel like shoveling the driveway because I was running short on time to make it to work and my wife had the day off work and didn't need to go anywhere. I started it, put it in 4wd, let it warm up a bit, proceeded with trying to leave. This is when it all began with the 4wd not working at all and grinding. As it made that noise, it sounded pretty light to me in the cab even with the window down. But, as my wife noticed me stuck in the driveway she stood in the front door watching with the glass storm door still closed. She said she thought that "light" grinding noise I heard, was actually quite loud from where she was standing, 60+ ft away.
Previous issues I've noticed with my 4wd that may diagnose my exact issue, it has had a frequent issue the past year or so with, when engaaged, if I applied too much acceleration, from a stop or not, it would suddenly "pop" out of engagement as I've previously noted on, but I would immediately let off the throttle and it would reengage right away.
On two other occasions, it has refused to engage into 4wd no matter what. I simply contributed it to the extremely cold weather during the occurrence, as it worked just fine the next day and/or the next time I placed it in 4wd.
4hi/4lo light always lights up in the gauges as they should and as if everything is working normal.
So, IWE's? Actuators? Vacuum?
View 11 Replies
I have a 08 f-150 super crew 4x4 and driving down highway or just on main roads,when ever my truck down shifts it make a quik vibration noise, kinda like driving on a washboard road.
View 5 Replies
Ok, just asking a question for a buddy. He has 78k on the truck and the shocks make a strange noise. When one of us bounces the truck up and down on the bumper (simulating a load) the shocks "click". Now I looked and it looks like the bushing may be wore out, and the actual bolt that goes through the upper shock mount is touching the top and then the bottom, emitting the "clicking" noise. Is this just a normal wore out shock, or perhaps a defect? Just asking because I am not as familiar with suspension systems.
View 1 Replies
Ok I have a 2004 F150 Fx4 ext. cab. I had the truck for sale and due to something coming up I was unable to sell it. Kinda wish I did now. But anyways the truck was running great up until last week. I was drove it to work which I normally dont do. On my way home the rear end was making a weird noise. Kinda like a brake sticking. I tapped the brakes a few times and it seemed to work. Then a mile down the road it was doing it again without me trying to come to a stop and the back end was shaking. I pulled over and crawled under the truck to see if a u-joint was going bad. Everything seemed good. It never happened again until today.
This morning I hoped in the truck and went to my parents house. Its about a 5 mile drive and truck was acting fine. Came home and it was still fine. A few hours later I figured I would go up to the fire department I am on and find something to do up there. I got in the truck and didnt make it 5 feet from where I was parked and there was this bad noise followed by my whole truck shaking. It felt like the truck was going to fall in pieces in my driveway. I stopped looked around and didn't notice anything wrong. I figured I would just try to drive a little bit further and it was even worse. So I put it in reverse and it was normal. I put it in Drive again and thought my teeth were about to fall out of my mouth.
What could cause this? I know my transmission was leaking some oil from where the gear shifter comes out. I would check the trans fluid and add some if needed. I drove it up to the fire hall Monday night and did notice a slight burning smell but that was the only time I smelled it. Could it be the transmission?
View 6 Replies
I bought a 2005 F150 supercrew w/ 5.4 Triton engine brand new. It now has 16000 miles on it and all was well until...
I was driving to work 2 days ago and all of a sudden my truck started acting all weird. I couldn't accelerate and it seemed as though I was driving over rumble strips. I went directly to the garage and they told me that 2 fuel injectors mal-functioned and that flooded everything with gas. I needed 2 injectors and 8 spark plugs. The next day the garage called and said that they replaced the parts but now there is a terrible knocking noise and that I needed a new engine.
I am not a car wiz so what other things should I be aware of? What other questions should I be asking?
View 14 Replies
My 2006 f150 was making a noise that's coming from the engine. It sound like rocks in the engine. When I'm going 50-60 MPH the engine starts to make a sounds like rocks in the engine. What's happening. When I go about 40 it stops.
View 12 Replies
I have just purchased an 06 long bed f-150 with high mileage on it. I am going thru it slowly as time permits. I had found the passenger door stop, not the hinges, to be making a "quite" squeaking noise as it is started toward a closed position. A simple drop or two of oil I am thinking, but it then really increases in sound. I then clean it off and apply a synthetic grease, still loud, maybe louder. I finally got it back to a "quite" squeak again by cleaning it. Use lubricant, or should I just leave it cleaned as it is now?
