Ford F-150 (2004-2008) :: Low Input Temp Sensor Fault On The Transmission
Oct 8, 2015
To make a long story short. I had a "low input temp sensor" fault on the transmission. I replaced the three solenoids and temp sensor in the bottom of the transmission and added new fluid. I'm still getting the "trans error" code. Everything is working/shifting like it should, just tired of the beeping and code on the dash.
View 3 Replies
Advertisement
I was plowing and when I put it in reverse it felt like it slipped, but then the dash message trans malfunction came up. I checked the codes and I got P0722 output shaft speed sensor.
Code P0720 (oss) sensor circuit fault
Then the truck went into safe mods. Is it just the sensor or is my reverse going out...
View 4 Replies
I have an ABS light on. I have crawled under the truck I don't know how many times everything is connected just as it should be. The wires did have to taped up because they burnt into after getting against the exhaust at some point, but I had fixed that awhile ago, I've even tore back into the tape and re-did everything again, nothing gets rid of the ABS light. When this first happened it would go away after I turned the truck off, but would come back after using the brakes a few times, especially harder stops. Then it got to where it just came on and stayed on, and didn't go out no matter what. Thinking my ABS speed sensor went, I bought a brand new motorcraft one from rock auto it fits perfectly in the rear, plug looks good. I can't find NOTHING that would keep this light on. The code is always the same "Rear ABS Center Speed Sensor Input Malfunction", how to get rid of this?
View 1 Replies
My 2008 f150 trans locked up while throwing trans fault and o/d light flashing, won't move in gear or neutral ! At dealership waiting to be tore into in morning .
View 3 Replies
Need solving a P0172 code I had. I just pulled out the MAF sensor and cleaned it with a MAF Sensor Cleaner (at most auto parts stores). Worked like a charm and the code went away and the gas smell is gone too.
Now I have a new code - P0712. I have been extensively searching the web and cannot find any good information on how to resolve this issue - "P0712 Transmission Fluid Temperature Sensor Circuit Low Input" ...
I checked the fluid level and it is fine.
I have a 2005 Camry, 2.2 liter, 4 cylinders...
View 4 Replies
The MIL light came on and I noticed the shifting P-D or P-R was hard. Checked the Transmission Fluid and noticed it was low. Topped it up, but still MIL is on and shifting hard still. I bought a OBD2 Scanner and it returns P0707 "Transmission Range Sensor Circuit Low Input". Should I try clearing the DTC? It's a drag because it's my wife's car and she's driving mine.
View 1 Replies
I have a 2006 F150 4x4, tow package 5.4, edge tuner, magnanflow muffler.
Towing a 21ft fifth-wheel, trailer weighs 4000 lbs, my trans temp will get up around 250 when pulling a large hill.
What is hot for a transmission?
View 13 Replies
2004 Sport Trac V6. Been having hard shifting and P0715: Input/Turbine Speed Sensor Circuit. Cleared the codes and still returns.
From my searches, readings and looking at the parts diagram. On the newer 5 speeds the sensor is the one on the inside of the tranny. This requires taking the entire tranny apart? Is there an external connector for the sensor that I can check or clean first? Replace this sensor. I know the older ones were mounted on top of the tranny. I think this one is mounted on the inside though.
View 1 Replies
My 2007 F150. That jack wobbles in the hole and, when I plug in a cave, it does not make solid contact. What I am wondering is, does that little panel on top of the dash pop out of that hole to give access to the jack? I am wondering if I can tighten it and re-tension the contacts if I can just get behind that panel.
View 1 Replies
I have just replaced the abs ecu and have cleared the codes, thought all was gonna be good but now two code are still coming up they are:
01044 Transmission control module - incorrectly coded
00778 Steering angle sensor-G85
View 2 Replies
Where the transmission temperature sensor is on a 2014 Camry 4 cylinder. I am contemplating unplugging it to improve shift points. I know it may affect gas mileage but the current shift points suck.
View 2 Replies
I have a 2011 Sonata with 30000 miles. It started shifting funny. It would jump when you put it in drive and shift strangely in all gears. Called the dealer to make an appointment, cancelled as I couldn't get off work. In the meantime, car stopped doing this.
After a while, this started again. Stopped by a shop that offered free code check, the code is P0711 Transmission Fluid Temp Sensor. They said your fluid is overheating and we don't know why, we have to take the transmission off to find out the cause.
View 21 Replies
I have a 2008. My car has a 12V socket in the centre console, but no auxiliary jack.
View 6 Replies
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 Replies
My check engine light came on over the weekend. It was not blinking so I am hoping for just a sensor fault or some other inexpensive issue. I am trying to remain hopeful but after having to replace 2 coils and both catalytic converters about 40K miles ago I am really nervous...
I took the car to the shop this morning for diags but what might be causing the problem? It is a 2004 V8 with about 142K miles.
View 2 Replies
I have a 2008 Camry SE with about 118K miles
I have replaced the Water pump and the temp sensor recently.
The problem is when you turn the thermostat control to hot on the HVAC dial only warm air blows and it is only warm when the engine is revved or going down the road.
My question is: Is the door on these electronically controlled or vacuum controlled? it is like the blend door gets stuck and is not closing fully or something.
View 3 Replies
Check engine light is on, this is the code that came up when checked at OReillys, "P0113 Intake Air temperature sensor 1 Circuit high input". Earlier took it to repair shop, he did not give the code, some sensor needs to be changed (don't know if he came up with same code). He had erased the code but it came back on within minutes. Wanted to check if there is any cheaper way to fix this. This is a windstar van.
View 15 Replies
I have a 2000 Ford E350 Short Bus 7.3 It has abs in the rear diff. I have changed the sensor. I have connected my AE but get nothing at all from the sensor. My speedometer does work. My overdrive light flashes and the transmission does shift properly. I plan on looking for a bad ground. Can I test the wiring using a volt meter
View 2 Replies
Got a new 2008 F150 King Ranch. Great running truck with a lot of "stuff". But now the bad. Got about 5 blocks from the dealer and the tire comes on the dash. Sure enough the rear drivers side tire is getting low. 1st thought I'd load it with some Slime but decided to take it to a tire store as we found a screw stuck in the tread. Turns out the screw was too far out on the tread to be patched.
I bought a new tire instead of going after a plug kit and driving a few more miles before replacing all tires. Drove home. Went for a short drive today and now the TPMS fault is showing on the dash. Little yellow tire blinking. Finally got home and checked all the tires. The lowest was the front drivers side at about 38 PSI. So did the tire store mess up my TPMS system or is something else going on?
View 5 Replies
What can be done regarding these faults? P0037 and P0057
Description:
Oxygen Sensor Heater Control Circuit Low (Bank 1, Sensor 2)
Oxygen Sensor Heater Control Circuit Low (Bank 2, Sensor 2)
The catalytic converters have been removed but the fault was present before that anyway. All I want is the VSC function to work again and the lights to go off. I have heard you can put dummy sensors in.
View 3 Replies
My 06 f150 v6 auto died on the way to work last night. It said trans fault on the dash. The trans has been shifting fine no slipping no hard shifts. The trans has 113k I replaced the motor and it has 57k. Both have been working great until last night. I plugged my scanner up it had a bunch of codes so I cleared them and done a koeo test and got 10 codes.
P0141
P0161
P0740
P0743
P0748
P0750
P0753
P0755
P0758
P0962
With the key in the on position the truck was showing 27.3 psi on fuel.
View 8 Replies