View 1 Replies
I recently purchased as used 2006 F-150 Lariat 4x4 with 77K miles. I am having an issue with the shift on the fly, I had a vacuum leak that was causing the auto hubs to make noise on occasion but it has never allowed me to shift from 2wd to 4H while moving. I have replaced the IWE solenoid and repaired the vacuum leak but it still will not engage while moving. The light for 4H comes on but the hubs will not engage. The dealer where I purchased the vehicle is not a ford dealership and whey have been trying to solve the problem but to no avail.
View 3 Replies
2008 Ford F-250 5.4L VVT. Setting both cam position sensor codes and both VVT PO12 and PO22 Codes. Runs good for a few minutes cold then goes to making noise and retards timing when warms up . Replaced both cam phasers and 1 vct solenoid and camshaft position sensors, changed oil and filter with motorcraft.. Tried unplugging VCT solenoids but still runs bad when warms up. Ran bad when engine was cold or hot before replaced phasers now only when warms up. Is it a oil pressure problem pressure shows good on dash gauge.
View 8 Replies
i have a 2006 f-150 xlt, i was driving it today and it started making a 5x5 beeping noise shortly after i started it up. I read on a few forums that that beeping is a warning about the passenger airbag sensor or something. anyways it went away and kept driving for 5 minutes or so when suddenly the dash went out and all the gauges dropped but i was still able to drive fine. A minute later the engine just died and i managed to pull over to the side of the road. now nothing works when i turn the key, not even a light, its just a dead weight, the remote locking doesn't even work. the only sign of life is a LED from my phone charger that is plugged into the outlet. the battery is only 2 months old so its not that.
View 2 Replies
The speakers themselves are not rattling, but the door panels themselves are. What kind of cheap material did Toyota use on the Gen 5s to cause door 6x9s rattles on the panel when listening to bass heavy music
View 14 Replies
I drive a 2008 Ford Expedition and every time I go on long trips after a while on the road the car starts making this grinding noise when driving uphill. As soon as i take my foot of the gas it stops. It has never done it in the city, always when driving on the freeway. I can manage it if I keep the gas pedal as steady as possible but if I try to give it more gas it will start making the noise. This does not happen all the time, it is intermittent. I was told that it might be the 4x4 engaging on the front wheels but I am not sure what it has to do with the speed or gas. I have changed the spark plugs, fuel filter, fuel pump.
View 19 Replies
I've got a 4.6 in a 2005, 178000. I assume the 4.6 in an E150 would be the same as the F150.
So anyways, Started and an intermediate problem where sometimes it would stalling when making turns, such as entering a driveway, making turns or going from reverse to drive. Now its turned into more of a problem with stalling, even while in just idle and not just in gear.
At idle RPM is sporadic from 300-900. Here is where I'm at New Fuel Filter. ECM is reading 38 to 41 psi fuel pressure at idle and when the throttle is pushed.
Took a chance and changed the belt since the old was a bit lose. Even ran the engine without a belt and there was no change in my problem.
I've removed the throttle body, just learned these engines don't have an IAC, they use and IAC motor instead. I don't know how to test that but I'm googling it.
Back of throttle blade is all gunked up so I'm cleaning that now. It has no codes btw.
View 7 Replies
I have a 2007 Ford F-150 small box bought new, now has 80,000 miles. The rear end started to make a slight roaring noise that started to turn into a vibration. That turned into a major vibration (windshield wipers would hop). I figured a bad U-joint, but it had no "clunking sounds". I took it to a non-dealer mechanic and he said the "rear end is shot, and also a bad leaf spring..." I do not tow with this truck, or go off road, but it does have a Tommy lift installed. Does this sound normal for the miles and usage of the truck? Any recalls for this model that effects the rear end?
View 16 Replies
I have a 2000 X 5.4... There is a loud roaring noise when releasing gas pedal or stopped (doesn't matter whether its in park or drive)...noise stops when giving gas...the noise is almost like a bull horn...there are no engine lights on so can't get a code...
View 8 Replies
On my 96' Explorer 4wd, 4L V6, auto tranny the front end makes a roaring noise when slowing down from 30mph to stop; no shimmy or shake or any other noise, it has 133K miles on it, original wheel bearings; just wondering if it is wheel bearing assembly and are these pressed on or can you remove them and replace with new assembly fairly easily. Are there any threads with the procedure here.......
View 11 Replies
